Golf IV R32 :: Seat Buckle Airbag Error
Jan 28, 2013
My seat belt latch is throwing the common error:
1 Fault Found:
00591 - Seat Belt Switch; Driver (E24)
32-00 - Resistance too High
I measured block 2 and found that wiggling the seat belt latch showed a 'On' vs 'Too High'. So I know it's that switch inside the latch. I don't want to buy a new latch. But since I always wear my seat belt I could just use a resistor to set it to 'ON' at all times.
I have found a few DIY, but thing seem to vary from R32 to Golf. In this .pdf, it is for the airbag defeat, but I am thinking this is a different issue all together.. [URL] .... This guide then shows different wires than the R32... [URL] .....
View 15 Replies
Advertisement
Airbag light came on the other day while out on an errand. Take it to work and pull the codes. I got a low voltage code and a driver seat belt buckle code "00059" maybe I'm trying to recall but unsure. I have a pair of seat belt buckles out of a mk5 Jetta. Do these will plug into my mk4 by chance?
View 2 Replies
Had a rather annoying noise on my R for a month or so now.The drivers seat belt buckle is rattling, If I put some tension on the belt it stops.
View 5 Replies
I'm not sure if this is an epidemic or not but I thought I remembered seeing some others with this issue: when driving alone, usually in cooler temps, the passenger seatbelt buckle near the console rattles like a mofo. I have seen some reports of people getting it fixed at their dealership, some managed to get it done under warranty with some effort. I'm considering trying to fight the dealership to do it under warranty when I go in for my 30k service, but wondering if it's something I could tackle at home. Hasn't been too bad since the weather warmed up so not even sure I could duplicate the issue for the dealer tech.
View 11 Replies
For the first time I noticed a little glowing light[s] in my drivers seat belt buckle [female end....actually 2 lights, one on each side of the female part where the male end inserts]. It glows for about 10 seconds when starting up. Probably useful for connecting seat belt in the dark. What it does at night under normal driving conditions.
I did not see the same light on the passengers' side. Don't know if there is not one or it only works when there is weight in the seat.
Esoteric little item....but just wondering if there should be the same light on the passenger side and , if so, where /how to troubleshoot? Would it be a bulb or built in to the buckle? I did not check rear seat....I will do that next...
View 6 Replies
I just bought a 2015 Camry LE. The back seat belt buckles keep disappearing beneath the seat surface when you try to put your seat belt on. It's even more annoying when you have a child trying to buckle up in a booster seat. I went back to the dealer & they showed me several other 2015-2016's and they all do the same thing. Apparently, it's a Toyota design flaw & not an annoying quirk to my car. Any solution to keep the buckle above the seat?
View 4 Replies
2008 Suzuki XL7 Luxury FWD105,000 miles3.6L 6 cylinder engine
The "buckle seat belt" symbol keeps popping up on the dashboard for the driver's seat even though the seat belt is certainly buckled. This happens off and on throughout a drive, but it does happen at least once every time the car is driven. Other than the constant dinging and the dashboard light, the seatbelt seems to be working properly.
We took it in to a mechanic and they said it is a switch in the seat belt assembly that is failing, but they don’t sell just the switch. They have to replace the whole assembly. They determined this by doing an electrical test in which they compared the resistance of the working passenger seatbelt to the non-working drivers seatbelt.
We are concerned that this is a problem that would cause the seatbelt to fail in the case of an accident. If we ignore this problem and just have them shut the seat belt warning sound OFF, are we in danger? Basically I just want to know how critical is this problem?
View 10 Replies
So tonight I took apart my glove box and center console in hopes of relocating the TPMS button...Once I put everything back together the MFD says airbag error and when i sit in the passenger seat the airbag icon in the center console is flashing and a 2 and a X. Also the airbag icon is on the dash.
View 13 Replies
Having issue with seat belt buckle vibration, passenger side, when the vehicle speed is between 40-50 miles/hr ? It feels like an exhaust vibration transferred through the floor connection of the seat belt. How can I get rid of it ? The vibration feels like a cell phone set on vibrating and is very annoying for the passenger.
View 2 Replies
Where I can get replacement interior panels? The covering on the column between the doors has been damaged by the seat belt buckle. I want to replace it. Where can I get a new or used one?
View 4 Replies
My airbag light went on so i scanned for codes and I got:
00592-seatbelt switch:right (e25) 32-00-resistance too high.
What I need to do to fix this and make the light go away?
View 4 Replies
I picked up a 2016 CSG GTI S 4-door with DSG on Dec 31st. I had an Airbag Error! message come on when I started it this weekend. I went through several cycles of restarts and it didn't go away. I did a quick Internet search and didn't hit on any common problem with airbags, seatbelt pre-tensioners, etc. I called that Saturday and was given a Monday appointment. I was dreading them having to take out interior dash, seats, trim, etc. to troubleshoot. I just got the call that the problem turned out to be with an airbag sensor connection in the front bumper and it is ready to go. Can't wait to get back to driving!
View 5 Replies
2001 F250. My drivers side seat belt buckle randomly releases and it's getting worse. Any sources on a new one or used even. Also, what other vehicles may have the same part number if I go used.
View 10 Replies
I could find mentioned using a 4.7 ohm resistor to disable the airbags at the connector. I need to get my seat re-upholstered and the VW haus wants to charge me like 80 bucks, how can I do this for less money?
View 19 Replies
I need an expert. 2007 Ford F-350 King Ranch and tonight, the wife and I were coming home from friends house and I tried to buckle my seat belt. The receiver would not click and hold the seat belt. Cannot find the replacement. What should I do?
View 13 Replies
I swapped my cloth seats for leathers today and the airbag light came on after... the seats were out of a 2000 golf, so I was expecting to have to splice wires, but, the connectors were the exact same on the cloth from my car and leathers from the donor car... so I just did a plug and play... I scanned with vcds and got these codes:
Address 15 -------------------------------------------------------
Controller: 1C0 909 605 A
Component: 1M AIRBAG VW51 02 0006
Coding: 12621
Shop #: WSC 00000
2 Faults Found:
00592 - Seat Belt Switch: Right (E25)
30-10 - Open or Short to B+ - Intermittent
01218 - Side Airbag Igniter: Passenger Side (N200)
32-10 - Resistance too High - Intermittent
I take it the passenger seat is the problem... I didn't clear the codes, I wanted to ask here first before I did if I need to do anything to connectors there or just the clear the codes?
View 3 Replies
I have a 2004 Jetta which has the 2-wire seat belt sensor on the passenger side and a 4-wire sensor for the drivers side. I swapped seats from an older style MKIV which had no seat belt sensor on the passenger side and a 2-wire seat belt sensor on the driver side.
As of now the seat belt sensors are disconnected and I am throwing seat belt sensor codes for both passenger and driver side. I have already tried to clear the codes via VAGcom...took care of 2 ignitor codes, but not these seat belt switch codes.
Is it possible to splice in the 2-wires from the older seats to the correct 2 out of 4 wires coming from my car? What's the difference between the 4-wire and 2-wire connector on the driver side?
Also, reading through the DIY here: [URL] ..... It states that I would need a recoding of the Airbag controller in VAG-COM to deal with the airbag light. What this code is suppose to be?
View 9 Replies
Last winter I had to replace my front passenger seat. The seat was starting to burn a hole or two, generally getting too hot for the passenger. At about the same time my airbag warning idiot light came on! I changed my front seat. The seat change was no biggy, but I keep getting the airbag light! Can this be cleared simply or only by a dealer?
View 8 Replies
While driving on the highway I lowered my seat. Once it got to the lowest setting, I heard something sort of like a snap, and it threw an airbag light, so I raised the seat back up. I'm new to VW, but I know there's lots of possibilities for the light.
2000 Jetta GLS
View 2 Replies
I went to a stereo shop to have all my doors covered with DynaMat. They did a great job there but now I have an airbag error. How do I reset this? I do have a VCDS cable. I know it was because the battery was not unplugged before the door trim was removed so I'm not that worried, just wondering if VCDS can take care of it or I MUST go to the dealer.
My other issue are the interior lights. I had them all replaced with LED bulbs and when I left the shop I turned the map lights on and all was good. I left the shop to put some fuel in and when I started the car again I had no lights. Now NONE of my interior lights go on. What Happened? I've seen plenty of people with LED bulbs in their cars so I didn't think anything could go wrong? Do I just go back to the stock bulbs?
View 17 Replies
I have a 2012 passat se and the airbag error light came on, after it did all the buttons on the steering wheel and the horn stopped working. How is the best way to fix this?
View 4 Replies
