Ford 6.0L Power Stroke Diesel :: How To Turn Off CEL After Plugging EGR
Nov 8, 2016
I am getting tired of my EGR valve plugging up and disabling my Excursion, I pulled the valve and installed an EGR plug. The valve is still plugged in and sitting on the intake.
After a couple of drive cycles the CEL came on for "low EGR flow".... yeah, you don't say.
Anyhow, what's the easiest way to turn this thing off? I don't want to crank up HP with a "tuner", but if that's what it takes. Can I turn off the CEL and retain the factory performance?
View 14 Replies
Advertisement
What the coolant temp should be around after plugging in the block heater overnight? Not looking for an exact measurement since this can be affected by OAT and the length of time it has been plugged in. But when it's -15 to -20F this weekend I was wondering what to expect.
View 13 Replies
A month ago I got into my truck in the morning and when I turned the key to Run everything lit up like normal and after the glow plugs warmed up, I turned the key and there was about a two second delay between me turning the key and the engine cranking over.
The next couple times I tried starting the truck that same morning I had to try to start it a couple times because it wouldn't try to crank over the first couple times but it would always eventually start.
It's been continuing to give me problems but never stopped running once it was started and then this morning I tried starting it for 45 minutes with no luck.
What I have tried so far is:
Resetting batteries
Jumping the truck
Checked to see if the starter is getting power. ( I put wire testers on it while someone else started and I didn't get a good reading even when it did start. New starter was put in 9 months ago.)
I also made sure wire going to starter wasn't corroded
Battery terminals are also not corroded
Checked fuses
Tried starting truck with fan clutch disconnected
Cussing at it
Tapping starter with a hammer while trying to start it
Also, everything sounds perfectly normal when I turn the key, it just doesn't even try to turn over.
View 7 Replies
In the morning, she starts great. Right up. And that's the least time she'll start until tomorrow's morning. Once in a while I'll turn the key and nothing happens, all of my lights are on like normal, but once I turn the key to start, absolutely nothing happens. Next morning, started right up. I can't leave her running everywhere I go. This is my first diesel, I just bought her with 265k miles, looks like she was well taken care of. But she doesn't like to start since the day after I bought her. New alternator because Ford told me, battery light doesn't come on, she still won't start once warm.
View 14 Replies
Truck was running fine. Stopped and got fuel. Then crank truck and after about 15 secs it shut itself off. Now it WILL turn over but it is very slow and sounds "tight". 2004 f350 6.0 4x4 auto. I'm leaning towards torque converter.
View 2 Replies
2004 Excursion, won't start, just turns over. Pulled the cap off the fuel filter and it's filling fast so seems to be getting fuel. FICM replaced with a unit from Ed a year ago, along with a high output alternator, tests at 49 volts at key on, 48.5 cranking.
Truck started up fine last night, went for a drive with the family through Christmas lights. It has been running very rough at start and then smooths out after a few seconds. Went to start it up today and it just turns over, never fires. Unplugged the ICP on the passenger side valve cover and no improvement.
Pulled codes and had P0269, P0672, and P0676. Looks like a couple flow plug codes an injector contribution code.
What else can I check before pulling the valve covers?
View 8 Replies
I have a 2005 Ford f250 Diesel 4x4 with - unfortunately - the crappy 6.0 engine. Yesterday my Daughter parked in the yard and this morning the truck not only will not start but will not even turn over. I thought maybe the batteries were dead but that is not he case. When you turn the switch on you can hear the pump start up but it will not turn over? All the lights come on and the bell comes on when you open the door and the dashboard lights work but the thing will just not turn over. I am assuming this may be some type of electrical issue or something but whatever the problem is it just came out of the blue. Ford imo should have recalled this engine.
View 14 Replies
I have a 2004 Ford f 350 superduty. Everything runs great. Now the other day my fan came on and stayed on for three days now. It goes with my rpm so when I am doing a 100 down the highway in hopes it will disengage but won't.. Everything is Stalk.
View 3 Replies
My 05 F350 6.0 won't turn over with the key, everything comes on like normal but won't turn over. Starts fine with factory remote start. What to check?
View 3 Replies
This truck is bone stock FYI. I get in it to crank it and I get nothing. Batteries are good, everything in the cluster lights up, and looks normal. No codes are thrown. I can hear the solenoids click under the dash and hood. I check the voltage of ignition cable at the starter and I get no reading.
There is a single thick yellow with light blue stripe coloured wire on the passenger side of the engine compartment, beside the vacuum pump with a "squeeze and pull" type disconnect. Disconnect it, and connect the male half of the connector to the passenger side battery positive terminal. Do this with the ignition key in the RUN position. Does the truck start?
This is where it gets weird. The truck does start and after i reconnect the wire it it starts normal. I started it several times throughout the day. The next morning I get in the truck. No start. I have to use the wire and manually connect it to the battery and it starts right up again. This time I get a "Tow/Haul" light blinking on the dash. It will go into gear but pressing the acceleration pedal does nothing. I turn it back off, attempt to start it normally and it starts right up. No it will go into gear and drive. Now I am thinking maybe the neutral safety switch?
Could it be a solenoid sticking or the neutral safety switch or something else entirely?
View 14 Replies
I have a 2015 Platinum Superduty that came with a heated steering wheel but cannot figure how to turn it on and off. I have looked for a dash switch and in the climate portion of the touch screen with no luck. My wife's car has a simple dash mounted switch and also a temp sensor that cuts it on automatically when cold. No such luck with truck.
View 14 Replies
I have an oscillation in the steering wheel at speed in a turn. Feels like the pump is trying to straighten the wheel then gives up then trys again then gives up etc etc..... The oscillation is slow so its not like the wheel is shaking or about to fall off. The faster you go the more pronounced it is the tighter the turn the more pronounced it is. Doesnt matter left or right. Seems like its there at any speed but just gets worse the faster you go.
View 9 Replies
Can't figure out how to turn on dome light, so I broke down and did the un-thinkable, I read the manual.... from page 66
Press and hold the top of the control to the full on position to activate the "dome on" feature. This will turn on the interior courtesy lights. The lights will remain on until the bottom of the control is pressed.
[URL] ......
And no luck. Can hold the button down for a long, long time. The dimmer function works OK so the buttons are working. I would like to be able to turn on the rear light so my kids can buckle themselves.
View 8 Replies
My 4x4 was broken which of course made it harder driving in the snow but here are a few things I had issues with,
1. When I went to turn, the truck hard trouble turning and wanted to slide straight.
2. When I was sitting in traffic... the truck kept "sliding" off the road. I would be still and then the truck would start sliding....yet the cars/trucks infront/behind me didn't slide. What could be the causes of this ? Some of the front end work I did was,
> Ball joints
> New drag link
> New steering rods
I'm pretty sure my alignment is "decent".
View 14 Replies
Love the turn signals of flashing 3 times if you just tap it. It will flash 5 times on the tap when you are pulling my rv. Is there a way to increase the number of flashes? Say 3 to 5 and 5 to 7. Couldn't find anything in the owners manual.
View 1 Replies
If doing a EGR delete on a early 2004 6.0 will turn on the check engine light? I was going to leave the valve in place and harness connected, I was just looking to add durability to the truck so don't want to use a tuner but also don't want the engine light on, I seen conflicting reports that it may or may not turn on the light!
View 3 Replies
I recently purchased a 2006 f350 with 6.0 power stroke. I drove it approx 15 miles shut the truck off, let it sit for approx 3 he's. Then I drove another 15 miles and shut it off. When I went back to it. To start it up would not start. The dealer said brand new injectors when I bought the truck. I tried to start it for approx ten min. I didn't want to bog down the battery. So when it wouldn't start I sprayed a shot of starting fluid and it took right off. But when you shut it off it won't start again.
View 14 Replies
So I changed my fuel filter today and everything went as planned. I replaced it with a Ford OEM filters. I drained the filter housing under the truck by turning the yellow thing 1/4 turn. I then used a wrench and changed the filter. I put the new gasket on there and and tightened back down until it mechanically stopped. I then changed the one under the hood. I then did the bleed procedure 10 times and the truck fired right up.
Now for the reason with the post. I am getting a humming noise from the lower filter. I can find the issue. The yellow thing if fully seated closed and the housing is tightened as far as it can go. Under the hood, both lines are snug and on there properly. I can't figure out what is causing the humming.
The truck fires right up and the noise seems to go away, but I get the humming noise each time I turn the key on. I know something isn't right. I drove the truck around the block and didn't get any codes, but I have to drive it tomorrow and I don't want to risk damage to the truck.Thoughts on things I should try?
View 14 Replies
So i did this with mine but friend just bought 06 6.0. How do u shut the chime off for the seatbelt again. I know parking brake on key to on position not run. How many time do u buckle and unbuckle again?
View 14 Replies
Started truck, used windshield washer and noticed High Beam Indicator was lit on dash. Headlight switch not on. Drove to Ford dealer, turned off truck, high beams would not shut off. Dealer replaced the Turn Signal/wiper/High beam switch assembly. Dealer had one in stock. Service manager said they have replaced a few of these Switches. So if your High Beams come on without the headlight switch on you cannot turn them off even if you shut off and exit truck. Also the "You left your lights on warning chime" does not sound when you exit truck.
View 14 Replies
The other day i noticed my turn signal was blinking rapidly. I found that my drivers side bulb was burned out. I am trying to convert most of my lights to LEDs on my truck and figured that I'd replaced the tail lights with LEDs. After replacing both rear taillights with LEDS I still have the rapid blinking turn signal. Whats the deal? is it just the LEDS or what?
View 13 Replies
