Ford F-150 (2009-2014) :: 2012 - Brakes Dragging - Noise / Hum At Slower Speeds
Jan 6, 2015
I have a 2012 F-150 4x4 super crew all factory with 54,000 mi. I've noticed a new noise/hum at slower speeds, more frequent now. The noise doesn't sound like its from the front or back specifically. I pulled the front wheels this evening and the front rotors seem pretty tight, how easily should they turn with vehicle off for about 30 min? I started it and pushed and released the brake and quickly tried to turn them, very tight, after a minute or two they relaxed a little, another 5 min they seemed tighter? I sharpie mark on both inside and outside of the rotor and turned it past the pads and they are both squeezing equally ruling out binding of the slider bolts.
View 3 Replies
Advertisement
Whenever Im driving at slower speeds - parking lots, side streets, etc I get a squeaking/squelching sound coming from somewhere in the front end of the truck. I thought at first it may have been a rattling heat shield someplace under the truck, but now Im not so sure. No loss of power, check engine light, or anything of that nature has occurred so Im not sure what to do. Its a 2010 Ford F150 XLT 4wd ....
View 5 Replies
2013 Platinum. See sig for details. 37,000 miles. 1 owner. Truck has been basically parked since June. However I take it out for a quick spin every 3 week for 10 miles or so. Currently has storage insurance on it.
When backing out of the garage the brakes are grinding and squealing bad. Also getting feedback through the steering wheel for the first couple miles which leads me to believe it's one or both the front brakes.
View 6 Replies
When I gently apply the brakes at slower speeds there is a single "click" noise. This happens every time. I took it to the dealer. They said it was normal. I am just trying to find out if indeed it is. Do other people get this click when they apply the brakes.
View 19 Replies
I have a 2006 Subaru Forester with 115K miles. It's been well-maintained and well-loved.
For the past few months, the brakes have been inconsistently making a dragging/grinding noise when coming to a stop at low speeds (<5mph). It sounds to be coming from the front half of the car - I can feel it vibrating a little near the driver side. We've taken the car in to be looked at three times - each time, the mechanics think they've heard the noise and report there is absolutely nothing wrong with the brake pads or rotors. Twice they reported a shim was out of alignment. After the last shim adjustment, the noise got a little better - instead of grinding, it's more of a dragging sound now. Because the noise is inconsistent, I haven't been able to crack the formula of the conditions that produce it, other than that it only happens as I'm coming to a stop at very low speeds.
Is there something besides the brakes we should be having inspected? Does this sound safe to drive?
View 10 Replies
2012 F150, 5.0
Quiet at idle, makes a crinkly, scratching noise under load, becomes almost a rattle or sounds like something is dragging (there isn't anything dragging). I can rev the engine in P and do not get the noise, only when in gear and moving. Quiet when cruising, noise comes on when accelerating. Did not notice the last time I drove it, it sat for a couple of days, then noticed it the next time I drove (yesterday). Took it around the block this morning to see if it was still making the noise, it is.
Obviously, it needs to go to the dealer, but want some info if it's harmful to drive it there, or if I should have it towed.
View 6 Replies
Brakes are too agressive on the Passat 3.6L 4Motion? Seems like the initial application, especially at slower speeds is too jerky. You have to be very soft on the pedal so as to not get your passengers hit the dash...
While you do want brakes that grab, I think that the modulation needed is beyond most drivers talent in order to execute a smooth stop without jerking.
I track my other car, so I'm familiar with brake modulation and race pads but again for a normal driver, this does not seem normal. The Audi A6 Bi-turbo is much smoother.
View 10 Replies
Ever since my last oil change, I've been having this low whirring or moaning sound at slow speeds (below 30mph). Switching the dial from 2WD to AWD, the moaning noise increases as if it engaging AWD; then it decreases. When switching back to 2WD, the sound doesn't go away. Other times, I don't hear this moaning sound and I hear/feel a very slight clunk.
It's like my truck is always in AWD and won't disengage. When I took the truck to the dealer, the service manager was with me and heard this noise, but when the 4x4 tech drove it, of course it acted perfect. Apparently, they had engaged/disengaged the AWD/2WD so many times that the 2WD/4WD appeared to work. The guy said, oh what you're hearing is normal, lets get back to the shop. My mileage is also dropping - another indicator being in AWD.
The dash panel always shows the electronic shift as successful. I know it engages while I'm driving because I sometimes hear/feel a slight clunk and then the roaring as if I'm in 4WD.
View 3 Replies
2012 f150 5.0 liter....Every morning when I leave for work I back out of my drive way and when I push in the breaks they are super squeaky. When I got my tires rotated the dealer said breaks were fine. I noticed my neighbors f150 Eco boost does the same things but not as loud. When the breaks are warm it doesn't do it. Can this be prevented it wakes up my parents in the morning.
View 8 Replies
I have a 2012 Ford F 150 crew cab 4x 4 and have a problem it squeals in reverse. Brakes too and it's only in reverse and it's only for a short period of time as soon as I come to a complete stop.....
View 7 Replies
From everything I have read I can't seem to figure out exactly what the fix is for what feels like brakes sticking after coming to a full stop, then accelerating? I will describe as a clunking and kicking feel, as if power to the rear end is being delayed then kicking in.
From all the posts and replies it seems like a differential issue. Exactly what the issue is and the correct fix? 2012 purchased used with less than 5K miles in 2013, problem has slowly been getting worse over time.
View 8 Replies
If the selector switch is in 2WD, should the front wheels spin freely if they are off the ground? In other words, should I be able to spin the wheels and they have at least one revolution from the force of the spin?
The reason I ask is that I'm hearing a "whirring" noise at slow speeds in 2WD. When switching to AWD mode, the whirring gets louder. I don't hear the normal clunk/click while it engages/disengages. I suspect, the hubs are engaged somehow.
I jacked up the front end so the front wheels were off the ground. Neither will spin (even allowing for slight friction from the brake pads). To make the front wheels rotate, I have to put a lot of force and there is a lot of resistance. My gas mileage is also dropping.
View 14 Replies
I have a 2009 F-150 with 5.4L 4x4. Recently I've been hearing a whining noise when I'm driving at low speeds. I don't hear it at startup and if the truck is idling in the driveway the sound goes away after a while. Only while accelerating and turning. I can't tell if it gets worse while turning or not. At first I thought it was an idler pulley, but since it doesn't happen when idling, I am leaning on power steering pump.
View 6 Replies
I replaced my front axle pads but the driver's side brakes seem to be dragging on the rotor making a very loud squealing noise when im driving. When I parked it in my driveway it was really hot and smoking. It doesn't happen to the passenger side. I pushed back the Pistons easily to get the brake pads in there so that wasn't a problem. But I must admit I changed them when my brakes were grinding.
View 13 Replies
I was uber excited to buy my first brand new truck in 09..... Amount numerous issues, defective rear window (fought with ford for 3 years never replaced under warranty), sync issues draining my battery, multiple O2 sensors replaced, multiple lights replaced and a blown drive shaft all under warranty. Now my warranty literally just ended, years not miles, just rolled 36k yesterday, ran out 3 years in November 12, now I'm having break issues.
A few weeks ago while driving, I released the gas and truck seem to slow faster than normal. Seemed kind of unusual but also began to noticed a drag on my mpg, about 2-4 mpg difference, depending on highway or in town. Now 3 weeks later, I feel grinding under breaking. Now it's beginning to make sense. I figure probably a stuck caliper. While driving with head out the window , freezing in IL, by the way, seems to be the drivers front. Checked rotors, outsides only as there are the guards preventing me from checking the back side. No visual or touch grooves ground into the rotors from the pads being worn out. Best bet is its the back side of the caliper that is locked.
Question 1, does this make sense, only one side of the caliper locking up? I had a caliper lock on my old GTP but the whole thing locked up.
Question 2, do I just suck it up and replace the breaks my self, gf's dad is a manager at O'rylies so I can get anything I want at cost, or do I go back to the dealer and bitch about mechanical problems being constant with my new now only weeks out of warranty truck? I read some horror stories about clogged lines and numerous other issues causing calipers to lock. I don't feel like replacing my whole break system, lines, calipers and all just to make sure the problem is fixed. At 3 years this seems ludicrous.
View 4 Replies
The other day I pulled a fella out of a ditch. It was a dulley 350 with a lowboy trailer and a small dozer on it.
Well, after finishing and driving away. I inadvertently left the truck in 4x4 while driving on wet pavement at speeds ~30 mph. What I noticed was: when I let off the accelerator there was a low growl/vibration noise coming from the front/under the floorboards while the truck coasted to slower speeds.
I have never had my truck A) in 4x4 on clear roads or B) at speeds above 10mph in 4x4. Maybe they all make noise at low speeds in a quite cab in 4x4. I wouldn't know, I've never driven it under these conditions.
So, can you hear your truck in 4x4 when not giving it gas and coasting on the road?
I did not think I put the truck through too much while pulling that fella out, but now I'm wondering....oh, and I at one point I coasted forward and ran over the towing strap that was attached to my front pull hook and it made a HECK of a noise...could that have done something bad?
4x4 still works, and everything seems/sounds fine otherwise. I might just be hearing the front end putting friction on the transfer case and I can hear it in the tranny as she coasts to a stop (it goes away as soon as I press the accelerator at any speed) but like I said, I've never noticed this before.
View 8 Replies
OK, when I first got the car in June it needed strut mounts so I got the 034's and new bearings and all was good, recently I noticed just a creaking/knocking type noise, not the same as before. So I checked the bolts on the mounts just in case and they are good. Been reading lately about the subframe and it is leading me to believe that may be it. The noise is more noticeable at slower speeds when just going over slight road imperfections(like small dips) and sometimes I do not hear it at all even over rough roads?
View 6 Replies
I have a 2007 volvo S40 T5 AWD with 25,000 miles. When driving at slower speeds and I let off the gas, I hear a "clunking" noise similar to driving over a lose manhole cover. The car makes a very slight jerk as well. I notice this as well between 2nd and 3rd gear, but not just then. I am thinking transmission problem, but don't know and want some info before heading to the dealer.
View 2 Replies
We have had the 2014 Camry SE for 3 months, 2000 miles, (we also have a 2005 Camry LE) and our first interstate trip is when we noticed it. When we get close to 70 mph and above we hear it. Sounds like some maybe flapping/rubbing? No really metal sounding, maybe plastic? I have checked under the car, do not see anything loose. We first thought it was coming from the storage area in between the seat, but we took everything out and the noise continued. Dead center under the car it sounds like. It does it every time, the same sound.
View 11 Replies
I have a 2012 f150 supercrew ecoboost with 6,000 miles on it. I just took it into the dealer for a clinking noise from the rear end. It happens when shifting between D and R and during dowshifting at low speeds. They said that ford is aware of this noise but does not have a fix yet.
View 2 Replies
First it was the RH now after replacing the rotors, calipers and new shoes. The LH is now doing it. It doesn't stop the truck just gets hot, the wheel, and u can smell it. The truck is a 97 f150 ext cab 2wd short box, had since new and has over 200,000 miles and going strange until now. I want to get 300000.0 before I let her go. Had to replace a rear axle brake line years ago, and do not think the lines were bleed right, the brakes never work just right.
View 4 Replies
