Ford Brakes/Suspension :: Truck Badly Pulls Left When Braking Hard
Feb 2, 2011
Just replaced break pads and rotors. Inner pad on left side was gone leading me to believe slides were not working properly. Pulled apart, cleaned and greased everything, and replaced pads and rotors. Calipers seem to be working fine. Now when I break hard, the truck pulls badly to the left. When I break softly, it seeks normal. My front end is a bit out of whack and veers just a bit to the left. Do you think this is my issue with the breaking ? I'm getting new tires and an alignment soon but was just curious.
View 3 Replies
Advertisement
Truck pulls to the left while braking, pretty bad. So, pulled the front right wheel off thinking the pins are stuck again as last year. Bottom pin was fine, top pin pretty gummed up but not froze so I cleaned it up good, used thin layer of the good stuff, put back together and test drove........same thing. Pulls left upon braking just as bad as before. Caliper pistons seemed fine, didn't take much to compress them either. Would a right rear cause this?
View 14 Replies
My 2003 F250 6.0 pulls to the right when driving at any speed. In order to keep it going straight the steering wheel must be slightly tilted to the left, not much but a little. When the brakes are applied hard it will go to the left slightly if you are not holding the wheel good. Neither of these are terrible, just a nuisance. I'm worried about uneven tire wear too. One front wheel bearing was replaced a few weeks ago. It had this problem before that and still does after. Does this sound like an alignment or maybe something more?
View 13 Replies
So I've been noticing the truck pulls left when under braking. So, I replaced the front calipers. Now, it still pulls left. When I got home I felt the discs on all corners and found three about the same, barely touchable, and the front left a little warmer. So, it seems its braking more, but its brand new. So, what should I do? They are also pulsing a little.
View 14 Replies
02-F150-4.2L-102k. Truck was rolling down the road at approx. 35 to 40 mph. A speed bump/table appeared out of nowhere and was hit before beeing seen. Immediately since this event, the truck pulls to the left while applying the brakes. It pulls very hard and is fine while rolling down the road. Is there some damaged steering component or did one of the calipers go out from the jolt?
View 4 Replies
What would cause the rear drum brakes to lock up upon hard braking? I have replaced the wheel cylinders, installed new spring kit, and adjusters.
View 9 Replies
I have a 1997 Ram 1500 when I apply the brakes the truck pulls to the left for a spit second then goes straight.
Example: doing about 40 MPH take hands off the wheel and slam on the brakes, truck pulls immediately to left, like I did a quick lane change then goes straight.
About a month ago I replaced a section of brake line going to left rear wheel.
View 3 Replies
I have this truck (in signature below) that I have not driven for ~3 years. As I am starting to drive it I am noticing I need to put A LOT of pressure on my brake pedal to get the brakes to work. They stop the truck and the pedal doesn't feel soft as if there is air in the line but it feels as if I apply a lot of pressure and there isn't a lot of grab.
While it might be possible, I don't think I have any type of glaze or coating on my brakes that would cause this. 95% of those 3 years, the truck was inside.
I wonder if it feels as if the truck is hard to stop because of the additional power I have coming from this new motor?
Is there any type of part I can replace in the brake booster to adjust the pedal? Or brake booster. Maybe that is going bad?
View 2 Replies
I have a 2004 Nissan Frontier pickup that pulls to the left. I've had the alignment done - no change. I had the tires moved from the left to the right side - still no change. Firestone is recommending I all the front ball joins at a cost of $1200. Is that really the problem?
View 6 Replies
I have a 2002 F350 4x4 diesel. When I brake it pulls to the right momentarily then straightens out almost immediately. I've heard that this can be caused by bad ball joints, but I just had all four replaced less than a 15,000 miles ago, and I keep them greased regularly(every oil change). The rotors are a bit warped, but would that cause only a momentary pull? Other than that the brakes are good. I'm sure that the shocks are due for replacement. Tire wear/pressure is good. I had an alignment when the ball joints were replaced.
View 5 Replies
1981 f100 2wd 4.9 L6 c6 9" rear w/ front discs and rear drums. went through and fixed all leaks after I got it running. Then I got to steering and suspension. Replaced all tie rods. only thing i reused were adjusting sleeves. Taped off thread protrusion on oem steering parts so i could measure and get the new rod ends in the ballpark. Did a simple shadetree toe adjustment so i could drive it to get it aligned. I should mention i already replaced front rotors and bearings as well. Mic'd the spindles so they're in spec.
I am however running used tires but they balanced out pretty well. all torque application was strictly adhered to by the maintenance manual. made sure tire pressures were up to snuff and greased everything that could be lubed to include kingpins. the kingpins are the only thing i have not rebuilt....but i did check the radial and axial play....nothing out of spec. So I took the truck in for alignment. picked it up and it pulls to the right just as bad as it did when i drove it to the shop. the tech tried to tell me it was just a bad tire and that i needed a new one....of course i knew that was wrong.
Swapped tires from side to side, and magically the truck still pulled to the right. So I've narrowed it down to either the steering box maybe, or just a shade tree alignment tech that doesn't know his fourth point of contact from his elbow. It does not have a steering stabilizer installed, but i would think that shouldn't matter?
View 1 Replies
I put on a new set of tires (X Radial) at Sams Club with installation plan which includes balancing. I also brought the car to the dealer to have alignment (front I guess) done. The car goes a straight line no matter what except it always pulls left if I release the steering wheel when I brake from a high speed.
View 7 Replies
I have 1994 Ford Ranger 4.0. In Nov. I had the tranny rebuilt in Boston and also had new rotors and pads put on the front. By the time I got home, the truck was shaking badly when I hit the brakes. Since then, after it's parked a while, (I drive it once a week or so) I can't get it to move in "Drive". Reverse works fine. I thought it was the tranny but if I increase the gas flow, the rear wheels will screech, so I think the front brakes are stuck. After I'm able to "break" whatever holding them, the truck works fine. One of the rear wheel drum brakes is too tight and the wheel will feel pretty warm when I get it home and that will be taken care of but I don't really think it's the rear brakes or they wouldn't screech when I hit the gas.
View 5 Replies
I have a 2001 vw Jetta with a manual transmission (just over 155,000 miles). My first set of front brakes lasted to about 135,000. After they were replaced a shimmy started to appear when braking a few thousand miles in. At about 8,000 miles the shimmy became so bad that I brought the car back to the dealer. They said the rotors were warped. The pads and rotors were replaced again and in about 5,000 miles same thing. The pads and rotors were replaced again at no charge and it is now about 5,000 miles later and the same thing is happening again.
View 2 Replies
Had mechanic check suspension components, alignment is fine, nothing looks damage or needs to be replaced. Tires are 35 inch and practically brand-new...
View 3 Replies
Could my strut replacement have anything to do with my 2009 pulling left when I brake.
View 6 Replies
My 2000 ranger in 4x4 high never did this. And in 2wd it doesn't pull at all...
When in 4x4 high it pulls hard to the left ?????? is left not working? It has automatic hubs ...
View 3 Replies
If I am going over 40 mph and I have to brake hard my truck pulls really hard to the right. I mean so hard it will take me off the road. My truck is a 2004 f250 with 147,000 miles.
In the last six months I have replaced both hubs, rotors and brakes. I really drive like an old man so I don't know how long I have had this issue. Just someone pulled in front of me on the freeway and I had to brake hard and I found this out.
I have checked both front capilers and brake lines and those are fine. I have brand new tires on it. I really have no clue what is going on. I have pulled the brakes off three times and checked everything out and it looks good. If slowly push the brakes everything is great, it is only when I have to really slam on them.
View 13 Replies
So my 01 has been parked in the garage for about 2 months. Normally on battery tender but it accidentally got unplugged and I didn't realize til yesterday when I went to start it. So I got the battery charged up and put air in my rear drivers tire since every time it sits it goes flat. Well I did all this I so I could take it to get tires today.
Driving to work and its shaking pretty bad at highway speed. Don't recall it doing this yesterday. Never really did this before either. The truck also pulls hard to the right. Its done this for a while so I'm not sure if it's just the tires or needs alignment or something else. Or all of the above.
I'm mainly concerned with why it was shaking. The front tires don't look low however I will check the pressure on my lunch hour today.
View 13 Replies
My 2012 f350 6 lift when I push the brakes it pulls to the left kinda bad and the steering wheel is off to the right..
View 4 Replies
I know this has been discussed but I still don't understand. Hence my "dumb blonde" user name.
I just purchased a 2013 super duty f350 extended crew cab DRW.
I also purchased a 42 foot (box is 36) Goose neck Bison LQ horse trailer. Trailer weight is 12048 and tongue weight is 4468. Fully loaded I am about 18,500.
Truck pulls and stops great but it is obvious the rear suspension is sagging.
Now what? Do I need air bags? Timbren? Spring Coils? I have called several installers and they all say something different.
View 14 Replies
