Ford Super Duty (1999-2016) :: 2002 - Batteries / Cables And Starter All Good - Truck Barely Turns Over?
Aug 2, 2015
On my 2002 7.3 liter for the last about 1 week it has been getting harder and harder to start. Up until yesterday when it will not start at all. What it does is this. A week ago I noticed it cranked slightly weaker but still ran perfect once started. This has progressed slowly but definitely. It has never gotten better, only worse. Even with jumper cables hooked up it does not improve at all. The starter is a Carquest POS but only has 50 thousand miles on it.
I have driven hundreds of miles with this problem in the last week and the truck has never skipped a beat aside from the starting issue. I took the batteries in to no less than 3 places and they all said the batteries are good. However when I put my multimeter on them when it is being cranked the volts drop from 12.6is down to about 8 volts. When I did get it started the other day and put a meter on it the batteries were charging up to around 13.7 or so.
When there is no load on batteries they show good but have been unable to get a solid answer if any of these places are load testing them: I am convinced they are not. I checked the resistance of the cables and they all have none. The grounds are all good. So I pulled the starter and took it in as a last result. They say the starter is good also! The connections were all tight and I cleaned them all very well.
View 5 Replies
Advertisement
I have a 96 f350 that I just replaced the batteries on and now when I go to start it does not hardly turn over. Starter just barely turns motor over and definitely not fast enough to start truck. Battery connections are tight and starter was replaced about 4 months ago.
View 4 Replies
I drive a 2002 F-250 7.3l and have been having a lot of issues. The most recent one is that my truck won't crank unless I've had the block heater plugged in. Like I said in the title, the batteries are supposedly fine. They've been tested by a mechanic and Advanced Auto Parts. But when I crank the truck, it will only turn over for 10 seconds or so before it loses enough juice to even turn over. So it's kind of cold, but only 40-50 degrees, so I didn't think the truck would have that much of a problem starting. I'm wondering if my issues are a combination of an electrical problem and a heating issue.
View 8 Replies
Got 01 F350, 7.3
Started having issues with starter bogging down my batteries. Slow crank, it would catch anyway and runs great. I have spare used starter in the garage, threw that on and it cranks fast, but occasionally just free spins half way thru the cranking.
My question is, can I make one good starter from these two? Monday AM buyer is coming to get my truck, and I don't want to have to buy brand new starter if I can avoid it, but I want him to have reliable used starter.
What causes free spinning (not flex plate related), and what causes power drag and slow crank? I was thinking throw solenoid from fast starter onto slow one, since slow one doesn't spin out but it bogs down my voltage?
View 1 Replies
I have a 6.0L diesel that is not a daily driver so it sits for days and even weeks at a time. When I go to start it the batteries will be run down to the point that sometimes the truck will not start and I will need to charge the batteries. I was thinking about installing a battery tender and leaving it plugged in so the batteries will stay charged. I'm looking at the tender in the link.
View 14 Replies
My truck ran and drove then I changed my Steering Gearbox. After all that, I went to go start it, the trucked cranked and the batteries died. Hooked up the charger then and nothing, No start no crank. F250 2006 diesel 6.0 ...
View 14 Replies
The batteries keep dying. I can charge the batteries and drive it to work a couple of days and by the fourth day, it's dead again. Have replaced alternator, batteries, and starter and I am still having issues. Just noticed this weekend, the instrument cluster going off, coming back on, shutting off again all while the truck had been running for about an hour. I'm not sure if it is because the battery was dying or what. As soon as we got home after the instrument cluster incident, turned the truck off and tried to start it. The battery was completely dead.
I have been looking up on sites and I keep coming across the GEM Module. I want to ask around before I buy it. I have also noticed small issues with my 2000 Excursion. Back windshield wiper starts up upon the vehicle starting. Goes a few times and stops. Not sure if this is the same type of issue as in the GEM Module.
2002 Ford F350 7.3l Diesel with 148000 miles
View 4 Replies
Dealing with a 02 f350 7.3 powerstroke . The engine cranks fine . It fires but won't start smoke coming from exhaust while cranking and firing so seems to have good fuel . When it does start it misses for a few minutes and blue/white smoke . When the miss ends so does the smoke and starts fine after that and runs great until it sits for 12 or more hrs . Then back to same start issues . Fresh oil ,new glow plugs, new cover gaskets , glow plugs test at 1.3 ohm across all 8 of them , no voltage drop through glow plug relay , good voltage to each glow plug when tested right at glow plug terminal on each feed right at glow plug , fuel filter housing stays full doesn't seem to bleed back , high pressure oil pump pressure test was high enough to trash a 1000 lbs gauge in 2 to 3 revalutions of engine when cranking . Tested at presure sensor port .
View 2 Replies
I pulled the battery cables this weekend to install a flatbed on my 02 f350, I did do some welding on the frame of the flatbed during install and the bed was in contact with the truck frame which is why i removed the batt cables in the first place, now after my project is finished i have reconnected batts only to have my gauges bounce around and an audible clicking under the hood when I try to start, gauges bounce back and forth several times, odometer comes on slowly.
2002 f350 7.3 diesel 4x4 auto
View 14 Replies
I have a 2002 f-250 7.3 diesel, i straight piped it but only by cutting muffler off and welding a piece of pipe in its place, it is pretty loud but id like to hear the turbo more like more of a whistle, it has a pretty good whistle once i get past 1500 rpm, is there a slightly bigger turbo i could put on without putting too much strain on the 180,000 mile engine?
View 6 Replies
Last night I was watching tv when my truck tried to start I thought I hit the remote start on my keys but it didn't start which I found weird. I went down stairs too see if it did anything else and it did it again it would turn over and turn over but never fire all while the keys are in my hand. At the same time the done light was stuck on and the radio went on and off. I'm pretty sure that my GEM got wet through the windshield, also Is the GEM dead or can it dry out and be ok
View 12 Replies
Truck was running fine up until now. After the WTS light goes out, I crank it and.... nothing. It doesn't even try. It's not a battery problem. I have 12.6 V from each battery before and after cranking. The lights are bright, the horn works, the dash lights are strong and bright all both before and after cranking. It just doesn't want to engage the starter. I tried my backup key as well, thinking it might be a problem with the PATS. No dice. Where to start looking?
View 6 Replies
I have a 2004 to 250 super duty 5.4 and automatic trans it has about 233,000 miles on it. Yesterday when I started my truck I could see my reverse lights were stuck on against the garage door in the dark. After I put the truck in drive the lights went out later on I shift at the truck and to park and the starter engaged I put the truck in neutral and it stopped the starter from running after doing that several times the truck now does it even when it's in reverse or neutral. I have to leave it in drive and push the emergency brake on I am in and out of the truck all day long. I did change the shift to blast may I check the screws on the back of the shift to bury thing seems fine.
View 1 Replies
I have a 2010 F250 V10 4x4. about every 3-4 times when you start the truck....it seems as though the starter "sticks". If I catch it and shut it off and then turn the key right back it fires up and does not stick. Its as if the gear is staying kicked out into the flywheel. Are we thinking the starter itself? I'm thinking starter...but looking for input before I crawl under it.
View 1 Replies
I recently bought a 2003 f350 7.3, I ordered a tuner for it and tried installing it, at one point while the ECM was still connected I did something and it sparked. Then the powertrain relay (302) started clicking really fast. It clicked in the on position. I switched it with another and it was also clicking. So since I sparke the ECM I figured I messed it up. I ordered another one and it's doing the same thing. Then I pulled fuse 45 (which was good) and put it back in. When I turned truck to on position it wouldn't click anymore, but it still won't start... What it could be? OV ruled out the ECM, powertrain relay (302) and fuse 45, I don't know what else to check.
View 2 Replies
At center, my truck is able to turn 2 1/2 revolutions to the right and only 1 1/4 turns to the left. Making sharp left turns is not possible currently. What needs to be adjusted in order to get the steering centered and even?
View 4 Replies
I have a 02 F250 Super Duty XLT with a triton V8 with a automatic transmission . and when I shift into reverse after driving for a while the starter engages . It does not happen all the time . If i start up the truck and shift through or into reverse it doesn't happen . the only time it happens is when i've been driving for awhile and want to back up or park it will only do it once or twice after each drive so trying to get it to happen while in the shop is almost impossible . could this be caused by the transmission range sensor . I just had the code P0705 (transmission range sensor , A circuit input ) come on but the problem has been happening for a few weeks before that code came up .
View 6 Replies
2000 F 350 super cab 4wd 7,3 auto srw long bed. Problems with emergency/parking. My cable probably needs replacing. My pedal will go to floor when setting the e brake. I use very infrequently, but when loading hay on the big bale trailer. I could ignore it but when hit the slightest bump the brake pedal goes down just enough to activate the brake light on the dash and activates the bell/chime until I raise the brake pedal up.
When searching this site one post stated that should not happen. I am trying to figure out if I need to replace the front cable, intermediate cable, and rear cables. And do I need to replace the foot pedal assembly as well. What are the part numbers for these. I generally order from who ever took over Edpartguys for original ford parts. I have new cryo rotors and Hawke brake pads.
View 14 Replies
2002 F450 7.3 Turbo
Ok first problem : Starter Motor fuse kept blowing and I spent weeks trying to figure it out. No luck. so wired up a push button just to get the truck started, its a work truck so it was needed asap.
2nd problem : he truck stopped starting completely. Wont start in Park or neutral and after a NEW STARTER (because I thought the solenoid on the starter was bad I replaced it) Everything work correctly for one start with the key. After the second time trying to start it blew the starter fuse again. So I tried the straight wiring to starter. still nothing. I was wondering if there are any shims or anything at the transmission housing to correctly position the starter. I am thinking that maybe the gear is stuck or gets stuck sometimes. when I straight wire the starter it does nothing but the wire gets hot so I know its pulling.
View 3 Replies
I have a 2002 F-350, 7.3 that is not charging. It has no power coming in on the big supply lead on the back of the alt. I traced the cable back, and it goes to intake heater solenoid. Cable is good, but intake and glow plug solenoids both have no power coming to them. I am guessing there is an open circuit between solenoids and starter. My question is, does the power come right from the starter, and is there circuit protection in there someplace?
View 2 Replies
My truck seems to shudder between 40 and 60 mph when it's in OD. If I turn off OD it seems to go away with the increased rpm's. Although I can't be sure if it genuinely disappears or if I just don't notice since I'm at 2100 rpms instead of 1500. Trans fluid is clean. Is this a common problem in these trucks? Just filled up from flat E the same day air temps about 4 deg. Truck was fully warmed up. Does this sound ignition related, tranny or fuel related?
View 14 Replies
