Ford Super Duty (1999-2016) :: 2005 F350 - Low / Tow Overdrive Light Blinking - Number 8 Cylinder Misfiring
Nov 21, 2014
I have been having some inconsistency with my transmission in my 2005 F350. I bought it used 2 months ago and have had the low/tow overdrive light blinking. a month ago I removed the pan and changed the filter in the transmission. I had a friend run the diagnostic test and found transmission solenoid code as well as both cat. converters as well as my Number 8 cylinder misfiring... I pulled the transmission pan and filter to find what appears to be 7 solenoids? Where to start?
View 1 Replies
Advertisement
The problems that I am having at the moment are that the abs light is on from the speedometer, odometer, also the blinking overdrive light that comes on at around 25 mph. After some research I had purchased a ford factory sensor for the rear dif. I then replaced the old sensor with the factory one. Started the truck and not a single thing had changed, both the meters were not working as well as the od light was still flashing.
View 4 Replies
I have a '99 F250 SuperDuty Diesel with an Automatic Transmission. There is a button on the end of the gear shift which allows you to turn off overdrive -- in other words the transmission won't shift into overdrive once you press the button.
Here's my problem. I start off driving normally. I've not done nothing to the overdrive button and the truck shifts normally into overdrive. 10-15 minutes down the road, the overdrive light (which indicates the state of the overdrive button) is FLASHING. Pressing the button doesn't stop the flashing. Once this flashing starts, the only thing I notice is a much more abrupt shift from 1 -> 2 gear.
View 14 Replies
My dad gave his 2005 Ford F-350 truck with the gas 5.4L (?) I drove it home. If i floor it it misfires badly, or if the RPM's get over 3000 it misfires then about 3800 it stops and keeps going. but i can't give it to much gas....
The spark plugs where replaced 2 years ago along with the cat converters. I can hear some very fait manifold gasket leak ...
A few days ago it was raining and it had a bad misfire with blinking CEL. but it never threw a solid CLE. can i still put the codes on it to see what cylinder it is? Are these issue related? Where should i start?
View 8 Replies
I have an '01 F350 super duty dually, 7.3L, auto trans. Over the past weeks my overdrive light on the gearshift would flash intermittently, maybe once every couple weeks. I chalked it up to a prior theft attempt where the steering column was damaged, and had turn signal/hazards issues after that.
Over the past few days my reverse gear has taken longer to engage, and is hard getting into the higher gears at speed. As of yesterday, reverse is out and won't shift out of second. Fluid level is good and clear. Could this be a PCM issue, or some sensor or relay?
View 1 Replies
I currently am driving a 2001 F-350 V10 SuperDuty, and recently the battery light was blinking. I replaced the alternator in it, but it didn't work. I thought it was bad so I went and got another and it still didn't work. Turned out that the alternator wasn't big enough. I then went BACK and got a larger alternator, and it still won't work. Now the battery light is solid, and I'm getting absolutely no charge out of the alternator. I checked all the fuses and nothing is wrong. It seems like all the things you think could be wrong are running perfectly fine! What could be wrong. The truck will start, and idle, but will run off the battery only.
View 14 Replies
My buddy has a 2002 F350 CC Longbed with a 7.3. Last night the overdrive light started blinking. He said he drove it today and it takes about a mile or so for the light to come on but then it is a steady blinking. Truck has about 254K miles on it. He said other than the blinking light everything seems normal. How to figure out what this issue may be?
I got AE hooked up on his rig.
When I pull (ALL) codes this is what I get:
When I pull (Current) codes I get this:
I tried to clear the code and the light stopped blinking, but he said it started blinking again on the way home.
View 2 Replies
Recently drove a 3500 mile road trip with no issues after installing a SCT X4 programmer from 5 star. Upon returning home the following week the ABS light came on and has not gone off. Additionally, last week the truck stalled while driving down the road at around 45 mph. Had something similar happen last summer, got the truck stuck and was trying to rock it in the mud and every time I shifted from reverse or forward the rpm's dropped to 500 and the truck could not respond to the gas pedal and the ABS light came on. Once I got out and washed all the mud from under it light went off and it ran fine without any warning lights.
Truck is an 05, V-10, 4x4, off road and tow package, lariat. No other mods besides the programmer.
View 9 Replies
I have a 2000 f350. When idling uo can't really hear the miss. Driving at about 40-50 mph it will shack and shutter real bad. Hooked up spanner and had miss fire codes for cyl. 1,4,9. Changed out all 10 plugs, and boots. Also changed out the coil on all three cyl also. Still have the miss and shutter. Also changed out #9 injector ...
View 12 Replies
I bought my 2005 F-350 Diesel 6.0 Brand New. Whenever my low fuel light comes on, I only have a few miles to go before I run out of diesel. Is there a way to adjust this light so it will come on with maybe 20-30 miles to go before running out? Its seems to only have maybe a gallon in the tank when this light comes on...
View 7 Replies
While driving into town during a recent snowstorm, my truck started to misfire quite badly. The check engine light started to flash and then remained on as I went to the auto parts store. The code indicated cylinder two misfire. I don't a few things of dry gas in the tank and let it run for a few minutes which seem to solve the problem.
Since then, however,every time the engine gets even a little bit wet it starts to bark again. It usually lasts a few minutes then goes back to normal. Typically, I would have replace the plug wires. When I lifted the hood of my truck I realize I knew nothing about it.
View 2 Replies
2005 6.0 F350 dually, speedometer quit working and the ABS light came on. I replaced the speedo sensor in the diff, but to no avail. Hear a lot about the cluster, however nothing with the ABS light on.
View 3 Replies
Blinking instrument panel. When I turn my key on in my 99 F350 power stroke everything inside the cab just starts blinking like crazy motor turns over just fine but it won't start.
View 1 Replies
So my right blinker is blinking really fast, after working fine for about a week. Nothing changed. I checked all bulbs and they're working fine. I repeat: ALL BULBS ARE GOOD. Truck has a service body on it with LED brake lights. Thought maybe the LED lights didn't have enough draw for the system to detect a good bulb, but left side works fine. Swapped bulbs from left side to right, still right side blinks fast. I even removed left rear brake light and it still flashes normally.. So not sure what's going on. Light control module??
View 4 Replies
I have a 2005 F 350 with a 6.0 Diesel! My heat quit on my wife and I the other night! I replaced some fuses and started the truck to make sure the heat was working and it was! So I thought while I am here I should replace some bulbs in the cluster that were out!
I took the cluster out, looked at the bulbs and they looked oK so I put them back in and put the dash back together! When I went to start the truck once I turned the switch on my gauges and lights started flickering on and off fast and all it will do is just click when I try to start it! I just had it running 15 minutes before this!
I went through all the fuses and if I take one of the relays out and turn the switch on all the lights and gauges seem to work right but when I try to start it, nothing! I replaced the relay and it starts flickering again! I had the relay checked at Napa and they said it was good! The relay was for the Powertrain module!
View 2 Replies
I have a 06 f350 with 5.4 140k miles. Recently it has been shaking bad on idle but only in gear and it's hard to start when cold. The exhaust is moist at all times and the fluids never leak. When you floor it it hesitates feels like it's overly rich but if you let off a little it stars to pull again. Also while cruising at 1500-1700 rpms in any gear it will surge and skip. Only time it will miss and the CEL comes on is over 4000 rpms for a random misfire. Just put new coils in new fuel pump and filter. There has always been a cat code but it never effected the drivability. Could it be injectors?
View 3 Replies
A cab light (OEM) has burned out. I'd like to replace it. What style/part number bulbs are used?
The closest tangential reference I can find is to 194, with additional references to 168 and 912. A Google Image Search of makes it seem like I'm getting warmer.
View 4 Replies
I have a 2001 F 350 with a V10 it keeps coming back as a misfire on cylinder 3 and 4.. I replaced all of the coils and plugs and pigtails I have even swapped out the coil packs from side to side and I still keep coming back with the same code. The truck has a bad check around 1500 RPM with a load on the motor mainly doesn't in overdrive and first starting off...
View 14 Replies
1995 7.3L f350 400k mi developed 1poss 2 cyl miss does not change after warm up and will die after 10 min .
View 1 Replies
My '05 F250 (5.4) started misfiring and threw codes for p0300, p0305, p0307, p0308,and p2198. I used an inline spark checker to check cops, which all had spark. Replaced 5, 6, 7, and 8 plugs and cleared codes. Ran truck for a few minutes and codes came back. Switched #5 and #6 cops and cleared codes. 5,7,and 8 cylinders still misfiring (same codes). Truck only has 36,000 miles and spent alot of time just sitting. Plugs were original plugs.
Replaced 5-8 with Autolite OEM replacements. I haven't checked cops for resistance yet. Weather was pretty cold when problem started. Threw in about 10oz. of Lucas to no avail. I had this problem last winter with the same cylinders throwing codes. Threw some Lucas in the tank and idled truck for approx. 1/2 hour and problem went away except for stumbling most every time truck came to a stop. I'm starting to wonder if it's a coil or a fuel issue.
View 10 Replies
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 Replies
