Ford F-150 - 1997-2003 :: 2001 V6 - Hesitation / Missing At Low RPM - 1000 - 1800 Or So
Sep 11, 2013
I have a 2001 F150with the V6 motor, automatic transmission and 73k miles. It has begun having hesitation/missing problems at low rpm, 1000-1800 or so, and it feels like the engine shuts off for a fraction of a second. At idle and above that range it seems to run fine. Also, it only happens in Drive and when the engine is fully warned up - it does not do it when cold or in Neutral. Uphill, downhill, doesn't matter. There are no OBD codes. The spark plugs, air filter and MAF sensor have been replaced recently. I have OBD scantool on my laptop, but have not been able to use it yet.
View 1 Replies
Advertisement
I have a 2001 F250 crew cab, it currently has bench seats with the center console missing. Can I put a 40-20-40 split bench seat out of a 2012 f250 in my truck? And if so how much modification will need to be done?
View 1 Replies
My 2002 F-150 with the 5.4 has an issue with a high rev (1000 RPM for a few seconds) while at a stop sign, along with a clunking/banging sound coming from under the truck. This is when I have the brake mashed all the way, and this all happens at the same time, almost every time I come to a stop at a stop sign or light. I do have an intake manifold leak, which i have recently determined, but I do not know if the high rev at a stop sign has to do with the manifold leak or to do with the transmission sounding thump I hear. Could this be a torque converter not unlocking, and then suddenly unlocking? Because after the thump sound, the RPM's go down to around 650 from 1000 every time.
View 4 Replies
it's missing at an idle and it acts like it dont wanna take gas but once you get it going on the road it does good. the motor is a remanufacture motor it's only got 6,000 miles, new coils, plugs and wires, cam sensor, crank sensor, idle air control, mass air flow,and temp switch.
View 9 Replies
So today, I planned on switching the belt, idler pulley and tensioner since at least two of them are making noises. After taking all of the stuff off, belt, idler pulley and tensioner... and since I always compare parts I buy to parts that were in, making sure they are identical and I didn't order the wrong one. So first up I checked my tensioner and the position of them or angles are different, completely different.
So Google it to view a few diagrams and bang! it hits me... the one I took out from my F150 is for a non-AC... so back into the truck and I'm looking. Didn't have to go far when I realized that my AC compressor is missing!!!!
I keep looking around and I see that yes, I did have AC in it before I got it; because the guts are there but sliced! Great, so the job went from easy and easy I mean buy compressor and install; but now since the guts were cut, the PO sliced the thing out simply put.
1.) What are the bolt sizes that hold the compressor in place?
2.) Is there a wire connector on the compressor? or no?
View 1 Replies
I have 2002 f150, fx4, ext cab, 110000miles 5.4 automatic truck, i just replaced my spark plugs, it still have a little miss, thought spark plugs will resolve but its the same, im wondering if i should change O2 sensors? clean EGR Valve? IAC valve? i am not getting good gas mileage and maybe its this missfire or something, its runs good without any problems, just this slight miss makes me think if its the cause to bad MPG.
I tried to find threads with pictures of how to change O2, how to clean EGR, and IAC, i remember seeing these threads but cant find em. And you think these three things will resolve my MPG and the slight miss?
View 14 Replies
I have a99 5.4 and its missing slightly when cold mostly. I'm thinking egr poss did tune up 7 mos ago so I don't think it's plugs or coil pacs seems to get better when it warms up...
View 11 Replies
My 4.2 liter F150 suddenly started missing under load. A little background: It is a late 2003 and has 75k miles. It has been in my family since new, and I have had it for the last 4 years. This truck is as stock as they come, and has been well maintained.
On my way to work yesterday, it began missing. Not bad at first, but got worse. It misses while under load and under acceleration. The "check engine light" never came on. I have not put fuel in in several days, and it ran fine until now, so I doubt it is bad fuel. I started the engine after dark and looked for arcing. None visible, and I even sprayed the wires with a mist of water. I pulled the plugs and they all look normal. The gaps were all way too large, so I regapped the plugs to .054". I pulled the coil pack and it checks within range with my VOM. Can the coil pack be the problem even though it checks out on the bench? Can the large plug gaps have contributed to a coil pack failure?
Where to start. I HATE just throwing parts at this thing, and I don't like wasting money... If I let one of the auto parts stores run a scan, will it show a code even though I have no check engine light? I used to think of myself as a pretty good diagnostician, but then again, when I used to spend a lot of time under the hood, those cars had points, condensers and carburetors...
View 4 Replies
I have a 2002 f-150 4.6 that sometimes has a miss upon acceleration but not all the time.the truck is a 4.6 with a manual trans.has no engine codes and scanner never show a misfires but sometimes it does , have replaced all spark plugs and coil boots twice.
View 4 Replies
I have a 2005 Chrysler 300C ( original owner )Mileage 172,000 and I take care of my car. I use full synthetic oil and change it every 5000 miles. I noticed a hesitation between 1000 and 2000 RPM's. It disappears after 2000 RPM's. The Chrysler dealer kept doing repairs and claimed the problem was gone and it is still there. The dealer did a full tune up, induction service and also replaced the EGR valve, gasket and seal. The problem gets worse in higher mountain altitudes.
View 3 Replies
Have a p0401 code which I need to diagnose and solve. However, I don't believe the symptoms are indicative of the EGR system. Its a 1999 4.6L auto approximately 200k miles. Truck runs fine until it warms up, and then occasionally it begins to act like its missing under load. steady state on the freeway it may have an occasional miss, but put a load on the motor and the miss becomes real bad. This doesn't seem to me to be symptomatic of a P0401 code, but I don't really understand the EGR system enough to be sure. Searching on the forums for other p0401 codes doesn't seem to have the same symptoms.
View 10 Replies
I recently purchased a 1997 F150 4.2 Liter. On the way home it started missing. Within the next few days it died on the side of the road. After towing home I found no spark. A few days later I t started but only for a few minuites and died. No spark, coil pack is new so I replaced the CKP and it started up. Drove it about 1/2 Mile and died again, No spark again. Not getting power to coil pack when I am turning it over. So in short, new coil pack and CKP sensor and no spark. If it sits for a few days it may start or it may not. But if it does it only runs for a short period and then no spark again.
View 3 Replies
This a 02 with 5.4, had codes po306, pulled and checked sparkplug had moisture in it. Fixed that ran ok for a little bit then started again, no codes now and smells a little like rotten egg.
View 1 Replies
2003 Ford F150 XLT - Truck hesitates (or bucks) as the throttle is pressed. Not from a stop though. It starts / runs fine, but no matter how how fast, what gear, hot or cold, it feels like the fuel cuts out for 1/2 second. Also it is not a specific point in the throttle motion. It does it when it is halfway, 3/4 or fully depressed, but is not consistent. It does happen more frequently now than two weeks ago. I am not getting a check engine light.
4.6L V8, 5 Speed Manual 4x4, 74000 mi
View 14 Replies
I have a 2001 f150 5.4 with 200,900 miles. Just bought the truck about six months ago off my dad when he got a new one. I am now experiencing what seems to be a slight misfire. With the hood up pulling the throttle around 2200 rpm starts making a loud knock. Above that rpm nothing and below that nothing. Standing by the tailpipe it sounds like a small backfire. It Idles really rough and when you get that sound out of the tailpipe it jumps like its hiccuping. And tailpipe is vibrating quite a bit.
Things I have done in the past month include replacing the pcv valve, changing spark plugs, cleaning throttle body, cleaning MAF, took down exhaust to check cats because i was experiencing a power loss and bogging. When the exhaust was off i punched the two rear cats. I ran a bottle of iso heat in the gas. Everything seems to have supported the power problem but now less than a week later i am starting to experience the knock and backfire type sounds.
View 14 Replies
Recently purchased a 2000 ford f150 4.2l. started hesitating when i would try to accelerated stressed or when a.c on. if i drive it like a grandpa wont do it. filled up the gas tank and it completely went away. the second it went down to the 3/4 line, started hesitating again. mind you when it was full even with the a.c on and going 80mph on expressway it would not hesitate.
View 2 Replies
97 f150 4.6 4x4, no check engine light, no missing or sputtering, however when I try to get going I can't get passed 2500 rpm and when it finally does its still kind of sluggish and can't pass as easy. Changed fuel filter. It idles fine and when I put it in neutral it will go up to 5000 rpm if I want.
View 6 Replies
I have a 1998 f150 w/ the 4.6L V8
For months I have had a hesitation in this truck when i go to accelerate, and at times you can even feel a little buck with the cruise set at 70MPH. It has gotten worse and worse. When i start pulling a trailer good luck, it will do it but its terrible, hesitations and misfiring,
There is always a misfire/hesitation. Will Idle nice After its warmed up. Sat for 2 weeks fired it up and it had a HORRIBLE idle for at least 1-2 min. This is new now it wont idle when cold. Now I had one code Cylinder 4 misfire, cleared the code never came back 2-3k miles later still not back on -
replaced coil packs
New plugs
New wires
Fuel pressure test good
Checked the Heater hose - not leaking and nothing in the hole.
View 3 Replies
Just bought a 1998 5.4l F-150 Lariat. 136,000 miles.
Question about the overdrive button on trans handle. When I push the button, I don't see any light turn on (or off) and I don't feel any change in the gear ratio or increase/decrease in rpm's. I assume since the button in there marked "overdrive" that the vehicle in fact was equipped with it. Could it be a bad button, fuse, or ?
Also, it just started the shudder/hesitation at certain speeds that I see a lot on these threads. Seems like that is a coil issue as the description in many threads is exactly what I am experiencing to incl the rotten egg/fuel odor. However, it started the same day (not same time, later same day) I decided to push the overdrive button while checking out all the things on the truck.
View 1 Replies
I was looking at my exhaust manifold..and I found a couple of studs missing...so if I want to replace both of them , is it better if I replace all of them on both sides of the engine ?
By the way..my exhaust manifold is good I don't think none of the studs are broken.. but I have been having this engine knocking noise on my engine, do yall think a couple of studs could be the problem of why my engine is knocking?
View 2 Replies
I've got a 97 f150 4.6 that has randomly started missing over the last month. It has started to get more frequent and codes are showing a misfire on both cylinder 1 and 8. Both of these cylinders run off the same coil pack. I'm thinking its the coil? The plugs and wires, motocraft, have about 3k on them and the truck runs great otherwise. I just don't know how common a coil would cause this or if they would act intermittent like this.
View 5 Replies
