Golf V R32 :: Slight Grinding / Vibration Noise On Takeoff?
Sep 6, 2016
I've recently been hearing a grinding/vibration noise on takeoff. I only hear it pretty much as soon as my foot comes off the brake, when the car is in drive, and the car gets its first bit of forward engagement/movement. It seems to only happen when the DSG engages in drive, before I put my foot on the gas pedal.
The closest thing I can say it sounds like is an exhaust rattle, but way less violent/not metal on metal sounding.
View 2 Replies
Advertisement
2001 F250 7.3L 280k miles. Truck is new to me in the last 6 weeks. Was driving out to Glenwood Springs last night and I got a weird rear end vibration between 79 and 81 mph - couldn't say if it's a new vibration as haven't had the truck long enough. It's sort of still there over 81 but less obvious than bang on 80. Whilst the vibration was there I caught a slight dip in the road that caused a grinding noise to accompany the vibration - I'm guessing because something's was getting extra loading on the upside of the dip.
I'm away from home until Monday so my options are a bit limited, however while crawling around in the dark last night pushing and shoving stuff to see if anything was loose I noticed a couple of things:
Minor leak from pinion seal - but it has flung some spots of oil. Drive shaft 'center bearing'(? U shaped attachment on drive shaft to chassis with rubber bearing?) has play I can push the drive shaft at least a 1/4" with my hand and it seems a little sloppy but I'm no mechanic.
I'm going to check transmission fluid level today and top up if required and check the magnets, such that I can limp home as necessary avoiding 80 and get the diff checked and pinion seal replaced. Does the drive shaft bearing need changing or should it have that much play? I'm assuming it's LSD on the rear?
View 14 Replies
Noticed A Slight Hesitation On Take off?
View 23 Replies
I've noticed recently that on startup I'll hear a minor grinding noise after the engine has kicked over. Seems to happen more when the car is really cold.
View 24 Replies
I've got 39K on an 04' R32, just had new tires put on 17" rims and the car was aligned. Whether the alignment has anything to do with these noises I'm not sure but thought I should at least mention it. I'm also still on the original front brake pads if that matters.
So, shortly after getting the tires & alignment done I was driving at around 35-40 mph down a steep hill and applied the brakes. I heard what I'll call a clunk and it felt like something shifted. No other noises were heard or felt until I got home. As I rolled backwards into my parking spot with the tires cocked to the left I hit the brakes and again heard a clunk. However, this clunk was much quieter. It sounded like it came from the front drivers side wheel and I could feel the "clunk" in the steering wheel ever so slightly.
Next day I went down the same hill and applied the brakes quickly and a bit hard. Nothing. No clunk, no noise, nothing. Got home and when parking heard/felt a small clunk. A friend said it might be the caliper or pads shifting which made sense to my ignorant a$$ because the pads are originals.
Since I don't drive the car much I'm waiting on getting it checked out and wanted to do some research here before I take it in. Well, it's time to take it in because now I'm getting a slight grinding noise when the wheel is turned any amount to the right and also when I turn hard to the left. I can feel a slight vibration in the steering wheel too when this grinding noise occurs.
I've seen some posts that seem similar to my situation. They include wheel bearings, sway bar linkage, coil something or other and hopefully not CV joint. Is it possible the alignment caused something to go bad? If so, I'll go back to that shop. I really want to avoid the dealership because I hate being raped on parts.
View 3 Replies
I know it's stupid but rattles and vibrations in an otherwise quiet car drive me absolutely crazy.
So, driving I have noticed this slight non-metallic vibration type noise. It seemed to come and go. So I emptied the car thinking it might be something I was carrying around. No such luck. Turned off the climate control, still there. I had the better half drive while I searched. I could never really see anything but thought it sounded like it might be either in the dash or around the floor area. Totally frustrated I unbuckle my seatbelt and crawl into the passenger floor head first. Nothing on the passenger side. I glance over to the Driver side footwell and notice the slightest vibration from a panel that covers the steering shaft as it goes through the firewall right behind the pedals. Aha! A plastic panel being held in place by 2 plastic type screws that are both loose. i tighten them down with a straight screw driver when I get home and silence! The rattle goes away. You might look at yours as well. I think this might apply to all Mk5 cars. Finding/Fixing a rattle like this for me is like finding money.
View 8 Replies
I have been experiencing a slight wheel vibration from the rear of my R32? I am thinking about replacing my wheels and tires, (continental sport contact 2 is what I have now) I have heard that the continental tire has an aggressive tread pattern because i get a tire noise above 45 mph.
View 12 Replies
I am experiencing a slight rumble-strip-like vibration/noise when veering to the right. There is no noticeable vibration when driving straight or to the right - sounds like it's coming from the front. I thought it was my tires but had them rotated with same symptoms/ I first noticed this shortly after I had them rotated in July. So it's probably front suspension.
View 3 Replies
Just recently, my car 6 speed has started acting up and it's got me worried. First, and most notably, when I go to shift into 4th gear, there is a slight grinding noise and its a little tough to shift into 4th. Once it is in 4th gear, though, it shifts and drives fine with no other grinding noise. A buddy of mine says it might be the synchros, but what that means or how I can fix it.
Also, it has been having a rough idle on startup for a while now. It will idle at around 1,200 RPMs for a bit when I start it up, and it will kind of backfire out the exhaust a bit, kind of like it's a misfiring coilpack or something, but will usually go away after I drive for a bit.
Driving my car right now isn't very fun when I am only worrying about what's wrong with it, so I really want to get it fixed sooner rather than later, before these develop into larger problems.
View 7 Replies
I was driving down the street and i noticed i couldnt get it in first gear, almost like a wall blocking it. and then i put it into 2nd gear and i started rolling... i turned my car off and when i started it back up, it had a slight grinding noise (in neutral). i put it in first gear, took out the clutch and i wasnt going anywhere... same with 2nd gear...
so i towed my car to the shop, they said my clutch went out and i "lost first and REVERSE gear".... is that possible?!
View 9 Replies
I have an '04 Corolla with 206k with a slight grinding noise from the right front when I make a left turn. Is it the outer CV joint? The noise sounds like the tire is rubbing against a splash guard but it's not.
View 3 Replies
I have a very slight grinding noise coming from the PS pulley area. Its possibly bearing noise although its hard to say. Is there a specific torque requirement. Any good parts...
View 1 Replies
I've noticed that on cold starts after work, or in the mornings in start up my Santa fe's really rough at idle.. I'd like to say even slight hesitation when I take off.. I notice a drop in RPM and lately harder shifts out of first..
My sf is the 3.5 AWD w/ nav it's a month old with 2900 Kms on it..
View 8 Replies
Just read the comsumer report "Annual auto issue", it reminded me the hesitation issue with the 2.0T (... page 70: We found the Passat hesitates slightly on takeoff from a rolling start..."). Is it a common problem with the turbo engines? it could be deadly when you change lanes on a busy highway.
View 7 Replies
I recently was driving down my road in an ice storm from work and slid sideways into what I think was a depressed storm drain. (Lots of snow as well so unable to tell what exactly what it was) I hit the right front tire/rim into it. It was the loudest thud, one where you would think the tire came off. Nothing apparent visually, but on the highway it did create a slight vibration so i had both front tires re-balanced. Again, still a vibration about 35mph and up. Rebalanced again and still the same exact vibration.
It's not like hand numbing on the steering wheel but annoying and when you know you car in and out you know what vibrations are supposed to be there and which ones aren't. The tire place said the rim was not bent. Has anyone else had a similar experience? I was thinking of switching that right front tire to the back to maybe see if that worked with the vibe. Next step would be an alignment but the tire place insisted that wasn't the problem since I had one in November when the snows went on.
View 7 Replies
Just purchased a used 2008 prius with 80,000 miles on it. Braking system makes slight grinding noises when getting below around 10mph. I know the brakes are different, so I'm not sure if this is normal or if it means my brake pads need replacing? Car didn't come with an owners manual .
View 6 Replies
I've been catching up on some minor things with my car and have gotten to this one issue I've been having. When I take off from a stop I get a very slight click. Not every time but most of the time. It's a 2005 Elantra GT 5 speed. I replaced both axles due to torn boots. There is no play in the front end whatsoever, so I have ruled out ball joints and tie rod ends. Anything else I should look at?
View 15 Replies
2015 GTI have a slight vibration at Idle speed is this normal I have a 2008 a3 that car doesn't do it, it's almost like it's misfiring I know the car switches between direct injection and port injection?
View 6 Replies
In the last week i have noticed a slight vibration and click in the 6mt on my 2010.
It happens when i have the car in gear, and was accelerating but then lifted off the gas without taking the car out of gear. what happens is about a half a second after lifting, the gear shift gets a little shake for a tenth of a second, which comes right with a faint click (like a solenoid clicking) which is from right about mid right thigh in the middle console. it also is louder and more vibration in the lower gears, almost unnoticeable in 6th
I never noticed this before, its rather annoying in traffic. Thinking I want to take the car in to see if something needs work.
View 15 Replies
Driving home from work today I hit the largest pothole in my life (seriously). I had a slight vibration between 40-50mph after the impact. Got home took the wheel off and it bent it partially and bubbled the sidewall of the tire. No worries I have the VW wheel/tire protection and can get it repaired and get a new tire. What really concerns me is the right side axle. It clearly hit the frame of the car and is indented slightly. As I turn the axle by hand I can tell it's slightly off on one side. My question is do I need a new axle? Or do you think the indent is throwing me off when I spin it making it look unbalanced?
View 6 Replies
So having done a single track day, I feel like my rotors must have warped, as there is now a slight vibration when applying the brakes. This is very surprising as I don't do anything out of the ordinary, and tried to use brakes intelligently, including a proper cool down lap and so on. Is this normal? What are my options for making life better? Is there some set of rotors I should get that wouldn't be prone to warping like this? Is it a question of pads?
View 18 Replies
