Ford Super Duty (1999-2016) :: AC Not Blowing Cold / Compressor Making Whine Noise
Mar 11, 2015
This week was our first nice week of the year. Monday I got in my truck at lunch time turned the a.c. on and it blew ice cold. Today my truck sat in the sun all day and I got in it and turned the a.c. on. I noticed instead of the normal "click" you hear when the clutch engages in the a.c. compressor I got a wine and wimper kind of noise. The system never cooled the air after this happened. Is the compressor shot? Is it safe to drive or is the compressor going to tear itself up and send metal pieces thru the system?
View 7 Replies
Advertisement
My tuck has been making a whining noise very similar to this and only when it's below freezing out. At 5 degrees it's even louder. Just noticed it the other day. Sounds like power steering whine. I have the 6.2 super duty.
View 14 Replies
Got in my truck this morning and everything worked fine, no problems. Arrived at my destination and parked. Come out about two hours later start the truck and my A/C wont blow air, My truck is an 05 lariat so it has the climate control A/C. Everything was working fine it just wont blow air, When i turned the A/C on and off i could hear/feel the small thump of the clutch engaging on the compressor. I am thinking the blower fan just went south? or maybe something stupid that controls the blower fan? Summer is in full swing here in central florida, temps are 95+ not including the humidity...
View 14 Replies
My 2015 f350 6.2 truck started making this whine noise..... Sounds like a bearing..... Stops at 40 seconds.. [URL] .....
View 14 Replies
I think the truck needs a recharge, it's not blowing any cold air. The question is - which port do I use? There's one on the top of the accumulator and another in the line just off the passenger side of the radiator, near the coolant tank.
My only recharge experience was after I replaced a leaking accumulator in my 2007 Crown Vic police interceptor, and this obviously doesn't look quite the same.
View 6 Replies
Background : 2002 Excursion 7.3L, 320k miles ...
AC was working OK, but not great. Then AC stopped blowing cold at all. Checked pulley, gap was huge, but pulley bearing was completely destroyed. Like, 1/2" wobble, half the ball bearings in there. Amazed it hadn't seized. Replaced pulley, set air gap to bottom of the spec.
Air seems to blow kinda cold briefly, then fades to no cooling after a couple minutes. Same at idle or moving. Front and rear both not cold. Lines in engine bay are cool, but not real cold
Compressor body feels hot, like...right at that threshold of too hot to touch. Don't have pressure gauges, but will buy/borrow some and take some readings.
What would symptoms of a clogged orifice tube be? What would symptoms of a clogged condenser be? If low on r134, I could refill, but any tips on chasing down leaks?
View 8 Replies
Here's what's happening:
I can have it on hot and be driving along, then it will start blowing cold air. I can move the temperature switch to cold then back to hot, and it'll start blowing hot air again.
Need to know if that would be temp or the motor? I don't want to just change parts randomly.
03 F250
View 8 Replies
I have a 2000 f-350 that overheated 2 months ago I replaced the radiator...it seemed fine for a month then started blowing cold air then would start to overheat and back and forth so I replaced the thermosat.......but when i checked the old one with a cooking theromometer it was fine. not long after that the heater core started leaking so i replaced that..and now its back and forth overheating and blowing cold air....then fine for 1/2 hour..then back and forth again.. Truck has 250,000 miles on it
View 12 Replies
2002 F350 with V10. A/C stopped blowing cold. I can hear the clutch clicking on and off, so probably needs refrigerant? Other thing is that with A/C off, the temp control turned to cold, and fan on, it blows hot air. On my other vehicles with A/C off and temp turned to cold, I get outside air at ambient temp.
I removed the cover off the evap core under the dash and observed the blend door opening and closing as the temp selector is moved. The duct door moves correctly, so am I'm missing something? Is the Ford system such that ambient air is always heated? This happens even in cold temp conditions.
View 2 Replies
I have a 2004 Ford F250 Turbo Diesel, egr delete, headstuds, intake, dual stacks, etc and when i turn my wheel a loud whining noise comes from under the hood, I noticed it put tension in my brakes. When I accelerate it gets louder and when i let off the gas it goes away... i checked my fluid in my steering pump and it was low so i put some more in and the next day it was all sitting under neath the truck.... any quick fix or do i need to replace the whole pump?
View 2 Replies
My truck had devolped a whine/howl over the past coulple hundred miles. I thought it was a wheel bearing failing me. So yesterday I pulled it into the shop and jacked up the front end. Everthing checked out fine so I jacked up the rear end, started it up, put it in gear and to my surprise the noise was from the rear end.
I pulled the rear end apart and found the front pinion bearing had a defect in the race and the rollers were starting to pit out causing the noise and harshness when turning it. The truck has 130k, seal wasnt leaking and fluid looked/smelled normal. I think it was a legitimate defect not from abuse or lack of maintenance.
View 2 Replies
My '01 Super Duty 5.4 has an overheating/heater problem that the dealer can't seem to fix. I noticed my heater was blowing cold then a few miles later it overheated pushing coolant out of cap. Next day drove fine to Ford dealer who replaced my heater core, thermostat, reservoir cap and a hose. Drove it for a day till the exact original symptoms occurred again with a gurgling sound in dash. Dealer kept for a week pressurizing system but no leaks found. Replaced my thermostat again and gave it back. I drove it 300 miles over a week before the exact same symptoms occurred. Brought back to dealer who said that air was in the system, added a bunch of coolant and supposedly got all the air out. Same symptoms still. Brought back to dealer that finally changed the water pump they said had a leak. Guess what, same symptoms. Heater will work fine for days then it will blow cold, then hot, then cold and sooner or later truck will overheat then just as fast cool down and heater will work again. Still hearing gurgling. Dealer said I don't have a HCV.
View 6 Replies
I guess my AC Compressor is about to the bed. AC works good however there is a lot of rattling going on. Been driving it like that for two months plus expecting it to fail.
Just not sure how long I should let it go. If the compressor pully fails on the road I will lose my serpentine belt and the ability to put the spare on and I will be stuck for sure.
2008 F250 XL 5.4L .....
View 1 Replies
Bought a 2014 SD 4x4 in December of 2013 and this is the second time the big girl has been to the shop with A/C problems. First time it was the evaporator about three or four months ago. During the last few weeks of the summer I began to smell something strange (like band-aids) when the A/C was on and it lingered until the next re-entry. ALso, began to hear a slight hissing noise when the compressor was kicking in and out. They replaced the evaporator, smell remained as they said it was the refrigerant I was smelling. About two or three weeks ago the smell got slightly "larger", and last weekend she would not cool. This is the fourth time shes been to the shop with other problems such as the My Touch system..............
View 7 Replies
I have a 2003 6.0l did a rebuild on it. Got it all back together runs ok, but the turbo is making noise. I can unplug the actuator and the noise stops. How can I check the actuator. now the noise is of course when it is running.. but unplugged the noise stops.
View 2 Replies
So when my hubs are locked they make a popping noise. Not when I'm turning like a 4wd would but all the time. And then when I turn on my ESOF in the cab something makes a horrendous noise like its binding up really bad. When I unlock my hubs and turn off my ESOF it all goes away. My 4wd does not engage without the hubs locked. I have the warn standard manual hubs. I'm not sure how to check to see what's messed up.
View 14 Replies
My 1999 Ford F350 Dually 4x4 started making a grinding noise every once in a while about 3 weeks ago. Now it is doing it quite often, randomly as I am driving. I do notice the noise stops when I stop the truck, or when I flip the switch to 4x4 and back while driving.
View 1 Replies
Have a rear wheel bearing making some noise. A friend told me that it is always the outer bearing that goes first . Can you replace the bearing without replacing the race?
View 14 Replies
I have a 2016 F250 extended cab with 8 foot bed with snow plow and camper package currently less than 2500 miles on it. Every once in a while when I make a turn (typically a left hand turn) I will here a brief noise that sounds like a rubbing or "squawk" noise. The noise doesn't seem to be related to the turn so much as to the roll of the truck when it unloads / loads the suspension. I'm guessing it might be related to sway bar bushings or something similar, but I just don't know.
I have tried to find a stretch of road near the dealer where I can make the noise happen so I can take a tech for a ride so I can let them hear exactly what I hear, but as hard as I try I cannot reproduce the noise consistently.
I have visually checked underneath and I do not see anything wrong and I suspect it's not serious, but I'd like to know the cause and obviously correct the problem.
View 14 Replies
An odd noise just started recently where as I'm turning left, a popping noise happens seemingly right under my feet. I don't have a video, but I can probably try to take one later. It sounds like something is loose and when the weight shifts off of the left side of the truck, something is shifting and groaning.
I lifted the truck up yesterday and there is no play in the ball joints, wheel bearings, sway bar/end links, or tie rod ends. There is no play in the shock or in the spring, nor is there any movement in the radius arm or where the axle mounts to the body.
I should probably add some info on the truck. '00 V10 CCSB 2wd. I can't see anything out of the ordinary, and can't reproduce the sound unless the truck is in motion.
View 9 Replies
I remember seeing a post a while back stating that the reverse sensor would make a clicking noise (when you're ear is up against the sensor) when working properly, I only had one working but I figured I'd replace them all since the 4th one was sure to go out . Fast forward to using two different sets of sensors, and not a single has worked or made that clicking noise like I would assume it should be. Can an aftermarket head unit cause these sensors to not work properly or have I just gotten two bum sets?
View 3 Replies
