My upper radiator outlet broke off when we were removing the upper hose(plastic tank) . is there any way to repair this ? I was laid off and cant afford a new radiator right now. but with it being the outlet I don't hold much hope...
View 3 Replies1992 3.0L V-6 RANGER
New thermostat
New Water Pump
I noticed the other day that the Upper radiator hose gets Sucked Flat when RPM is higher than Idle BAD it completely collapses IDK how it can circulate the coolant very well in this Condition. If the hoses have ever been changed But the Upper hose Really gets sucked flat. I've seen this a few times on vehicles that have been shutdown But they have always expanded upon startup and are fine....
The Lower Looks Fairly Old and only partly collapses under higher RPM.... I am going to change the Upper hose at a Minimum as its really Bad and probably a lot older than I am thinking and really Soft. I am just wondering if the radiator could be plugged up causing some of this.. Or anything else I should check into????
92 Toyota Pickup (22RE auto). New block, rebuilt head, new water pump at 300k about a year ago. Sounds strange I know but that's what seems to have happened. Ive never been able to get heat from the truck since Ive owned it so Ive been trying to fix that. I flushed the coolant out and replaced the tstat. I brought the car to a mechanic and he put a pressure tester on the cooling system and he said it wasn't holding any pressure. He also pulled off the heater core inlet hose with the truck running and no coolant was coming out. He thought there was a blockage somewhere but how to fix it. I figured I might as well try replacing the old radiator cap with a new one so I did. Once I did this, the first time the truck went out, it overheated and the radiator crimped upper seam (on the plastic) burst outward.So all in all...something is wrong.
View 2 RepliesI went to unscrew the radiator drain plug but the head broke right off leaving the rest of it inside.
I drilled out a little bit of it so I could drain the coolant and bough a replacement plug but there are still pieces stuck inside and I cant get them out.
Should I just drill out the remaining pieces or is there a better way to get them out?
After chasing the smell of coolant for a couple weeks, discovered that the upper radiator hose was leaking at the engine. Based on my schedule and drive schedule, and unfamiliar location this last week, I took my truck to the last people I wanted to - the Ford dealer, where they attempted to charge for the hose replacement. During this time I discovered the nature of how these hoses work and asked the tech why they don't just replace the O-rings ... "Ford Motor Company wants to sell you a new hose with labor" - a direct quote from the Ford tech. And that is why Ford is the LAST place I want to go for repairs I cannot perform. I kept the old hose - any spot where you can get the O-rings alone?
View 5 RepliesNoticed this past month on colder days my upper hose is collapsed, typically a symptom of a bad radiator pressure cap.
This hose is connected from the water pump to the radiator. The radiator is connected to the Degas bottle which has a nonstandard radiator cap.
Do these plastic caps vent the same way a typical cap does?
Cap for 2011 Ford F-350 Super Duty|9C3Z-8101-B
This weekend while towing a light load I noticed my FWT and EOT starting to climb rapidly, EOT reached 260 FWT I think about 240. I exited the interstate to find I had a busted radiator hose. I replaced the hose and filled the system with distilled water, but didn't add antifreeze at this time. The system wasn't completely empty.
I noticed once back on the road my EOT seemed to be higher than normal but FWT seemed to be normal. Could the lack of antifreeze cause a greater delta between FWT and EOT? I have seen articles which state do not use Ford Premium Gold Coolant, but to use CAT EL-1 coolant instead. Which should I use?
Ok I have a 97 f150 4.6L. My radiator has been bad for a while. With brown rust color. I replaced my radiator, thermostat, new upper and lower hoses. Everything runs great but I have no heat. I flushed everything including the heater core. Core is not leaking into cab, and both heater hoses are cold. What should I do next FYI heat worked great until 5 days ago.
View 14 RepliesSo i cant figure out how to remove the radiator side of the upper radiator hose. I pulled out the pin but i cant remove the hose.
Do I just pull it straight out? Or do I twist and pull? I dont want to break the connection.
I smelled antifreeze when walking by my fiances Sonata, so I popped the hood and saw there was a small leak from the upper radiator hose, where it meets the thermostat housing. I adjusted the stock clamp, but the leak was much worse.
I swapped it out for new clamp that you can tighten, and all is well again. But, what I noticed when I had it off was that the metal neck of the housing was really corroded. Only 15,000 on the car, so I was surprised to see that the corrosion on the metal had already built up causing the leak (pushing the hose away from the housing). I scraped and scuffed to get it clean again, but just wanted to give you all the heads up in case you notice a leak in the same area. The antifreeze tested good and is really clean.
1991 Toyota Celica 2.2 liter standard water is boiling in upper radiator hose what could be the possible cause of this problem I have changed radiator and cap, water pump, radiator hoses and have flushed the system. could crossed hoses from engine to heater control valve and heater core cause this problem?The head has been checked and no exhaust gas was found in radiator fluid ...
View 4 RepliesI have a 2002 saturn l series and we rebuilt the radiator because it had oil in it and know the car wont start but, their is no water in the oil, is it possible that the oil cooler broke.
View 3 RepliesOn my 92 Aero 4.0L with A/C, I need to replace the radiator but I am not sure how to move the A/C hoses out of the way to extract the shroud and the radiator.
I have viewed a video where a guy said to remove the serpentine belt and then unbolt the A/C compressor and move the compressor and hoses out of the way. Hope this means that I don't have to discharge or disconnect AC hoses. Not good for me.....
Well, the video instruction seems simple enough......but there doesn't appear to be enough "play" in the AC hoses to move them far enough to extract the radiator, and not being an AC guy (and the potential danger of releasing freon), I am at a loss.
How to move the AC hoses out of the way (without disconnecting the hoses or discharging the system) ....
Not to mention it would be great to find out what the torque specification is for tightening the AC compressor bolts for proper reassembly. And being the backyard mechanic I am, any drawings, details or diagrams that you can provide would be very useful.
BTW, I have looked in the forum for radiator removal information and none of the threads I read addressed moving the AC hoses (which of course run right over the top of the dang radiator).
If I get past these "hoses" I will also take advantage of the radiator removal to replace the fan and fan clutch and thermostat while I am there, but first things first, if you know what I mean.
I recently had my radiator replaced on my 1992 accord lx. Now I have notice that my temp. gage starts to climb up. All of the hoses are not leaking. I was wondering could this be a relay problem or a switch or motor fan. The a/c fan does come on when it is engaged.
View 6 Replies92 Honda Civic, it has been steaming under the hood when i drive it and it's going into the overflow tank. When I pull the cap off after it's cooled down and then refill it. I watch to see if it's flowing and it's not. My initial thought was maybe a bad water pump, however I spoke with someone today that said it could very well be the head gasket. I am tending to lean this way now as well, as there is fluid on the ground after I park it. I put down some cardboard so the next time I drive it, I can see where it's coming from... Before I spend any money I want to exhaust the basics. I know I can get a combustion leak test kit to ultimately determine it.
View 9 RepliesI start the car, with AC on, radiator fan starts and within a few minutes the engine radiator fan stops working, idles rough since the AC compressor pump keeps cycling on and off and engine starts to overheat. After shutting down I check the engine cooling fan fuse and it sure enough is blown.
How do I determine as to where the short is? Is the short in the wiring somewhere or can the actual motor short out?
I tried to change my filter today and I couldn't get the outlet side off after removing the clip, is there a trick to it.
View 8 RepliesI replaced water pump and thermostat...thermostat 2 times.
This is the thing : No coolant will come out the water outlet pipe.... I sit there for way too long and nothing flows out the outlet. remove the thermostat or an inlet hose and coolant flows out.
I overheated pretty bad... I drove maybe 10-15 minutes unaware. I suspected blown head gasket but no missing coolant and nothing in the oil. I removed the water outlet pipe and thermostat and just poured coolant in to see if any reached behind the thermostat. It did.
I even started the engine with it removed and coolant flowed out. now it didn't pour out...as in filling the entire diameter and squirting out... HOW MUCH pressure or flow should be normal there.
I am really stuck. I don't think air is an issue because I don't have a radiator cap. I am thinking blown head gasket restricting flow? New water pump is not up to par ?
Why the hell won't the thermostat open at all!!!!??? removed I get some flow!!! Its a get a jiggle pin. I am about to take into to be diagnosed but I cant believe this problem has turned into this. Can they test head gasket? I am preparing myself to do the head gasket and the rest.
What is the torque value for the 2 bolts on the upper radiator hose water outlet on an '04 4.6L?
View 1 RepliesI put a dash cam in my truck that powers off when the truck is turned off. But all of the 12v outlets in the truck are constant power. Is there any way to change one of them??
View 3 RepliesOn a 2012 F-150, does the motor need to be running to use the AC outlet?
View 3 Replies