Passat (B6) :: 2006 - Front Passenger Low Beam Bulb Keeps Blowing Out
Dec 18, 2012
Been about 3 months now trying to figure out my issue in my 2006 passat 2.0t the front passenger low beam bulb keeps going out no matter what kind of bulb I use. They last for a week or two then burn out .When the do burn out they actually blow into pieces the only thing left are the wires in the bulb checked into everything I could think of looked at the plug of where the bulb plugs in checked the wires that connect to it ran as far as I could follow in the engine compartment all the wires seemed fine. And there's no moisture getting into the headlamp assembly.
View 9 Replies
Advertisement
Replaced both bulbs (left and right even though only left was out) with fresh H7s and my left headlight still doesn't work. so i thought, maybe fuses, but manual only references fuse #5 on both left and right fuse boxes as headlight control - but for XENONs only. Since i don't have HIDs, there is no fuse in spot #5 in either fuse box. Any other fuses i should check that i may be overlooking in the manual?
View 3 Replies
I have 04 Passat and my passenger side fog light bulb keeps blowing up I had to replace it 4 times already. Same thing happened when I upgraded to PIAA H3 yellow bulbs as well. I checked all connections, wiring and everything looks ok.
View 8 Replies
I have a 2005 prius. The low beam bulb on the passenger side had a flash the other day and wouldn't be turned on any more. I changed bulb, fuse. It still doesn't work. The high beam on this side and the low and high beam on the other side are fine. I noticed the socket to this bulb is kind of fried. I check the voltage. It shows zero.
View 4 Replies
How to replace a front (passenger side) fog light bulb on a 2006? I removed the plastic cover and see several screws. There are no instructions in the manual.
View 1 Replies
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
View 4 Replies
Where can I buy the bulb and what is the model number/size of the bulb? My headlines aren't customized or fancy. It's regular. I need to replace the right/passenger side. And how do you replace it? I'd like to save money. I read somewhere that micro clamps are necessary (for 2003 model at least) because it's hard to get in or out? If there's a DIY tutorial with pictures, that'd be great... I drive a 99 1.8 Passat...
View 3 Replies
2002 Passat W8. I need to replace the Right low beam xenon bulb. Looking for some pics on how to replace this! Or write a detailed description step by step on how to get this sucker changed out.
View 6 Replies
Are there any 2009 Sonata owners that's changed the low beam headligh bulb themselves? I need specific directions for installing. The manual instructions are not very clear.
View 10 Replies
I have a 2006 V6 4Motion and one of the HID bulbs has slightly dimmed and is projecting a light purple beam. I called my local dealership and was told this is normal and VW will not replace the bulb under warranty unless it's projecting under a certain candlepower or the unit is completely out. I plan on having the dealership check the bulb, but if it's starting to go bad, I will just replace it.
View 4 Replies
I had a low beam bulb go out a month ago on the driver side. I bought some silvania silverstars to install on both sides. The drivers side went fine but as I installed the passenger side the inside reflector housing came loose, apparently popping off some spring clips inside the headlight housing. The passenger side headlight assembly now pointed towards the ground 10 feet in front of the car... I tried to adjust the screws to bring the light pattern back up. No joy.
Anyway I messed and messed trying to get the reflector housing to fit back on the spring clips. I ended up having to pull the bumper apart and the whole front side of the car to totally remove the headlight assembly. Once I got it out I found these little ball/socket spring clips and was able to put the assembly back together.
Now my issue is I have lost track of the adjustment screws and where the headlights should point. Any formula such as, "park your car 10ft from the garage door on the flat level. The low beam should be 30 inches off the ground on the bottom and the 40 inches at the top. The beam should be 50 inches from the center line of the car" Something like that so that I can get my headlights back to factory settings.
View 4 Replies
I started my car and this error comes up, along with the bulb failure notice????
2006 2.0t 36K miles
View 7 Replies
I had the heater core flushed, inspection done, a tie rod end replaced, and both low beams replaced to pass inspection in January. The driver's side low beam stopped working after a week.
When I would hit a bump in the road, it would start working for a while till I hit another bump and then it would go off. Now the driver's side low beam never works.
I could have gone back to the mechanic, but it's an 80 mile round trip(they used to be a lot cheaper than the dealership). Now that the weather is starting to get better, do you think it's a simple problem that I can fix myself? I don't want to waste 80 miles worth of gas just to have them charge me for something that they already charged me to fix. The next time I'm due an oil change I may go there and demand that they fix the light too, but I'm not going to waste 80 miles of gas just for the light.
View 1 Replies
Car is a 2002 b5.5 1.8t sedan.
Bought the DDM Tuning HIDs, 3500k 35w for the fogs, installed with no problems. Also ordered the 5000k 35w for the low beams. Installed them, they flickered on for a second, then nothing. Let the ballasts charge for a while but still nothing. Called DDM, they said my car needs a error code eliminator kit thing later they were at my doorstep. Plugged one side in, flicked on then nothing. Thought both sides might need the code eliminators plugged in...wrong. both flickered on, and then nothing. Tried again, no flicker, both low beam fuses burned. Plugged the regular bulbs in, changed the fuses, lights working again.
I don't know much about electrical, but DDM said i def don't need a relay kit. Do I need a relay kit? Or would putting higher amperage fuses in the place of the original ones work? if so what amperage?
View 7 Replies
My passenger bulb on the sun visor is completely out... Any way, to get a bulb for it? I can't seem to figure it out
View 16 Replies
On my W8 sedan the passenger low beam is out and it looks like its an HID headlight... How do you change them in these cars? Also is it HID? It's odd sometimes it is on and sometimes it is not, but today I think its out completely...
View 4 Replies
Looking for instructions on how to replace the bulb on the passenger side?
View 5 Replies
Having some difficulties with my passenger side low beam. I replaced the bulb with one known to work but it wouldn't come on. Keep in mind the driver side works. Fuse if fine and I swapped relays but it still wouldn't come on. Took a multimeter to both sides; driver side reads 12v and works but the passenger side reads anywhere between 8-10v and does not work. I'm really stumped on this as all other lights work fine and the wiring in the engine bay seems fine.
I'm thinking as a last resort I might figure out how to wire a relay behind the pass side lamp using the 8 volts the wire receives to switch the relay on then run a new 12v wire from the fuse box to power the low beam when the relay activates. This would really be a last resort scenario though if it would even work.
View 5 Replies
Any tips for replacing the passenger side high beam? I can get my hand in there by there is no way to turn the bulb. Any easy tool to grip and turn the bulb?
View 5 Replies
My passenger side headlight(low beam) isn't turning on. Replaced the bulb. The light flickers and dies out.
View 1 Replies
My passenger side headlight bulb stopped working, neither in high or low beam. Does this point to the ballast being the issues? I've never dealt with HIDs before so not really sure of the common problems.
View 2 Replies
