GTI 337/20th Anniversary :: Car Died On Highway - Crank But No Start Or Spark
Jun 27, 2014
So driving on the highway my car died. It would crank but not start. Got it towed. This is what I have done to troubleshoot.
1. Swap ECUs. The car should start for a second and shut off because the car doesnt match with the ECU. Still just crank and no start.
2. Fuel pump still primes when I open the door. I also hear a weird air leaking noise when I reconnect the battery, but I think it comes from the fuel pressure regulator (which I think is normal).
3. Checked for current at the ecu wires, wasn't sure what to look for but it was getting numbers.
4. Battery had 12.1 volts running through it (Haynes said 12.5 but is that really much of a difference?
5. Checked spark plugs for spark. Pretty sure we did it right, but there was still no spark. We tried multiple times.
6. Scan car, get code P01314 twice (ECM error).
7. Try to clear codes, says Comm error.
Why am I not getting spark? and why is the ECU error occurring, because we tested with a new ecu, and there was still no start, not even for a second like there should be.
View 2 Replies
Advertisement
I have a perplexing problem and I'm at wits end trying to figure it out. I have an 03 GTI 1.8t 20th. The car has been running great until today when I replaced a few bolts with the front bumper and replaced a motor mount bolt on the passenger side mount. Everything was great until I did the work on it. I figured I had bumped the cam position sensor so I swapped it out for a new one and nothing still. I have verified I have spark and I definitely have fuel as it keeps drenching the spark plugs. I have cleaned the spark plugs and tried starting only for the car to violently sputter and misfire. No codes are being recorded and nothing else has been touched.
View 9 Replies
Truck died going 50 mph and would not restart. I turn the key to run and nothing. I can hear the injectors buzzing but it will not turn over or crank. I can jump from the battery and the truck will crank. However, it seems to be in limp mode. It will start off in 3rd gear and won't shift gear Tow/haul light is flashing.
The wire harness that goes down to the fan clutch is chewed up and frayed so I'm assuming that may have caused an issue. But i have unplugged the sensor to the fan clutch and it still won't start. I can hear the injectors buzzing but when I turn the key to crank it, it does nothing. Just clicks. I've cleared the codes and these keep coming back.
View 14 Replies
Having issues with turning over but no start, sometimes takes up to five turns to start up, and hesitation on hwy in 6th gear. Fuel problem im pretty sure.
View 1 Replies
There wasn't even a crank. Held the ignition for a couple of seconds and it starts. The next day I had the battery and the alternator checked, they were both good. Another couple days passed and it did not want to start again. Got it scanned no codes come up. I changed the ignition switch and still I have the same problem with no crank.
View 8 Replies
So today as I was pulling my handbrake after parking the car, apparently it snapped, so np, taking it tomorrow to the garage for a fix. Anyways had an urgent outing, started the car and went for a 10 mins drive. I didn't give it enough time to warm up. So finished what i had to do, got back in the car, tried to start it, nothing. Took me two tries and 20 seconds of cranking before the car would start. started with EPC light on, drove it nothing wrong in it, except the check EPC light is on. What it might be?
View 3 Replies
My battery died quick and my car doesn't start anymore it starts but it's turns right bak off I scanned it and code p0688 came out something about a relay.
View 1 Replies
My Truck : 1999 Ford F-150 Extended Cab 4x4 5.4L V8
So the other day I was driving the truck and it just dies on me. Tried starting but it just cranked and cranked. Got it pulled over to a parking lot and then tried to start and I got it to run again. Died a couple mins later uo the road and it will not start at all anymore. I got it towed to my driveway and I've started diagnosing some things.
I dropped the tank thinking it was a pump I replaced awhile back. The pump wasn't running but jumped to conclusions and took it back to the auto parts store. They bench tested and it works fine. I checked for voltage at the pump connector. NOTHING. So I'm not getting power to Fuel pump. Then I checked the fuse and relay for the fuel pump. Everything was okay.
I did some research and decided to check for spark. NO SPARK. Another thing I noticed the other day was that the odometer is displaying all dashes. So I'm really unsure on what to really troubleshoot. I am going back to the truck tomorrow to check a few other things. I'm not sure if the Theft light is blinking or not so I will check that tomorrow and get back to you.
What to check? Any other relays or fuses besides the fuel pump? What about any modules to check like PCM, GEM, etc. Or I've heard the crankshaft sensor could be an issue.
View 14 Replies
My 20th has been having a starting issue and I've honestly tried everything I can think of, this issue just randomly started one day the car will not start on first crank it starts second or third every time. After it's started and running it runs perfect its just getting it started.
I've replaced the Crankshaft sensor, Camshaft sensor, Coolant temp sensor, the car has had new injectors (440) installed about two months ago, has the new battery. My father is a mechanic and he has also tried everything he knows to do and we asked our local VW specialist and he said to try the things we have already did. Ran codes when the issue started and it only came up with camshaft sensor and we replaced that and cleared the code still nothing. Once this issue started we parked the car and started troubleshooting and the oil was low? even though I know before the issue started it was good and full. the car has a stage two intronic tune, 440 injectors, secondary air delete and all and a shaved and partially tucked bay, there are no resistors is the open unused sensors.
View 1 Replies
I was driving the other day and accelerated in 5th and the car stuttered before finally going- I got the flashing CEL. I figured that the car was misfiring and that a coilpack change was the culprit. All my coilpacks are fine and the sparkplugs look good as well. CEL hasn't come back, but the car just feels like it doesn't want to go right away when if i give it some gas when I'm going about 55-65 MPH.
Other guesses would be there is a fuel cut somewhere and that may be causing it?
View 6 Replies
just found my cranksensor was dead.. on the highway today.. sooo!.. can som1 tell me where is that sensor exactly so i can change it today.
View 1 Replies
Drove ~1500 miles this week, from MN to MA. While driving through PA my left headlight died in the middle of the night while raining. I ended up fixing it after spending an hour at a gas pump for shelter. Also in PA I randomly stopped.
View 14 Replies
So over the past couple months when driving on the highway I would notice that sometimes my car would lose all power and slowly coast to a stop, but then the power comes back on and I'm off after a few seconds. It happened again today and I notice when I do hit the gas when it decides not to accelerate my boost gauge shows that there is vacuum building up in the engine. It just doesn't make sense to me. Would my car be getting thrown into a limp mode? Or is it something to do with fueling?
View 4 Replies
I have a 2003 20th anniversary edition GTI. Yesterday I noticed my car started shaking when I was driving on the highway. The only thing I can think of that I did was run into a snow bank during the snowstorm. What is causing my car to shake?
View 2 Replies
50k Miles on my clutch. Was driving a couple weeks ago on the highway and clutch stuck to the floor. At first I thought it was my Slave cylinder. Got the trans out this weekend to find the mess (below) inside my bell housing. Obviously need a new clutch now and will still replace the slave while I am in there.
Cars setup is around 375ish whp. I know I could spend 1300 bucks and call it a day for a clutch master or south bend but was seeing if there is a cheaper alternative.
Also If I were to buy an OEM clutch or an upgraded one that was not rated for up to 400~whp would it drive and pull the same as a fully upgraded one just not last as long?
6 Speed ...
View 3 Replies
I got the car like that. When I take off hard there is a crack somewhere in the front. Then when I stop hard it cracks too. What could it be??? Sometype of bushing??
View 1 Replies
So I was driving on the HWY in 6th gear cruising at about 60, and I go to speed up and when my RPMS hit about 3k or over it feels like I am pressing in the clutch, like my RPMS are going up but I am hardly gaining any speed.
View 24 Replies
So, yesterday I had my GLI in the shop to put a new timing belt on as well as some ECS Lightweight Pulleys. When I went to pick up the car, they did not install the pulleys. The reason they said was because the stock crank pulley has a dampener which keep vibration and balanced weight on the crank assembly and that the lightweight crank does not have these benefits.
So, now I have a set red anodized pulleys.. [URL].............
View 8 Replies
About three nights ago I had a complete power loss on the highway and the car began to bog down alot under throttle (and surge at points as well although with no boost). It also idled very rough/erratically. When I unplugged the MAF it cleared up right away; Idle was smooth and it ran without hiccup but in safe/limp mode so very tame (again, without boost really, gauge shows it stays in Vacuum and never passes "0" or goes into boost).
I scanned it this evening and got 2 misfire codes and a MAF code, along with a code related to traction control which I noticed had activated as a result of this and could not be turned on (by activated, I mean the light came on, disengaging T/C). These things make me think it is MAF related, especially because I have bolt down Hitachi coil packs so I do not think that is what it could be in relation to the misfire codes (which I think may be old and needed to be cleared).
Fast forward to last night: I can pretty confidently say my MAF is not the problem and I think I saved an unnecessary expenditure. I was able to meet a friend with a 337 as well and his MAF did not change my car at all and my MAF ran fine in his car so I think my problems are something else. Although with the MAF plugged in my car runs very poor and unplugged it clears up and just runs "limp" (no boost and slow but stable) from what I tested this evening the MAF unit seems to not be the issue.
I think there must be a vacuum leak of some sort between the MAF and the engine which allows more air in than the MAF signals when plugged in which causes the issue. Also, I know a common thing to think is "coilpacks" but I have bolt down Hitachi coil packs so I would imagine that would eliminate those from being the failure they tend to normally be. Agreed ??
View 14 Replies
I got my 2005 jetta gli used with about 41000 mi on it. Ever since i've had it, when i accelerate on the highway at 50 mph or faster, the car almost feels bouncy throughout, what that is.
View 8 Replies
I get a ticking niose when i crank the wheel all the way to the left or right and reverse .. What it could be (its fine when I drive forward)....
View 2 Replies
