Suddenly all these lights came on in a 2012 Elantra . Had at the dealer and they checked wheel speed sensors, wiring to sensors and said all those are ok and the abs module is bad. I replaced the module, bled the brakes and the exact same lights are still on with the same codes coming up. Tech is confused as I am.
View 5 RepliesThe auto delay feature has begun to fail. Sometimes the parking lights stay on for at least an hour. Sometimes they stay on even after pressing the remote lock 2x and hear the chirp. So far have caught this prior to dead battery situation.
View 3 RepliesI have a 2013 elantra limited with the tech package. Today I discovered that my parking lights or headlamps stay on after the car is turned off and the vehicle is armed. The interior blue lighting ( gear selection, push start ignition button, a/c selections, Eco button etc. ) stays on as well. I checked the fuses, but couldn't find anything that pertains to the parking lamps.
I usually run my lights in the drl or headlights position as I lost the auto feature when I installed my H.I.D's. And they usually shut off after a good 15 seconds.
I installed a powered compact subwoofer today and initially wired it to the same battery terminal as the H.I.D.'s but now have switched to another terminal.
Went to leave for work this morning and released the parking brake and she wouldn't budge. Had to give it quite a bit of gas to finally move, along with a big popping sound. It was cold out, and haven't been using the PB in cold weather lately but did yesterday and this happened. Is there something that needs to be done with the brake? Thought I might have to get towed.
View 1 RepliesI have a 2004 Elantra GLS. My left rear brake was hanging (wheel was very hot to the touch after driving, while other wheels were not), so I had a friend check the brake pads. We decided to replace the pads and rotors. While doing so, the parking brake seemed stuck in the on position, so I opted to have him disconnect it completely until I could afford to replace it. I had used it for the first time about 2 weeks before I noticed the hot brake problem, so we figured that must have been why the brake was hanging.
My friend replaced the rotors and pads, put some penetrant/lubricant on the piston of the caliper and reassembled the brakes. He did use the special tool to spin the caliper in when putting the pads on, however he didn't know that was necessary and tried to force them in with a C-clamp first.
Now, I seem to have two problems:
1. The left rear brake still hangs sometimes. I will drive the car and when I park it I can feel the heat coming off of the left rear wheel. It is extremely hot, so I know the brake is hanging (even with the parking brake disconnected). What is the problem here? Is the caliper bad? Would replacing the caliper solve the problem? Does the parking brake have to be connected to stop the caliper from hanging up?
2. My second problem is the pulsating of the brakes. I am afraid the rotor is warped because of the heat, or maybe he didn't clean everything well enough before he put the new rotor on. How can I figure out what the problem is? Is there a way to check a rotor to see if it is warped? Could there be another reason I feel the pulsating brakes? By the way, the brake fluid is full.
If the caliper needs to be replaced and I can leave the parking brake disconnected, are there any special instructions my friend should know about before working on this? He does work on a lot of cars and rebuilds cars to sell, so he is pretty knowledgeable. I think the only thing he didn't know about was rotating the piston. I would like to provide him with detailed instructions if necessary.
Doing a rear brake job on my 2008 elantra. Left went fine. However, the right rotor is stuck on the parking brake. It is loose, but held on to the springs of the parking brake.
How do you back off the parking brake? Also, how do you remove the parking brake cable?
Noticed this evening that my parking lights were on in my '01 Elantra. Car has been sitting since Friday evening in my garage. The lights were not on earlier today.
The car did start right up when I turned it on. Went inside to research and an hour later the lights are off again.
I noticed the rear parking cable's one end hanging. Not sure how to connect it. Appears a part is missing.
View 7 RepliesI recently had a Car alarm/remote start installed in my van and it seems that every now and then my ABS Light and Parking Brake Light come on while driving but if i shut the van off the lights all go out and don't come back on for a few days then it's the same thing. I also changed the front brakes right before i had the install done so i don't know maybe i did something or maybe it was the shop i am thinking it was the shop as they seemed pretty incompetent and could not to this day (3 weeks/19hrs shop time (8hr+3hr+8hrs)) get the alarm to function right.
View 8 RepliesMy son parked the car and I noticed the brake lights were on. After depressing and releasing the pedal a few times the lights go off, then 2 or 3 seconds later, they're back on even when the pedal is released. This happened all of a sudden. I'll pull the switch in the morning and test it, but what else could it be but the switch, right?
View 1 RepliesI drive a 94 Pontiac sunbird LE, and recently I was driving up to a stop sign and just about stopped when the brake pedal went straight to the floor. I pumped the brakes a few times and they were fine again. Then the next time I started up the car the abs and parking brake lights were on, and stayed on for 4 days. Just the other day the same thing happened again. What is going on?
View 5 RepliesHad my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 RepliesI replaced brake pads on my 05 Prius Monday. The instructions I have say to pull 2 relays and pump and hold the brake pedal until I hear a buzz. This has worked fine the last time I did the brakes. This time I got the Brake, Parking brake,VSC and ABS lights when I powered up.
I did not open the hydraulic system, just push in the pistons. I test drove it then touched the brakes. The left front and right rear rotor/drums were hot but the others were not. Long story short, I want to reset the ABS system.
I replaced my rear brake shoes this past weekend. Immediately after I replaced them, the ABS, VSC, ((!)), and Parking Brake lights came on. I had not read that I should've disconnected the 12V battery before changing the shoes, so I wonder if that's related to the issue. I've read through as many threads here that I could dig up, but I still have questions. Here is what I know so far:
Car Info: 2004, 210k miles, Original 12V battery
Relevant Info: While replacing the shoes, one of the seals(?) (rubber part that slid over the piston(?)) slid off. I put it back on, and have checked for any fluids leaking, and have found none. I may pull the rotors off and check this again, though. There were no DTCs logged prior to the shoe replacement. Battery has shown no signs of dying, although I am going to check the voltage on it after I post this.
I tried jumping the pins, and I get the following flash codes (I tried resetting, but they came back immediately):
ABS: 4-2
VSC: 4-5
((!)): 6-5
I tried finding information on these flash codes, but have found nothing...
My CHS Tank was damaged in an accident a few years ago. I just replaced the CHS tank and the Inverter Coolant Pump within the last 12 months. It is still running when I power the car on and off as it should. I also jumped the fuse with a paperclip to double check that it runs.
My brake fluid levels are fine right now.
Possibly unrelated to the lights, but applying the parking brake is very easy. I don't think I adjusted the star adjuster enough. This is my first time messing with drum brakes, so it's possible I didn't adjust that correctly. Are these self-adjusting, or do I need to go back and adjust them by hand?
So today, I started my Lexus Ls600hl and the lights were flickering and the car wont start. Then on the Dash it has the yellow ! icon and the lcd says Parking brake not available.... The car wont start. I tried disconnecting the battery etc. nothing. Then i jumped the battery and got it to turn on, but it says parking brake not available - see dealer for information. But the car runs fine and everything now - But i don't understand the warning, the parking brake wont engage anymore. I will take it to the dealer tomorrow to see what's wrong.
View 14 RepliesProblem accrued since the 2012, after I installed OEM HID headlights. Everything was fine for a month or so, then I found out the left parking/turn lamp isn't working. I checked the bulb and it was OK, however I replaced it for a new one. However it didn't work. So I replaced left bulb from right side and vs versa. Didn't work. Then I replaced headlights on KDM aftermarket one with LED DRL and everything repeats...
However when I put back the halogen headlights, that problem disappeared, looks nothing happened. Now I want to put back my OEM HIDs, but expecting same problem again...what it can be?.
Dealer doesn't know anything, already I have asked him, they just put again a new bulb and thats it. Where and what should I look at first...
I found out last night that all 3 of my brake lights are out. However, my tail lights work, and my turn-signals work. So obviously its not a big wiring deal. I was looking for the brake switch but i don't know where its at because i looked underneath. What fuse is the brake lights cause my manual doesn't have it listed. I drive a 04 Elantra GLS.
View 6 RepliesI have a 2003 Variant V6, 34,000 miles - I was pulling out of a parking spot and the car had no "power". but eventually it kicked in..then when I got home I noticed that the brake lights stayed lit...no problem, I pulled the fuse so the battery wold not run out...put the fuse back in for the ride to the dealer, but a block out and again no power - depressing the gas pedal had no effect. Could these be related? The cars been at the dealer all day, they have no clue so far. I had the fuel pump replaced under recall...could it be some sort of electrical problem.
View 4 RepliesWhen I was at Luscious Garage earlier today for a transmission service, the technician told me that my parking brake is out of adjustment. Sure enough, I checked the factory service manual when I got home and found that the spec is 8-11 notches at 67.5lbf. My own test revealed that it was taking between 15-17 notches on mine!
View 7 RepliesEvery time I speed up or slow down my ABS, TC and parking brake lights turn on and my car beeps at me. I'm assuming that I have a wheel speed sensor going out. But when I check the codes there is nothing and the check engine light never turns on, so how do you tell which one to replace? Or is my problem something different? I drive a 1999.5 vr6 Jetta.
View 10 RepliesSo a little while ago I had my parking brake, ABS, and traction control lights all come on at the same time. There was no change in performance, but they have been on ever since. I looked in to it online and a bunch of people said this was a common problem with damaged tone rings, so I checked them out, but they were fine (as far as I could tell anyway). So I scanned the vehicle using a buddy of mine's Snap On scanner, and it came up with the following code:
B1342 Faulty Control Module
We tried to check the fault code through Mitchell OnDemand but it said that this code was for a faulty Parking Assist Module. I don't have any kind of Parking Assist system on this vehicle however. I looked around a little more and this seems to be a pretty generic code for brake system faults with Fords. Also, if the control module for the ABS is the same one that handles traction control?