Ford Super Duty (1999-2016) :: 2007 F250 - Steering Gear / Suddenly Developed About A Quarter To A Half Turn Of Slop
Jan 7, 2015
My 07 has developed a steering gear issue.....it suddenly developed about a quarter to a half turn of slop......mechanic checked the front end and found everything to be tight and right so......I ordered a Redhead rebuilt box and will replace it upon it's arrival. My question is How often do these boxes go bad and if and when they do is it at all safe to drive the vehicle with that much play? I have to drive it about 15 miles to get to my mechanic ( far too cold for me to do it at home) and I also plow a couple of yards commercially and will need to use it there in the event of a snow storm.
View 8 Replies
Advertisement
My steering pulls hard left or hard right, and also seems to have a mind of its own when it turns sharp right or left suddenly, as though someone else is driving. It's very disconcerting when you think you're making a left and the truck veers right.
Today I was making a left onto a bridge and truck kept going straight. I almost hit the bridge. I have an 06 Ford F250 Turbo Diesel. What this could be?
View 4 Replies
I just went from 3.73 to 4.30 gears on my 2007 f250 6.0. It has the standard Sterling 10.5 rear and Dana 60 front. My mechanic friend who did the swap said the ABS light came on during his test drive but the truck drove fine. I was of the understanding that the truck would not need to be recalibrated for proper speedometer and transmission function, but what about the ABS?
View 7 Replies
Just bought this '08 F250 CCSB 4X4 5.4 Problem is the steering seems heavy, it tends to wander at higher speeds and won't return to center after a turn. I've searched on here and found a few possibilities (axle u joints, ball joints, steering gear, etc). I have an appointment with the dealer on Friday to fix it under warranty but he is convinced it's the u joints in the steering shaft seizing. When my F150 steering shaft began to seize, it would be hard to turn then break free then be hard then break free and this is not what is happening on the SD. I haven't had a chance to check the front end myself but not sure how you would check the axle u joints if there was no play in them. How would you check to see if they were seizing up.
View 3 Replies
I have a 2003 super duty crew cab 4x4 with V-10 auto w/167k. Awsome truck. I recently have noticed alot of slop in the shift lever on the column. Everything is tight on the tranny end. It appears to be under the dash. Is there a part that may be replacible? And if so... is it fairly simple to repair?
View 14 Replies
2000 Super Duty 2wd. My truck has a lot of slop and wanders down the road. My rotors are also warped and after they get warm they shake like crazy. So I plan on new rotors, bearings, calipers, pads, dust caps and rear rotors, calipers and pads for the rear. I will also be doing factory wheels and new tires and shocks all the way around.
My questions is to rebuild the front suspension and do it to last what all will I need? I see some moog kits but I do not think they are complete for what I need. I only have 126,000 miles with a sound motor and tranny so I feel she is worth it. I know how to work on the truck but the suspension is my weak spot. At 126,000 miles I feel it is a good investment
View 10 Replies
I have 03 F-250 with a 5.4 in it. Recently noticed the gas gauge is not moving much and seems like it will not go below half a tank. The gauge will go up however when i put gas in it. I just put techtron in it last night to see if this might work. Wasn't to sure if i did a battery reset on the truck if that may work as well.
View 2 Replies
2007 F250 4WD 5.4l ... when I turn sharply in either direction I am getting a light clunk sound similar to when you are in 4WD on blacktop and try turning. The engine also seems to wanna stall when I cut the wheel too sharp.
View 4 Replies
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
View 2 Replies
I have a 2006 Ford F-250 5.4l the symptoms are when it's warm it has half power and it will stall at idle. What I have done with the truck is.
New cam phasers
new chain
new tensioners
new vct solenoids
new oil pump
new plugs
new ignition coils
new stock cam shafts
new rockers
new lash adjusters
new exhaust manifolds both sides
new muffler
oil change with the right oil
ran it with sea foam in the crankcase before oil change
new fuel pump module
new evap vent control
new abs speed sensor
I cleaned throttle body with brake cleaner ... Scanned it after a 15 min ride of having to use 2 feet to drive it. The engine codes that came up are p0022 iacv short to ground and p1000 readiness test not complete. I also got p1804 4 wheel drive high indicator circuit failure p1808 4 wheel drive low indicator circuit failure .... Not sure what else to try.
View 7 Replies
My 1999 f250 superduty with the 5.4 was sitting in front of my house, and started all by itseft, did not have keys in it either and the doors were locked. I ran out thinking someone was stealing it but nope,? As far as I know it does not have a remote start either,i have owned it for the last two years and it has never happened before. It is a lariant edition also .
View 14 Replies
I recently bought a 2005 Ford F250 Super Duty, diesel 6.0.
As I was driving to work this morning I noticed that the fuel gauge read almost full when it should have only had a half tank. A little while later I heard a beep and saw that the gauge was now on empty with a "Low Fuel" message displayed. Then I noticed the heater was suddenly blowing cold air.
I've only had the truck for a few weeks, but haven't had any other problems. I did replace the CD receiver and all of the instrument cluster lights a couple weeks ago, but everything seemed to be working fine after.
View 1 Replies
I was driving and all of a sudden the radio died, battery light came on, Power windows and interior lights died, gauges died speedometer went all the way up to 100. The Head lights, turn signals and heater work. When I got home I opened the hood and the battery was boiling.
View 14 Replies
My 2000 F250 SD 5.4 AWD's A/C wouldn't blow cold suddenly the other day. I confirmed the A/C relay (engine compartment, 3rd down from firewall)was "clicking" but compressor clutch was obviously not engaging with dash switch on Max A/C and engine running. When I take of the 2 wire connector to compressor to see if it is getting power, the truck won't start..if I disconnect the A/C compressor plug while running, the engine similarly quits. I have never had another vehicle do this on me before..I could unplug the compressor on my Jeep GC, for instance, measure 12+ volts with A/C ON w/car running and no problem with Jeep engine turning off.
I have searched for A/C wiring schematic w/o success. I checked every fuse in cab/engine for continuity since I don't know which ones might deal with A/C..jumped hi/lo pressure switch connectors with engine running/A/C ON w/o compressor clutch engaging. Clutch turns easily, have banged it a few times, and air gap looks good. More bizarrerly, I hooked the compressor to a 12V/ground via its 2 male prongs and didn't get the clutch to engage.
View 7 Replies
My 'new' 2004 F250 ExtCab SB w/5.4L sometimes 'drops' my keyless entry (key fob) for no apparent reason. Also, when I attempt to do the 'eight turns' of the ignition to get into program mode, it doesn't always work the first time (or second, or third, etc). Is this a common problem?
View 5 Replies
I own a 1999 F350 CC SRW w/ 7.3L PSD engine. My turn signals stopped working suddenly. I've checked the fuse panel under the dash but it doesn't show any fuse for the turn signals.
My hazards do work although I noticed something very strange. When I tilt the steering column down the hazards stop working and when I tilt the column all the way up they work again. Still no turn signals though.
View 1 Replies
My 2008 250 suddenly lost ability to adjust temp control of heat and A/C. I can adjust the fan speed and the defrost/dash vents/foot heater position controls, but no matter how far I turn the cold/hot dial left or right, the temp is the same. Even in the Max and Norm A/C setting, it's the same temp, which is stuck in the hot range.
View 10 Replies
My F250 with V10 has developed an overheating problem. While driving, the temp gauge suddenly shoots to max, and the truck goes into limp mode. Turning off the truck and ignition, waiting a few minutes, and all seems to be well again - sometimes for only a minute, sometimes for several days. No steam leaking, the water in the reservoir seems to be normal temperature, the radiator is not overly hot, and the AC keeps on blowing ice cold. Me thinks it is not really overheating, it just thinks it is. So where to start? Change the temp sensor first, or the thermostat? It seems the hoses are fairly firm, I don't believe they are collapsing from suction.
View 14 Replies
So running into an issue with boost numbers. Factory gauge reads between 20-30lbs on throttle, but I have a SCT x4 and it only reads 3lbs and at idle it only reads .25-.89 somewhere around that range. Are these numbers accurate?
Also, it has developed a sort of buck or chug at like quarter throttle while accelerating, it's sluggish leaving stop signs etc. and it sounds like the waste gate or blow off it holding on even after I let off of the throttle.
View 1 Replies
Friend's truck started shifting wierd the other day, starts in second gear (maybe higher). The transmission is a fresh rebuild, the shop wouldn't warranty the rebuild and blamed electrical problems outside the tranny. Fuses are all good, engine light is on but the cheapo code reader won't show a code. Did a search and no answers. Had the overdrive light flashing from before, that code was for a wheel speed sensor.
1999 F250 (7 bolt) 5.4L 4x4
View 1 Replies
Is there a steering stabilizer for a 92 Ford F-250 custom 2wd? and what's the difference between a f250 custom and a f250 heavy duty?
View 2 Replies
