Shes a rocket at low speeds but at speeds above 50-60 acceleration is slow. How can you boost it? Bigger turbo? Better injectors? Rpms aren't maxed, it just seems sluggish...
View 14 Replies,the symptom that I'm wondering about is that when the truck is cruising at different high speeds like 65 or 75 it starts to jerk/jolt, if I accelerate it goes away, or if I let off the accelerator.
Once I settle on a different cruising speed it does it again. There is no smoke out the exhaust pipe, it does not loses any power, I look at the RPM's and they don't move when the jerking/jolting starts. Truck runs fine except for this issue.
I do get the P0404 and P0405 codes which are for the EGR valve and the sensor. By the way **is there an EGR SENSOR** anywhere on this engine, I seen some posts where people refer to it as the EBP Sensor, is this correct? I cleaned the EGR valve, but it did not do anything to fix the issue. I'm thinking I damaged the valve when I cleaned it, but I would like to verify that this symptom could be the EGR valve before I buy a new one.
Your breaks yet? Mine are starting to get really annoying, that high pitch noise at slow speeds with just a slight touch on the break peddle. To give an idea of loud, I have hearing loss from my job in the military and they are starting to bother me.
View 13 RepliesFor a month or two now my truck has been making a squeal and the turbo has been sticking after hard acceleration. The sticking was a woebegone unison ring and I was hoping the squeal would be resolved when I cleaned the turbo but it didn't, in fact, it got worse.
It used to be occasionally and go away after warming up, but now it's more constant than not. It goes away when the VGT does its idle cycle and once you get up to speed.
Here's the sound - YouTube.....
I have a 2005 6.0. I just got done doing the HPOP seals, injector o-rings, stand pipes and dummy plugs. I have drove the truck 600 miles since the work with no problems other than a wiring issue I got fixed...
I was driving at highway speeds, and all of a sudden I lost power and got a shake when trying to accelerate. I pulled over and turned it off, and when I went to restart it I got nothing at first, then it went to what seemed like a partial crank followed by a thud. So I'm thinking I just hydro locked it. I waited a few mins and tried again, and it started but had a few knocks for 15 seconds or so, then it ran rough with smoke pouring out of the exhaust (grey then turned kinda white).
I the only codes I have are for the egr which I've had unplugged for a long time, and a glow plug code, but when I started it back up, I had no codes. I'm baffled. I did notice I have oil on my oil filter housing at the cap, a little oil had slung on to my wire harness and my intake. I don't even know where to begin!
I have a 2006 f250 6.0. the truck has 101k miles and to this point I have had zero issues. I am having trouble loosing power after running at highway speeds. Once I stop and begin to accelerate the truck looses power for a few seconds ,Belches smoke and begins to operate normally. I had an egr code, so I replaced egr and the problem persist. It is intermittent and does not happen if I stay under 50 mph.
View 12 Replies165k miles 4x4 6 speed, bone stock unmolested
Slowly progressing problem over 6 months. Occasional miss at highway speeds uphill has progressed to bucking and jerking during even gentle acceleration attempts.
I hadn't got my cam sensor recall done but no change after that procedure completed yesterday. Oil recently changed as well.
I have a torque pro but it never finds any fault codes even though 'service engine' light comes on sporadically. I'm not sure I'm operating it properly but it at least reads rpm when its running.
I'm contemplating the hutch mod but I'd like to have an official diagnosis beforehand if its possible in my case.
My parents have a 2006 RX330, and I decided to see how their traction control works, so I tried doing a quicker acceleration on a sharp turn to see how it would react.
I found that the vehicle started to slightly tilt and beeped, making it seem like the traction control wasn't activating at all (unless its only function is to beep).
Is this normal?
So the 04 is rolling down the road when the cluster gauges ping, the truck loses power/acceleration but the radio never goes out. Have a new alternator and batteries passed a check. It has done it three times. We are 1100 miles from home. OBD and cigarette lighter fuse was blown as well.
View 10 RepliesI have an issue with my 6.0. I was running the extreme street tune from IDP for the past 2 years now and recently purchased the xtreme X tune from IDP. I loaded in the tune and had low boost, low power and horrible acceleration. Max boost i would see is about 10psi and it would take about a solid minute to reach highway speed when merging on the highway. I went back to the stock factory tune and have the same issue. No boost leaks from the boots or pipes and no check engine light. What is going on?
View 2 RepliesI have an 03 6.0 Power stroke. My problem all started the other day when I started to occasionally not get any boost on acceleration and lose of power and a lot of vibration like it's about to cut out but it got worse now today I drove it about 5 miles into town when I got to town I noticed a rough idle I got gas in a gas can not in the truck. I got back in to leave and I had absolutely no power at all the truck stalled out and it was very hard to start finally got it started and it runs really rough almost like it's going to shut off.
So when I started driving I would only make it about a mile or so with out it chocking out and having to let it site for a minute or two and start it back up and go another mile or 2 and have it do the same thing all the way home all the time I have vary little boost if any at all except for when I first pull out now oil pressure is good and engine never over heated some of the codes I have is an EGR code and a contribution balance code for several cylinders I was thinking possibly a maf sensor or a clogged egr not working right.
My 2007 6.0 has a really rough (almost 'miss') during cold start up. After 5 seconds or so, it smooths back out and sounds normal. Until gauge reaches normal operating temp - there is a surge/lack of power during light acceleration. I also hear a frequent compressor coming on and running for a while which I am contributing to a possible vacuum leak. Maintenance is always done on time and I've already had a few costly repairs (both internally as well as externally) on the engine. I usually always wait for the glow-plug indicator to turn off before cranking the engine and let it idle for 5-10 minutes prior to driving it. Once the vehicle climbs to normal temp. everything seems to be fine but the compressor still comes back on every so often.IS it worth simply replacing the vacuum canister located behind the passenger side battery - or should I find someone to hook up a diagnostic unit first?
View 5 RepliesI'm on the road and I pulled over for a pit stop so I don't have time for a search right now, but I noticed under heavy acceleration a turbo whine so high pitched it almost sounds like metal on metal. Is this normal and I just noticed it, a leak somewhere, or maybe indication of something worse? The truck seems to be running ok otherwise. It's an '02 w/7.3 and 220k miles.
View 3 RepliesDriving around town it doesn't happen too often. Like if I am starting from a stop it feels fine but when going up a hill or passing on the highway it bucks and shakes and doesn't want to go over 3000 rpm. Also, the check engine light is on and it flashes when it's really bad. I took apart the intake and didn't see anything weird. I am about to take it in to see what the code says because it's been getting worse.
View 6 RepliesAt idle it stays at 48.5v-47.5v But as I pick up speed it continually drops. At 70mph it gets as low as 29v. But will go back up slowly as I let off the throttle.
View 8 Replies2003 f-350 6.0 4wd dual rear wheels
4 inch superlift suspension lift, dual shock steering Stabilizer
33 inch wheels.
4 inch turbo back exhaust
Other than that it's really bone stock
Here's what's going on. In 2wd, between 55mph and 62ish mph, once I hit a constant speed, a rumble beneath my feet emerges. If I either speed up or slow down, it immediately goes away.
Does the same thing in 4wd high.
I can eliminate front drive shaft and u joints seeing as they shouldn't be turning while in 2wd. I did notice that when I push up or side to side motion in the front drive shaft, there is a click and a bit of motion. Is that normal? Just a side thought.
When i take off there's a bit of vibration from the rear half of the truck, but I've isolated that to the center support bearing. With all this being said, none of these symptoms were around before I lifted it.
I have a 2011 F250 that I bought new. It's been the best truck I have ever owned. It now has about 105K miles (170k Kms). Lately the turbo has started whining at low speeds and idling. Is this something I should be concerned about. I talked to a diesel mechanic (not Ford) and he said this is fairly common in some vehicles.
View 6 RepliesHave a 03 f350 with the 6.0 have been experiencing very harsh shaking problems. This only happens at highway speeds 55-60 any other speed is smooth as can be weather it's 25-95 mph. The weird part is that it only shakes when the truck shifts into overdrive and it shakes bad and if you lay into it like you were gonna pass someone it stops then shifts back into overdrive and shakes again.
View 6 RepliesMy dads 2012 f250 6.7 shakes SOMETIMES at speeds anywhere from 30 to 65mph he had ford look at it they said that everything looked fine, all the normal items were checked. How can something like that just show up for a few minutes then go away for days at a time. He said it shakes the whole truck then he slows down it goes away then speed back up and its gone. He does need new tires and balanced but I would think if that was the issue it would be a consistent shake or am I wrong?
View 4 RepliesWhat makes a 6.0 or 7.3 "clack"? I am not experienced enough with internals of a diesel to understand it.
Reason I ask, is my 6.0 is clackier than ANY other 6.0 or 7.3 that I have encountered. I mean it really cackles. Injector timing?
the engine was "bulletproofed" and (as the seller stated to me) was "flashed with a custom designed tune made by a Powerstroke specialist"... to which I have no further information on. This I assume was done for longevity and not performance.
Its quiet on the highway, but in town and stop-starts or low-speed acceleration it is crazy crackly.
First of all, I have 2004 f-350 92K miles with a stock 6.0 - EGR deletes and new oil cooler is the only updates.
Two weeks ago I had an issue pop up. When I tried to start from a dead stop there was no acceleration, it would idle ok but when i pressed on the peddle NOTHING! I called the local diesel guru, he recommended I change the fuel filters. After I did this there was a tremendous improvement in performance.
After a few days of normal driving, I noticed a subtle reduction in throttle response. Today I noticed a slight lag when accelerating which lasted about 3 miles until there is once again no acceleration. It will start normally and idle is a little rough, but will not accelerate even in park the engine is extremely slow to accelerate.