Just picked up a new to us 2004 GX470 for my wife.
One of the things wrong with the GX470 is the passenger door exterior molding is unclipped at the bottom. I ordered new clips from eBay and they just came in. Now I just need to figure out how to get the molding off without making the problem worse so I can replace all the clips.
How to get the plastic exterior molding on the base of the doors off. I see 2 screws and thats it. Is there a trick to it? I need to replace the passenger side or epoxy one of the clips back on then remount it.
View 2 RepliesMy driver side door molding is missing a clip. This is the bottom half of the mold and one of the clips snapped off. I've checked junk yards and they never have any GX's. Just to elaborate the clip I'm missing is on the exterior side of the door, down by the bottom edge.
View 2 RepliesHave owned my 2008 GX470 for about 8 months now and love it. However, over the last month I have noticed the molding between the driver door and roof has been popping out. I don't know if there are clamps down in there that have fallen out or if the molding just needs to be clamped back in. Picture is below.
View 5 RepliesHow to install the rear door glass chrome molding? Do I need any special instructions?
View 14 RepliesChrome Side Molding coming loose on passenger back door. I tried a clear silicon and clamped for 3 hours. Unclamped and trim is lifting back up ?
Looks like clip behind trim snapped. Any kind of glue or adhesive can be recommend that will work?
While clamping trim to door I put a crimp mark in trim. Somewhere down the road I will replace this crimped trim.
My 2008 460 has the damn peeling drip molding on the passenger side. I found a wrecked 07 gs of the same color in a local wrecking yard and I was wondering how hard it is to pull off the drip molding myself. Do I need any special service tools? Don't want to damage my car.
View 2 RepliesOn my 2007 Prius the exterior lock button on the driver door works maybe 1 time out of 10. After shutting all the doors I press it and usually nothing happens (when it works, it locks all the doors and makes the beep sound as expected).
View 6 RepliesMy car is Lexus Rx 400h, 2008, AWD, European version.
Looking for installing this chrome "molding" under the doors?
Recently, I noticed that the left passenger side door will not close all the way. It seems that it needs a bit of excessive force for it to close all the way when I'm closing it, otherwise it will not close properly. The other 3 doors close normal. At first I thought it was my wife that leaving the door like this until I experienced it myself. I close the other 3 doors like you would close a normal car door and they pass with flying colors. However, when I close the left passenger door, it didn't close shut. I wonder what can I do to make it close normal like the other doors. GX470 2008....
View 5 RepliesI changed the actuator motor on the DS passenger door. Now the door does not open. The electronic lock moves, locks and unlocks but the door does not open from inside or outside.
After a few tries the lock tab chatters but the door still does not open. What could be wrong? As far as i know i put it back together, like i took it out.
How to take the panel off from inside then i can atleast get to the two wires that go to the lock and see if i can open the door to take the actuator out once again.
Lately I've been having issues with my windows, door locks and power mirrors not working. Here are the symptoms;
What works;
Driver window Sunroof Key fob unlock/lock (Also all of the doors unlock when I open the door)
What does NOT work;
All passenger windows (they were working intermittently before but now none of them work) Door locks from any panel (Sometimes I can unlock the doors but can never lock them) Side view mirror controls
Seems like it could be a faulty ecu. Plan on removing the door this weekend to inspect everything.
Now that I have the audio upgraded in my LS, we have uncovered a slight issue with the drivers rear door. The installers will work with me, but I thought there is so much knowledge up here, why not ask.
Everything else on the vehicle works perfect, its just this one door as if all the power is off or disconnected.(ACC or ON power it functions fine) I have checked the fuses under the driver side and the ones in the trunk, they are all fine and we took the front driver door apart to make sure any connections were good. everything seems secure, we even looked over the ECU in the door to make sure it didn't seem fried or anything, all functions on front and passenger doors are perfect.
Here are the symptoms: passenger rear door light wont come on with the door open unless the ACC is on. the other 3 turn on, with or without ACC.
The door lock actuator from the outside on this door wont lock the doors or with the sensing when you approach with the fob and grab the handle (as in the lights there wont light up).
The door closer that finishes off the door being slightly open wont grab and pull it in.
The trunk lights wont come on and there is no fuse or connection issue we can see. Its puzzling.
How do I remove side chrome door molding? Do they clip off?
View 3 RepliesJust noticed the other day that the door handle on my GTI squeaks when pulled, especially when done slowly. The only one that does it is the driver's side. I'm guessing it needs some kind of lubricant?
View 7 RepliesLooking for a DIY about removing exterior door handles? I am referring strictly on the handle, not the mechanism inside the door.
View 1 RepliesI have a 2005 V8 Phateon. The molding on the driver side and rear passenger side door molding is coming off. Any clips you have to buy or can you just slide it off and put it back? Don't want to break anything trying to take the molding off.
View 2 RepliesChrome trim on passenger side near headlight popped out some of it broken (only the pieces on the inside) any way I could salvage this trim without having to buy a new 1?...
View 4 RepliesI have an 01 B5 Passat and the interior cloth covering surrounding the front door frames keeps coming off the rubber gasket. I have tried many different types of glue and contact cement but nothing seems to last longer than a few months.
View 3 RepliesI've noticed on both rear doors, the Lower Moulding (black cover at the bottom of the door) #12 in the attached diagram (Light Blue Circle), is very much separated from the body of the car, it's like bended toward the outside, but it seems to be exactly the same on both sides, I am not sure if this is normal or mine has a defect
Both front doors are OK, not 100% perfectly aligned with the body of the car, but MUCH better than the rear doors....
I have the car door apart, how to remove the panel on my camry. I got all the way to where I have to remove the outside handle to completely take out the part that has the actuator built in. Everything is all good until I got to this part. How to finish getting the handle off so the part that goes into the electrical mechanism where the actuator can be removed is done. I got the mechanism basically hanging there. I got the two bolts to what I thought was holding the outside handle on. One bolt is on the side of the door covered by a rubber grommit and the there inside the door in the middle of the handle.
View 3 Replies