Ford - Mountaineer :: 2004 - Died While Driving And Rarely Start Back?
Mar 23, 2012
friend with their Mountaineer issues and i have no clue where to go or what to do now. Shes had it for approx 2 months and didn't have any issues till this one. It died on her while driving and would rarely start back. She had it towed to a crappy garage and the lazy mechanic stood beside it and "listened" for the fuel pump. He said he didn't hear it, gave her a quote and walked away. She then had it towed home and i was contacted. If i get under the truck while she turns they key on, i can hear/feel the fuel pump. It's quiet, but there.
But now, you can turn it over for about 10 seconds and it will start the almost immediately die. During one of the times before she had it towed, she took it to auto zone and had the codes pulled. I have a scan of all the detailed info i can post if needed, but it pulled: P2104 P2106 P2111 and P2135. Each of those mean something along the lines of a sensor but the only two sensors mentioned in more that one code is the throttle position sensor (TPS) and the Electronic throttle control (ETC). I've been trying to research what i can on it, and from what I've read is when these codes are pulled, those two sensors are rarely the problem.
View 7 Replies
Advertisement
I have a 2003 mercury mountaineer 4.6L AWD. The other day it died at the grocery store and now won't start. All it has is the check charging system warning light on. Changed Alternator, battery and starter already and still nothing. It does start sometimes but i need to give it gas to keep it running.
View 7 Replies
I was driving down the freeway, headed up a hill and my truck started slowing down, rapidly, it eventually died. I put it in neutral and started it up, went about 1' and it died again. It did this several times. I was almost to the top of a hill and was hoping I could coast down, but didn't make it. It ended up dying completely.
I would turn the key to start it, and it would keep trying to turn over (even when i let go of the key. it was weird). Then after a few times of that, the battery just died.
I also noticed a smell. Like something burning. I noticed it off and on for the last week and asked a friend to check it out but he was like "oh its nothing".
View 13 Replies
My wife was driving through the intersection when the truck died... Tried to start it again but no go, I had it towed home, and stared to troubleshoot.
I have a Scan gauge2 and these were the readings: FMP: 47.5, IPR: 84.71, SYC: 1, ICP: 0
I pulled the IPR (that was only a year old) and the screen was perfect. I had 11.5v at the plug for the IPR, and on the Ohms scale I was reading 1.8Mohms.
I went to the dealer and got a new IPR, and still no start. and the only change in the reading on the scan gauge was the ICP is now reading 56. The gauge on the dash is reading normal oil pressure, but I haven't checked actual Low-end oil pressure.
Last month I replace the HPOP, and 1 faulty injector. Now I thinking wire loom, defective new IPR from the dealership or the new HPOP has failed.
View 5 Replies
Was driving the other day and it just died and wouldn't start back up. It has fire and is getting gas. It's a 4.0 Sohc...
View 3 Replies
I was driving my 85 2.3 liter down the road and it died all of a sudden like and wont start back up. I took out a plug to check for spark and had someone turn it over and I touched it to the big metal part the grill connects to at the top but I got nothing. It IS getting gas. The spark plug was white as if it was really hot and rough-looking for its relative newness. I bought a new distributor cap because it was corroded, but it didnt work. They tested the ignition module at the store and its good, so I am thinking distributor?? Also, could compression issues keep it from sparking? I am a little worried it got over-heated somehow, but don't know....
View 9 Replies
I am working on a 96 Mazda b2300 auto 2wd for a friend. His son was driving it when a loud noise, it died and wouldn't start back up. He had it towed to my house, I started to tear into to it and found it slipped the timing belt. So a rebuilt head, gaskets, timing belt, fuel injectors, water pump, thermostat, plugs, and fluids; tried to start it and nothing. Started troubleshooting and found the primary coil pack was out of spec, replaced and still nothing.
Changed out the CKPS still nothing? I have spark, I have fuel, I'm going to check compression tomorrow but the way the cylinders and pistons looked I don't think that is the issue but I going to check anyway, rechecked the timing marks they all lined up. Checked the fuel inertia switch not tripped. Could the PCM, or ICM cause a no start, and still be able to get spark and fuel?
View 2 Replies
My 4.2L died all of a sudden, it cranks but won't start. Checked the harness side to coil packs, pos. signal but no neg. Tried a code reader keeps coming back link error. Does this mean PCM is fried?
View 4 Replies
My 331 ran good til it died driving down the road, won't start unless gas is pushed and cuts out immediately after starting, even if gas is pushed more. I know it's getting fuel cuz I can see it in my filter, brand new plugs.
View 15 Replies
My niece has a 1999 F150 with a 4.6L engine. She was driving it down the road and it died and would not start. She called her husband, he went where she was, and when he got there, it started. She drove it home, and the next day, same thing. Died going down the road, no start, let it sit overnight, cranked like a new truck. Now it has died and will not start at all. They replaced the fuel pump. Nothing. When you turn on the key, the fuel pump runs continuously. If you pour fuel in the air filter, it will start. They checked all the fuses, nothing blown. When they try to hook it up to an OBD scanner, it does not work. No codes, nothing, it won;t pick it up.
View 9 Replies
i just bought my first diesel truck, a 7.3 of course. 2002 f350 4x4 crew cab, short bed. Any ways i drove it for like 2 weeks and left it at my uncles house so he can use to go to work. then 2 days later he calls me to tell me that the truck shut off while driving just like that. he tried turning it on a couple of times and it would just crank. he gave up and had it towed. I have been looking through all power strokes forums and found some solutions like changing the CPS or the IPR.
View 14 Replies
2004 F150 FX4 5.4L. I drove from Vancouver to Edmonton and back this week and I started to get some issues. If I'm in overdrive at highway speeds, from about 90km/h to 120km/h give or take, which would be around 1600-2100rpm, and then I try to accelerate, sometimes on flats, rarely on downhills, but always on uphills, the truck will begin to jerk fore and aft. It feels like it's something through the driveline, either the driveshaft or the differential, but I really can't say for certain as I'm stuck in the driver's seat while this is happening.
If the truck downshifts or if I take it out of overdrive, i.e. getting the revs up high, the problem is no more. Other than the issue I'm having, it operates perfectly so this is very odd. I know that overdrive isn't a hill climbing gear, but normally an engine in the wrong gear will simply lug along until it's downshifted. The entire truck jerking shouldn't happen.
On my way to Edmonton, I noticed that this would cause one single, minor jerk. This is my way of describing it, but it was like the driveshaft had spun freely and then promptly re-engaged with the differential gear, causing a clunk. I doubt that's actually what happened, but I'm just trying to explain the sensation. It kind of feels like trailer jerking.
On the way back to Vancouver, it was a lot worse. Like I said, the whole truck would be jerking about once per second but there was one time that I found the sweet spot and it began jerking rapidly, twice per second. I threw it out of overdrive to stop this but the vibration caused the check engine light to flash a few times but it went away and didn't stay on.
What I might be up against? Been doing a little research. Seems as though this is common and it's supposedly the spark plugs, but those only have 50,000km on them.
View 11 Replies
So my engine light came on a few months ago. Shortly after white smoke came out of the tailpipe and it smelked like gas. Hooked the truck to a code reader and it was showing codes for spark plugs misfireing and 02 sensor. So my husband had someone change a few sparkplugs and a coil pack. They start it up after that and still doing the same thing. The guy checks the oil and says getvrid of this thing cuz your motor Is blown. Now I couldbt believe that because there was no knocking and the engine sounded fine. Anyway we get it home and leave it. A few days later we try to start it and it wont start. Then the battery starts dying out.
I take the battery to be tested and it needed to be charged but wasn't bad. So we jump the truck and it starts but won't stay running. Someone looks at it and says you have gas in your oil its your headgasket. Unwilling to accept that I have someone look at it. He gets it running and seems to burn all that gas out because eventually the oil doesn't smell of gas and the smoke was going away. So I decide its worth taking it to a shop and hope its something minor. Mechanic calls me says I know what it is. You need a fuel pump, your regulators are sticking...new fuel pump everything will be fine. My truck still won't start and its doing the same thing. If you jump it it will start then stall. They said its running so rich the gas is coming out the tailpipe. So again they know what it is the ecm. They try a used one and it doesn't take. Now I think they don't know. I tow my truck out of there. Try and jump it and nothing. No turn over.
View 10 Replies
TBC fault has been showing on my 2006 Ford F-250 for a couple of years dealer said it wasn't an issue--- check engine light has been on for months, then lost speedometer back in November. Intermittently radio and fuel gauge shut off while driving--- stared needing a boost in really cold weather for the last month.
Driving today my battery just died while driving and I had the truck towed to mechanic--- they put new battery in and ran electrical diagnostics. Saying that it might be timing chain/cam shaft OR electrical components for computer system... I'm lost and so are they and don't want to spend thousands while they diagnose the source.....
View 6 Replies
While driving uphill yesterday, my truck 6.0 f250 completely died. Added oil cause it's been a while and tried starter fluid. Cranks but won't start. Pulled OBD codes p0300, p0304, p0401, p0460, p0562, p0606, and p2290. Checked IPR, works fine. Checked fuses. Low voltage codes are most likely from battery dying during the test.
View 2 Replies
I have a 06 f350 with 140,000mile and today I was driving to a buddy's house and the truck died on me as I was doing 45mph so I towed it home and check the codes I have 1 low icp pressure and 1 low icp during starting / cranking and 1 ckp out of range I think that how it's worded so I looked at the icp pressure and it's 0 and the desired is around 1000 and the volt is .56 and as far as the ckp the rpm are reading so I don't know what to do about that ? Could the STC fitting and dummy plug and standpipe o rings really go out on me like this ? Or am I missing something? I am also trying to track down a oil pressure gauge for the Icp fitting to check it
View 9 Replies
I have a 07 6.0 that won't start it died a few weeks ago while driving. Being a mechanic I've done numerous things to the truck in order to fix all the common 6.0 problems but can't figure this one out. It will crank and get oil pressure and fuel pressure but seems to not be getting fuel. The IPR valve isn't clogged I tried with 2 working valves nothing worked. Along with changing the ficm. The connections to the ficm are clean and all in tact. I have an edge evolution chip that isn't even showing any codes. Not sure what to try next since I don't have any codes to go off of.
View 11 Replies
UK 2.2 Diesel
Problem for about 3 years. Always starts in neutral, rarely starts in park.
Any possible cause. Maybe a micro switch or a cable adjustment.
View 8 Replies
We have a 2004 Ford F250 gas pick up. Went out this morning to start to let it warm up it started and ran for about 10 seconds then died. Almost sounded like a shot going off when it died. Now it is completely dead no lights, no chiming when you put the key in the ignition no nothing. I have tried to jump start it and obviously that didn't work. I also checked the fuses and didn't see anything blown.
View 3 Replies
Driving to work my trucks radio turned off.. My abs light came on.. A screeching sound from front hubs.. Then I stopped abs light went off hubs locked.. Air bag light came on.. I hit the power button on radio it displayed low battery.. All interior options were off. Outside lights dim .. When I got to work I shut it off and tried to restart... Acted like battery was dead.. It's a 3 week old battery. I also noticed , it seemed like I could not turn off my head lights.. Switch did not seem to make any difference with lights. After being off for a mon. The lights got a little brighter. Is it just the alternator? I got no low battery or dummy light. It did have a mildly sluggish start.
View 5 Replies
I have a 2004 Accent. When driving on the interstate yesterday, I turned the turn signal on and my car died for a moment. After I parked it, it would not start. It did not turn over. Took the battery out to get checked. It was good. Put back in and then the car started. Drove home. The radio and clock would flicker intermittently but made it home. Today it will not start at all. Nothing comes on.
View 14 Replies
