Lexus RX 2004-09 :: Clunk Noise From Rear During Slow Speed
Jun 26, 2015
Problem is noise that you can describe as clunk, not any harsh or sharp sound. It appears on road bumps or unevenness during slow speed up to about 40kph/25mph. The noise has not been heard over that speed even in bad bumpy roads.
List of thing I've done so far:
- Driven with empty rear compartments
- Driven with open rear door
- Checked the tightness of spare tyre
- Replaced rear stabilizer bar linkages
- Replaced rear stabilizer bar bushings
- Replaced rear axle carrier knuckle bushings
Could it be possible not coming from rear? Should I sit in the cargo space while somebody else driving, any success with this? What to do next?
View 10 Replies
Advertisement
I recently bought a CPO 2007 GX 470 with 110k miles. At no charge dealer made repairs re the Bulletin about clunk in rear when I slowly drive over speed bumps. Had all front and rear shocks raced with OEM shocks, and four new Michellin MS2 tires installed. Rear end still feels like is is bottoming out sometimes during regular local and freeway driving when going over different times of road bumps.
My 'i89 a Dodge Ramdharger ( only car I ever bought brand new off the lot ) with 174k miles and old shocks and original springs drives better over bumps and speed bumps than the GX. One Lexus dealer said the reason is because the rear air bags ( that are not leaking )do not fill up fast enough when going move bumps and that can cause the bottoming out feeling. My mechanic is going to check it over again. What could be causing the bottoming out feeling?
View 6 Replies
Just like the tittle says. My 2011 ISF with 56k miles on it is making a Clunking noise when pulling out of a parking spot or just anytime I fully steer to the left side and begin to move. If I try it in reverse it doesn't matter if I turn the steering wheel fully to left or right it makes the same noise as I begin to move at slow speed. It almost feels like something is pushing the front wheels out. During normal driving I don't feel anything at all, just as steady as solid the car can be.
Is there any common issues with ISF with premature wear of ball joints, cv joint, sway bar bushings or hub bearing?
View 7 Replies
My wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
View 2 Replies
I got a TSB done on my clunk about a year ago. The old clunk felt like the car was hit from behind at a low speed collision (I have the experience). But now the car has developed a different type of clunk. Now it feels like something is hitting me from directly below my feet. I can actually feel the vibration right between the sit and pedals. What gives now? Is it the same thing, anything to worry about?
View 4 Replies
I have a rear wheel bearing type of noise that appears to come from the rear. My vehicle is front wheel drive and has 135K miles.
I checked the rear wheel bearing/hub assys on both sides and they had no play but I changed them anyway. Noise did not change at all. Rear tires have normal wear, no cupping or anything. Noise gets louder with increasing speed up to a point and then remains a constant level.
My next thought is to check the front wheel bearings/cv joints.
View 6 Replies
I would like to post this performance issue on my 2003 GX470_79Kmiles which happened on the freeway yesterday. The sequence:
1) During start and at idle/stationary, the rpm shoot to 1100rpm and stayed there for a while, i would think that it was normal since the engine was still cold.
2) Drove to the freeway, I noticed that speed is very slow to pick up. My normal driving experience was that at close/equal to 2000rpm, the speed usually at around 70-75mph. But there was a considerable reduction of speed at around 60mph at almost more than 2000rpm, plus a buzzing engine noise. I tried to really rev-up the engine but very sluggish to pick up the speed not even close to 70mph.
3) Drove the car to lexus shop this morning, top speed of 60 to 65mph and tried to rev it up to plus 2000rpm to pick up speed, but the engine noise is very abnormal.
View 6 Replies
I have a clunk/rattle in the drivers side front end when I go over a small bump at a slow speed. The dealer said it was the struts - they replaced them along with the upper support thing. Noise still there, next they said it was a worn motor mount - noise still there --
View 1 Replies
I have had an issue with a clunk in the rear end. Passenger side. It was only happening when I would hit a bump. Over the last couple days it has started getting worse. At about 40 mph and above the clunking will increase and can be fairly rapid. Also have a slight vibration at that speed. Do not feel it in the steering wheel.
I think I have narrowed it down to the rear knuckle? bushing. While holding onto the bushing I rocked the top of the tire in and out to produce the clunk. I could feel it in that spot. I had ordered a set of bushings, months ago, which claimed to be a direct replacement.
Tonight I decided to try and swap them out. Should be easy. Nope. The old bushing will not come out. I have some pictures. Maybe I need to call my mechanic in the morning? My diagnosis might be wrong anyway?
View 10 Replies
I have a clunk/rattle in the drivers side front end when I go over a small bump at a slow speed. The dealer said it was the struts - they replaced them along with the upper support thing. Noise still there, next they said it was a worn motor mount - noise still there --
View 3 Replies
Our 2005 Ford Taurus makes a rhythmic clunk from the rear when you slow down. The rhythm seems to slow as you brake. The noise isn't there when you are cruising or accelerating, only when you slow down. We recently drove 2000 miles with a small trailer attached. Could that have anything to do with it?
View 1 Replies
I just replaced all 4 struts on my 04 Camry. The car has 87,000 on it. I went with the Monroe OESpectrum struts and new strut mounts (Monroe). Springs looked fine, the rubber spring seats were fine as well and the bellows, so reused those items.
I now have a noise in the rear end that I did not have before. It sounds like it is coming from the lower part of the car and is not metal sounding. It is a very dull clunk when going over bumps in the road and is coming from both sides.
I replaced the sway bar bushings a couple years ago. I checked those and there is no play and appear to be fine. Also checked the sway bar links and they seem fine to me, but not sure what makes those bad. Torqued what I could. Used an electric impact wrench on the strut nuts and could not torque that because the rod spins.
I am taking it in on Monday for an alignment and to have the shop see if they can figure out the noise. Is it possible that the new parts could be binding and the alignment may take care of it? I have doubled checked my work and everything appears to be on correct.
View 2 Replies
Hearing a slight clunk noise inside the back of thier gen 2? I've taken apart all the paneling used foam tape to secure things and took apart the spare tire area etc and the clunk persists. It seems to vary intensity every time I close the rear hatch.
View 4 Replies
Have a slight clunk noise inside the back of their gen 2? I've taken apart all the paneling used foam tape to secure things and took apart the spare tire area etc and the clunk persists. It seems to vary intensity every time I close the rear hatch. I now suspect this thingy I found mounted in the center of the rear hatch under the plastic...
View 6 Replies
My 2007 GX470 is making a clunk/thud noise when braking (more often when braking hard or on a downhill slope) and then again when I let off the brakes and start to accelerate. It is significant enough that I can feel the car jerk some when it happens, almost as if someone has tapped the back with their car. What it could be?
View 2 Replies
My RX350 is a 2007. Recently replaced the two front struts and noticed the passenger side is exhibiting this peculiar clunking/clicking/popping sound when turning. It mostly happens when turning in motion but once in a while when parked. Clunk/click sound usually only occurs once, or in a short series of 2-3 times, during turning.
Video of this clunk/click while parked : [URL] ....
Noise is almost silent at the strut mount/bearing, so I suspect it's lower in the assembly. Can feel the clunk/pop vibration with hand placed on the lower spring seat.
Took the tire off and thoroughly inspected things. No tears/leaks in any joint sleeves/bushings. Tie rods and CV joint look fine, as do strut mount, bearing, upper spring seat, insulator, rubber bumper, sleeve, and spring. None of these were replaced during the strut replacement as everything looked great and with only 55k miles.
I've not been able to reproduce the issue with the engine off, nor when the tire is off the ground when jacked/lifted.
During Google searches, it was suggested the culprit is likely either the strut mount/bearing or CV joint. We removed the strut today and everything looks the same as during the install. We can't reproduce the sound with just moving the knuckle around with the strut removed. Strut mount/bearings look in excellent condition.
View 12 Replies
I have a '13 SE that I purchased new last year and recently I've noticed a noise in my steering when I am turning the wheel at slow speeds.
It's like a clunking or knocking noise when I turn the wheel either right or left all the way. I'm totally clueless as to what could cause this sort of noises.
View 7 Replies
So I cant figure out where this is coming from. It only happens when the car is in low RPM. Like starting from a stop or going slow in very low RPM I hear plastic rattling constantly. I went in the back and the only thing that is making similar noise is when I tap on the plastic cover of the rear hatch under the window.
View 3 Replies
2001 Santa Fe 2.7L 4wd ... In December I bought this vehicle it only has 95K on it. When I drove the car home I noticed it needed brakes so I put brand new pads and rotors on the whole way around. I changed the oil, air filter, wiper blades, and made sure all fluids were good. I had the front spring recall done and also put some new sway bar end links on the front. The car runs fine and I am rather impressed with it. It does have some rust but I'm not to worried about that. This isn't my everyday car just a winter/extra car. Recently I have been getting some clunking only when going from reverse to drive and going slow. You get a clunk..clunk pause clunk..clunk almost like you have a flat but once I get the car up to speed it is fine and you never hear it again until the car sits a day or so and then it will do it again. I don't know if I have a differential problem or a u joint or maybe something with the e brake or rear brakes? but it is -3 right now outside and I would rather know where to start so that when I can take a look at it I know some things to check or what it might be.
View 3 Replies
Lariat stepside, 5.4L with 150k miles. Loud popping noise, almost a clunk, when making a slow sharp turn. Put it on jackstands and did the normal tire grab and shake and found no issues there. Tie rods, ball joints and sway bar links all seem tight. Looked for signs of unusual rubber to metal and metal to metal wear and found nothing. The only thing I did see was the rubber boots on the upper control arm ball joints were split. What I have checked or if I am missing something?
View 9 Replies
2010 f150 4x4... Whether I'm in 4wd or 2wd when I turn at low speed something in the rear has slow clunking but clears out after a few feet of going straight. This occurs with or without a trailer behind me. Just bought this truck a week ago m noticed it about the third time I drive it.
View 4 Replies
