Golf IV R32 :: Clicking Noise After Turn Signal Turned Off
Apr 19, 2010
So the other day driving to work i was driving my car to work, i put my turn signal on and after i turn it off it still kept doing the clicking noise. At first i thought i was just hearing stuff cause it was early and i was tired, so after work i checked it out again i sure enough it was doing it. It even does it sometimes without even first putting the turn signal on. My buddy and i thought it was a relay or a fuse. Is that right?
View 7 Replies
Advertisement
Had an issue arise today where out of the blue my turn signal decided to turn on and stay on... and i do not mean it was blinking as if i was going to turn i mean solid on, no clue what caused the issue, the stalk is still in the middle position, and when i turn the other side on (passenger/right) it blinks normally, now if I turn the hazards on they both come on and stay on solid, this problem does not even stop when i pull the key out of the ignition, I have to remove the negative battery strap for it to turn off completely.
View 3 Replies
We have a 2015 Sonata 2.4 Sport that has developed an intermittent turn signal problem. When the left turn signal is turned on, the right signal will blink. When the right signal is turned on, nothing blinks. A new symptom that recently started is sometimes neither turn signal will turn on regardless of the position of the turn signal stalk. I managed to get the car to dealer #1 while the LEFT=RIGHT & RIGHT=NOTHING issue was happening but while troubleshooting it, they ran across an inactivated aftermarket alarm system that dealer #2 that sold me the car had installed. I guess the alarm they install is so cheap, it's not even worth removing if they are unsuccessful in upselling you at the time of purchase.
Since dealer #1 would not troubleshoot any further unless the alarm was removed, I retrieved the car and took it back to the original dealer #2 I bought it from. They removed the alarm and the turn signals started working again, however, this lasted about 2 weeks before the symptoms returned. I booked an appointment at the dealer #1 to bring the car in & half way during the drive there, the turn signals started working again. With nothing to show them, I didn't drop off the car. Now the problem is back. Since it tends to come and go, I have try and time when I can drop the car off so it's happening when they get it.
View 2 Replies
My 05 Malibu classic is making the turn signal clicking noise constantly which then causes the warning chime to start going off. I have replaced the turn signal assembly three times and each time it fixes it for a short time then it starts again.
View 4 Replies
I have been reading threads all day. Noone seems to have exactly the same issue so I'm just looking for some clarification. Turn signals dont work but lights work as "parking lamps" and internal climate lights are not illuminating either. Also, my blinkers making the clicking noise but much faster when the turn signal bulbs are not flashing. I had a radio issue but that is resolved. Where do I start? Do I go right for the hazard relay? I read somewhere there was an ignition relay that could potentially be causing all of this?
View 7 Replies
Example, if I'm turning the wheel to the left with the left turn signal on there will be a LOUD click, click, click ect. sound from the column. The sound is louder than the turn signal relay and can be heard with the radio on.
Today is the third time I've brought it in to have fixed and now they tell me it is "normal". They came to the conclusion that it is "normal" because two other trucks on their lot make a noticeable clicking sound and one is just as loud as mine. However, My truck JUST STARTED making the noise a few months ago and was quiet when I originally bought it.
I know this is not a big problem ,but it is annoying and I want it fixed. Anyways, my Ford dealer had bailed out on me so how do I fix it myself?
Can you hear the column switch clicking ALOUD in your truck?
View 14 Replies
I just got a 2003 1.8T Passat about a week ago. I have already installed a new HU and put some subs in it. I haven't really had the chance to test the headlights while driving because I haven't driven after dark since I got the car. When I used the headlights today some strange things were happening.
When the headlights are turned on the right signal comes on and stays on until the headlights are turned off and doesn't pulse. If I try to use the right signal while it is stuck on it makes the indicator clicking noise once then the noise stops but the light stays solid the whole time.
If the headlights are off and I try use the right signal the signal works fine but the instrument lighting pulses with the signal and I assume I haven't noticed this because driven only in the light I probably just never noticed.
The left signal behaves completely as it should as far as I know in all conditions. The hazard lights are also behaving oddly but I'm thinking it's because of the problem with the right signal.
View 2 Replies
This is the first time I ever encountered this then again this is my first non-Honda/Acura vehicle. I pulled into my driveway turned the engine off , opened the door and the sound that signals your lights are on was blaring. I looked and did not have any lights on and all doors/hatch were shut. I could not figure it out why... then I noticed my right turn signal light was on.............. so I clicked it off and the noise stopped. Is this normal for the engine to be off and the signal light stay on and wail if it has not reset itself from a turn?
View 4 Replies
My turn signal relay clicking and stuttering randomly. When turn or warning signal used it operates normally with absolutely no problem and sounds healthy. But when not used and supposed to be quite - it goes again. When stuttering - there is absolutely no indication other than clicking sound that something is wrong.
View 11 Replies
Where the flashers are located? I turned my turn signals on to find the clicking sound, but I couldn't see anything under the dash.
View 9 Replies
I installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
View 14 Replies
So...I'm driving home yesterday and hit my left turn signal when all I get is a fast clicking sound. The light on the dash did not light up at all. Right signal is working fine.
Checked it out in the driveway -- my left signal is totally out. No front, rear or dash light when I hit the left turn signal. When I hit the hazard switch, I get only a right blinking light. The right turn signal functions as normal.
I thought this was probably a bad bulb so I replaced both the front AND the rear bulbs. Got no love - same results.
2008 Prius...
View 6 Replies
This is in reply to a question I just heard on the radio show from Stash (sp?) I believe. He has a jetta and the there is a fast clicking coming from the turn signal after it is used and returns to the "neutral" position. I have a GTI of similar vintage and replacing the blinker did not work. What does work is even cheaper! Get some CRC electronics cleaner from the local auto store and spray out inside of the turn signal switch. What happens is, over the years the lube inside of the switch wears away, allowing the contacts to wear against each other, creating little metal debris that ends up completing the circuit. The CRC cleaner dissolves all of the gunk and gives the necessary clearance inside the switch to allow it to function properly.
View 1 Replies
My wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
View 10 Replies
New owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
View 9 Replies
I turned the car on this morning and my turn signals don't work, there is no clicking sound when I flip the left or right signal and when I step on the brakes the brake lights don't illuminate. Needless to say the cars behind me don't like it when I slow down to make a turn. Can't be the bulbs and the symptoms make me think it is more than a fuse.
View 3 Replies
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 Replies
So one of my headlights turned purple, and I get an "light" signal on the dash. It still lights up but it's purple. I have 23,000 miles on the car and I have had it for 1 year and 4 months. Also, should I get both light replaced.
View 8 Replies
I have a 2013 f350 powerstroke, and the other day i climbed in it noticed that with the right turn signal on that it wasn't clicking through the speakers. Then noted that the arrow wasnt lighting on the dash either. But the lights were still working in the headlight and the tailight. but not the mirror, where to start.
View 2 Replies
There's a clicking noise in the dash behind the headlight switch and all the cluster lights blink on and off when I turn the key. If I try to start it-nothing! If I pull the key out and try again all the blinker lights stay on. Could it be my aftermarket alarm or something else? I didn't have much luck searching.
View 7 Replies
So the Jetta developed a new noise lately that sounds just like what can be head on this video.
The spring-clicking kinda noise only happens when i make a sharp right turn at low speed and seems to be coming from the driver's side. So i though bad outer cv joint.
Well, I put on a brand new OEM unit last night and noise is still there.
View 1 Replies
