There had been a lot of discussion about the engine light coming on and the Engine fail safe mode. A lot of folks said the dealer could not fix it. It happened to me and my dealer fixed it. This is what the dealer did to correct the problem
EEC Tested
Code P2106
Disconnected all wheel speed sensors and reprogramed PCM per SSM 17272 and Ford Hotline
No more problems.....
I was driving down a road tonight and my entire truck shut down, and it said engine safe mode. I lost all power steering and gas, all I had were breaks and electronics. What does that mean?
View 1 Replies2001 Accent, 1.5L Automatic with OD, 263,000 km
Transmission goes into Fail Safe Mode but the CEL does not light up and code reader shows no codes. Shifts fine in town,1-2-3-4...4-3-2-1, but on highway when going up inclines (steep), transmission downshifts from Overdrive into 3rd,as i press the accelerator it will downshift into 2nd (as normal), until i reach the top of the incline (3500-4000 rpm) but then as the car levels out on the highway, it will shift back and forth between overdrive and 3rd, (jerky shifting) then finally goes into Fail safe mode, 3000 rpm at 80-90 km/h. Once I shut the car off for a few minutes, the transmission is fine and shifts normally. Fluid levels are good. Why the CEL is not giving code?
Is it safe to rev the engine while in inspection mode (forced idle). Someone has a question about checking for valve noise in the top thread about common 2G problems in the maintenance discussion, and I unsure about giving advice concerning revving the engine via the throttle motor. I will mention, I suppose, the check engine light will turn on.
View 3 RepliesI just got an Egde Evo which I installed and everything looked great. After a few runs, I noticed the ABS light coming on an soon after that my transmission goes to limp mode (the wrench lights up).
I receive the DTC error: P2106 on the Edge Evo.
I have gone back to Factory default, but it keeps coming back, ie. the ABS light lights up and the Trans goes to Forced Limited Power (according to the Evo).
I have a 2004 F-150 Lariat with a 5.4. (FYI-Have not had clockspring recall fixed yet)
124K miles. Vehicle has been operated in AZ and TX only until coming to Minot, ND 6 weeks ago.
3 days ago I got an "Engine Failsafe Mode" on startup. I shut the vehicle off immediately. Started it up again and the "Engine Failsafe Mode" message disappeared, but the engine light came on and has stayed on for the last 3 days. It seems to be running ok, maybe a little rough.
I ran the reset info on the dash screen and all systems read out OK. I have not run the truck over 40 mph since, and not on the highway, but it seems to accelerate without a lot of hesitation.
I've seen in other forums that this might be a dirty or faulty throttle body and/or the dealer may be able to re-flash with updates but this is old 2004 info from newer owners back then.
What am I looking at from a time/price angle when going to the Dealer for service? I don't want to replace a throttle body if it just needs to be cleaned and re-flashed because I'm ignorant.
Anything I should watch out for? I'm not a competent mechanic!
I was driving at 40 -30 mph on a dark street and rammed through a bit of water ( maybe 4" high and 6 feet across). So right after i got these tranny codes and my tranny went to safe mode kicking hard when shifting:
P0705
Transmission Range Sensor Out Of Self Test Range Or Shorted To Ground
P1783
Transmission Over Temperature Condition
P0712
Transmission Fluid Temperature Sensor Circuit Input Low
P1702
Transmission Concern
Luckily I was a block away from home. So i assumed all those sensors shorted with water ( I thought they were all water proof...hmm) so i let them dry.
So the codes went away and the truck seamed fine for 2 weeks until i felt the tranny kicking again into gears yesterday. So today i went on a test drive and it was fine at first until it went into safe mode again with only 2 codes:
P0705
Transmission Range Sensor Out Of Self Test Range Or Shorted To Ground
P1702
Transmission Concern
So, that means the other sensors dried out and i destroyed the TRS? and if so would it malfunctioning cause the tranny to go into safe mode or could there be some other issue?
I'm in a bit of a bind. I was very low on gas drove my car on fumes (mistake, yes) back to my place. Today, it will not start. I dumped 3/4 of a gallon into the tank, and still no start.
The ignition will try, fail to engage the engine, and then emit rapid clicks as the interior light flashes. The battery works, as all the cabin lights turn on.
I really don't want to the fuel pump to be broken, so I'm trying to eliminate possibilities before that. Is there something wrong with the ignition, perhaps? What is the clicking after the attempted "heaves" of the ignition switch?
My auto tranny goes into "safe" mode every so often. It thinks there is something wrong and stays in third gear. The d4 indicator stays on even if another gear is selected (it's indicator light is on too). I changed the fluid (clear, red - in fine condition).
View 14 RepliesWhere I live people on the highway accelerate quickly. I try to stay in the EV range up to 15 mph but, when I do someone is up my rear end.
However, when I accelerate manually in EV mode I can accelerate up to 25 mph with the flow of traffic.
My concern with repeatedly accelerating up 25 mph in EV mode will be harder ( lessen the life ) on the battery or the transmission or the electric motors.
I'm guessing it's safe for the electric motors and the transmission because the plug in prius can accelerate up to 62 mph and it's fine.
However th
So is it 100% safe for the car to repeatedly accelerate out of EV mode?
I got a 99 B.5 Passat..
a couple days ago.. I put water into the car cause the light came on. The next day the check engine light appeared. I drove the car and parked it for a few hours..
When I went back into the car the check engine light still appeared.. And not only that it went into SAFE MODE with all lights highlighted... PRND432..
I have a 2009 SX4 Crossover, which came with a Garmin nuvi 760 ... but which has been customized for Suzuki. I actually already own a "real" Garmin nuvi that we've been using in our other vehicles, so the Suzuki customizations are fairly obvious to me.
For the most part, they are welcome value-adds over a standard Garmin nuvi 760, with one very annoying exception ... and that is the mandatory "Safe Mode".
Suzuki has apparently decided for me that I must always have Safe Mode enabled, by removing the enable/disable option for this in the Suzuki version. A "real" nuvi 760 (and for that matter all other real Garmin nuvis with Safe Mode) has a Safe Mode enable/disable toggle button on the Security settings panel; and that has been removed from this panel in the Suzuki version.
While I understand the safety issues involved with a driver trying to use certain features while the car is moving, did Suzuki forget that they also install a passenger seat up front as well; and that maybe me or my wife, while in the passenger seat, might be trying to look up some location information for us while we are driving through an unfamiliar place looking for things? The only way to get out of Safe Mode is to pull the car over somewhere and stop ... very inconvenient, especially in congested city traffic. This has happened to us a number of times now, and is really getting old.
So I'm just wondering if any way to disable Safe Mode on the Suzuki version of the nuvi 760? Or, what I am actually hoping is that the option to turn toggle it on/off really is still there but just hidden, and that maybe there is a way to un-hide it ...
I had to do some work on the car which required disconnecting the battery, Usually the radio goes into safe mode which I unlock using the 4 digit code. However this time i entered the wrong code and the radio went into 02 safe mode?? Now the radio is not responding at all to any inputs from the buttons, its literally locked. I have disconnected the battery again and left it for a bit hoping it would clear it but no luck it still says 02 safe and I can't enter the code to unlock it.
View 5 RepliesI unhooked the battery for about an hour. I hooked it back up. I started the car put the selector into drive. CLUNK. Disengaged the parking brake. Drove. It turns out when I shifted to D it went straight to third and stayed there. I turned off the car, restarted it. Still stuck in third. Drove a few miles. Restarted it. No more issues. My guess the tranny went into safe mode, but why?
View 3 RepliesI have replaced my trans and now I have a problem with it going into fall safe mode. I was told it was to do with a sensor on the transfer case. Could this be my problem? I can turn the truck off and turn it back on and it will shift out, but when I stop and start to take off it goes back into the fall safe mode, staying in high gear.
View 4 RepliesHow to bypass the safe mode feature of the navigation unit? I've found bypass modules on the internet that go for around 200 but was wondering if there's an alternative method that would possibly be DIY and very low cost?
View 2 RepliesI have no vacuum coming from the engine to the IWE solenoid. This is making my hubs stay locked all the time. where this line from comes from and how to fix this. Which line is the line from the engine, the one with the T in it or the other one?
5.4L V8 2004 New Style
When the truck is idling it has a weird vibration and their is a hum that comes from the engine. It then clicks like my clutch fan disengages or engages and both go away. I have only noticed at stop signs and sitting in a parking lot. 2004 5.4L....
View 2 RepliesMy mom gave me a 2004 f150 lariat with a 5.4l and were having an issue with the engine when coming to a stop the engine wants to stall out and runs like a bag of hammers and sounds like its going to explode then i give it a shot of fuel and it runs fine for a a while and then does it again. I brought it to the local dealer and he said it was either the vct or the cam phaser bank 2 so i changed both and it still does it just wondering before I keep getting intake cam sensor code retarded and a bunch of other codes but we replaced the cam sensor already.
View 2 RepliesI just bought an '04 F150 from a friend. It has 250K miles on it. When I got the truck there were no tapping noises coming from the engine. Now that I changed the oil, at start up till about 5 miles down the road, I hear the tapping noise. I put Castrol high mileage 5W-20 in it. Could it just be the oil I'm using or something more expensive?
View 9 RepliesI have a f150 with a 5.4 triton I have noises coming from the engine loud when cold get quiet as you increase rpm almost sounds like the valves if you go under truck noise gets louder truck has less than 68000 miles.
View 2 Replies