I have a squeak that developed in the steering column whenever I turn the wheel. It is as if something lacks lubrication. It does it in all steering positions. I guess next step is to open it up and see if I can get closer to the source so I can hit it with WD40.
View 6 RepliesSo I've begun to notice an annoying intermittent squeak/screech in my steering column while driving, obviously aggravated by the rough roads we've got down here. I can silence it tho, if I push in/up real hard on the steering wheel, so I'm pretty confident there's some bushing or bearing in the steering column that needs some lube or maybe just outright replacement.
View 7 RepliesStarted truck and turned the wheel far to the right and shut the truck off to get better access to the grease zerks. Now the entire column, ignition is locked up tight. I can't turn the key, remove it, anything? Thoughts? I'm stuck
View 14 RepliesLooking for a diagram of the steering column? I am looking to see what is behind the ign tumbler that sends power to the ign switch module. I believe a problem might be there . this is for a 2000 x limited 7.3.
View 1 RepliesI have a 2002 F250 diesel, the key will turn to acc. but not on. It feels like it is hitting something in the column. I tried moving the shifting lever back and forth with my foot on the break, as I turned the key but it would not turn. I am thinking the tumblers are OK because it goes into acc. It feels like their is some lever that is not releasing the shift lever, because if I turn the key hard the shift lever jumps. What is wrong, or how the interface between the lock tumbler and the shift lever works?
View 4 RepliesJust on my way home during the last few turns down the underground parking, I found the steering wheel column making some squeak noise. Is there anything I should check before bringing it back to the dealership?
View 6 RepliesStarted hearing a squeak from drivers front wheel area when turning right, thought maybe pads might need replacing but they were fine as were the pins. So I checked for play with tire off ground and there was def some play pulling from top to bottom, so that lead me to the front hub, I read some posts about pulling the abs sensor and getting some grease in the the hub bearing so I did that but when I replaced the sensor and spun the hub it was scrubbing on the bearing.?
So I shimmed the sensor with a washer but now the abs light comes on but there doesn't seem to be a squeak when turning right anymore. Any example of doing this and had the sensor scrub? And with the play I would assume I need to plan to replace the hub assembly fairly soon...
2000 X 4x4 V10 with 147k
I have a rubbing sound that seems to be coming from the steering column when turning. Don't hear it outside of cab just in the inside.
View 4 RepliesMy steering wheel has a squeak when turning either left or right slightly from center.. I usually notice the squeak while stationary or parking. It's louder and more noticeable when it's hot outside.
Listening carefully, it seems to be coming from inside the steering column, not from linkages or joints from under the car. Looking for a exploded diagram of the steering column components, perhaps it's just a U joint (tilt?) that needs some lubing to make it quiet.
I did a search on all three of these and did not find anything.
1) Odd noise coming from steering column while turning.
2) Vanity mirror on driver's side, the lid/flap thingy does not stay open.
3) Trunk only opens when using key. Using FOB of door button does not work. You can hear movement but it does not open.
My sister has a Camry that has a squeak in the steering wheel occasionally when you turn the wheel. She lives in another state, and so I'm only going by her description, but I'll be visiting soon.
She describes it as an intermittent squeak/groan when the wheel is turned. I think it may be plastic on plastic, but it is definitely coming from the area around the column (up by the combo switch and ignition switch area), not down by your feet, she says.
I'm not sure of the year, but it is in the 2001-2003 range, I believe. I think this is just an annoyance thing, not a mechanical problem.
I am a recent new owner of an 06 f350 Powerstroke. Steering Box developed a leak so I decided to replace the box and go ahead and do the pump and hoses while at it. Pump would make some noise so i figured I'd just do it all and be done with it or so I thought. The job was a pain, much harder than the pump and boxes i've done on the older 7.3 powerstroke.
Anyways, used all OEM components (pump was a rebuilt rotorcraft, can't buy new anymore) and everything seemed great for about a day. I tried to bleed the air out per standard practice of turning the wheels with the truck off the ground. At startup and during the first day it had almost no noise at all and the steering felt much easier than the old pump.
Then the pump started to develop the standard annoying ford power steering whine that I hear all the time. Drove it over the weekend on a 160 mile trip and the noise just kept getting worse. As of tonight I can't turn the wheel if the truck is stopped even with my foot off the brakes.
I used synthetic ATF for fluid and there is absolutely no foam or aeration in the reservoir. Good news is I don't have any leaks but the bad is I now don't have power steering. It does make a much louder whine or squeak when I hit a large bump turning, I guess that's just the sound of the pump being stressed more. I am guessing the pump just crapped out but before I do it all over again.
2002 Solara, 69K miles, occasional squeak from steering wheel when turning, sounds as if it is coming from where the wheel connects/rotates at the column - sounds like a weak rubber horn (like clowns use) or a rubbery, balloons-rubbing-together sort of sound. Not loud - only noticed when I was w/out the radio on (had an exhaust repair last week and was enjoying the quiet). It's not an external steering pump whine - it really seems as if it is coming right the steering column. Short of leaving cheese to there to coax out a mouse . . .
View 6 Repliesso I was heading off the freeway to take my exit at night. Didn't see there was a little curb island between the main freeway and exit. Went with the car over the curb and my right passenger tire went out.
I changed the tire and driven off, then noticed the car sound got much louder all of a sudden and when I turn the steering wheel right or left, I hear or feel a heavy sharp sensation- yet the car turns fine, it just sounds louder when I press the gas and when I turn the steering wheel I can feel my feet vibrating a bit and a soft/sharp squeak sound comes out.
What could this be?
I'm experiencing intermittent steering loss only when I'm turning, left or right, on my 2004 Excursion. I was told it could be the outboard u-joints, so I've replaced them along with the ball joints. Still have the problem. For grins, in park I tried turning the steering wheel left and right, no issues. But when I applied the brake and tried turning the steering wheel, it felt like I had no power steering. Not every time.
View 3 RepliesMy wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
Starting having a problem with the front suspension on my 01 excursion. When you go over a incline I am getting a big bang in the front suspension also when you turn the steering wheel to the middle it has a jerk right before its in the straight position.
I have new wheel bearings and new locking hubs coming, this problem still happens without the hubs in. Could it be a front axle or U joint but it happens with the 4x4 disengaged.
I think my steering column bearing is bad up at the top end. I got the steering wheel off and the coil spring wire thing without too much drama, but my Haynes manual stops there, it doesn't tell how to go any deeper into column. How to proceed? Almost forgot, this is a '97 F150....
View 2 RepliesSteering column recall ? The ford sites don't have much info yet. What is involved steering column replacement ? Computer reprogramming to sove the issue of the steering ?
View 1 RepliesMy `88 Aerostar needs a replacement steering column. I believe everything can be swapped over therefore color of steering wheel does not matter. Cruise control buttons and tilt are a must. I would like to find one that is tight(er) and not sloppy floppy like mine is slowly becoming (143k miles).
View 1 RepliesI recently bought a 1993 Aerostar. When I go to drive it after it rains as soon as I turn the steering wheel a good deal of water comes from the bottom of steering column right into my lap! Why this happens and what I can do to fix it?
View 2 Replies