Passat (B5) :: 2001 - P0430 Code / Stutter And Misfire After Cold Start
Feb 20, 2013
2001 V6 Passat with 125k miles throwing a P0430 code.
Having trouble on cold starts, takes about 10 minutes to finally get it to turn over. When it does the idle is extremely rough. For the first 1/4 mile the car bucks, stutters, and misfires. After that it runs fine and starts fine when already warm. I am noticing slightly decreased gas mileage but nothing major.
Valve cover gaskets were replaced 2 months ago, but were leaking oil for at least a year before I could afford to have them replaced. I am still noticing some oil leakage, however not as much as before. I have had both O2 sensors replaced twice in the past 5 years. Timing belt was replaced at 98k. What might be causing the starting issues?
View 1 Replies
Advertisement
I got a 2001 Escape XLT (V6) a couple of months ago. Its in great condition, only 82k miles on it too. It had the notorious door handle issues which I have had fixed. It also had the wet weather stuttering problem, which I had fixed by having all 6 spark plugs replaced (Motorcraft OEM plugs), the back 3 coils replaced, upper intake gaskets replaced, Valve cover gasket replaced, PCV valve replaced (motorcraft).
It runs great when its warm, the problem I am having is when its cold outside and the engine is cold, it starts up fine but idles like crap and if its really cold outside, it starts and dies 3 or 4 times before it can even get to the crappy, stuttering idle. I have to intermittently feed it gas to keep the cold idle going long enough (3 or 4 minutes) before I can drive it. Once the engine is warm it drives like a champ. The only warm engine issue, is occasionally after driving it and putting it in park, the engine will rev up to 2000, 3000+ rpms, and just keep going up until I shut the engine off.
The codes read P0171 and P0174, which are lean on bank 1 and bank 2. It had also thrown a misfire on cyl 6 but once I cleared that it hasn't come back, just the lean codes are still present.
From what Ive been reading, this can be a number of issues, ranging from the IAC valve, EGR valve, MAF or the lower intake gaskets. I'm very much a rookie when it comes to car mechanics, but I think I can handle changing the IAC, EGR and MAF since they are all on top of the engine. However I don't know if I could handle the lower intake gaskets. Ironically, the gaskets are the cheapest part, but the most labor if I paid someone else to do it.
If I replace the EGR, do I also need to replace the EGR Modulator as well? Looking for brand names that are best bang for the buck when it comes to these other parts I have mentioned?
View 14 Replies
My 2001 6.8 L V10 runs great all day & night without issue, but first thing in the morning when below freezing it has a hiccup. It'll fire right up and stutter and stall within less than 2 seconds. Usually twice. Third time it fires and keep running. Is there a fuel check valve somewhere on this thing? Not sure what that would have to do with the temps. Wondering if it's/there's an easy fix or not?
View 5 Replies
I have a 2005 Santa Fe with the 2.7l engine....during the last two summers I've had this code pop up only to disappear. Well, we're into the winter here in New York and the code popped up again and after a week its still on. What's causing this and are there any easy fixes? The wife loves the SUV, its got 120,000 miles on her, the engine is strong and the tranny was rebuilt this summer (that another story).
View 1 Replies
05 santa fe/3.5L/ owned since new. Had a misfire problem and solved that by changing coils/plugs/wires...
Still getting a P0430 code (bank 2 cat efficiency low)
Following the Repair manual troubleshooting of that code says
Read H02S - got a scan tool and did that -
Comparing Bank 1 H02S1 and 2 show they are are different voltages and do not follow.
Comparing Bank 2 H02S1 and 2 show nearly identical traces.
I also checked the wiring harness around the sensors and check for air leaks...couldn't hear/see/feel any.
My conclusion based on the info obtained is that the bank 2 cat is bad and needs to be replaced.
View 3 Replies
Situation 01 Jetta AEG 2.0L codes catalyst below threshold and random misfires.
•found exhaust clogged due up catalyst. It was actually making contact with the rear O2
-replaced cat as an assembly and reset codes with Ross-tech
• start up, idles perfect no hesitation smooth. Road tested it and upon entering freeway ramp at it started stuttering/misfiring
• CEL flashed for cylinder 3 & 4. Inspected wires found #3 lost continuity, installed new wires.
•road tested and same result but only 4 came back. Swap plug with #2 and retested.
• #3 and 4 misfire came back again
- shooting in the dark to identify which way to go with it I tested:
•compression was solid 140
•fuel pressure 35 psi at idle and 45 when snapping the throttle.
-Suspicious spec is 55-72psi
•squeezed the return line to inspect if the Fuel pressure regulator valve possibly leaking excess.
Psi never went higher than 45 at idle and throttle snap to wot
•graphed the tps signal smooth with out drops or glitches up to values of 84 according to toss tech scan tool
•looking at measiring blocks one item that was odd is engine load at idle 99.5%
-swapped parts with known good parts with a good running 2002 Jetta aeg motor.
•MAF -no change
•ignition control module/ coil pack no change
-today ill be checking fuel pressure at the fuel pump and inspect if the fuel filter possibly clogged.
View 1 Replies
B5.5 2001. When I am giving her gas you feel her stutter. But its not like a misfire stutter. Its more like a lose of power. Its almost like shes switching from boast to naturally aspirated. These stutters can also last a few seconds at a time. Where to start looking?
View 5 Replies
It came on 2-3 miles after a cold start. 3.6 with 137,000 miles. What's next? First car I've owned that uses very little oil between oil changes.
View 1 Replies
Ok after finding out I had a bad battery @ Toyota shop they also say the scan is reading an exhaust leak ( I could hear that one ) they also say there is a misfire on cold starts should I worry and what could it be or is it a misread from the other two ?
View 4 Replies
I have an '04 F150 with a P0430 code. Not sure where to start, I have read that it could be numerous things so I thought I should start knocking them off the list one at a time. Thought I would start with the cats. 2004 F150, 4x4, 5.4L, 126,000 miles ...
View 6 Replies
Bought a 2006 (later production) with 25,000 miles over the weekend. Couldn't pass up the price and the warranty (1 year left + CPO). Picked up the car Saturday at noon..... had to drive to DC for business and the CEL came on when I turned on the car this morning. I researched at lunch that it could be a cold start misfire but I am already pretty heated about this. When I get home tonight I am going to plug it in to my OBDII scanner and see what I can pull. If it is something bad.... I am giving it back to the dealership.
View 24 Replies
I get a cold start ignition miss on cyl #2, then goes away (with a little revving), car then runs 100%. No problems during hot re-start. 2005 1.8T AWM. I replaced all four plugs (NGK OEM), all four coils (OEM latest rev), Coolant temp sensor (temp gauge was flaky). No other codes other than Cyl#2 miss and Random Cyl miss. Could I have a leaking (fuel dribbles out) injector on Cyl #2, causing a too-rich misfire when the car is cold started??
View 6 Replies
Car dumbie back again with another question.The diagnostic for my check engine light indicates numerous cold start misfire codes. The cylinders are OK. That was checked during the diagnostic.The fuel intake is carboned up. It is recommended that I clean the intake manifold. Does this mean cleaning the fuel injectors, the throttle body or both? 2006 Passat VW....
View 1 Replies
Our 2001 Passat wagon 4cyl turbo automatic has a random idle stutter. When sitting at a stop light the RPM's quickly drop and then regain idle. It happens at random times and only when idling after the engine has warmed up. It doesn't seem to matter if its in drive or park. What sensor could be failing or a possible cause? Over the past year the problem has increased from almost never to a few times at every stop light. My OBDII reader shows no codes. Car has 105K miles and I cleaned the throttle body.
View 2 Replies
Im working on a 2001 arctic cat 300. After it is started it will run fine for 5-20 sec. 5 sec at idle, and around 20 with more throttle, then it starts to stutter and sounds like a two stroke. If I open the throttle too much, it just dies on me. The interesting thing is that if I restart it, it will run fine for another 20 sec.
The trick I have found to get it running like it should, is to open the trottle very slowly over a period of as much as 5 minutes. After that it will run perfect! The air temperature is that of a typical norwegian summer, ie in the 60s. But it shouldnt take THAT long to warm up. lol
The engine is a four stroke, single cylinder, cv carb, electronic ignition. The carb is the keihin cvk32. What could cause this kind of problems? I have of course taken apart the carb, and cleaned it.
View 7 Replies
I have a 2000 Passat 1.8T. When I start it up in the morning I hear a loud obnoxious noise like a vacuum leak from the engine compartment. It lasts for about 1.5 minutes then runs normally. After about a minute it starts up again and only last for about 7 seconds...ish. When I drive it afterwards, less that a half block or so, the CEL light goes on after 1 beep. Also, at that time I get a messages from the instrument panel that says "Emissions Workshop 1". I've read that it could be a simple damaged vacuum hose to the secondary air pump. Definitely a huge price difference to repair.
This morning is was colder outside than usual and the dash kept beeping and flashing the "Emissions Workshop 1" code intermittently.
View 1 Replies
My car is running great, no issues. I just changed the ignition coils, i was having a misfire. It was easier since i was changing the back to replace them all. My CEL and VSC went on and it is code P0430 bank 2. Before i spend a ton on a new catalytic converter i would like to change the o2 sensors. Problem is, I am not sure which ones to change or where to start. Is this even something i am able to do?
View 2 Replies
My 2009 Camry came down with the p0157 code which I looked up & is oxygen sensor circuit, low voltage bank 2 sensor 2. I'm trying to figure out which side this is(driver or passenger)? Also have a p0430 code-catalyst system efficiency below threshold.
View 2 Replies
My CEL came on and is throwing code P0430. Is it just an o2 sensor? if so which one primary or secondary?
View 2 Replies
I recently purchased a used, high mileage 2004 Infiniti G35x (AWD) 145K miles from a reputable new car dealer here in my town. The car was impeccably maintained and clean inside and out. Just a week or two after the purchase my SES light came on revealing engine Code: P0430 (catalyst efficiency below threshold bank 2) pointing to a new catalytic converter in my future. Infiniti recommends premium unleaded for this vehicle. I found out my son filled her up with mid-grade unleaded. Is there any chance this could have triggered the SES light to come on? (Previous owner states he always used premium unleaded in the vehicle since ownership.) I also double checked the gas cap to make sure it was on tight. I find it extremely odd that the SES light would come on so shortly after the purchase. I mean what are the odds? Don't dealers run a diagnostic scan of their trade-ins to check history and for potential problems prior to selling their used cars? I test drove this car numerous times without any indication of a problem and right on the heels of the purchase it passed state emissions... now just a few days later, the SES light comes on. Why wouldn't emissions pick that up? I have reset the SES light (code) and filled her up with premium unleaded. Now it's a waiting game to see if the light comes on again. If the light reappears, I plan on taking it back to the dealer to work out some kind of "reasonable solution" to repair costs. I'll find out just how willing he is to stand behind his cars. I realize that this is a high mileage car, and I hardly expect perfection, but I didn't see this coming. What to do... what to do... By the way, I checked all the fluid levels ... no discoloration in the oil (fresh, golden brown)... no discoloration in the coolant... transmission fluid, good... all other levels are good. Car runs fine, no rough idle in cold...
View 11 Replies
Just read that a clogged EGR valve is common and reduced performance and increases emissions. Need to clean this valve? Where is it located?? Just noticed tonight that there is not a lot of suction from my vacuum lines and I wondered if this is related. Plus I have a p0430.
View 3 Replies
