Ford Transmission :: 1994 F150 Not Shifting Into 3rd Gear Or Above
May 15, 2014
My 94 F150 has been actingup lately with the 4r70 transmission not shifting into 3rd gear or above. I replaced the MLPS sensor and re pinned the plug as per the instructions with the switch.The old sensor had the plug on the side, same type of plug, but wires indifferent spots. Truck wouldn't start like that, so repinned to match the instructions. I couldn't get the neutral mark to 100% line up as there is not enough adjustment, but it is very close.
The old plug had
32-298-140-33
57-199-359-463
I switched it to
57-359-199-463
33-140-298-32
Then tried
463-359-199-57
33-140-298-32
Truck still won't shift to 3rd, overdrive off button doesn't light up and itwon't start in neutral. I tested the ground at the connector and it lights up atest light connected to the pos bat cable with no issues.
Back up lights won't work, but flicker as going from R to N, so I suspect that is due to the fact I couldn't get the marks to line up 100%, but i'm not worried about that now.
View 1 Replies
Advertisement
I have a 2000 F150 5.4L with 157k miles on it. I think it has the 4r70w trans. The transmission has started holding 2nd gear too long before shifting into third. Throttle position doesn't matter, it does it even under light throttle. I do not have a check engine light. I have owned the truck since new and the trans fluid has been changed 3 or 4 times. The fluid looks pretty good now, not burnt or anything. The truck has been sitting in the garage a lot over the past 2 years, I drive it at least once a month and have put maybe 2000 miles on it this year. It shifts fine through the other gears, just 2-3 has an issue. Truck has the towing package.
View 6 Replies
I did a C6 swap on my '94 F150 4x4 recently to replace the M5OD the previous owner burned up. Just to check on things I hooked a brand new autometer trans temp gauge up to check out the temps. What I'm worried about is that on the highway (60-70 mph) it climbs up to 210*.
This was at night at about 75* outside temp. I know the C6 doesn't have a lockup converter, but these temps seem kind of high. It's not a heavy truck, not towing anything and I'm running stock sized 235's with 3.08 gearing.
For now I'm just using the internal radiator trans cooler, but I have a large factory bolt on cooler from an F350 of the same year that I plan on putting on. I have the gauge sender in the drivers side test port just in front of the shift linkage. I'm also running a deep pan that adds 2 quarts to the system.
View 4 Replies
Daughters 94 f150 4.9L 204K miles e40d started leaking transmission fluid from the bell housing, so she parked it for 2 years...Now I have been nominated to fix it... Truck was running good when parked. Got it started (Just charged battery and started it up), and backed it up. Reverse is good and solid. When I tried to move it, it wouldn't move in drive. Starts to engage, then drops out. Pulled into first, and the truck moves, but have to have high rpm.
Replaced tc seal, filter and fluid, (12 quarts). No change... Ran it down the road, had to start off in first, good power up to about 35, shifted to second, it shifted...ran up to 45, then shifted into drive, it shifted, and maintained power. Had to slow so stopped and turned around, tried moving out in drive, and it just kept dropping out. Returned home as I left...read a lot of this forum, and learned some but not enough..
Pulled codes 327,116,536,538. No transmission codes.
View 10 Replies
1986 F150 3spd Auto 300 v6. My truck will not shift out of 1st in Drive, to shift into second I have to column shift to 2nd. 20mph top speed and idk what to do to fix it. I would like to put a 5 spd manual in it cause I would like to drive over 50mph.
View 4 Replies
I have a 02 f150 4x4 5.4 135 k the transmission will not shift into drive unless you rev it up to about 1500 rpm and when it shifts it goes in very hard but when you get moving it seems to work ok but every time you stop or slow way down it does the same thing. It works fine in reverse and the oil and filter is good. I am thinking TC but i dont know ...
View 3 Replies
96 F150 carbed 300 with a C6/208 SAS44/9" with 3.55 on 35s.
I put a transgo shift kit in the transmission before putting it in the truck, it also has a small stall. At half throttle you can manually shift 1-2-3 with no issue at all. Under full throttle when you shift to second it won't go into second until you push the shifter into third. Then it'll go to second and spin the tires when it grabs second in dirt. This is all in 4lo, I was gonna switch to 2hi and try it but it's raining and I don't feel like crawling under it to change it. The truck is a mud toy so will spend 90% of its time in 4lo.
I don't have a vacuum line currently hooked to the transmission because I have the same shiftkit (transgo) in my 77 and no vacuum line on it either and it works fine.
View 4 Replies
Our 93 Ford F150 with <100,000 miles had no transmission problems until a squirrel built a nest in it and chewed through some of the wires. It wouldn't start and what a surprise when we lifted the hood. It chewed through the EEC Test wires which have been reattached, through the cruise control wires (all but two have been reattached.
The remaining two are chewed to the box and can't be attached), two other wires next to these that were reconnected and chewed completely off is a part #E53B-14A624-0 with the stubs of two red wires.
The E53B was lying under the truck. After reattaching the wires listed it started but now lugs along and shifts hard into first gear. After that it's OK most of the time but it has surged unexpectedly when making a turn. I've been told the cruise doesn't need to be rewired completely so don't know if it's the problem (can the cruise be left with two wires cut off) or if it's the E53B part or something else we can't see.
View 3 Replies
My 1994 Ranger keeps shifting in and out of overdrive. It will go into OD easily, but it keeps downshifting, then shifting back up constantly. If I go up hill, if will downshift and stay in drive, but on a flat stretch, it wont stay in OD. It works fine when its cold, but after it warms up, then the shift problem begins. What do I do?
View 2 Replies
I have a 94 E350 with a 7.3 diesel. I took it to the Ford dealership to have a new fuel filter and oil change when I got it back the OD light was flashing and transmission shifting hard. They tell me they cannot find a problem could they have possibly knock a wire off of something to make this happen...
View 3 Replies
This is an Auto/4z4/4.6 V-8. It's Skidding or a Clutch is not holding at times when shifting up or down while on Cruise and slight hills.
someone suggested changing oil and filter about two years ago. I did that and it didn't change a thing. $145 that time.
I'd like to know if its the clutch in the torque converter, or the Transmission? If I have to change something out, should I get both?
View 3 Replies
My Step Brother has a 1994 Chevy S-10 Blazer with a 4.3L V6 Automatic and the Transmission isn't Shifting Right what could be the Problem?
View 2 Replies
1998 Ford f150 172984 miles automatic with 4x4 runs and drives transmission is going out will not hit 3rd gear have to drive in 2nd. Is there a fix without pulling the transmission?
View 5 Replies
I made a horrible decision after my Ranger got totaled and bought a 94 Jetta... When I first got it, the car had trouble starting in the rain but eventually she would fire up. If I drove it immediately away after finally starting, it would jerk really bad when I gave it gas while shifting, until 4th gear. Once she ran for a bit it would smooth out. Nowadays if it rains the car won't start at all, just keeps turning over and I have to wait for a nice dry sunny day then it starts right up.
My mechanic worked on it recently and replaced a sensor in the distributor and the crank shaft sensor, because they showed up on the diagnostic as bad. Once his work was complete, he said he sprayed the engine with water and it started. So that was a week ago and it's raining and it won't start, the engine just turns over so it's not a starter issue. The car only has 143,000 but I am gonna get rid of it this fall but I just wanna know what this wet weather problem is.
View 3 Replies
My manual transmission got stuck in 4th because of a melted oil trough sticking between the gears. I got all the plastic out, and the dog clutches/collars are "free." But, I don't know how to put the gears back into neutral. When it's reassembled, the stick doesn't work to change the gears. How can I get the gearbox back into neutral?
View 19 Replies
My 82 f150 4x4 302 c6 trans is acting up. My c6 is slow to shift into any gear when I shift the column shifter, after a moment it jerks into gear, also it doesn't seem D is doing anything but all the other gears seems to function manually or auto.
Fluid level looks ok, maybe a little high on the dipstick. I'm going to check the modulator and do a fluid/filter change but looking for a link to the band adjustment screw ?
View 3 Replies
I have a 2007 F150 FX4 with 105K on it. When it goes from 2nd into 3rd, it acts like it's in neutral. There's nothing there. This is in "D" with "OD" on. If i turn OD off, it will wind up and grab 2nd again and will coast if I let off the gas. Also, if I manually shift into 2nd, it will engage 2nd and I'll have engine braking if I let off the gas.
The trans fluid was full and bright red as is should be with no burnt smell to it.
I dropped the pan and the magnet was a little fuzzy with some metal filings but there was no metal laying in the pan. I also dropped the valve body and there were no broken snap rings and the e-clip on the OD servo was intact. The valve body was also clear of anything that shouldn't be there. I'm hoping that I can replace the shift solenoid and that will solve my issues.
View 4 Replies
I have a 94 Camry 2.2. When I am driving 45 MPH the transmissions acts like it is shifting into N or OD and then the RPMS fluctuate between idle and 1500 or so. Then when I it will shift hard because the car has decelerated. If I stay in the throttle during this it just jerks or lunges.
View 3 Replies
I just got my 03 F-150 with 112k on the clock. It has the manual 5 speed tranny behind the 4.6L.
However, since I've gotten the truck, it's kind of difficult to put in first gear. If you are sitting at a light and in neutral and the light changes and you push the clutch to the floor and put it in 1st (fairly quickly - a normal reaction time), it will actually do a little grind and/or thump. However, if push the clutch to the floor and wait a couple of seconds and then shift into first, it's a bit of a "push" but it will go in without grinding.
Once in a while shifting to 3rd it feels the same way, but won't really grind.
I'm just wondering if that means the clutch is toast or is it the trans that is toast? Reason I ask is my 96 Cobra with the T-45 5 speed would grind going into 5th gear if I just normally put it in. I used to have to put it in neutral and then push the clutch in again and slowly shift to 5th for it not to grind. And it wouldn't go into 3rd if I tried to shift fast or under power. I replaced the clutch and found out the trans was actually going bad, but it had 173k on the clock.
So, I'm really paranoid that it's my darn trans in the truck instead of just the clutch. Whenever my old Camaro clutches used to be dying, they would slip more than they would ever grind going into a gear.
View 14 Replies
I think my E4OD in my 95 f150 is slipping in 4th gear. Just started the last couple of days, the engine rpms stay steady but the speedometer bounces around 3 to 5 mph. Thinking rebuild of the trans....
View 7 Replies
I posted earlier this month about my 1996 Ford F150 4x4 manual tranny truck. It had gotten stuck in fourth gear, and I, along with others, assumed it was the shift forks. I cracked open the top of the transmission yesterday, and what do I see? Melted plastic staring back at me. What's going on here? There was melted plastic jammed between fourth gear and the inner wall.
Is this a case of the surgeon leaving his instruments inside the patient? Could a mechanic have dropped his tuna sandwich wrapper in the transmission at some time?
View 8 Replies
