Ford Super Duty (1999-2016) :: 2004 F350 - Tow Haul Mode Pop On And Off When Shifted From Drive To Reverse
Jan 23, 2012
One of our trucks, 2004 F350 Powerstroke, my company truck, recently the last snow even we had, my tow haul mode would pop on and off almost evertime I shifted from drive to reverse while plowing. I didn't want it on, it just kept poping on and off. Thought maybe the button was stuck, but it moved like normal. My other thought was there is a loose connection in the shifter or column causing it to go on and off.
View 6 Replies
Advertisement
This maybe a dumb question. But when do you use this feature? How many pounds should I start using the tow mode? I dont haul much. I just haul a 4place trailer with 4wheelers. And in the bed another 4 wheeler or camp gear. All the 4wheelers weigh over 650lbs wet and the trailer not too sure but its steel.
My truck doesnt have a hard time hauling, it shifts fine. Feels like its not even hauling anything. I did use to tow mode once but it seem it just keeps the rpm higher and I felt that the highter rpm was not needed when I was hauling.
View 14 Replies
I have a 2009 F350 and use it almost exclusively for towing. Every time I stop to fill up or eat or whatever I have to push the tow haul button again when I start the truck- no big deal really just annoying at times because I don't always remember to turn it back on. Is there a way to have it turn on with the button and not turn off until I push it again (even after the trucks been turned off)? I suppose while we're on the subject same with the heated seats?
View 12 Replies
I have just bought a 2004 F-250 SuperDuty 6.0 Diesel with 98k miles from a Ford dealer (no warantee)...
Just after I drove it home I noticed the Tow/Haul mode switch was not working - no dashboard light and no transmission downshifting.
The dealer took the truck back in and kept it for 2 days, it came back working, they claimed to have replaced the gear shift lever. 500 miles later and the Tow Haul has failed again.
View 14 Replies
New 2016 - 6.7 automatic with exhaust brake:
In tow haul mode is the exhaust brake automatically activated or do you still have to turn on by button? Getting mixed answers, and seems to me that it does not activate unless you push the button which is seems to be what the literature is saying.
On steep downhill pulling heavy trailer, in tow haul mode every time you hit the brake it downshifts, and isn't long before it will over rev, unless you kick it out of tow haul mode. is there a way to hold it in a gear in tow haul mode? Or should I shift into manual mode at the top of the hill then use the +/- buttons.
View 5 Replies
My 05 SD started to flash tow haul mode and check gauges message came on while I was towing my car hauler trans temp gauge quit working then check engine light came on too truck runs fine disconnected batteries then re connect them ( trailer now disconnected) problem solved for about 3 mi of driving then it came back w/o trailer I'm thinking rusty trailer ball on hitch caused this maybe not a good ground for trailer tow computer? What kind of scanner etc do I need to possibly clear this problem out? I am the original owner never seen this happen with this or any other trailer I've towed.
View 3 Replies
I have a 2006 6.0. It's hard to put into to drive and for you to get it moving you have to just about floor it. The tow haul light is flashing but my bullydog won't pull the codes. It stops moving after like 30 to 40 ft after you got it moving and acts like it's in natural. If you turn it off and back on it sometimes will move another 30 to 40 ft sometimes. It also sometimes if you put it in reverse won't let you give it gas. Like you can push the pedal but the rpms won't climb for this reason I'm thinking something to with a solenoid or fuse or something along those lines and also because if you restart it will move again. I don't know much about transmission. I'm taking it to a shop tomorrow for them to try and read the codes. If they say the transmission is toast i already located another one 2 hours away to swap in which I'll do myself to avoid the high cost of the shop which also I'll look to yall for guidance. I drained some of the transmission fluid and didn't see any metal flakes. Should I pull the pan as well and look if nothing is coming out in the trans fluid ?
View 4 Replies
I have a 2006 F250 Lariat super Duty / 6.0 L engine / 143000+ miles / once started and transmission shifted into drive it takes 5 seconds or more for it to engage hard or if I build up the RMS then it jumps into gear hard, after it gets going it feels like I am driving on a washboard until it get warmed up good 10 mile or so. Is it the transmission filter and if so which one, I understand there is a small one on the outside of the transmission if so where? I can't find it.
View 14 Replies
I have a tow haul problem with my 2008 F350 6.4L. It will not go into tow haul unless I tilt steering wheel up all the way and than slam it down and than it will engage. Than when I want to take it out, I have to shut off truck. Any wiring diagram and info on how to get at the wiring. Do I have to disarm Air Bag and pull Steering wheel?
View 13 Replies
I have a 2006 F350 SRW 4WD 6.0 with 127000 miles on it. A couple of weeks ago it, pulling out of my driveway, it hesitated and tow haul started flashing. I had codes pulled and it showed P1780, P0751, and P2700. After turning off, codes were gone and tow haul off. Ran fine since then every day. Yesterday while going about 50 mph it started acting like it was in neutral (revving up), nothing happened when mashing the accelerator. Coasted to a driveway and truck would not move, only sounded like it was in neutral.
View 1 Replies
I have a 2004 F350 Crew Cab DRW 4WD 6.0L.
The front drive shaft is making a high pitched metallic squeal while the truck is in motion. I thought it might be the universal joints but after lubricating the joints, I can still hear the squeal and it sounds like it is coming from inside the drive shaft. I also hear this squeal when I spin the drive shaft by hand.
I have quite a few questions about these drive shafts:
- What would cause a squeal from within the drive shaft?
- Are there any replaceable parts or do I have to get a new drive shaft?
- How do I identify the correct drive shaft part for my truck? Seems like there are a LOT of different models on the web.
- Are any of the aftermarket drive shafts any good? Any to avoid?
- Is this a DIY job or will I need to take it in to the shop?
View 3 Replies
Ive got a 04 f350 that after u shift into 4hi or 4lo when u accelerate it it makes loud clunk noise in fwd or reverse hi or lo. With hubs unlocked it still clunks. Have checked, wheel bearings, axle U-joints, and driveshaft joints all good. So I am thinking I've got issues in t-case. Popped drain plug out and wow that dex merc 4 looks nasty. So thinking I need exploded view of transfer case.
View 4 Replies
So I was driving my 2004 6.0 auto on the freeway today when the tow haul light randomly started flashing, nothing felt wrong until I stopped, then when I went to pull away it wouldn't shift down from 5th according to my livewire ts says under the commanded gear gauge. It shifts into 6 and overdrive fine. I turned the truck off, the light went off but as soon as I put it in drive it jumped around from 1-2-5 and back down until it locked in 5 again and the light started flashing again. What this could be?
View 1 Replies
2011 F350 loaded. Stuck on vent mode. Found actuator can feel it trying to move but something is stuck. Tried to remove the actuator but not enough room between the motor and a steel bracket welded in to the dash. (Not removable). Do I have to remove the dash ? (I suspect something fell inside and is stopping the big vent door from moving as i did pull the motor far enough away to move all the door except the vent door.
View 2 Replies
I just picked up a 2003 F350 4X4 5.4L it has 130k on it. It drives ok, it doesn't seem to be able to accelerate very quickly and one thing I noticed is when i go into reverse it seems to stutter or feels like it scoots a little bit.
View 14 Replies
Last Oct. I noticed that my ac/heater started to intermittently stop blowing from AC fresh air/recir/vent/etc. mode and stick to defrost only. Do I have a bad switch and or a vacuum issue here? It's a '01 F350 CC 7.3 .....
View 6 Replies
Today I noticed that our 5R110 was delaying slightly when shifting from drive to reverse. It was probably about a 1-2 second delay but it replicated itself twice in a row. There was no delay going from reverse to drive. It is just an engagement delay. We are running a Superchips Heavy Tow tune on the truck, it is a 2006 6.0 Powerstroke.
View 4 Replies
I'm getting a really choppy low RPM drive. If I'm above 2-2.5k rpm it runs okay but as soon as it drops under 2.5k it starts to run very choppy and loses power and Boggs in and out of power regardless of how much throttle input I give it. I had a tune up done last year and a recent oil change...
View 1 Replies
Here's what I have 2000 F350 XLT 105000 miles and a 4R100 tranny, was coming home from work no issues, stopped at my mailbox to retrieve mail.
when applying brake, it lunged forward a bit and stalled, I started back up put in drive, stalled again. started back up put in reverse, no issues.
I put in neutral revved it somewhat and it moved forward enough to start the roll down the small slope at my drive, I then started in neutral again as was rolling and then put into drive and drove 1/2 mile down my lane to house. backed up in my parking spot, no problems then shifted to drive and stalled.
Today I dropped the pan and checked the filter as I have read that sometimes they will fall out and cause same symptoms, filter was where it was supposed to be, no easy cure here.
View 1 Replies
I have a 2001 F350 7.3 4WD that does not want to shift into drive. When you shift to drive you can feel a slight difference in the trans but it will not move, it will rev freely but not move. If I shift it up and down it will engage after a lag period ranging from 10-15 seconds up to several minutes. Reverse is ok and after forward engages it appears to work as it should, shifts ok through the gears. I don't have much experience working on automatics.
View 4 Replies
I have a 2004 F250 Torqshift trans, 155,000 miles. It has had a slight hesitation when trans is engaged for about 4 years, not a problem the dealer has no fix they said.
Now today for the first time I had a tow haul light come on while driving on the freeway. It would not go into overdrive and the light keep blinking. Later in the day, I let it cool down and it drove fine to the store about 2 miles. When I got in to drive home it had tow haul light go blinking and check engine light came on this time.
I hooked up my code reader and it's giving codes: P0720, P0751 and P0766.
Should I take it to the Ford dealer, a Transmission shop or have a friend who worked at Ford Dealer do the Work? I see that some people have changed out the TFT sensor and corrected the problem. While the pan is down should I just have all the shift solenoid sensors changed?
View 11 Replies
