Maxima :: 2002 - Shudder When Braking From Speed
Jul 25, 2011
I replaced the pads and rotors on the front end of my 2002 maxima (it had a shudder when braking from speed). By mistake, I did loosen the spindle nut, but re-tightened it. Braking is smooth, but I am plagued by noise. Used CRC on the back of the pads, have pulled the tires/wheels 3-4 times looking for looseness, mistakes, etc…. This is a pretty simple job – right? Even had the front wheel off my other 2002 (yes – I have 2…love this year/model) and compared them.
Did I cause an issue with the loosening and re-tightening of the spindle? Is this just a spline? I have it “wrench” tight and it had not loosened up even with 500 miles driving. There is not any play in the wheels mounted to the axle… What do I need to look at next?
View 9 Replies
Advertisement
My 2002 Ex 4x4 developed a shudder during breaking. Today while trying to jack it up and put on jack stands. My 2 3/4 ton jack was too weak/short to lift it up to put on stands. I am using 6 ton stands just to lift the front.
So have to get new jack. Keep in mind I don't have a ton of cash for new jack. What size are you all using to get your ex up on stands?
View 14 Replies
I have a 1998 Nissan Maxima, and when I brake or am moving very slowly in stop and go traffic, my car sounds like a foghorn. I am thinking maybe I need new brake pads, but I thought brakes were supposed to squeal when they are bad. I remember them squeaking a little bit, but nothing major. Then all of a sudden I'm starting to get this foghorn sound.
View 2 Replies
So I bought my R with 9000 miles on it, and I noticed a little bit of shudder when braking. For some reason it is starting to get a little worse.....and I haven't been bagging on it. Really, warped rotors....at 9k.
View 24 Replies
I got a phaeton v8, I feel a big shudder in the whole car while I have an amount of pressure on the brakes. for example: when approaching a red traffic light soft braking: no shudder, half braking: shudder and when hard braking the shudder is gone again. what could be the problem?
View 24 Replies
2010 Camry LE 4 Cylinder (~76,000 miles)
I purchased new tires for my Camry at a mileage of about 70,000 (~11/2015). I do mostly city driving. A few months ago I sometimes started noticing a steering column shudder upon braking when traveling at higher speeds (~50+ mph). I read on the web that this type of shudder is typically caused by warped rotors.
I was considering getting a front brake job (new rotors + pads), but decided to get a tire balance/rotation. It was reported that the right front tire was out of balance and that now all four tires are in balance. After the Balance/Rotation, the problem was still there but not as bad (Shudder reduced by at least 50% over what was experienced before the balance/rotation).
I went to a brake shop and discussed the problem and they said that they suspect that there may still be a problem with proper tire balancing. They recommended a second opinion on whether or not the tires were properly balanced. They did not explain 'second opinion' so I went to where the tires were balanced two weeks earlier (Discount Tire) and they did a free balance check and reported that all four tires are still balanced.
Basically, I have no detectable shudder at less than ~50 mph. All rotors and pads are the original ones that came with the car when it was new.
View 2 Replies
So I just bought a 2004 Ex 4x4 4wd with only 50k from a dealer. While test driving the truck would shake/shudder when braking at 50-70 getting worse if you were going faster, as a condition of the sale they said they would look into it. They did and said it was the tires?? They balanced and rotated and did and alignment. Are they correct? the tires are BFG AT 33x12.5x16.5 on aftermarket rims.
View 11 Replies
I have an '09 Avalon with 34K miles. On braking we get a shudder. It's especially noticeable on gentle braking. I am pretty sure this is due to the brake rotors being warped or whatever the correct term is. Are these covered under warranty? I'm a skeptic and I feel sure the dealer will try and blame the tires but they are wearing evenly and are rotated every 5K. The ride is smooth when not braking so tire balance should not be an issue.
View 7 Replies
I just bought a 2007 Sonata V6 (GL or GLS). Before buying the car, the last owner had the rear brakes "serviced" because the mechanic said the brakes were "sticking" - charged the old owner $300 for it. When I am on the highway and I brake, the rear brakes shudder. Do you think the shudder is because the rear brakes are still sticking, or because it needs new rotors?
View 5 Replies
Picked up my MK6 GTI DSG last Saturday. I have noticed a slight shudder when braking and coming to a gentle stop. At first I thought it may be the brakes bedding in so I kept it over the weekend. By today there's still no change. Is it normal for DSG transmission stop like this? Because I have never driven DSG transmission.
View 11 Replies
I have a 199 Ford Expedition that started shuddering several months ago. The shudder was the most pronounced when braking, but was also pretty bad when accelerating and letting off the accelerator.I took it to a Nationally recognized service center. They charged me over $1,200 to replace everything associated with my brakes, but the shudder, (although no longer so pronounced when braking), was still there.Their best guess was the “U” joints, but since they had just a little play in them, they weren't sure that that would cause so much shudder.I took it to a Ford dealer. They had it for 3 days, and charged me $366 for a diagnosis that I had 3 different brand name tires, and the All Wheel Drive was having difficulty keeping the wheels in sync.The problem seems to be most pronounced when letting up on the accelerator Also pronounced when accelerating, not as much so as when letting off the accelerator, but when cruising steadily with my foot on the accelerator, it nearly goes away.
View 2 Replies
I got a 2006 Solara SLE. while braking from highway speeds, the steering wheel shakes VIOLENTLY. city driving its not noticable. cruising the car is silky smooth. The one front caliper was sticking and i replaced pads, pins, rotor. Still shakes. i tried swapping pins as one pin has a sleeve at the tip and i didnt remember which one went where. i did notice the pin with no sleeve fits loosely. the rotor is AZ Duralast brand. the car has 200k trouble free with no suspension work ever done.
I am lost what to do and need to make a long trip coming up. I was going to try in order- replace other rotor, spin the one rotor and replace guide pin with a sleeved one, then do lateral run out test/lathe, alignment, then if that dosnt work a stick of dynamite. Iheard a bad tie rod or ball joint can cause this, i find it unlikely as it would probably shake all the time. Other small issue is a loud thunk in the rear when it hits bumps. Rear swaybar mounts?
View 5 Replies
So Ive got slotted rotors with Hawk pads up front. I put them on a while back, pads are probably getting to the end of their life. Rear brakes and rotors were done by the dealer recently. X code springs up front, stock springs with RAS in the rear.
Under quick, semi-hard braking I get some heavy shudder, not sure if its from the from or the rear. I had been thinking it was probably the brakes themselves, and planned on addressing the fronts soon. But then I read something around here about axle wrap under braking, and am now wondering if that's the cause. I am pretty sure that big rubber cone on my rear springs is gone, and I read that that is what prevents axle wrap.
View 4 Replies
The truck is a new to me 99 f250 7.3. The problem occurred before doing the brakes, and after. The front brakes had new pads and calipers(rotors appeared to be in good condition) while the rears got New rotors, calipers, pads. The persisting problem is a really bad brake shudder that seems to be getting worse. It only occurs below about 5-10mph when braking. on this trip back to school there is a hill with a stop sign at the bottom where i should have rolled forward when i let my foot off the brake. This didn't happen.
It almost seemed as if the tires(meaty 35in dick cepek crushers) where rubbing and catching on something. but we checked and it didn't seems as if they were, though they do come somewhat close to the bumper. Im not even sure if its brakes or what it is, a friend of mine said possibly the hubs, but what can i do to pinpoint it? I wanna try loading down the front with something to simulate the drop when braking and see if the tires do indeed hit as when going to a rolling stop with only a little braking it doesn't do it. Any other things to check?
View 7 Replies
I have Nissan Maxima 1996, everything is good as far as I know until recently it started stopping shutting off on the road, sometimes when am going at high speed it gradually decreases speed and come to stop.
View 1 Replies
So my 07 with 125k miles has had new rotors for about 50k miles or so, but for a while now when the brakes get hot it gets a violent shudder on braking at highway speeds....the odd part to me is nothing at lower speeds, and not always at higher speeds....do I just have warped rotors again? The rest of the front end I good and tight....
View 9 Replies
I had the transmission replaced last fall under warranty. the VW rebuilt unit was 09L 300 035 PX. When unit was replaced the dealer used G 060 162 A2 as the fluid. Was that the right oil? Shouldn't they have used the upgraded G 055162 A2 and the new reflash? The shudder has started to return and I am off of warranty.
View 15 Replies
2008 F250 Crew Cab 5.4, 79K miles, had new brake pads installed at 40K miles. Recently, I noticed front end shudder and some pedal pulsation while braking. It started kind of sudden. My first thought was a warped rotor.
When I took things apart, I found passenger side front rotor was cracked and the caliper pistons were rusted and falling apart, the old pads were only worn about half way. My thoughts on a bad rotor were confirmed, and then some.
I replaced the broken caliper, both front rotors, installed new pads on all four wheels, and bled the brakes. To my surprise, the brake shuddering did not go away. I'm stumped.
View 10 Replies
I have a 2002 Nissan Maxima GLE. I had had problems with it misfiring. It said it was misfiring on cylinder 6. Put all new spark plugs on it, same problem. Put new ignition coils, still same problem. Had it checked by several mechanics. NONE of them could find why it wasn't getting power. Then about 2 weeks ago I was driving it home & it died. Got it started & it drove less than a mile & died again. when it died that time, I suddenly had NO POWER to anything in the car. Lights don't work, no horn, no radio, no beeping when key is inserted--NOTHING. if I let it sit for a day or two, it will start clicking & then interior lights will come on--until I put the key in it & turn it over. Then I am back to no power. It does not crank or anything when I turn the key over. I have had the battery checked and they said it is still good, had 100% charge--even after being off the car for over 24 hours. I have been wondering if it is the ignition switch or starter...
View 19 Replies
I have a 2002 Nissan Maxima with 118K that the heating and a/c fan always blows on high. Even when you turn everything off. I've been told it's the blower motor resistor. Is there anyway to check with a volt meter before purchasing new one? Once I buy the new one I don't think I can return
View 10 Replies
Checked but could find much on the throttle body. I have a 93 Chev 1500 2wd 5.7 320000km when I drive on highway, it drives along good when I get to slower speeds is seems to studder. I have to push gas pedal to push it threw. I bought some throttle body cleaner and I noticed that when I sprayed around the bottom of throttle body. It almost stalls. Could this be the reason why I am getting the studder and is that the indication that I should replace the base of throttle body gasket ? I replaced the plugs and fuel filter cleaned iac motor ....
View 5 Replies
