I have a Toyota Prius 2012 type 2 and I did install a vip 3200 Plus alarm system. My question is that why is the automatic lock not working? I park the car, get out, and close the door but do not lock the car. After 5 minutes, the automatic lock system is not engage or the alarm system does not arm.
View 11 RepliesI cannot lock my prius hatch door. It will shut but the lock does not engage. Apparently the lock is broken. Can I order the part and have a mechanic friend do it for me as Toyota want to charge $200 to install it. The part from Toyota is $210.
View 3 RepliesEver since I installed my L.e.d. lights in my doors the automatic door lock once moving keep locking like 3 times. I don't know why this would happen I didn't touch anything I shouldn't have. Why this would be happening.
View 11 RepliesI own two Prius, the 2005 & 2007. Been driving and repairing both of them for years
My 2007 has the red triangle for the "P" park won't engage issue. No issues at all just the dam message keeps popping up when I come to a stop and of course the constant red triangle. I drive it 60 miles everyday in the snow, rain and wind with this issue.
Still researching the issue and one day I'm sure I will resolve it but until then I'm not worried. BTW its 100% not a battery issue, been down that road.
My question is about the emission test. I don't and never had a CEL on or any codes although I do know there could be some deeper Toyota codes that I can't pull with a traditional OTC scanner. With that said, given that I don't have a CEL on, will the red triangle cause for me to fail the emission test when they run the test?
I have a 2010 explorer. I bought it with a lot of the lights, i.e. tire pressure, skid control, abs, service engine, air bag, service rcs and some others on and these systems are not working. a module was missing associated to the AWD system, I have put one in but awd still does not work through the 4 high and 4 low work. The automatic door locks does not lock when the vehicle starts moving. Some of the lights on the dash and doors don't work either.
View 2 RepliesI am trying to change the automatic door lock setting to unlock the doors when I open the drivers side door not when I shift into park. The manual is vague and I am not having any success at all.
View 2 RepliesI just bought my 2001 with 153k on it and I notice that sometimes it didn't appear to fully engage in park. What I mean is that.... If I park on a a small incline occasionally after I put it in park and take my foot of the brake..... It will pop into park..... Or I'll have to wiggle a little when I notice the key can't be removed from the ignition. Now that I notice this.... I can make sure it is fully in park each time.
My emergency brake cable doesn't work (and I always do use this religiously on my other cars), and I think having it reduces strain on the transmission..... But darn its near 300 bucks to replace I'm told.
Recently, I've been having issues with my door locks. When exiting the car, and pressing the door lock on the outside handle, I would here the door lock solenoid fire once, then open, and the door would not lock. Same thing would happen when I used the FOB. The door would not lock. On occasion, I would get the door to lock, and stay locked by using the door lock inside the car when the door was open.
On the occasions when I did get the door locked, I then had issues unlocking. If I approached the drivers door to unlock the door, the car would just keep repeatedly beeping, and would not unlock the drivers door. But, the back door would unlock, so I could reach in, and open the drivers door from the back.
After trying to start my '08 Prius, the following message appears on my touch screen about 2-3 times a month: "The transmission PARK lock mechanism is abnormal. Park your car at a flat place and apply the parking brake completely". I try to patiently wait it out while I apply the parking brake, unapply it etc. Finally, all dash lights will go out, and I can then start the car.
View 5 RepliesI have just bought a 2001 Prius with 127,550 miles. Hybrid battery has been replaced with a used one and all systems seem to work fine except the shift lever in the "Park" position does not lock the transmission. No big problem as long as the Parking Brake works. Preliminary investigation does not reveal any easy fix.
View 6 RepliesI have a 2011 Ford Fiesta and yesterday morning I went to start it and the check engine light came on. When I tried to shift into reverse, the gear lever moved but the gear wouldn't engage. None of the other gears worked either. I turned the car off and back on again, and it was fine (the check engine stayed on, though). I have to repeat this process every time I start the car, and this afternoon it took three tries. This a low-mileage car: I bought it brand new a little over 4 years ago, and it's barely over 20,000 miles. I have an appointment scheduled with the dealership, but is this something that's going to cost me a lot of money or is it just a computer issue? One other detail: it was very very cold the night before the issue started (about -10 degrees).
View 19 Replies1999 Toyota Camry. Suddenly gears failed to engage. When sfitinthe gear shaft does not go in to any gear- shifter moves easily but does not engage at any gear. Is it due to lack of transmission fluid?
View 3 RepliesI have a 2004 Explorer 4.0 4x4 with 130,00 miles that started with the transmission periodically going into neutral while driving and sometimes while stopped at an intersection. Engine running, but no reverse or drive gear. After shutting down engine and restarting, I can drive again only to have it happen soon again. I have changed rear speed sensor, throttle position sensor, dropped the tranny pan and changed the ATF as well as tranny filter.
I also attempted to replace the transmission range sensor but was unable to remove the nut that holds the shift level onto the sensor. Sent 5 hours one day.... nut will not budge. Now the shifter inside the truck does not feel the same when shifting through the gears. Now the transmission will only engage in reverse but the truck will not move. If I wait 30 sec or so the truck will move in reverse. No engagement in drive, 3rd, 2nd, or 1st.
Just wondering, when you start your car in the middle of the summer, if it is set on automatic, the A/C will automatically start and cool down the car. is the opposite SUPPOSED to happen like that also?
View 11 RepliesI have a 2009 Santa Fe (Automatic 3.3 v6 AWD). I have found the last few days (-20 C) where my gear shift will move into all gears (R, P, N and D) but the car wont move in Drive. R, N and P all work fine. It does seem as the car warms up everything's fine.
The light in the dash for D does not light up either when not working. What this might be?
My wife has a 2008 Eddie Bauer 4x4 explorer and when you are backing up or pulling forward with the wheel turned, it feels like the automatic 4wd wants to engage. The Ford dealership mechanic told me this is normal but it does not do it all the time. Is there anything I can look at to try and figure out why this does it sometimes or if this is even supposed to do this at all?
View 7 RepliesIts a automatic transmission with a v6 4.3 vortec. The front axle will not engage, it is not the acuator (I replaced it and the cable) you can pull the cable and the axle will engage. There is a low buzzing noise(coming from the drivers side) until you give it gas. This noise stops when the front axle is engaged. The transfer case will go from hi to low without any problems.
View 1 RepliesI drive a 2007 camry hybrid. i live where there is a lot of snow and unfortunately my only place to park is in the street. last winter, a couple of times i had an incredibly difficult time getting my car to move because the 'automatic traction control' would engage as i tried to pull out of the parking spot. there was a decent amount of snow, but if this automatic feature hadn't engaged, i would have been fine.
I know in the newer models, there is a button to push near the steering wheel that turns off this function. this is not the case with my car. is there any other way i can disengage this function?
In my haste last year i quickly read a couple of other messages suggesting i go through a series of depressing/releasing the brakes, followed by turning on/off the car etc etc (like a video-game cheat code!), however i had no luck.
I have a problem with automatic tiptronic transmission my golf MK4 TDI 1.9 2001, it dosent engage on 4th gear when i am driving, the codes that I received for this foults:
01316 - ABS CONTROL MODULE
49-10 No communication- Intermittent
00652 - Gear monitoring
27-10 - Implausible Signal - Intermittent
Have a 2014 Prius III. Was getting 50-60 mpg until i took it in for the 5k mile service. Immediately afterwards the mpg dropped to 43-50 mpg. It seems when the car is cold, it will start in EV mode for a few seconds and then the engine will kick in and it will not enter EV mode for the first few miles even with the battery 80% charged, driving under 20 mph, a/c off and keeping the Hybrid system indicator in what should be the EV range.
View 19 RepliesMaintenance Mode is useful for running the engine continuously without it shutting off, such as when you do a coolant drain and fill and want to purge air out of the cooling system. This thread was created to clarify the procedure for engaging Maintenance Mode on the G3 Prius after attempting to do it according to the Prius service manual and finding that the manual does not clearly describe or include all the required steps.
Perform the follows steps in less than 60 seconds to engage Maintenance Mode for the G3 Prius.
Begin with the car and all accessories turned off.
Set the parking brake.
With the car in Park, and your foot off the brake pedal, turn the Power Switch "On" by pressing it twice.
With the car in Park, and your foot off the brake pedal, fully depress the accelerator twice.
Step on the brake pedal and use the shift lever to shift from Park to Neutral.
With the car in Neutral, and your foot off the brake pedal, fully depress the accelerator twice.
Step on the brake pedal and press the Park switch/button to shift from Neutral to Park.
With the car in Park, and your foot off the brake pedal, fully depress the accelerator twice.
Check that "Maintenance Mode" is displayed in the multi-information display.
Step on the brake pedal and then press the Power Switch to start the engine.
Important: DO NOT drive the car in maintenance mode to avoid damage to the transaxle.