Ford F-150 (2004-2008) :: Bad Shaking / Rattle At Start Up Only After Changing Oil
Apr 8, 2013
I have a 2004 F-150 5.4L V8 3v vin code 5. I'm a heavy equipment mechanic and know my way around engines. The longer I own this truck the worse the problem gets. I believe I've narrowed it down to the oil actuated timing chain tensioners. I get a really bad rattle with a shaking condition only after changing my oil. Other then that it runs perfectly. I'm guessing it's losing its prime and trying to build up oil pressure. Is there any way to hand prime those tensioners? Or should I just go ahead and replace the whole assembly?
View 5 Replies
Advertisement
Ok noticed this a few times recently. On the first start up of the day, sometimes it sounds like something "rattles" in the engine before it comes tight? This only happens when I first start the truck from sitting overnight, if I run to the store, or at lunch go out, etc, it starts normally. I did have one of the pulleys replaced this past summer, it was making a whining noise so maybe the new belt they installed is loose? I know it could be any number of things.
04 5.4 with about 87k miles...
View 14 Replies
I have a 2012 Camry SE with about 30k on it. I've always been a huge Toyota fan but I've had some interesting things happen with my first new car that has me questioning quality. I've had a mouse nest in the cabin air filter with the dead mouse laying in the engine bay (not a toyota issue), a loud rattling exhaust/engine rattle when I start the car, and the common interior creaks that I've been reading about.
However I've noticed a noise coming from somewhere behind the dash, maybe the instrument panel area that has been very annoying. It occurs at highway speeds usually above 65mph and it's kind of like a quick tapping. Very faint but definitely noticeable.
Its not the sunroof because, unfortunately I have that issue also lol. It took me a while to narrow it down to behind the dash but that's as far as I can get because I can't search for it while I'm driving. I'm not very picky but I do like to drive in silence sometimes and listen to the sounds of the engine/tranny shifting (weird I know) but that dashboard noise has been ruining it.
View 1 Replies
I purchased a Ford Ranger from a single owner last year very good condition. It has about 320 000 on the odo. The truck was working perfectly the last year but recently started giving problems when I start up the engine (cold start).
Whenever it gets cold the engine would shake violently every 1-2 seconds during idling but stops when the engine is hot. I also hear some scary sounds from the engine while it is shaking (only if I stand outside).
I have researched it and I can't find a solution, apparently it can be a lot of things as well as timing belts etc. I had a mechanic change my timing belt a few months ago along with a major service. I am very scared something might go wrong with the engine.
Make, FORD Ranger
Model, 2008 Montana
Engine 2.5 tdi
Mileage 320 000
2x4
View 4 Replies
2007 Ford F150
XLT 5.4L Supercab
55,500 miles
Only Owner
I have owned my truck since mile 1 and have not had any issues up to this point. That being said in 2011 there have been 5 occassions where I have been on interstate driving between 55-70 and had to pull over due to my truck shaking. This shaking is very extreme and truly scares me, thus the reason I pull over. I replaced my tires with Michelin 70,000 mile tires and also replace my front brakes just over a year ago.
After not being able to reproduce the shake for my mechanic, they said my upper front ball joint needed replaced and my rear shocks. They hooked the truck up to the computer and did not receive any codes and my check engine light has not come on to this point.
The research I have conducted to this point has pointed to a number of issues and I had my mechanic check all of them and they said nothing was out of the ordinary, these were: e-brake issues, front brakes, calipers, plugs/coils.
View 14 Replies
I changed the battery 6 months ago and twice it has failed to crank since. Is there something draining the battery?
View 3 Replies
Ok, my next job is replacing a very rusty power steering pump, don't want and unplanned failure. (06 f150 5.4 XLT)
View 4 Replies
I have a 2007 ford f150 FX2 5.4 with 3.55 limited slip rear end. It has 68,000 miles and would like to change the rear differential oil. I have read and I know the oil it requires is 75w-140 plus the friction modifier. I would like to use mobile one. But was reading and the mobile one sites states that is already has friction modifiers. Is that ok to use on my truck? Using mobile one and not adding the extra modifiers?
Also some other brands say they have friction modifiers as well. Should I use mobile one and add extra friction modifier or just go with what it has already?
Mobil 1 Synthetic Gear Lube 75W-140 LS contains special friction modifiers designed for limited slip-type differentials. In most applications, the addition of special LS (limited slip) additives is not required. For axles requiring the highest level of limited-slip performance, OEM specific LS additives can be added to this fluid.
View 4 Replies
I own a v10 and am getting ready to assist a buddy out with his 05 5.4l. He wants me to change the spark plugs out. I have changed the spark plugs on my 04 v10. I think this is the year for went to the 2 piece spark plugs. Also what torq setting should I torq them to? Should I also use anti seize with them or no? Does the gap need to be set on the plugs? I dont have a book to go buy.
View 12 Replies
I was driving my f150 going down the highway. Cruise set at 110kmh. All of a sudden truck started shaking And sounded horrible. Shut off the cruise. Floored it.it misses fired like no tomorrow and no power, looked down check engine light was flashing. Then all of a sudden everything normal. Now its intermediate and light solid on. So I thought I will just I will hook up the code reader. And NOTHING it didn't turn On. No beep nothing. Tried 2 readers no connection. Trucks a 2005 ford f150 fx4 5.4 217600km on the clock
View 2 Replies
I have a 2007 an at about 52mph the truck has a slight but irritating bounce (up an down) an after a while sickening. It maybe felt it was coming from the rear. So I had the rear tires balanced an the guy said my right rear tire had a bend to it. Well assuming that the balancing fixed the problem it did not. So I'm going to put on the spare to see if it still bounces what else should I do?
View 14 Replies
I've done some research on the shaking that is occurring on my truck an it's a possibility that it's the e brake seizing up. I've read where everyone has taken it to the dealer to get it fixed ....
View 7 Replies
Have a 2004 Fx4. Lately its been shaking violently when i accelerate. When I turn the overdrive off it stops.
View 9 Replies
It seems like I am going thru brakes I just replaced my brakes in May and my Rotors in July and when I brake my truck shakes like crazy. Is it the brakes again or am I missing something.
View 7 Replies
I have a 2006 F-150, V6, automatic transmission, a little over 214,000 miles. When I started it up this morning, no issues, but when I dropped it into reverse, it started shaking pretty bad. Got on the road and put it in drive, and the shaking continued, then the check engine light started flashing. Haven't had any problems up to this point. Checked all the fluids including the transmission fluid a few weeks ago and all was well.
View 4 Replies
On my 2007 f150 5.4 last week i changed out the driveshaft and it smoothed things out. This past weekend I dropped the transfer case oil and refilled it with motorcraft transfer case oil as per ford but now the front end seems to shake more than before. It just seems to come through the steering wheel but the wheel seems tight almost like a death wobble with solid front axles except obviously this truck doesn't have that. There are no leaks and I filled it up to the top fill hole with between 1.5 to 2 liters of oil until it started running out. I should also mention that when i went to check the level it was overfull on the top plug but it was that way for the last 90,000 km or so.
View 3 Replies
2004 5.4L ... Codes indicate a firing issue on #4 cylinder, figure it's the coil pack. They bought truck used a few years ago and plugs have not been changed since they have owned it. I was going to change plugs while I was under the hood. While checking threads on this engine I picked up on plugs being a major job unless you know the tricks. So what tricks do y'all have up your sleeve to keep from breaking plugs?
View 14 Replies
I have an '05 5.4L 3V and I was way to trusting in how it was running. BTW, I change the oil every 3 to 5 and have only driven highway miles, albeit a lot of them...155k! I bought it with 40k on it but was not aware of the plug change issue until I heard about it off-hand. I let the plug change go cuz it was running so well. Bad move.
Anyways, a few weeks ago it began to lose power and I suspected that the PCM was retarding the timing for some reason. Before I could get to the shop, the thing went nuts on me at 75mph. Started shaking and sputtering and throwing cel codes. I shut it down and after 5 minutes re-started. It seemed fine and actually was running a bit better. Took it in and the code was the 0302. #2 cyl misfire.
They also said the compression was very low on that cylinder and slightly low on 1,3 and 7 as well. I had them change the plugs and the #2 COP even though they said I needed a new engine and then I picked it up. Now the engine barely runs at all. It shakes violently, where to go from here. What should I do now? New engine?
View 14 Replies
I have a 2006 F150 5.4 3v rattling and shaking excessively. I have installed two new cam phasers, two vct solinoids, two vct housings, flushed oil and installed motor craft oil and filter. This never happens if bank two vct is unplugged or in open loop. Monitioring vct's on ids only bank two is erratic. Also when I had vct housing off I blew regulated air through oil passage seems free.
View 7 Replies
After my 2006 Ford F150 Lariet started shaking and pulsating when braking (38,000 miles) I took the truck to the Ford dealer and asked to have my brake pads checked. They came back and siad they looked fine and I had alot of wear left. Then I mentioned that is was shaking and asked them to check it again, they drove it and then said my rotors are warped and I need to replace the rotors and pads. I don't haul, tow or do anything crazy with it.
Now, here's my questions:
1. Can the rotors go bad and the brake pads be fine?
2. Should I go with a ceramic pad or stick with the OEM?
I'm just a female and don't want to be taken advantage of at the dealers. Cost is not an issue when purchasing a good product.
View 14 Replies
Ok, I have a 2006 Ford f-150 5.4L engine. it has 88000 miles on it. Here recently it has started acting up on me. It starts shaking violently when I slightly accelerate going up hills at any speed. On level ground it doesn't do it. Going down hill it doesn't do it. When stopped it doesn't idle rough.
It does this shaking when I barely press the gas. When it starts I either let off the gas or I push the gas to the floor and it stops. What is going on? This is the first Ford I have ever known. I don't know anything about these vehicles. I have read it might be the coils and plugs but then people have told me it might be the torque converter.
View 6 Replies
