Ford 6.0L Power Stroke Diesel :: F350 Transmission Whine After Several Minutes Of Pulling Some Large Hills
Jul 6, 2015
I have a 2006 F350 6.0L Powerstroke. While towing my RV this weekend in 96 degree weather, it appeared that my transmission started to whine after several minutes of pulling some large hills. I was in tow/haul mode. It did not appear that I was loosing power however the sound was very concerning. The sound went away after leveling off, or switching out of tow/haul mode. The sound coincidentally appeared as I approached the top of the hills which ranged from 1 to 3 miles in length.
View 11 Replies
Advertisement
Got stuck, noticed when in four wheel drive only the front passenger side and rear passenger side was pulling. Is that normal? Or should both fronts be pulling?
2011 f350 dually 4x4 6.7.....
View 13 Replies
I have 07 F350 6.0 never heard this out of any of my 6.0s. it's almost a whine but can hear it w turbo and out of empty exhaust. Almost like a supercharger noise stumped almost leaning towards actuator for turbo? Noise got real loud swapped turbos used same actuator noise is there but much quieter.
View 1 Replies
I have a 2005 F350 w/6.0 turbo diesel. Had starter replaced last spring. Went to store recently, came out & truck starter would just wind and whine, no flywheel engagement. Mechanic replaced Napa starter under warranty and now the starter whines when just trying to connect the battery(s) without even turning the key. I did try several attempts at starting truck when stranded at the local store, with no results but starter whining. Could I have created a dead short some where, and where would be a good place to start?? How do you get a schematic of the starting system?
View 2 Replies
I have an '03 F350 6.0 that occasionally wouldn't start until it had cooled off for about 30 minutes. A friend of mine recommended adding a little marvel mystery oil to the oil system, I did research this and found no negative posts, but now it has been 2 hours and it still won't start. Could i have added too much and thinned the oil out too much?
View 7 Replies
I have a 2006 F150 4x4, tow package 5.4, edge tuner, magnanflow muffler.
Towing a 21ft fifth-wheel, trailer weighs 4000 lbs, my trans temp will get up around 250 when pulling a large hill.
What is hot for a transmission?
View 13 Replies
Searched with no results. What is the correct bolt torque for transmission pan bolts on a 2012 F350 6.7L?
View 14 Replies
So I got a new tranny about a month ago. Everything works flawlessly. Until today.... Going up hills even small ones feels like I'm towing a house. No torque felling. In 3rd and 4th gear (automatic) it gains boost really fast and peaks at 28 lbs. and coasting downhill it slows itself down. I can go from 60 to 40 without braking in a half mile stretch. I fist noticed something was different when I started to drive home tonight; it makes a sort of whining or howling noise. I can't quite pinpoint where it's coming from. I'm tired of this truck but love it at the same time.
2003 125k miles New tranny New injectors New oil cooler and egr cooler Possible bad HPOP
View 9 Replies
Getting DTC P0401 on my 2011 with 92K miles. First time I got the CEL, we were on vacation, so I read the code, took a screen shot, then cleared it. Called my normal dealer, setup an appt, verified that they thought the truck was safe to drive. Coming home from vacation, I was pulling the TT in my sig, and noticed significant loss of power on hills that I have pulled many times before that I couldnt even hold 55 on now. Transmission dropped into 4th a couple times, on hills that it would sometimes stay in 6th, or at most drop to 5th.
CEL stayed off for a week , and came back on again. The funny thing is that after a day or 2, the CEL went back out on its own. I read the codes the P0401 is still there as a stored code(I did not clear this time). Around town the truck drives fine, the only thing I noticed was the decrease in power when towing. Truck is at the dealer now. TECH "isn't convinced" yet that there is a problem. He is not finished diagnosing yet, and I am sure that he has specific tests to run, but I am starting to fear that I will be getting the call to come get my truck.
View 6 Replies
Had Just replaced glow plugs and batteries along with a new set of tires. Truck had been running fine for the three days that is was. Went out the next morning and went to start and "POP" a large noise came from under the hood. I have yet to discover where this noise particularly came from or what it may have been that caused it. But ever since the POP it will not turnover what so ever. Key on every thing is normal all power just when go to turn key over it makes a faint click. You can feel the click in the relays on your hand when you try to turnover. But nothing. I am absolutely clueless.
View 14 Replies
When I am on the highway, my 2005 Excursion (6.0) will hesitate/sputter/buck intermittently, usually between 70-80mph/ 1800-2200 RPM, but especially triggered by hills and inclines. Each sputtering episode usually lasts about 5-10 seconds and then will go away for minutes at a time. Does not sputter upon take off or initial acceleration. There is no smoke of any kind. Just got it out of the shop where the mechanic replaced ALL 8 injectors and the fuel pump, as well as flushed the fuel lines, and new fuel filters, and oil change (2 injectors were bad, but there was metal in the fuel filters, so to be safe I replaced all of them - ALL OEM PARTS for everything, including filters).
The week before, I had the IPR valve replaced. Also, recently had the back pressure sensor replaced and the EGR was deleted - and turbo cleaned when the EGR was deleted last month. I also tried unplugging the ICP sensor to make sure that wasn't the issue. Dropped $6k into this thing in the past month and about to lose my mind (and wallet). All research points to either clogged EGR or bad fuel injectors, but both have been addressed, so I am not sure where to look next. No current codes showing up. No signs of leaking oil.
View 14 Replies
2012 F-350 King Ranch Diesel. I am eventually going to purchase a camping trailer to pull with this rig. I am thinking of bypassing the radiator with my transmission coolant lines. I did this on another vehicle and it worked GREAT! That vehicle was a 2001 Isuzu Trooper with that crummy 4L30-E transmission. My trans temps stay round 170 to 175 on the freeway which is far better than the 190 to 200 range that GM says they will run. At any rate, 2011-2017 F-250 to F-350 applications? I was thinking of adding a filter or two with a fan-cooler from B & M Racing Equipment.
View 14 Replies
My A/C will blow cold for about 3 min. and then stop for 10 min......then cold again for 3 min.....then warm for 10 min.......what is going on ? It does this when on climate control and on A/C . I had a compressor go out about 1 1/2 yrs. ago due to a fan failing...the compressor tore apart... This is not acting like that though .
View 9 Replies
Just bought a used 2011 ford f350 with the 6.7 diesel engine. Coming from a 7.3 1999 f350 with 330,000 miles, still going good. Took a 1000 mile trip on the 11 truck with out pulling anything did good. Hooked my enclosed trailer to it did a trip of 900 down and 900 back. Transmission temps were staying around the 250f, almost in yellow on gauge. Highest it went was 255f. Light never came on. Yesterday on trip without trailer was staying at 230f on trans temp. This is the first concern.
Second concern, had antifreeze coming out the cap on the degas bottle. Rolled over the hood and hit the drivers side windshield. Stopped un did the cap, it hissed. Put 2 quarts of antifreeze in drove on, this at 300 miles of trip. Primary water pump went out, half way there, at about 550 miles of trip. On trip back, about 1600 miles of trip, antifreeze was on windshield again. Undid cap, hissed, did not need to add any to it. Drove on no problems since. Have bought a new cap and installed.
Transmission doesn't want to shift right when its cold. First starting out. When it warms up shifts great. That's third problem.
View 14 Replies
What's the best tune for this motor? I have an hs mini max with the spe hot tune and has nothing but problems towing with with it. They swore up and down for a year I was the only one with issues for a year and then finally admitted it's not good for towing and lots of people had issues with it so they gave me their towing tune for free but it isn't very good either.
The hot tune is a little too hot and keeps going into limp mode when towing up hills even on the lowest stock setting, or really getting on the throttle on any setting not to mention way too high of boost for a stock turbo at 30-32 on every level . It makes sports cars look slow before hitting limp mode though.
Their tow tune fixed that problem but it's boost is too low at only 18-19 (had 24 running stock Ford programming) and it smokes like crazy, more smoke on higher settings without getting any faster or any more boost. It doesn't smoke much on the stock setting but clearly the other settings aren't very well tuned.
I want a tune that will tow 25k without issues and smoke(not literally) sports cars off the line at factory boost level s so it doesn't blow the turbo.
View 4 Replies
I am a recent new owner of an 06 f350 Powerstroke. Steering Box developed a leak so I decided to replace the box and go ahead and do the pump and hoses while at it. Pump would make some noise so i figured I'd just do it all and be done with it or so I thought. The job was a pain, much harder than the pump and boxes i've done on the older 7.3 powerstroke.
Anyways, used all OEM components (pump was a rebuilt rotorcraft, can't buy new anymore) and everything seemed great for about a day. I tried to bleed the air out per standard practice of turning the wheels with the truck off the ground. At startup and during the first day it had almost no noise at all and the steering felt much easier than the old pump.
Then the pump started to develop the standard annoying ford power steering whine that I hear all the time. Drove it over the weekend on a 160 mile trip and the noise just kept getting worse. As of tonight I can't turn the wheel if the truck is stopped even with my foot off the brakes.
I used synthetic ATF for fluid and there is absolutely no foam or aeration in the reservoir. Good news is I don't have any leaks but the bad is I now don't have power steering. It does make a much louder whine or squeak when I hit a large bump turning, I guess that's just the sound of the pump being stressed more. I am guessing the pump just crapped out but before I do it all over again.
View 2 Replies
A couple months back I blew an EGR cooler. My mechanic replaced it and oil cooler, when I got the truck back it was using coolant and on cold days below 35 degrees it wont start without a little shot of ether. I took it back and mechanic found a pinched o ring.T he coolant problem is ok but cold starts not. Now today truck was running fine then as I was pulling out of a stop sign I couldnt get over 40 mph, I pulled over and then tried to go but no throttle response,then died and wouldn't restart .I have no way of scanning, no dash lights came on. I am wondering if this is related another o ring or gasket,hpop ,fuel problem??? just replaced all the injectors and ficm a little over a year ago.where should I start?
View 14 Replies
After replacing both heads with remanufactured heads from ford along with new egr and oil cooler a month ago, she still overheats when pulling a load. While normal driving and not towing, no problems. In the last 5,000 miles since work was done and while towing approx. 15,000 lbs (load and trailer weight) she got hot once, slowed down, temp retreated got home - she has not overheated since then pulling 4-5 loads over the next 2,500 miles. Today at about 75 degrees only 4 blocks after picking up a load at about 12,000 lbs she started getting hot again. After I let her cool down and got on the Freeway the temp went down, appears she's not staying cool in the city with a load on. With all the work and new parts I had installed, what the problem might be?
View 12 Replies
Was trying to give back to FTE, all have been useful. So I figure I would post a problem solver. Had a nice oil leak traced to cam sensor o ring. All back together now crank no start.
Truck is half in and out of the garage, torque pro isn't pulling any codes. I did accidentally pull my alternator cable out of the connector, luckily had one to replace.
Did I wreck the sensor taking it out? Will have to try and pull the beast out tonight.
View 14 Replies
After my recent cooling system upgrade and power steering pump/HP hose replacement I am still hearing and feeling the power steering whine. I flushed the fluid and used Mercon V ATF fluid. I jacked the front end up with tires off the ground and cycled the steering lock to lock 100 times or more now and the whine does not stop. Do I need to put a vacuum on the system and try to purge it that way? There was no whine before but I just replaced the pump while I had room with everything out of the way and replaced the high pressure line because the fitting was leaking at the pump. This is very irritating because I thought replacing the pump would be beneficial.
View 2 Replies
2011 ford f350, 200,000 miles. I was getting an antifreeze spray on the windshield while pulling and going up a hill. It was from exhaust pressure going into the coolant system. It was building over 16 psi and blowing out the degas bottle.
View 14 Replies
