Ford Super Duty (1999-2016) :: 2011 - Radio Locked Up?
Jul 14, 2017
Radio locked up. Dealer says $800 to replace which seems way out of line to me. Are there any aftermarket solutions that retain the Bluetooth phone integration and don't look gawdy once installed?
My radio has the CD player, a digital display and steering wheel controls but no large screen or touchscreen for mapping or backup camera or anything like that.
Or if there is no good aftermarket solution perhaps I would be better off replacing it with a higher end Ford radio with inputs for a backup camera, etc?
View 9 Replies
Advertisement
2011 F-250 King Ranch, bought new, 59,995 miles. Dealer Serviced, always. ESP to 100K.
Took it in for an oil change, running perfect. Jan 4.
Service writer comes and gets me after 2 hours. "Engine locked up after they went to start it after oil change."
They are getting a remanufactured long block from Ford.
I am still in shock.....
View 14 Replies
They problem I have is when I am driving and the headlights are on my odometer and radio display is extremely dim. When this first happened I thought the displays were completely off until it got darker outside. It only happens when it is dark enough for the auto headlight feature to function.
When it is bright outside I can turn the between off, headlights on and auto and the displays are still bright. When it darkens outside the only way I can have the displays lit up to where I can read them is to turn my lights to off.
I have tried adjusting the dash dimmer switch, checked fuses and looked over the wiring but cannot find the fault.
It is a 2011 6.7L F250.
View 3 Replies
My truck is a 2011 F-250 6.7L. It's at 91,000 miles, and I have the PremiumCare extended warranty.
About 3 weeks ago (1,000 miles ago) I took my truck in for an A/C problem. The A/C quit blowing cold air. They diagnosed the problem as something inside the dashboard was broken and they needed to completely remove the dashboard to fix it. The repair worked, A/C was back, and I was good to go.
Last week my Satellite Radio and Navigation stopped working. I was getting a "NO GPS" message on the navigation screen and an error on the Satellite Radio screen saying something to the extent of there was no connection with the satellite antenna. I wasn't sure if something failed or if the dealership screwed something up during the A/C repair.
I booked an appointment and took my truck into the dealer that's 50 miles away from my house. The dealer took the truck, put me in a rental, and I came home. As soon as I got home I got a phone call from the dealer saying a cable had to be replaced and they were taking care of the parts and labor. When I asked him what caused this cable to fail (was it a defect, or was it damaged during the A/C repair), he said he didn't know. But, I'd need to pay for the rental car for the day and that they would make me another appointment to do the installation. At that point I asked the service adviser to have their manager call me ASAP. Two hours later I still haven't gotten a call.
Am I wrong to think that it's not fair that I pay for this rental car? My thinking is if it's defective it should be replaced and I should be put in a rental in the meantime. I paid additional for the rental car coverage to include any repairs and the first day of the repairs... but If it's the dealer's screw up, they should be bending over backwards trying to correct the issue and at least pay for the rental car for the day...
View 8 Replies
Just picked up a 2011 F350 6.2. (Couldn't take another day with my 6.0 which I'm now selling) New one has a few minor snags that I want to clean up. First one is the radio screen is black. Blank. Nothing there, although the radio does work. Seller had it tuned to a station. It has steering wheel controls. Here's the radio. Can this be repaired?
View 14 Replies
I have a 2011 F350 Lariat diesel crew cab. All of a sudden my remote start will not work, sometimes i can do it 5 times and it will finally but most of the time I just hear a lot of clicking noises in the engine like relays or something. Also when I exit my vehicle, if I use either the key fob or the outside keypad on the door to lock the vehicle, the stereo system turns on and stays on. When I open the door it shuts off. The only other thing that might be related is the other day when I put my windshield wipers on, the worked in super super slow-motion, stopped and then started again but at like 1/4 of the normal speed.
View 2 Replies
I was driving to work this morning and my hydraulic clutch linkage messed up on the 1999 f-250 super duty 7.3 with zf 6 speed. It acted like any clutch master cylinder when they go out, the pedal went to the floor and the clutch would not release, but it also became very hard to shove in the clutch pedal, so I speed shifted it without the clutch and made it to work. So I figured no big deal I will swap out the clutch master and slave cylinder complete assembly in the parking lot, except I had to get a ride 30 miles to an auto parts store that had it in stock. I changed out the complete assembly and same problem with the new one, extremely hard clutch pedal, so I did not dare to push it anymore and risk damaging the new cylinders, and left the truck at work. I am thinking broken throw out bearing jammed into the clutch, or dislocated throw out arm causing the problem. The clutch disc, pressure plate and single mass flywheel were replaced by the previous owner 3 years and 15,000 miles ago.
View 3 Replies
Its a 2016 F-250, 6.2L gas truck with the electronic shift on the fly transfer case.
I have put right at 22,000 miles on it like this, frequently at 70-80 mph.
What are the odds I have damaged it and is there anything I should do now that I discovered it - other than put them both in "AUTO".
Truck has been to the dealer twice and not once was this noticed. They blamed the squealing on the brakes which I knew it wasn't.
View 14 Replies
About a year ago, I had my right rear brake caliper lock up on my F350 dually. The shop said it can happen and replaced both rear calipers. Last week I started to hear something from the rear and within less than a a few days, before I could get to a shop the noise increased and when I looked the rotor had been gouged on the right rear.
I cannot see the left rear rotor to compare as the wheels don't line up on that side to see through. So my question is this. Could it be the caliper failure was a symptom and not the cause. Maybe a proportion valve or something that could affect the pressure on that one wheel.
View 11 Replies
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies
Well long story short, I had the the factory hubs in my 04 f-350 and I was driving down the road and it started making this horrible popping noise. So I pulled over and couldn't find anything and just curiosity locked in the hubs and all was fine. Made me think my hubs were bad, so I went and bought the warren premium hubs, installed them. Went for a drive and still the same noise is there when they are in free spin. But once they are locked in its fine. What this could be? Wheel bearings?
View 4 Replies
2004 F350 150,000km ... I have a rattling/clicking sound from the front right wheel when the hub is not locked (Free) and I hit small holes or run over rough roads. the sound is gone when I lock the hub front hubs.
View 3 Replies
I just bought a 95 f250 4x4 with the 460. The guy i bought it from had a trans slipping towed it to the shop when the shop went to pull it in they started it put in gear and engine died. The motor is now tight w no movement either direction with a bar obo it. Is it possible the trans is holding the motor tight? What can I do?
View 10 Replies
Yesterday while traveling about 30mph and starting into a slight left turn the steering wheel locked, when the brake pedal was applied it was rock hard and would not engage braking resulting in a single vehicle crash, no injuries. 8300 miles...
How would I make Ford aware of this incident and get them involved? Is it likely that such events may have been logged somehow in the computer? The truck is at our collision repair shop waiting for an insurance adjuster to inspect.
View 14 Replies
We have a 2009 F350 that the engine is now locked up. Anyhow my question is can a 2001 Triton V10 interchange with what was a 2009 Triton V10 both 6.8L...
View 2 Replies
My brother is having a issue with his 99 F350 diesel 7.3 automatic tranny pu. When in manual 1rst gear the engine stumbles and runs like crap. In drive or 2nd gear it runs fine. He's getting a code for a bad cam sensor. A new OEM and aftermarket sensor has been tried with no solution to the engine problem. What might be going on? Maybe a bad ECM.
View 2 Replies
But on my 2000 SD V10 the hubs are worn I just cant find which way to turn them to auto ?
I'm getting popping and such so I think I'm locked while turning.
Also.... IS there a way to check the COPS with a multimeter? I think I got a bad one.
View 1 Replies
Had to make a sharp circular turn last night in a parking lot, with the steering turned to full-lock...noticed a very audible clunking or clicking noise during the turn...went away after full-lock turning was released. My hubs are locked in...but I was told there was no issue with leaving them locked in, even during the summer. And there shouldn't be...4x4 disengaged, of course. Must have been the u-joints clicking / clunking? Problem?
View 5 Replies
Just got done with a ball joint replacement on my 2003 F550, everything went together great, just as it should. Until I got to the drivers side hub lock.
I have Mile Marker 449s/s manual hubs. Turn from free to lock and theres this loud clicking sound about halfway to LOCK (passenger side doesn't do this). Hub will stay locked for about 2 rotations, then it unlocks and makes a clicking sound. You cannot turn the hub back to FREE, it gets halfway and stops. I tried forcing it and broke the spring fingers inside. Have a new set on order.
Is this a locking hub issue or an assembly error? I was going to take these steps.
- Take passenger side hub lock off and see if it operates normally or same on drivers side.
- If same, remove axle and re-seat/re-assemble everything again
Anything to specifically check? All the parts went back in, washers were in correct order, outer snap ring is in groove.
View 11 Replies
2004 F250. Just got about 6 inches of snow. I use this truck to plow my private road. A few other residences on the road rely on my plowing.
I usually use 4WD Low and gear 2 on automatic transmission to plow. Hub manually locked. But today, when I shifted to 2, and pressed on the gas pedal. The truck was not engaging to drive, as if it were in park or neutral. And when I tried to shift to park, there is grinding noise and wouldn't allow me. I had to turn off the engine to be able to shift to park.
When I manually freed the hub and used 2WD High and gear D, I was able to drive the truck without problem.
Later, I tried using 4WD Low and gear D, and was able to drive a little distance before the truck no longer drives, and pressing on the gas is as if the truck was in park or neutral.
Previous to this earlier, I was driving down the private road to see how much snow we got. Without the plow on, I might have gone up to 10 or 15 mph, and still using 4WD Low and gear 2, maybe for 1/2 mile. Could I have damaged something by driving too fast in that setting?
View 9 Replies
Ok so some one locked my hubs and put the truck in 4x4 4low i assume my aunt was driving it, truck wouldn't shift from 2 to 3rd is this normal since its in 4low. The shifter also seems pretty stiff and 4wheel isn't used much if there a way to know if 3rd gear toon a crap? Trans fluid seems fine not dirty or burnt...
View 1 Replies
