Elantra XD (2001-06) :: 2004 - Rear Brake Sticks / Parking Brake Is Broken
May 21, 2012
I have a 2004 Elantra GLS. My left rear brake was hanging (wheel was very hot to the touch after driving, while other wheels were not), so I had a friend check the brake pads. We decided to replace the pads and rotors. While doing so, the parking brake seemed stuck in the on position, so I opted to have him disconnect it completely until I could afford to replace it. I had used it for the first time about 2 weeks before I noticed the hot brake problem, so we figured that must have been why the brake was hanging.
My friend replaced the rotors and pads, put some penetrant/lubricant on the piston of the caliper and reassembled the brakes. He did use the special tool to spin the caliper in when putting the pads on, however he didn't know that was necessary and tried to force them in with a C-clamp first.
Now, I seem to have two problems:
1. The left rear brake still hangs sometimes. I will drive the car and when I park it I can feel the heat coming off of the left rear wheel. It is extremely hot, so I know the brake is hanging (even with the parking brake disconnected). What is the problem here? Is the caliper bad? Would replacing the caliper solve the problem? Does the parking brake have to be connected to stop the caliper from hanging up?
2. My second problem is the pulsating of the brakes. I am afraid the rotor is warped because of the heat, or maybe he didn't clean everything well enough before he put the new rotor on. How can I figure out what the problem is? Is there a way to check a rotor to see if it is warped? Could there be another reason I feel the pulsating brakes? By the way, the brake fluid is full.
If the caliper needs to be replaced and I can leave the parking brake disconnected, are there any special instructions my friend should know about before working on this? He does work on a lot of cars and rebuilds cars to sell, so he is pretty knowledgeable. I think the only thing he didn't know about was rotating the piston. I would like to provide him with detailed instructions if necessary.
View 2 Replies
Advertisement
I noticed the rear parking cable's one end hanging. Not sure how to connect it. Appears a part is missing.
View 7 Replies
I replaced both rear calipers, rotors, pads, parking brake cables and it still sticks once in a while. I have played with the adjustment on the console many times, but to no avail. I have to crawl under the back and press the link up to unlock the parking brake. It's only about a 1/4 to 1/2 inch at most. Is there some type of spring I can use so it retracts all the time? I have seen Toyota's with them.
View 4 Replies
Gen 5.5 (2006 LE (57K miles), Rear brake drums and parking brake.
I want to get my parking brake lubricated and rear drums cleaned and adjusted. Is is difficult to lubricate the parking brake?
I plan on getting this done with a Mobile One oil change at a local garage.
View 2 Replies
My brother-in-law has an '04 with ~160K miles that we're potentially interested in picking up from him. It's been sitting for awhile with the parking brake on. When going to try it out today I released the parking brake (it seemed to release okay) but both rear wheels were stuck. I drove it a few feet and the left rear freed up but the right rear would not budge (multiple attempts.) It was dragging on their driveway and I could barely get the car back out of the way.
Looking for (videos, manual, etc.) how the parking brake works? Is there an external adjustment I can reach or some place to try to release the cable? We had an '06 that our daughter now drives but I've never had any issues with rear brakes in 200+K miles on that car.
View 19 Replies
I noticed an increasingly loud noise when my GX 470 is in motion. It isn't tied to engine speed, so I figure it probably has something to do with the wheels.
I jacked up the vehicle and spun each wheel independently in neutral. Front wheels were fine. Rear driver's wheel was fine. Rear passenger's wheel - fine with parking brake disengaged. But with brake engaged, you can spin the wheel backward but not forward.
View 2 Replies
This is my first time working on drum breaks, all the repair manuals and videos don't make it look too bad. I did have a question about the parts required to replace the rear breaks.
Assuming these breaks are very worn. What parts would need to be replaced in a typical break job.
The pics below are what I'm planning on buying:
Shoes
Rotors
Drum
Hardware Kit
Is there anything that I'm missing?
View 7 Replies
I have a 2003 hyundai elantra gt. All the lights and bulbs work, except for the rear left brake light. I've replaced it twice now, and used a bulb I know was good, so the problem is not a bulb. I checked the fuse, and the fuse is ok as well. When I measure at the bulb socket with an ammeter I get around 20 mA which I assume is too small and I assume there is a loose wire somewhere.
View 2 Replies
I am having an interesting sound coming from my rear brakes when I stop from reversing, for example, when I'm pulling out the drive way or a parking space. It kind of sounds like a loud "hum" that lasts a spit second, until the car actually stops. I changed the rear brakes and rotors about 1500 miles ago.
2006 Elantra Limited, 88,XXX miles.
View 5 Replies
Topped off my brake fluid 6 months ago. Last week my brake light came on. I checked and I only had half the fluid left so I topped it off again. Today I went out and there was some kind of oil near my rear tires and my light came on again, needs more brake fluid.
View 6 Replies
Have to replace both rear brake lines, I can't find any information about doing the job. I need to know what size the lines are and what type of flair is on the ends?
View 2 Replies
Had my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 Replies
F350 Super Duty sometimes the front driver side brake sticks and will pull to the left while driving and pull hard to the right while braking. It has a slight front end vibration when the symptoms are present. The wheel will be boiling hot to the touch and the smell of brakes burning is obvious.
After the truck sits, it will be good with no incident for weeks.
With the wheel still hot and on jackstand, the front wheel seems to turn freely until the brakes are applied, and seems to spin free again as brakes are released.
It seems to happen when I have a "hard braking" incident going forward until I park the truck and let it sit. If i consciously brake soft, the brakes seem to be fine.
I have read some of the posts and this is different in that it is intermittent.
I have replaced the brake hose as I thought it could be the "check-valve" symptom. No luck.
I have checked the sliders and re-lubed and they slide freely.
The caliper is relatively new and the fluid in the system is fresh as i recently changed the rear brake line and completely flushed and bled all four corners.
Do i just change the caliper, or, is there a way to find out if one of the pistons is intermittently binding? I would hate to invest in a new caliper if that is not the issue.
View 9 Replies
So one of the green wires broke off at the bulb connection and my 3rd brake light is not working. If I touch the ends together the light does work. Can I just remove the broken wire in the connector and reattach the current wire? Or do I have to replace the whole thing?
View 11 Replies
I've been having a randomly recurring problem with my 2004 Hyundai Elantra for several months now. I'll be driving along and will notice that my brake pedal won't depress. When I step off of the accelerator, it is like the brakes are already engaged. Eventually, the brake pedal won't depress at all and the car acts like the brakes are fully engaged. Sometimes I can let it sit for an hour or several hours and the brakes will readjust and I can move again. So far I have replaced both calipers, rotors, 2 brake hoses and the master cylinder, but I am still having this problem. My mechanic is flummoxed. Any time I have the car towed in, the brakes release by the time it arrives and he has no problem to observe.
View 3 Replies
Suddenly all these lights came on in a 2012 Elantra . Had at the dealer and they checked wheel speed sensors, wiring to sensors and said all those are ok and the abs module is bad. I replaced the module, bled the brakes and the exact same lights are still on with the same codes coming up. Tech is confused as I am.
View 5 Replies
I need to do a brake job on the front of my 04 Elantra, how to reset the caliper piston. I've tried the traditional c-clamp method but can't get the clamp to grip well on the non-pad side because of the caliper shape.
View 4 Replies
I have an 04 elantra 2.0. Seems to idle rough when in D and foot on brake at the the lights etc. Put it into N roughness goes away.
View 15 Replies
Doing a rear brake job on my 2008 elantra. Left went fine. However, the right rotor is stuck on the parking brake. It is loose, but held on to the springs of the parking brake.
How do you back off the parking brake? Also, how do you remove the parking brake cable?
View 1 Replies
Went to leave for work this morning and released the parking brake and she wouldn't budge. Had to give it quite a bit of gas to finally move, along with a big popping sound. It was cold out, and haven't been using the PB in cold weather lately but did yesterday and this happened. Is there something that needs to be done with the brake? Thought I might have to get towed.
View 1 Replies
I bought a 2006 Sonata V6 3.3L with 137k on it about a month ago. Engine and Trans is great, but I noticed an issue that developed within the past week and a half or so.
I am one to always engage the parking brake when parked, to relieve pressure on the parking paw in the transmission. After about a week of heavy use of the parking brake, I began to hear a slight 'clunk, clunk, clunk' coming from the rear passenger wheel (it actually sounded like something was loose in the trunk, but ruled it out). The 'clunk' sound at first only happened going over rough or bumpy roads, but within the past week or so it's gotten louder and more consistent. It now 'clunks' regardless of speed or road surface.
I used the parking break today for the first time while the car was in motion, and when pulled it sqreached very loud, didn't really stop the car, but the 'clunk' became very loud while the break was pulled - shockingly loud, actually.
A couple of days ago I took the rear passenger tire off while jacked up, and spun the wheel. With neither the parking or regular breaks engaged, the wheel made a 'clunk' sound very similar to that it makes on the road. Took of the Tire/Rim and spun the Rotor, to hear the same sound. Attempted to wiggle the Rotor and found no play at all.
At first, the clunk went away when you pressed the floor board brake pedal, even just a slight bit stopped the noise. Now it doesn't seem to stop it any longer.
My main idea is that the parking brake in the Rotor is the culprit, given that the issues didn't arise until I started using the parking brake - and the fact that brake appears to not work very well. However, my dad tells me he thinks it's a wheel bearing. I don't think it is - as its not making any metal on metal sounds, nor is it very difficult to rotate the Rotor while jacked up.
View 3 Replies
