Ford 6.0L Power Stroke Diesel :: 2004 F250 - Passenger Side Axle Out
Oct 17, 2016
I have to change out the inner seals on my front axle on my 04 f250 6.0 4x4. was wondering what the torch spects are for the bolts on the end caps and the torch spects on the differential cover? I already have the passenger side axle out. was changing my ball joints on that side when I noticed a bunch of oil in the axle case and on the hub knuckle. Also, this might be a long shot but is there any way to change the inner seal on the drivers side without taking out the axle on that side? I have the passenger out and if I could get away without pulling the driver side that would be awesome.
View 10 Replies
Advertisement
I have a 2011 f250 crew cab lariat that actually sits about 3" higher on the passenger side in the rear. I never noticed until I put some 4" pro comp blocks on the rear. I measured before and the rear left was 40" and right was 41-3/4". Now the drivers side rear is 42" and rear passenger side is 45"? I have looked at the blocks to make sure they are seated properly and everything is installed correct so what gives? What could be causing this. I bought the truck with 99k miles and now it's at 130k miles. I do tow a small cargo trailer sometimes but it is only about 3k lbs. Now I am thinking of buying some new leaf springs to see if that corrects the problem.
View 4 Replies
I have a 2011 F250 4X4 Supercab 6.7L that has a highly annoying knock/rattle (you can't hear it) under the front passenger side floor. It feels like someone is tapping on the floor beneath your feet any time you hit a bump or when on a rough road.
Its been in at least 5 times in 2 yrs with cab mount adjustments/shims, cab mount replacements and realignment of the exhaust and brackets. The knock has been there since about day one (I assume anyway, I'm rarely on that side of the cab) and have burned up my 36k warranty, although I'm told i'm good because it is pre-existing.
I keep insisting its in the suspension and keep being told they can't find anything. The mechanic indicated that this is a known problem, but Ford has not put out any service bulletins other than to do the cab mounts and suspension. Has anyone had this problem and found the solution?
View 9 Replies
Fixing issues with my truck. I just ordered some latex surgical tubing and am getting ready to fix the rattling noise in my rear door by using the Epic's Door Seal Mod. Hopefully this will take care of that issue.
One more annoying noise though. Has there been any fixes to the buzzing window noise that is coming from the front passenger side. If the wind is blowing right and I'm running over 50mph, at times get a loud buzzing noise and really bugs me. Something is vibrating and at first i thought i had a speaker going out but found out that wasn't it.
I've called my dealer and informed them of this and asked if they've heard of this but of course they haven't and this usually means the won't do anything besides look for recalls or something. I have the noise recorded and scheduled an appointment with my Ford Dealer but again, they won't do anything most likely.
View 7 Replies
My right side of my instrument cluster is not working. the Tachometer, Engine Temp and Trans Temp gauge are non responsive, and the CEL and Check gauge light is on. I have seen other posts with people that had the same problem but no solution to what fixed the problem. 2004 F250 Lariat.
View 4 Replies
I purchased a 2011 350 crew cab lariat 6.7 diesel last week. That night i noticed that the passenger side map light was considerably dimmer than the drive side. Had to go back to the dealership 2 days later anyways to get a second key made. Showed the tech the light and he gave me 2 new bulbs to replace both lights with. Both were great for about a week but i noticed the passenger side has once again become dim....
View 1 Replies
I have a 99 f250 7.3 4x4. The problem is in 2wd I can spin the front drive shaft freely and the driver side axle will turn but not passenger side. I've pulled both hubs off and both are in auto position and spin freely. Even with the hub off on the pass side the axle won't spin freely.
View 1 Replies
Bought this truck (06 F250 cclb diesel) earlier this year and (as far as the seat is concerned) worked perfectly until about 2 weeks or so ago, when I learned that the passenger power seat works in every direction except for to move the seat back. Since every one that got in the truck didn't believe me and now the seat is almost at the glove box I finally decided I should do something about it. I have removed the fuse and let is sit with the the fuse out for about an hour, no change. I had read on another fourm that if you recline the seat back a few times it resets the module, attempted with no change. It is to the point I need to get into a bit more serious diagnostic processes however I am unsure exactly where to start.
View 2 Replies
Here's my problem while replacing brake pads i found that my axle has leaked fluid on the pss,side rear rotor and all over .. I been looking for any info on repairing it myself . I found Everything for every other truck just not for this truck.
It's 2003 F-250 w/5.4L all Stock rear axle has 12 bolts and gears are 7.73 ... I believe its a Dana 60. No tags or markings on the Axle to go by..
I live in the Freak-en woods here so i like to order all the right parts once and do over the weekend .. its my only ride so once apart im stuck here.... I did check the Vent Tube its fine..
View 14 Replies
Can you replace the passenger side up pipe without pulling the turbo, etc? My bellows blew out. Y-pipe is still ok. I've already deleted the EGR, so what's the best to put back? Go back to the original style or just put in a straight pipe? Where to get one?
View 2 Replies
I know jack about tie rods. But what I do know is the passenger lower-outer tie rod is clunky [Right where it connects near the wheel. Jacked up the truck and moved the tire from right to left and the passenger side lower tie rod made a very obvious clunking noise right where it connects with the upper piece.
My question is, can I just replace the passenger lower arm or do I need to replace the upper [not sure what it's called] that it connects into? While under the truck I found it difficult to figure out exactly how they are joined together and taken apart? My drivers side is nice and tight, no clunking.
2005 F-250 CREW CAB 4X4
View 11 Replies
I discovered my passenger side carpet was a little damp not bad but was wet. I hosed down the window, windshield, door, and the sunroof areas and didn't see any water coming in!? The only thing I've noticed, when running the AC it seems to have "more" water coming down the frame area but not totally sure but sure seems like a lot more than I remember! Just wondering if, when driving down the road, that the water from the AC is coming in somehow?? Again, the carpet isn't completely soaked but damp, even up under the glove box area on the carpet. Heater core?
2006 F350 4x4 CC KR with 138K completely stock!
View 14 Replies
I've just finished a marathon replacing the y-pipe, and doing the IPR screen. I had many seized/stripped bolts to contend with. 2 I had to cut off in the most awkward places.. Anyways, it all came together and completed the project late tonight...
Befoer even starting the truck I noticed coolant dripping from passenger side manifold/block heater area.. I obviously must have damaged something in my reefing on turbo to get it lined up with exhaust pipes, etc...
I cannot see the source of the leak, but it seems wet above the block heater, but pools there then drips.. I'm curious where to look. Could I have damaged the EGR cooler and its coming from there? At the manifold joint closest to the back, is there coolant flowing there? I am pretty frustrated, because after going through a day like to day, ripping my arms to shreds, straining for 12 hours straight, then having yet another issue to figure out...
Also this is as best as I could get the y-pipe to meet the turbo... slight gap at bottom.
View 9 Replies
Got stuck, noticed when in four wheel drive only the front passenger side and rear passenger side was pulling. Is that normal? Or should both fronts be pulling?
2011 f350 dually 4x4 6.7.....
View 13 Replies
There's a pump or ?? I'm not sure . Our "11 6.7 is making whining vibrating sound coming off passenger side , front of valve cover . Not sure what this is . Nothing I'm searching is telling me n I'm not best with diesels .
View 3 Replies
I have a 2006 F250 with the rear driver side window that goes down but not up. I bought a new regulator and hooked it up to power before going through the trouble of removing the old one. It traveled down and wouldn't go up. The switch is working because I have power to it and thru it. What it might be?
View 5 Replies
We just replaced the #5 injector. Went to take for a test drive and the 4 glow plug caps on passenger side popped off and leaking oil while driving. Pushed them back on and they popped off again. They shouldn't be under pressure should they.
View 6 Replies
Drove my truck for the first time in a few months and there was a noticeable ticking coming from the passenger side glovebox area when the HVAC is running. I cycled between AC and fresh air and the sound persisted. What it could be?
Took a quick video on my phone, you'll have to turn up the audio to hear the ticking : 2011 F350 HVAC ticking - YouTube ....
View 3 Replies
I have a small coolant leak coming from the passenger side near the back of the engine that forms a spot about the size of a dinner plate if it sits for a few days.
One thing I noticed is if I turn off the AC selector switch when I park I will get the drip but if I leave the switch on MAX AC when I shut the truck off I do not get any leaking.
It is definitely coolant and not just the condensation from use of the AC. If I haven't used the truck for a few days or if I have run it with the AC off I will get the drips.
If I run with the AC on and leave the switch in the on position when I shut the truck off it won't leak. I have tried to locate it from looking above and below but can't determine where it is coming from.
View 4 Replies
I have a 2004 F250. Owned it for a little less than 4 miles (186k on the odometer) .. The other day making a routine run and the radio goes out. Stopped to check it out and found I had no power windows either.
Made it home, checked the fuse on the radio and its good and the the power window fuse is also good. Put a meter on the terminals and have no voltage going to them. What I need to look at???
View 11 Replies
I have a 2004 F250 6.0 DuperDuty with about 170,000 miles on it, so far no major break-downs, just a starter and a blinker relay, but now I have a problem.
When I start now, the truck starts fine and it sounds fine, but it has almost no power even if I floor the gas peddle, there is a delay of like 2-3 seconds and then responds slowly, like some tractor. Eventually it starts to move slowly, and after it warms up (after a few minutes), the gas peddle responds more normal.
Also - at about 45mpg, at lower RPMs about 1250, the engine starts to shake (weird), it doesn't do it at idle about 850 RPM, or when I get it up to about 1800RPM+, but at about that 1250 RPM it does do it, luckily I driver locally for a few miles.
What could this be ? What exactly happens when I press on the gas peddle, what systems are involved and in which order?
View 14 Replies
