I have a 94 Cobra Mustang with a 5.0. For the past few months it has had an erratic Idle and stalls when trying to idle. I've had a number of suggestions on how to fix it and nothings seems to work. I checked for vacuum leaks, changed PCV, new plugs, new IAC valve, tested ICM and throttle TPS and even adjusted idle. Still no luck.
View 3 Replies94 Ford Ranger 2.3L
I started to have a slightly rough idle a while back, but not severe. I figured she was just aging a bit.
Changed plugs. Check engine light came on. Changed plug wires. Then I had a couple of episodes where it started to lose power and idle really rough (stalling). Both times it stopped after a few minutes. Had code read- they said it was coils. Replaced ignition coils. Check engine light still on, but it went a few weeks without power loss.
Tonight the loss of power returned and didn't leave, and I had a glowing red catalytic converter after I limped home 20 miles (hope I didn't do any serious damage, I was stranded.)
Found this post : [URL] .... But there's no resolution.
So, I'm probably dealing with a misfire, and I'm sure I torched my cat after tonight. So any other easy diagnose/fixes for a misfire? I'm a shade tree mechanic- so I know just enough to get myself in trouble. If I can't get a resolution soon it will be off to the mechanic (which, maybe I should have done 1st...)
My 1994 mercedes C220 stalls at idle. the local mercedes dealer told me that it is caused by the alternator overcharging. can this be true??
View 2 RepliesMy 1994 volvo 240 stalls at idle when the engine is warm. It's happening more frequently as the weather gets colder, I'm not sure if that's a coincidence. The car is an automatic and I'm wondering if it could be something as simple as low transmission fluid.
View 1 RepliesI've had this 01 7.3 for a few months now. When I first purchased I dropped new battery's, couple glow plugs, and wire harness going to the Pass side valve cover. it has 150k on it and an Edge tunner.
My first problem was about 2 weeks ago, it was raining and i was making a turn at about 5mph And all power shut off. I put it into park cranked 3times started up and the tuner stayed off for about 3minutes. I ran to auto zone and picked up a cps (I've recently found that oem is the only way to go?)
I made a trip about 2hrs locked the CC in about 70mph and the boost was going well over 12psi. this seems crazy because i usually dont get it over 4psi. I drive it with a light foot. on my way home i was pulling a trailer about 8000lbs load driving about 5mph out of the lot it shut off again. Started right back up and made the trip home fine. With the exception of the erratic boost.
Yesterday it shut off at about 40mph and turned back on its own. I am not throwing out a lot smoke doesn't have problems starting, I did a once over on the wire harness's and nothings jumping out to me.
I have a 2001 Ford Mustang, V6, 3.8 Liters, automatic transmission, 120,000 miles. Recently, my car has started to stall/misfire at when I come to a full stop at a red light. It feels like the car is going to shut down and like it has no power. I have to press the gas really hard to get it to pick up power and speed. It doesn't happen every time and I've noticed that it happens less early in the morning or at night, and it happens more often during the day when it is really hot (I live in Az and temperatures are currently in the 100sF).
The "service engine" light is not turning on. The battery was checked and it's fine (recently replaced in September 2011). The alternator was changed 1 month ago. The cooling fan was replaced 1 month ago. I took it the the Ford agency and no codes are turning up and they can't seem to duplicate the problem even though the ran the car for 15 miles. They checked coils, spark plugs, fuel injectors, fuel filter, gas pump pressure, and it all seems fine. They advised that I fill up my gas tank with Premium gas and add fuel injector cleaning fluid. I did and the problem is still there. They then advised to fill up gas tank again with Premium and add Techrnon additive. I did and the problem is still there.
I am scared that my car will stall and turn off while doing a left turn with oncoming traffic or in the freeway.
My 1990 mustang 5.0 LX has a very consistent stalling problem when travelling long distance on the highway at a good speed. After 2 hours of driving highway speeds and then pulling off the highway, the car stalls after I brake or stop at a light. I don't know why this seems braking related, but not sure. I then sit and crank the motor and it cranks for a bit and starts right up. I think it's fuel, but now sure yet.
Here's what I have done:1. Tune-up: plugs, wires, cap, rotor2. new fuel pressure regulator3. new fuel filter4. new fuel cap5. Checked for vacuum leaks (none found)
It seems to not happen when the gas tank is low, but I can't swear to it.
I'm going to run a fuel pressure gauge to the futhel rail and see if I can catch the drop off of fuel pressure when it occurs. Also, I noticed that the gas cap does not hiss when I unscrew it at any point in time.
Here is a YouTube video showing my erratic RPMs while idling in park, then pressing and releasing the brakes and gas to show what happens each time: [URL] ....
I just bought a 99 Explorer Sport. The history I know is that the truck has 200k+ miles on it, with the engine replaced. Replacement engine has 90k on it.
Was told the fuel pump, and serpentine belt (I think, he said "main belt") were replaced in the last few months.
The car was driving fine on the test drive and for the first few days of owning it. Then a clicking sound started form under the hood while driving.
I first noted the clicking while at a red light, and when I accelerated it stopped. Over the last week it has increased in frequency every day and now is almost constant.
This evening I was coming to a stop with my foot off the gas and when I hit the brakes the RPM went up, and car lurched forward before stopping gently. This kept happening so I drove home and took the above video. Video taken shows the RPMs jumping up when in park and going form idle to idle with brake depressed. when I rev the gas and let go, the RPMs fall, hang for a couple seconds, and then fall back to ~1000. The captions are very accurate, they show exactly when the brake or gas was pressed and when they were let go.
My obvious question would be WHAT IS CAUSING THIS? Also, ARE THE CLICKING AND THE RPMs RELATED? Finally, SHOULD I AVOID DRIVING IT? I need to drive it a few times through the next few days and I can't really avoid it unless it will mean serious damage.
I have an 01 f150 4.6 4x4 automatic with 90,000 miles. I have an erratic idle but it only happens when I am on the freeway well actually when I get off the freeway and stop. the idle will fluctuate between 750and then drop to 400 then back and forth til I get moving again. I replaced the IACV because it was doing the weird humming and vibrating the intake tube. The humming is gone but still idles funny as stated above.
View 4 RepliesMy wifes 2008 Eddie Bauer Explorer V-6 recently started having an erratic idle and we've started noticing it while at higher RPM's. Its almost as if there is a cylinder that misfires but no engine light is coming on. The car stumbles like it is going to start to die, then the idle jumps up and smooths out. A little while later it does the same thing. The car has I think 74,000 miles on it and has never had the plugs or wires changed. I change out the fuel filter roughly every 24,000 miles and did it recently in the spring. Any places where I should start looking? Could a misfire not trigger the check engine light?
View 3 Replies97 shortie. 3.0 245,000 miles. I've already cleaned the throttle body and the idle air control valve. Throttle position sensor reads 5 volts, good ground, and a smooth voltage increase from idle to wide open throttle and back down. Which of these codes is most likely to cause erratic idle? Mostly in the morning.
P0340 Camshaft position sensor.
P1443 Evaporative purge flow sensor.
P0401 Insufficient EGR flow.
P0171 Air/fuel ratio is too lean or rich for PCM to correct.
I doubt it's number 1, and number 4 seems too general to be any use. I'm leaning toward number 3. Seems I read somewhere that the tube from the exhaust gets plugged up. This started when I disconnected a plug from the blue air bag box to get rid of that beeping. Coincidence?
I've had the fuel injectors cleaned and fuel filter changed.I notice it when im at a stop light, dont know if it does it in Park. Iv been told if it was the spark plugs or wires that the check engine light would turn on, and its not on. What should I check next????
View 7 RepliesI tugged on the little hose on the back pass. side of the engine,(5.4),...
and I could hear the vacuum leak that is apparently causing the erratic idle, and PO171 & PO174 to come up.
I know this hose is hooked to the Charge motion Control Valve on the back of the manifold,..I can't imagine what it does, as it terminates with some kind of plug or check valve??? Haynes say's to remove the entire manifold to get to the CMCV.
I can see it with a mirror,. I am thinking maybe long needle nose from Harbor freight,...bend the tip short,..maybe be able to change it out?????
I've read quite a bit in various threads about the large vacuum elbow collapsing, causing erratic idle speeds. My 2001 3.0 had that issue int he past. I shoved a 1/2" copper 45 degree elbow inside of the rubber elbow, and the problem was solved... until a few days ago.
We're now getting into the hot part of summer here. I've notice the same symptoms are beginning to return, once the engine compartment gets hot. My question is... is the large vacuum line a "hard line" all the rest of the way to the engine, or are there other places along it's length that can also collapse under vacuum?
Its a 1994 with 4.0, automatic, 4x4. Running fine, parked it, a week later I'm getting a bad but sporadic miss that according to the stealership is the 3 cylinders on the right bank dropping in and out. Driving down the road you can feel them drop out and when they come back its a kick in the pants like a turbo kicked in.
Shop says wires are good, plugs are good, and then lost me when they started talking around in circles and not making much sense.
What could make 3 cylinders all on the same side of the engine drop in and out? This wasn't anything that slowly came on. Fine one day, crap the next. The only thing I did prior to was replace the IAC because it was idling high, it was cruddy inside, and it looked like it was original. It was running fine after that till this issue popped up out of nowhere.
Mileage was claimed to be 178k but I'm beginning to suspect it's probably 278k.
I've been having problems with hesitation and a flutter at cruising speeds as well as erratic idle. I have a 2000 F-250 SD with 497K Miles. I was having poor starts during florida winter ( had to plug in a couple times) Had no oil coming out of #2 inject and #8 buzz was weak. Flutter was there and was the original reason I started digging. Right now the only code Im throwing with my chip turned off is a P0470. I cleaned the tube and the sensor but its still throwing.
I have recently replaced all Injectors, Glow Plugs, Valve Cover Gaskets & Harnesses, CPS, Fuel Pump, ICP was replaced before new plug no oil showing.
Mods: 6637 Air Cleaner, TS-6 Chip
Truck has mad power now no problem starting. Its really starting to frustrate me Ford dealer wont troubleshoot unless I remove the chip. I feel like it should be something simple because on the throttle it will set you back in your seat cruising at 70+ no flutter ..... but slow down to 50 55 in traffic and let off the throttle when you start to ease back into it 1500 - 1800 "buck buck buck" if I monitor ICP pressure I see a fluctuation in psi of about 200 -300 psi (1400 to 1200 or 1000 to 800) . If I throttle harder it will stop or let off the throttle. I can feel it do it sometimes before the TC locks so I dont think its a TC issue. I even tested with OD off and I can recreate. The magic area appears to be 1500 - 2000 rpm....
A while back my 05' f350 6.0 was having rough starts and an erratic idle. It died coming up to a stop sign it started back up after 2 cranks and then it did that same on the way home. The next day leaving work it wouldn't start. I knew i had a couple injectors on the way out so i decided it was time to replace all 8 upon tearing it down i noticed my oil cooler was leaking so i figured it was time to rebuild that and finally do the egr delete that i had been wanting to do. well i put it all back together and got a no start.
The dash gauge on my oil pressure is reading normal when i cranked it so i went and bought a scangauge2 to read the icp its hitting 1500psi when i crank it. The ipr% is reading good. But my ficm main power is at 26v with the key on then it drop to 14v while cranking and eventually down to about 9v. Its never at the 48v that its suppose to be at. The scan gauge is also showing that my ficm sync=0. Would the sync be showing 0 since the ficm is bad? My batteries are fully charged and i have both of them on the charger while I am cranking it.
When my 1998 Mustang has been stopped and started numerous times in a short period--say, like when you're running errands--the idle will sometimes (not always!) get really low (below 1000 RPM), and will stall out no matter how much gas you give it. It will then refuse to start for about 30 minutes. Then it'll start back up and run fine for another week until the whole thing happens again. The car runs fine in all other respects, and again, it's seemingly random, and only after the engine has been stopped and started several times. It won't for example, stall out first thing in the morning.
View 2 RepliesAt my wits end with a Tiguan problem that my dealership seems to be clueless ....
View 3 RepliesMy trucks symptoms include a illuminated service engine soon light, sometimes a high rpm idle, and sometimes a rough erratic idle. When a scan was done it indicated the oxygen sensor was defective. The issue is: which specific one (there are multiple oxygen sensors) or how could I check or determine the faulty one for sure. I am trying to economize and replace only the bad one myself if possible. I own a good multimeter, can it determine the bad one? 1999 F-150 4.2 Litre V6 oxygen sensor dillemna....
View 7 RepliesI have a 2003 Ford Musang 3.8L v6 when I start my car for the first time of the day or after several hours of sitting the car idles high between 1000-1300 RPMs for approximately 15-20 seconds after that it idles down to 600-800 rpms. I changed the spark plugs wires air filter not sure what else it could be no Check engine light.
View 1 Replies