Golf IV / Jetta IV :: Soft Shifting Into 2nd / 4th And 6th Gear
May 18, 2014
When I was driving on Friday I noticed that moving into 2nd, 4th, and 6th were "soft." I could hardly feel it engage into those gears at all so I thought maybe I would adjust my linkages. So I adjusted my linkages and while sitting in my drive way everything felt solid. When I took my car for a ride down the street I could feel it engage 1st, 2nd, 3rd no problem but after driving around for a few minutes my 2nd, 4th, and 6th gears felt soft again and then it got worse where I couldn't even shift into those gears anymore.
So my R, 1, 3, 5 all worked fine but didn't have 2, 4, 6. After taking a look at my linkages and I pulled off the selector cable and and shifter cable end. I noticed that on the shifter cable end that it felt wobbly and on the selector cable end it was rock solid. I am just wondering if the shifter cable end being worn out could be my issue? Is the shifter cable end supposed to have a little play in it and be wobbly? Or is there another issue I should be looking for? Here is a video of just how wobbly it is. [URL].....
View 13 Replies
Advertisement
I have a 2003 jetta 1.8t. Just recently it hasn't been shifting from 3rd to 4th gear. It will when the transmission is cold but once warmed up it will no longer shift into fourth gear. Just looking for some possible solutions. Going to check the fluid this weekend.
View 1 Replies
So I have a 2.0L jetta with 160,000ish (daily driven) miles. And I'm starting to see a bit of a shifting issue mostly into third. Seems like I get locked out of the gear while shifting from second to third. I have to push it in(catches the "lock out") then I pull back and push forward again and it pops in. I rarely miss gears or grind. And I've noticed only a few times it does it in fourth as well. No grinding (unless I try to force it super hard) just won't let me go into gear.
Also while on subject of gear issues...
When I go into reverse, after the car has been sitting over night or for a longer period ( I would say between 8-14 hours) it will act up, almost like I am trying to drive with the parking brake fully engaged. In order to make it stop such bad behavior I have to rev it higher and it makes a *pop* or *crack* noise. Then it reverses just fine.
I've done a little bit of searching, "Look for a binding in the engine bay" and I have looked and haven't found much.
View 2 Replies
So yesterday my car was running as fine as it always has. Then today came around...Car started fine, shifted into first and second fine, but when I hit 3rd it started to sputter in the low rpm's. Around 3000 it picks up a bit. This then continued happening through all of the gears. I noticed that the engine light was flashing for a few seconds and then went away completely. It still putters, struggles, and shakes when accelerating in the low rpms but its not throwing any codes. I know there are a few things it could be i.e. vacuum pump, bad coils or plugs, are maybe something more serious (fuel pump maybe?). I'm at a loss, especially since the car is throwing no codes (so there is nothing to scan for). I was hoping vortex could give me somewhere to start on this, I don't have a VAGcom so getting it scanned means $$$ and I want to get a start on the problem before I go that route. Here's some basic info:
Its at 182,XXX miles. Its never thrown any engine light or cel code in the 2 years 40,000+ miles i've owned it. I run 0w 40 eurpean car formula oil through it every 3-5k. I run seafoam through it every 6 months. I'm NOT sure when the last time the coils have been replaced.
View 3 Replies
I come today for a apparently transmission problem. I have an automatic VW Jetta 2000 2.0 that i bought a few months ago, the car is great, has 250K miles.
The problem is in the morning when car is still cold, the transmission isn't shifting gear until 3K RPM (For 1-2 is about 2.5K RPM, and 2-3 is about 3K RPM). After 5 minutes of driving all back to normality and transmission shift gear about 2.2K to 2.3K RPM.
The question is: this is normal?, what could be wrong?.
View 7 Replies
1999 Jetta MK4 with only 124k miles on it. Everything is fine with the car except when the car shifts from 2nd to 3rd it is jerky/violent/forceful everything else is good with car except check engine light is on but I don't really care about that and I'll go check with autozone to see what the code is. I am able to feather the gas when I know its going to shift and I can make the shift pretty smooth. My question to all the experts is does this mean that this tranny is on its last leg or does it still have a lot of life left in it. My old Cabriolet did it for years and never was a problem.
View 5 Replies
I have a 2004 2.0L Jetta with a 5 Speed manual transmission.
When shifting into third gear sometimes I push the shifter forward and it does not want to move all the way forward. It feels like I am pushing the shifter knob against a wall, or more accurately the bottom of the shift that pulls the cables feels like it is hitting a wall. If I pull it back out and press it in hard it will go into place sometimes.
This also solves the problem: While the shifter is mid shift into third, at the wall/ at the point of resistance, I let off the clutch slightly to give the flywheel some friction. This rolls the transmission a bit and allows third gear to slide into place.
I have experience with a MK4 Audi TT 1.8T that cam with a 6-SPD and it at had a 1-2 and 2-3 synchronizer issue (The one where the nipples are worn and it grinds at higher RPMS because they can no longer make a firm handshake). The issue I am experiencing is not that.
Could it be the transmission cables? Could it be some other cogs in the transmission? - If so does this mean I need to buy a used one? My car has 180K miles on it with the original clutch.
View 5 Replies
Car in question is my 2003 Jetta 1.8t with the 09A 5 Speed Automatic. For the past 2 or 3 months these have been the symptoms: 1st to 2nd gear, very hard shift depending on RPM's (Higher the RPM's the harder the shift) 2nd to 3rd gear, not really hard but it kinda 'flares' the gearbut still shifts. All other gears are fine, although if you accelerate hard out of 4th it will have a little bit of a hard shift. I'm thinking either solenoids, or the speed sensor?
View 1 Replies
I purchased a 2002 gti in Febuary with 161k miles. I believe it was a couple weeks after I bought it - it started making this creaking sound. At first it was more rare to hear it but it occurred going on uneven surfaces like up a steep hill or around an uneven turn or even stopping and going. It basically happened when the front end pitched up/down. It sounds almost like a rubber creaking or even plastic. (Some sort of bushing maybe? I'm no expert) Now it is rare for it not to make the creaking when taking off or slowing to a stop. It only occurs at lower speeds like right when taking off or at the very end of the stop right before the actual stop.
It will even slightly make the noise when accelerating in second gear right after shifting. (This is occasional) When I come to a complete stop and turn the wheel side to side ot will make the sound for a couple of turns and then go away. I have tried rocking the car and pushing down on it to replicate the sound. No luck. I lubricated various bushings and parts with silicon. It seemed to fix it but it only lasted for a few hours. (This could've been coincidental) It doesn't make the sound 100% of the time though. Probably at least 90% though when coming to a stop and going. It seems as the environmental factors (Temp and humidity) have a small effect on the creaking. I have a neuspeed 25mm front swaybar with endlinks.
View 2 Replies
Ok, so my 1.8T hasn't really run right in quite a while, it dramatically goes into boost, then sometimes will just backfire and go into soft limp at around 5-6 psi while accelerating.
Specs:
Stock ECU
3" turbo back
TIP
FMIC
Short ram air with K&N
2.0 coils with proper NGK plugs (I cant remember exact name right now)
All evap/SAI and emissions deleted
Coolant ball deleted
Replaced:
- Crankshaft position sensor
- Camshaft position sensor
- MAF (autozone brand )
- Coilpack wire harness
- Swapped between 2 different N75's
- Piston and spring in Forge Splitter
Below is what I pulled with the vagcom cable I just got in the mail today, along with the DTC names I found from Bentley's page. I know the 411 and 441 are from the SAI/Evap delete but other than that what I should replace next?
VCDS-Lite Version: Release 1.2
Monday, 07 July 2014, 17:30:49.
Chassis Type: 1J - VW Golf/Bora IV
Scan: 01,02,03,08,15,16,17,19,22,29,35,36,37,39,46,47,55 ,56,57,75,76
[Code] ....
View 2 Replies
I had my transmission fluid changed because it was leaking from the pan. I did the job myself but called VW to confirm how much fluid I needed. They told me the wrong amount but we realized that after we did the job.. they did the repair for a huge discount and I only paid $200 bucks for the work for them to "fix" what they messed up. Volkswagen did it and I got the car serviced at the end of April basically. now its the first week of July and under 90 days since the car was service and now it is shifting hard between 2nd and 3rd gear or 35 miles to 45 miles per hour. The car isn't throwing a transmission code I have a vag com and there is no code coming up on that.
View 1 Replies
I changed my oem clutch in my mk4 golf 2.0l with a stage 1 ecs tuning clutch kit. Lightweight flywheel, clutch disk, pressure plate and throw out bearing. But since I have my clutch pedal has been less stiff then usual. I like my clutch pedal as stiff as possible but it just isn't I bled off the slave cylinder. When I was done no air was coming out but it is still way to soft for me. What should I do next??
View 6 Replies
Shifter seem like it is way too loud going from gear to gear? Just holding in the clutch and rowing from gear to gear...seems way too loud, Seriously sounds like shifting gears in my old 5.0 mustang.
View 1 Replies
I have a 2001 jetta 5 speed. While driving yesterday, I had trouble shifting into second gear. When I took the car out of second, I would hear a slight popping sound. Shifting into the other gears was fine.
View 2 Replies
My wife and I recently purchased a 2013 Jetta and have noticed some abnormal lag when accelerating. It's an automatic transmission and the gear shifts aren't as smooth as they should be. I have read that it is possibly related to the drive by wire system and may just be an inherent result of that system.
View 4 Replies
I made a horrible decision after my Ranger got totaled and bought a 94 Jetta... When I first got it, the car had trouble starting in the rain but eventually she would fire up. If I drove it immediately away after finally starting, it would jerk really bad when I gave it gas while shifting, until 4th gear. Once she ran for a bit it would smooth out. Nowadays if it rains the car won't start at all, just keeps turning over and I have to wait for a nice dry sunny day then it starts right up.
My mechanic worked on it recently and replaced a sensor in the distributor and the crank shaft sensor, because they showed up on the diagnostic as bad. Once his work was complete, he said he sprayed the engine with water and it started. So that was a week ago and it's raining and it won't start, the engine just turns over so it's not a starter issue. The car only has 143,000 but I am gonna get rid of it this fall but I just wanna know what this wet weather problem is.
View 3 Replies
I have a 2006 f250 6.0L with 76,000 miles on it. And it just started to shift softer then normal under light throttle. The first to second to third shift are softer then normal. And the third to fifth gear shift seems to have a lot of what I would call overlap and some times it feels like it is slipping. Gets better under hard acceleration but not as firm as it used to be. I have always changed the trans fluid and filter every 25,000 miles. Trans temp runs about 150 to 160deg. I checked the fluid today and it's bright red and does not smell bad. And I don't have any coeds. Could it be a solenoid going bad ?
View 9 Replies
So I just got home from a road trip yesterday, no problems on the trip. This morning I drive out of my neighbourhood, turn onto the highway and I think to myself, that's strange, clutch feels a little notchy ... and then I go to shift gears and it won't go into gear. Any gear. I push down and it just won't engage, it pops right back up. Had to walk a mile home carrying my kid in his car seat and trailing my 6 year old little girl. Now I'm getting it towed home so I can check the engine bay to make sure everything is cool. If everything is connected and I can't determine the issue then I gotta flash back to stock and hit up VW and have it towed over there.
View 9 Replies
I know it will get a little notchy when its cold out, but shifting from 1st to 2nd is really notchy, and the shift box is pretty loud on that shift. I don't think its a trans issue, the noise seems like its only in the shift box. and goes away after 5-10 minutes or so, but it seems a bit excessive, especially for a new car. Car has 3500 miles on it, and has been doing this pretty much the whole time on cold starts.
View 14 Replies
Last couple morning here in Michigan we've seen temps in the low to mid 30's. The last two mornings when I shift between 1, 2 & 3 I'm hearing a clicking noise coming from the clutch when engaging the gear. After a few minutes, once it warms up, the clicking goes away.
I am @ stage 1+ W/VWR intake, but I'm not expecting clutch troubles from that.
View 18 Replies
The DSG in my MY08 R32 is a lemon. It thumps/clunks quite loudly when shifting into 6th gear at low speed (50-60km). It seems to make the noise a lot when it's in D mode.
View 7 Replies
