Passat (B5) :: Vibration When In Drive Or Reverse And Stopped With Brake Applied
Jan 26, 2007
As outlined in this thread: [URL] .....
I had a recent misfire issue. Unfortunately the dealer has been unable to find the source. Since the original misfire I can feel the car vibrating when I am in drive or reverse and am stopped with the brake applied (ex - waiting at a stop light). It goes away when I drive and when I am in neutral. I realize there is SOME vibration noticeable in gear, possibly because of the way the engine is mounted. However, this seems different.
The tach stays at 750 rpm in idle (it may fluctuate a TINY bit but never goes over 800 at idle) as always. The vibration feels much like a vibration one would feel if a cell phone or pager were left on vibrate. This doesn't seem to be a rough idle where the car is "jittery" or "jerks", and, as mentioned, the rpm doesn't change.
I would think a bad coilpack or plug (plugs changed at 40K, Im now at 45k) would cause a misfire, and a CEL. I've looked into a throttle body cleaning and will do this, but I would think that would cause a rough idle as well. My understanding is that a MAF problem would be similar.
The only thing I can think of is a motor or tranny mount issue, but the car only has 45k miles and this problem was non existent until the misfire. Im almost certain it isn't related to having the car lowered recently.
View 24 Replies
Advertisement
I am experiencing a slight vibration with in drive or reverse but not when it is in neutral. I change the spark plugs and checked the PCV. I have the latest model already and I replace the gasket in the PVC. There is no errors in VAGCOM.. What could be causing that? Mounts???
View 4 Replies
How much movement should the motor have? I have never seen a motor move period, so I am worried about wifes car. This is on topic [URL] ....
View 1 Replies
Is it normal on the 2.0T that when you are driving and stop at a red light to get vibration that you can feel in the car and hear in the motor? As soon as you let off the break it stops and the engine stops the noise. I don't drive the car enough really (my wifes) to know if it is normal or if this just started. It is an 07 and just turned 12k on the weekend trip. Also, having a problem on Sat radio with there being a high pitch hum in the back ground? [IMG] [URL] ...
View 13 Replies
I am about to begin servicing my new/old jeep. I am unfamiliar with fuel inj.
it is beginning to run a bit rough idling in drive with brake applied. It is beginning to start less easily, turning over longer before firing...
View 19 Replies
A coworker has asked me to take a look at their 2013 Camry LE, 48,000 miles. It has a quite annoying vibration at idle and only when in reverse or drive. AC is not running this time of year, but does get worse if the compressor is turned on.
I'd like to think the trans and engine mounts are fine. It does not have any noticeable torque converter shudder. I have cleaned the throttle body, not that dirty, but not much improvement.
I suggested that he try different brands and grades of gas to see if matters improved at all - Shell 89 seems to be a slight improvement over what is normally used (just 87 from Costco, Sunoco, or Hess), but nothing substantial.
Spark plug change, decarbonizing top end?
Spark plugs look about like I'd expect an iridium plug to at these miles - no signs of oil burning, not tons of carbon, etc. I didn't get a real good look at the piston tops.
View 7 Replies
My car vibrates really bad when stopped and in drive. It does not vibrate in park or neutral. I took the car into my local mechanic who replaced the spark plugs, idle air control valve, throttle body gasket, charged me and it actually runs worse. The mechanic assigned to my car said he couldn't feel it so just replaced what he thought might be causing this vibration. It took me a day to calm down and take the car back and speak to the manager of the department who was amazed at how bad the car vibrated. 2002 Honda Accord 86,000 miles....
View 7 Replies
My car stopped in the middle of the road after going 55 mph. It wouldn't go drive or reverse. I did get It to go in neutral so I could push it out road. It has done this before but after stopping putting in park then drive it would go but not this time. What could it be and how much would it cost.
View 2 Replies
I'm the original owner of a 2005 Mariner (3.0L V-6, 114K miles). We live in Central TX, so we are just starting to experience cooler weather (40's - 50's at night, 60's - 70's daytime). At this time of year and through the winter, this Mariner develops an annoying rough idle. It is more like a strong vibration when in Drive or Reverse, not really a miss in the engine. Increasing the idle speed with the accelerator pedal works, and it does get somewhat better as the engine gets to normal operating temp, however if the day is cold (30's or 40's) it doesn't get better.
I've changed the plugs, changed the IAC valve, and cleaned the MAF sensor a couple of times, with no improvement. We almost exclusively use Exxon or Chevron gas, which should have good fuel-injector cleaning additives, so I sort of doubt the injectors are at fault. I've had a local mechanic check to see if any codes exist, but nothing shows up. This has gone on for 2 or 3 years, but it was not like this when the car was newer.
View 12 Replies
I think I resolved the idle issue on my 2009 Corolla S with 82,500 miles and Automatic Transmission.
Symptoms:
Idled at between 600 and 800 rpms
Annoying vibration in drive and reverse, no vibration in park or neutral
On hard stops, the engine felt like it was going to die
Turning on the a/c would cause the idle to increase to 1000 rpms and the vibration would go away.
At 82,500 miles, I cleaned the throttle body which was extremely dirty.
Process:
Disconnect the positive battery cable
Remove the top of the air box and flex duct going to the throttle body
Disconnect the two coolant lines going to the throttle body, make sure and have a few old bolts to plug the lines so you do not lose too much coolant
Remove the electrical connector to the throttle body
Remove the vacumn line to the valve cover
Remove 2 bolts and 2 nuts (10mm) securing the throttle body to the intake.
The throttle body does not have a gasket, it is an o-ring which should be fine.
Once you have the throttle body off of the engine, clean it thoroughly with Chemtool throttle body cleaner.
The inside of the throttle body and throttle plate should look like shiny milled aluminum. when done.
Spray chemtool into the two ports where the antifreeze lines were connected. If possible use compressed air to blow out these ports.
Clean the inside of the intake and the mesh screen where the throttle body bolts to the intake.
Reassemble, connect the battery, crank the engine and just let it idle for a good 10 minutes
The 2009 Corolla S DOES NOT have a serviceable IAC. It is riveted on to the throttle body. This is why it is important to spray the cleaner in the antifreeze ports in order to clean it. These ports are the antifreeze bypass ports.
View 2 Replies
Haven't noticed it before, but now I pay attention to my steering wheel - when the car is stopped on Drive mode I can feel a slight vibration on the steering. Shifting to P mode eliminates is. Is it ok? Do Your steering wheels vibrate when You stop at the traffic lights?
View 10 Replies
Back in April when I was getting my car inspected the mechanic told me I needed new rear brake pads. I knew I did so I let him change them.
Now I get noisy brake pads this moaning sound out of them when I apply the brakes while I'm backing out of a parking spot or my driveway. I've only driven about 5 or 6 hundred miles since then.
View 8 Replies
I have a 2008 GS350. Been having brake clicking when I move from reverse to drive and lately been happening more when driving regularly. Brought it in to Lexus to get the complimentary 19-point inspection and they said I needed new brake pads and rotors. I did do a search and found it can be issues with front spindles, sway bar, bushings.
View 5 Replies
I am a new driver and I made the following mistake twice.
Twice over the last month, after street parallel parking, engaging the foot parking brake, turning off and exiting the car, I noticed the spacing from the front and back car is a bit off so I went back inside the car to move the car slightly.
However, I forgot to disengage the parking brake first, so I put the car into R, and when the car did not move, I tapped on the accelerator. Only then did I remember to disengage the parking brake.
If I just tapped on the accelerator slightly, does it damage my car? I haven't noticed any problems yet, but I feel terrible about the screw ups.
View 13 Replies
My V10 Excursion is giving me a little bit of a hard time. Once warm, it shuts off when I go from drive to reverse and when I have to brake hard. I cleaned the mass air flow sensor and replaced the idle air valve behind the throttle body. Not sure what else I can do.
View 14 Replies
'15 Gs350 FSport. 4K miles. I have been able to replicate this issue, and won't have time to bring it into shop until next week.
I am at a stop light after driving for a bit. Car in drive obviously, foot on brake. If I press the brake very firmly, almost to where it hits the floor board, the slip indicator light comes on and flashes, and call stalls (or goes into idle). I am forced to shift car into park, and then shift back into drive. Or I have to turn car off, and back on again.
What was going on - I was reaching over to the passenger seat while at a stopped light and pressed down the brake pretty hard by accident. But I am now able to replicate it.
View 14 Replies
My taillights, reverse lights and brake lights all stopped working! What the problem is. The fuses are fine and the bulbs are good too. How to fix this or what I should look for to try to fix it?
View 1 Replies
I have a 2000 MB C230 Kompressor. Over the past few weeks I have noticed a vibration when the car is stopped. Specifically, when the car is in drive & the foot on the brake, the car vibrates. There is no squeaking of the brakes & feel that the brakes are in good condition. What might be causing the vibration...
View 4 Replies
I currently drive a 2011 Comfortline 6M. I notice that when i drive over rough terrain (roads, curbs, speedbumps) that i feel a weird vibration in the brake pedal and don't have any braking control. I have also noticed this in heavy rain conditions.
(Note: I have taken the vehicle to have the brakes checked at the dealer and they cannot find an issue. It also feels different than the ABS)
View 6 Replies
When I put my car into 'd', I notice some vibration coming from the engine. If I'm stopped at a light with my foot on the brake and shift into neutral, the vibration goes away. put it in gear, it vibrates.
View 7 Replies
I've had my 2013 Hyundai for about a week now and I feel a slight vibration/shaking when the car is stopped and I have my foot on the brake. When I was in the finance office signing all the papers, etc. The finance manager was trying to sell me the free oil changes for 3 years/tire rotations/filter change for $600. He was adamant that if I do not get all my service done by Hyundai dealer all the warranties are voided. I asked him specifically this question at least 3 times as I was appalled at the notion, and time and time again he would say the second you bring it somewhere else for an oil change the warranty is voided. 5 days later I brought the vehicle back to get my sticker, and I asked the guy at service, he said absolutely not. He said it doesn't matter as long as you have the proof/receipts.
View 18 Replies
