Elantra XD (2001-06) :: Main Relay Clicking When Ignition Is On Not In ACC Position
Oct 5, 2013
My main relay is chattering badly when my ignition is in the on position but not in the ACC position. All of my "dummy" lights are flashing with the chattering main relay. I have tried to replace both the Start and Main relay and I replaced the battery 3 weeks ago. I have checked the wiring and I do not see anywhere the wires could have been chewed by a mouse and everything appears to be connected. Checked all of the relays and fuses to make sure they were in tightly. Could this be the ignition?
View 1 Replies
Advertisement
I own a 2013 Elantra GT that my wife drives. We have had it since late September 2012, so it is about 20 months old now, with only 2250 miles. Yes, I know, it is not even broken in yet.
Anyway, yesterday when the wife returned from some shopping she told me that the radio in the car is still on after the engine was off, the ignition locked and the key in your hand.
I checked it out, and sure enough, the radio was still on. I restarted the car, and discovered the power button would not turn the radio off, the radio volume could not be changed, and the station could not be changed. Every control for the Audio system was inoperative, along with all the control buttons on the left side of the steering wheel.
Every thing else in the car appeared to work. When I shut the engine off, and removed the key, the radio still played on. I took the car over to the dealership first thing this morning; the service rep, the service manager and a service tech could not figure it out. I had to leave the car with them, so that one of their Electronic Certified Techs who comes in later could check it out.
They drove the car to a service bay, and disconnected the battery, so the radio would not run the battery down. When the tech came in, he reconnected the battery, and everything now works. They have no idea at all what happened.
View 12 Replies
I replaced the front mail seal on my 2003 Hyundai Elantra. It was running beautifully until I put it gear to take a test drive. It dumped half the oil in about a minute. After reading online that there may be a problem with the thrust bearings, I pulled the oil pan and found a thrust bearing in the pan. Is this something I could fix without pulling the engine. Every thing looks good and there are no metal shavings or signs of wear. The car has 170k.
View 2 Replies
I have a 2001 Santa Fe, and the key is stuck in the ignition. I can't even get it to turn to the Lock position, so it's stuck in accessories. Since I haven't had the funds to do so, I haven't gotten it checked out yet, and it's started to drain my battery. I have to jump it every single morning, so I'm wondering if there's anything I can do until I can gather up the money to fix it.
I have tried moving the steering wheel and shifting it all over the place and spraying DW-40 in there and a whole bunch of other things I've seen work for people on a bunch of different forums, but nothing works. I don't know if this matters, but before it got stuck, it would sometimes be hard to pull out or push the key into the ignition.
View 4 Replies
I replaced blower switch last year a couple of years ago. I recently starting to get clicking noise from blower relay, and fan turns off then comes back on.
Question:
1- Problem more likely to be from the relay or the fan switch? Should I just replace the relay?
2- I can see and touch the fan relay, but how do I get to it to replace it? What dis-assembly is required?
View 1 Replies
I have a 2003 2.4L 5 speed manual Santa Fe. I was parking my vehicle and removed my key as usual and realized that the car was still running. I put it into reverse rolled back and back into 1st to roll forward just to make sure I wasn't dreaming. I ended up pulling the fuel pump fuse and disconnecting the battery to turn it off.
When I replaced the fuse and reconnected the battery I was able to bump start the vehicle without the key in the car and drive it all the way home with no problem. I took apart all the plastic pieces around the Ignition and attempted to remove the cylinder but was unable to locate any sort of small button or pin to push on to remove it. Where is the release button?
What are my options here? Do I replace the cylinder first or get a new key, or is there something else that I should check first before I take it in.
View 1 Replies
It's a 2001 Chevy cavalier. The key is stuck and won't turn the car off. Already have tried shaking the wheel and wd-40. The wipers won't work and the gauges won't turn on until I jiggle the key.
View 4 Replies
I want to convert my stock turn signals into LED, but i want to do without the hyperblink. I've done some research into this, and have ended up confusing myself. I don't know if I have to add resistors in order to stop the hyperblink that would occur, or if I can simply change the flasher relay and it be more straightforward.
2001 Hyundai Elantra GLS
View 1 Replies
My wife's 2001 Gran Prix has a problem with the ignition switch, or related to the ignition switch. Intermittently (more frequently in warm weather or when the car's warm) the ignition switch can't be turned back to the 'off' position all the way, meaning the key can't be removed from the switch. We've heard from several mechanics that there are a couple problems that can cause this, and in fact had the ignition switch replaced which did not solve the problem. I understand there is a connection to the transmission or gear shift lever that may also be part of this problem in some way. There can only be so many solenoids, switches, connections, etc, related to this, I'd like to fix the problem and avoid spending money unnecessarily.
View 2 Replies
I have been having a problem with my 2006 Hyundai Elantra power door locks, the power door lock switch only works in one direction. It only opens all of the doors locks, but doesn't lock them so I have to manually lock all of the doors. I am pretty sure that the power door lock relays have gone bad, so I was wondering where the relays are located on Hyundai Elantra 2006 so I can swap out the old relay with the new relay.
View 3 Replies
I am having trouble with my 2001 F-150. Starting yesterday it would not start. At 1st i thought it wa the battery, so i took it off, charged it, put it back in the truck and still no start. There is a clicking noise coming from a relay in the cabin fuse box, disconnected the battery, removed relay to inspect and everything looks good. After plugging it back in, and connecting the battery, the truck still wont start and there is a clicking sound coming from the dash near the radio. Rhis is my work vehicle!!!
View 3 Replies
My Car: 1989 Plymouth Colt Hatchback (similar to Mitsubushi Mirage); 4 cyl. 1.5 liter fuel injection; 93,000 miles.
Problem: Check engine light comes on & main relay clicks on & off when starting the engine cold. Holding down the gas & keeping the engine RPM's up keeps it from stalling out until the engine warms up. After that, everything is fine.
The problem isn't in the main relay, because we've tried replacing that, and it's okay. Either the engine control computer or something else is sending the main relay a signal to shut down. We know that the engine control computer has gotten wet, and there has been some corrosion there. That's clearly not good, and we're now protecting the computer from moisture, but is that really the problem?
My mechanic thinks that the processor in the computer that controls only the cold starting sequence is no good, and that the only thing to do is get a new computer (if that's even possible). Is it possible that an engine sensor of some kind is not working properly when it's cold, and is sending either the main relay or the computer a signal to shut down the engine?
View 1 Replies
I am new to Hyundai. I just picked up a 2003 Elantra and I'm doing a couple fixes to it. When I got it, the engine light was on and the code displayed said it had a bad camshaft position sensor. Is this a common issue with the car and is it an easy fix?
Also, I just installed new brake pads and a new battery. Now the battery and brake lights are on, although I know I didn't break anything. Could installing a new battery cause the two lights to come on?
View 4 Replies
01 Elantra, once warmed up to running temp starts to run like a pig & wont idle, has new plugs/leads.
Funny thing is there is no engine check light, in fact it doesn't even come on for the 6 seconds when the ignition is first turned on at all.
Secondly I have OBD2/ELM327 with scanpro but it doesn't connect to the ECU.
We put it into a shop & they claim they were able to connect to ecu but gave no codes which I find a bit strange.
View 16 Replies
My 2002 Elantra GT has been turning off while driving. The radio, lights, and other accessories remain on. The car doesn't lurch but all of the dash lights come on like when you're first starting a car. I was able to restart the car after about 10 min the first time and 5 min the second time it happened. 1 week between episodes.
Brought it to the garage and they couldn't find a problem while letting it run for 30 min. Also, there are no error codes. What could be wrong?
View 2 Replies
Just started having issues with my door chimes this morning.
Hopped in, started up, and now the door chime will not go until I take the key out of ignition. All doors are shut, seatbelt fastened. No lights on dash, no open doors.
View 1 Replies
I am experiencing a new problem with my 2006 Hyundai Elantra. For the 2nd time now (meaning this morning) the car will not start the first time in the morning. As I turn the key past the "on" position all the regular lights will come on, bells ding, etc. but when I move the key to the "Start" position, where the car would normally crank over and start, the entire car electrical system dies. (Interior lights off, non-responsive with the keyless entry, etc.) Yesterday, I figured my battery cables might be loose or something like that. By the time I popped the hood (no more than 30-45 sec) everything turned back on. I then tried to start the car again and the car started normally without issues, with me having done nothing other than pop the hood by this time.
When my car sits all day at work and I return to leave it will start normally without problems. This morning is now the 2nd time this has happened. My battery is practically brand new as it was replaced about three weeks ago. So, my question is: What could be causing the car to not start in the morning the first time, but then somehow "fix" itself without any user intervention on my part other than popping the hood?
View 7 Replies
I have a 2004 Elantra GT, and for the past year it sometimes makes no attempt to start when the ignition key is turned. All the dashboard lights, radio, bells and whistles are fine, but once the key is turned to start nothing happens. There are no clicks or anything. Some dashboard lights stay on and I can hear the initial whirring under the hood from the electrical system.
I've replaced the battery, ignition wires, and plugs. This will happen very erratically. Then all of a sudden it will fire up like nothing was wrong. This is always over a several minute time span of trying and retrying to start. I took it to a mechanic but we can never replicate the problem while there.
View 8 Replies
Engine runs very erratically and I got ignition failure codes on all cylinders plus mixture too lean code. 2 years ago I changed the gadget that sticks right into the middle of the engine and regulates the mixture and the issue disappeared. bought the part from rockauto. should I change sparks and ignition cables or order the same part again? Never changed the ignition cables and sparks.
View 12 Replies
When I try to start my wife's '06, it takes a little bit longer to start than in the past (used to take only 2 turns or so, now it takes 3 or 4). When it does finally ignite, it's a rough ignition and then it goes to normal. Why this is happening?
View 3 Replies
At seemingly random times when I take my Elantra to the gas station it will only fill the tank about half way before clicking off. After doing some quick google searches I'm leaning towards something being wrong with CCV system. I read that over filling the tank can cause debris to clog the system and a few months back my father-in-law borrowed it he has a tendency to overfill the gas tank. But I've also read that there's an error code that tends to pop up with it and so far there's been none. Either way I'm not familiar with how the CCV and related systems work.
View 3 Replies
