Ford F-150 (2004-2008) :: Shaking When Slow Down To Coasting Like 40 - 45 And Accelerate To 50 - 55 Mph
Oct 29, 2014
I just bought a used '05 F-150 and recently I noticed more a shaking I guess you'd call it. When I start from 0 to 80 nothing seems wrong, but when I slow down to coasting like 40 - 45mph and accelerate to 50 - 55 mph it shakes or acts like its having a hard time shifting or its skipping. And it doesn't happen till after I go past 40-55mph range and I've tried it in overdrive and out of it.
View 3 Replies
Advertisement
Have a 2004 Fx4. Lately its been shaking violently when i accelerate. When I turn the overdrive off it stops.
View 9 Replies
I have a 2012 SE 4 Cylinder Special Edition and just hit 60,000. Lately, I have been noticing this vibrating/shaking in the front of the car when I'm coasting or accelerating at a slow speed. What it could be? I got my front end alignment done thinking it could be that but it still continued.
View 7 Replies
I've began noticing about 2 - 3 months ago that while coasting up to 50-55 mph my truck begins to hesitate with a slight banging when it occurs. At first I was worried it may have been transmission, but once I talked to ford mechanics, they reassured me it was not, especially at 85,000 miles. I then noticed that taking it out of overdrive prevents the problem. It doesn't act up unless I am on the highway between 50 and 60 mph. It seems to progressively get a little worse and occasionally I can feel a jolt, as if it's struggling to shift into OD. What the problem could be? 2006 F-150 FX4 ...
View 4 Replies
All, i have an issue ( or at least i think its an issue) with my 99 f150 5.4. When i use my cruise control, i notice when i put on the brakes slightly to slow down, it feels like its not coasting because you can feel the engine still engaged and wont coast. I think this happens even without the cruise on. What this could be? I have the latest update on the cruise control harness. I believe that was for power always to it even in off, causing fires.
View 3 Replies
We bought yesterday a 2004 Prius with 73K miles. This was (unfortunately) a private sale. When my husband drove back home with the car, the VCS, ABS and ((!)) yellow came on when he reached 60mph and above. He also noticed a lot of noise when accelerating and the car was shaking. The noise is also there at low speed and when accelerating it is so bad and feels like something is rubbing?
This morning, we decided to try the tire pressure to see if this could be the issue. After correcting tire pressure (it was actually very bad), the lights went off and we decided to try it on the motorway. The car was noisy to start off but as soon as we hit the motorway, the sound was getting worse and worse. I could feel my passenger seat shaking under me and the 3 lights (VCS, ABS and ((!))) came back on and stayed on until we got home.
What was the issue in the end? We have spent all our savings in this car and can't really afford expensive repairs few days after buying it. We are just gutted. Oh and we have a 2011 Auris Hybrid with 15K that runs superb. My dad owns a Prius too and so I can tell the noise is just not normal- at the same time, perhaps a 10 yo Prius is supposed to do this noise?
View 10 Replies
2004 Mazda M3 . My auto is making grinding sounds at first-slow speed until it accelerates. It has 70,000+ miles.What could this be? What should-could be done for this concern.
View 3 Replies
2007 Ford F150
XLT 5.4L Supercab
55,500 miles
Only Owner
I have owned my truck since mile 1 and have not had any issues up to this point. That being said in 2011 there have been 5 occassions where I have been on interstate driving between 55-70 and had to pull over due to my truck shaking. This shaking is very extreme and truly scares me, thus the reason I pull over. I replaced my tires with Michelin 70,000 mile tires and also replace my front brakes just over a year ago.
After not being able to reproduce the shake for my mechanic, they said my upper front ball joint needed replaced and my rear shocks. They hooked the truck up to the computer and did not receive any codes and my check engine light has not come on to this point.
The research I have conducted to this point has pointed to a number of issues and I had my mechanic check all of them and they said nothing was out of the ordinary, these were: e-brake issues, front brakes, calipers, plugs/coils.
View 14 Replies
I have a 2012 GTI Autobahn, w/automatic, bought it w 7k miles on it and it was chipped. It runs great and is crazy fast. But, it has a lag in acceleration SOMETIMES when moving and coasting slow in traffic and then pouncing on the accelerator to change lanes, the accelerator is flat like its not getting fuel. It wouldn't do it when the dealer mechanic drove it.
View 2 Replies
I was driving my f150 going down the highway. Cruise set at 110kmh. All of a sudden truck started shaking And sounded horrible. Shut off the cruise. Floored it.it misses fired like no tomorrow and no power, looked down check engine light was flashing. Then all of a sudden everything normal. Now its intermediate and light solid on. So I thought I will just I will hook up the code reader. And NOTHING it didn't turn On. No beep nothing. Tried 2 readers no connection. Trucks a 2005 ford f150 fx4 5.4 217600km on the clock
View 2 Replies
I have a 2007 an at about 52mph the truck has a slight but irritating bounce (up an down) an after a while sickening. It maybe felt it was coming from the rear. So I had the rear tires balanced an the guy said my right rear tire had a bend to it. Well assuming that the balancing fixed the problem it did not. So I'm going to put on the spare to see if it still bounces what else should I do?
View 14 Replies
I've done some research on the shaking that is occurring on my truck an it's a possibility that it's the e brake seizing up. I've read where everyone has taken it to the dealer to get it fixed ....
View 7 Replies
It seems like I am going thru brakes I just replaced my brakes in May and my Rotors in July and when I brake my truck shakes like crazy. Is it the brakes again or am I missing something.
View 7 Replies
I have a 2006 F-150, V6, automatic transmission, a little over 214,000 miles. When I started it up this morning, no issues, but when I dropped it into reverse, it started shaking pretty bad. Got on the road and put it in drive, and the shaking continued, then the check engine light started flashing. Haven't had any problems up to this point. Checked all the fluids including the transmission fluid a few weeks ago and all was well.
View 4 Replies
If I start it on a cold morning and leave it idling for 20 minutes it will finish warming up within a mile or two. But if I just take off driving right after I start the engine, it takes close to 10 minutes to finally start warming the cab up. Is this normal for these trucks or is it possible the thermostat needs to be changed?
I found this service bulletin, which matches a symptom my truck has. Is it possible the rolling fan at cold idle could be keeping the engine from warming up as quickly?
05-4-3 COOLING FAN CLUTCH NOISE - VEHICLES BUILT PRIOR TO 10/1/2004 - 5.4L AND 4.6L ENGINES
View 12 Replies
I have an '05 5.4L 3V and I was way to trusting in how it was running. BTW, I change the oil every 3 to 5 and have only driven highway miles, albeit a lot of them...155k! I bought it with 40k on it but was not aware of the plug change issue until I heard about it off-hand. I let the plug change go cuz it was running so well. Bad move.
Anyways, a few weeks ago it began to lose power and I suspected that the PCM was retarding the timing for some reason. Before I could get to the shop, the thing went nuts on me at 75mph. Started shaking and sputtering and throwing cel codes. I shut it down and after 5 minutes re-started. It seemed fine and actually was running a bit better. Took it in and the code was the 0302. #2 cyl misfire.
They also said the compression was very low on that cylinder and slightly low on 1,3 and 7 as well. I had them change the plugs and the #2 COP even though they said I needed a new engine and then I picked it up. Now the engine barely runs at all. It shakes violently, where to go from here. What should I do now? New engine?
View 14 Replies
I have a 2004 F-150 5.4L V8 3v vin code 5. I'm a heavy equipment mechanic and know my way around engines. The longer I own this truck the worse the problem gets. I believe I've narrowed it down to the oil actuated timing chain tensioners. I get a really bad rattle with a shaking condition only after changing my oil. Other then that it runs perfectly. I'm guessing it's losing its prime and trying to build up oil pressure. Is there any way to hand prime those tensioners? Or should I just go ahead and replace the whole assembly?
View 5 Replies
I have a 2006 F150 5.4 3v rattling and shaking excessively. I have installed two new cam phasers, two vct solinoids, two vct housings, flushed oil and installed motor craft oil and filter. This never happens if bank two vct is unplugged or in open loop. Monitioring vct's on ids only bank two is erratic. Also when I had vct housing off I blew regulated air through oil passage seems free.
View 7 Replies
After my 2006 Ford F150 Lariet started shaking and pulsating when braking (38,000 miles) I took the truck to the Ford dealer and asked to have my brake pads checked. They came back and siad they looked fine and I had alot of wear left. Then I mentioned that is was shaking and asked them to check it again, they drove it and then said my rotors are warped and I need to replace the rotors and pads. I don't haul, tow or do anything crazy with it.
Now, here's my questions:
1. Can the rotors go bad and the brake pads be fine?
2. Should I go with a ceramic pad or stick with the OEM?
I'm just a female and don't want to be taken advantage of at the dealers. Cost is not an issue when purchasing a good product.
View 14 Replies
Ok, I have a 2006 Ford f-150 5.4L engine. it has 88000 miles on it. Here recently it has started acting up on me. It starts shaking violently when I slightly accelerate going up hills at any speed. On level ground it doesn't do it. Going down hill it doesn't do it. When stopped it doesn't idle rough.
It does this shaking when I barely press the gas. When it starts I either let off the gas or I push the gas to the floor and it stops. What is going on? This is the first Ford I have ever known. I don't know anything about these vehicles. I have read it might be the coils and plugs but then people have told me it might be the torque converter.
View 6 Replies
I have a 2005 F150 XLT with a 5.4 (198,000miles) RWD. A few months back it developed a miss due to bad COP's, typical shuddering around 50-60 MPH.
I pulled off the COPs and while I was in there I pulled my old plugs as well. New Motorcraft SP515 plugs went in with a little nickle anti-seize being careful not to get any near the end of the plug and I put a set of Granatelli COPs on with a little di-electric grease on the inside of the boot. The miss went away and the truck drove like a champ.
I will also note that I replaced the front wheel hub/rotors, front calipers and new pads. I resurfaced the rear rotors, new pads and new E-brake shoes also.
The issue I am having is under light acceleration, or "normal" driving conditions the vehicle has a mild shake which eventually smooths out.
My first assumption was that I did not torque my front wheel hubs correctly or that I messed something up so I took the truck to my local front end/alignment shop for a full inspection and they said everything is great. They also said that they didn't really feel the vibrations that I mentioned. I am used to this truck driving very smooth up until the misfire situation so to me it is quit noticeable. After the front end shop I went to Discount tire cause they mentioned that my rear wheels are bouncing pretty good and that may be what I am noticing. Turns out the tires were out of balance which Discount took care of and rotated my tires while I was there.
The vibration is STILL THERE! No CELs to reference, just an obnoxious vibration. I tried to isolate the issue by accelerating in 1,2, and in D. The issue occurs regardless of the gear I start off in.
View 4 Replies
