Ford - Fiesta :: 2011 - Automatic Transmission Won't Engage
Jan 10, 2015
I have a 2011 Ford Fiesta and yesterday morning I went to start it and the check engine light came on. When I tried to shift into reverse, the gear lever moved but the gear wouldn't engage. None of the other gears worked either. I turned the car off and back on again, and it was fine (the check engine stayed on, though). I have to repeat this process every time I start the car, and this afternoon it took three tries. This a low-mileage car: I bought it brand new a little over 4 years ago, and it's barely over 20,000 miles. I have an appointment scheduled with the dealership, but is this something that's going to cost me a lot of money or is it just a computer issue? One other detail: it was very very cold the night before the issue started (about -10 degrees).
View 19 Replies
Advertisement
I have a 2004 Explorer 4.0 4x4 with 130,00 miles that started with the transmission periodically going into neutral while driving and sometimes while stopped at an intersection. Engine running, but no reverse or drive gear. After shutting down engine and restarting, I can drive again only to have it happen soon again. I have changed rear speed sensor, throttle position sensor, dropped the tranny pan and changed the ATF as well as tranny filter.
I also attempted to replace the transmission range sensor but was unable to remove the nut that holds the shift level onto the sensor. Sent 5 hours one day.... nut will not budge. Now the shifter inside the truck does not feel the same when shifting through the gears. Now the transmission will only engage in reverse but the truck will not move. If I wait 30 sec or so the truck will move in reverse. No engagement in drive, 3rd, 2nd, or 1st.
View 3 Replies
1999 Toyota Camry. Suddenly gears failed to engage. When sfitinthe gear shaft does not go in to any gear- shifter moves easily but does not engage at any gear. Is it due to lack of transmission fluid?
View 3 Replies
I have a 2009 Santa Fe (Automatic 3.3 v6 AWD). I have found the last few days (-20 C) where my gear shift will move into all gears (R, P, N and D) but the car wont move in Drive. R, N and P all work fine. It does seem as the car warms up everything's fine.
The light in the dash for D does not light up either when not working. What this might be?
View 1 Replies
Its a automatic transmission with a v6 4.3 vortec. The front axle will not engage, it is not the acuator (I replaced it and the cable) you can pull the cable and the axle will engage. There is a low buzzing noise(coming from the drivers side) until you give it gas. This noise stops when the front axle is engaged. The transfer case will go from hi to low without any problems.
View 1 Replies
I have a problem with automatic tiptronic transmission my golf MK4 TDI 1.9 2001, it dosent engage on 4th gear when i am driving, the codes that I received for this foults:
01316 - ABS CONTROL MODULE
49-10 No communication- Intermittent
00652 - Gear monitoring
27-10 - Implausible Signal - Intermittent
View 3 Replies
This transmission shifted smooth and strong through all gears until today when it stopped all of a sudden to engage either Drive or Reverse. No previous signs of slippage, hesitation, stalling or lack of power whatsoever.
We checked the linkage to the transmission and it works as intended, nothing loose or broken, everything is in place. If there was something slightly different with it from other similar vans we have then it had a slightly delayed engagement in Drive (it took a second to engage it after you moved the lever) - on all other vans we have the transmission go into Drive almost instantly.
Van is a '92 Pontiac Trans Sport/Chevrolet Lumina APV with the 3.1L V6 Chevy TBI engine with the 3T40 automatic transaxle. Where we should start tackling this issue?
View 13 Replies
So I just started leasing a 2011 Ford Fiesta, with an automatic transmission, which as I'm told is actually an automated manual. In any case, from day one the car has had a terrible rattle coming from the driver's side of the vehicle, which occurs essentially when going up hills, starting from a stop, and basically between shifting.
I looked it up online, and found some articles talking about Ford replacing transmissions, and some other similar complaints. When I took it in to the dealer, since I felt that it's ridiculous that a brand new car should have any rattle at all, they said they had to update the software for the transmission, and that may work. Now, over a month later, it still rattles quite a bit.
My question is, how normal is this? Is there any information about the Fiesta's transmission or other parts that say it rattles, but that it's not something to worry about? I was told at the dealership that due to the type of transmission it is, it would rattle occasionally, and that it should improve as the computer learns my driving style. I just think it's absurd that I should hear such a noise, which is clearly not what I would call normal engine noise.
I have to note that this is also only my second car, and I have had very little experience driving American cars, since most of my life I've driven exclusively Japanese cars. I don't know if it is just normal engine noise for a Fiesta, or if it's something to bug the dealership to get fixed while it's still under warranty.
View 6 Replies
My automatic transmission slipped today. Really worried now. 2011 elantra with 36k on it. It was raining and I was turning right out of a shopping center. I floored it to beat the incoming traffic and the tranny slipped. It hasn't slipped since then and has been perfect so I know the dealer will say they can't replicate the problem. Should I be worried about this?
View 15 Replies
I have been having phantom automatic transmission problems with occasional harsh shifting, mostly up shifting through all the gears but sometimes downshifting. This problem started in May 2014, lasted off and on for several days, and then stopped occurring. There had been a few instances of small drops of fluid on my carport but nothing consistent. Then in September, the problem started again on the same basis: on/off again, nothing consistent. When I couldn’t locate the port under the hood to check the transmission fluid, I took the Elantra to the Boise Hyundai dealership to ask where the trans fluid port was located. My service rep told me that there was no port in the new vehicles and that the transmission fluid was not changed until 100,000 miles at a cost of $400. The service technicians could not find anything wrong with the vehicle when they hooked it up to their computers to check the error codes, and the vehicles would not perform the harsh shifting when they test drove the car. The techs re-set the adaptive points and I was sent on my way. A few days later, the harsh shifting started again on and off, phantom problem. I took the Elantra back into the dealership and told them to keep it for as many days as it took for a tech to drive it home and start it cold in the morning. The transmission did not perform the harsh shifting for the 80 miles the tech drove it home and back to the dealership for three days.
After driving the Elantra another week, the phantom trans problems re-occurred. After surfing the web and checking the Hyundai Customer Forum, all I could find was problems with 2010 Elantra transmissions and my service tech admitted that Hyundai had replaced thousands of 2010 transmissions.
Through the dealership I opened a Case File for my transmission problems because there is something definitely wrong with the vehicle and I want a new transmission, and will press my case to the max. I’ve kept a log since September, noted daily temperatures, and times the trans has performed harsh shifting. I’ve kept the problem to a minimum by letting the car warm up for about 5 minutes and will only drive it when the tachometer needle rests on 1,000 rpms.
View 19 Replies
My wife has a 2008 Eddie Bauer 4x4 explorer and when you are backing up or pulling forward with the wheel turned, it feels like the automatic 4wd wants to engage. The Ford dealership mechanic told me this is normal but it does not do it all the time. Is there anything I can look at to try and figure out why this does it sometimes or if this is even supposed to do this at all?
View 7 Replies
I have a Toyota Prius 2012 type 2 and I did install a vip 3200 Plus alarm system. My question is that why is the automatic lock not working? I park the car, get out, and close the door but do not lock the car. After 5 minutes, the automatic lock system is not engage or the alarm system does not arm.
View 11 Replies
Just put the 6.0 back in the truck, engine working good now. Went to take it for a test drive and the transmission will not engage in any gear. I don't have any codes coming up on my scanner. Can not figure out why the transmission is not working from engine R&R.
- Fluid level is good
- Swapped wiring harness from my other truck and still nothing
View 3 Replies
I drive a 2007 camry hybrid. i live where there is a lot of snow and unfortunately my only place to park is in the street. last winter, a couple of times i had an incredibly difficult time getting my car to move because the 'automatic traction control' would engage as i tried to pull out of the parking spot. there was a decent amount of snow, but if this automatic feature hadn't engaged, i would have been fine.
I know in the newer models, there is a button to push near the steering wheel that turns off this function. this is not the case with my car. is there any other way i can disengage this function?
In my haste last year i quickly read a couple of other messages suggesting i go through a series of depressing/releasing the brakes, followed by turning on/off the car etc etc (like a video-game cheat code!), however i had no luck.
View 3 Replies
I have a 2005 Excursion with 6.0 PSD just turned 80,000 miles. About a year ago, the vacuum hubs on the ESOF system became intermittent, so I changed then out with WARN manual hubs, which proved to be 100% reliable. Today, I got in the truck to move it, and engaged 4x4 High, as it had snowed last night and my inclined driveway was slippery. The hubs are locked, I get a lighted "4x4" idiot light on the dash, but the front wheels are not providing any drive power at all. I can hear the transfer case shift motor moving the gears, and if I select Low Range, the transfer case does change over to Low, but still no drive coming from the front wheels. I'm under the impression that the only things left to fail would be for the propeller shaft to be lying on the ground (it's not), the differential is not working, or something is wrong with the spindle shafts. Nothing has happened to the truck, and I have not heard any strange noises. I parked it 3 days ago, and everything, including four wheel drive, worked fine at that time. What may be going on here?
View 8 Replies
I have a 36 foot motor home on a 2000 Ford F53 chassis. (similar to single axle freight trucks and school busses) After getting one set of the rear wheels partially stuck, which resulted in some spinning of that side, the overdrive off light on the shift lever began to blink and the service engine soon light came on. The fault code said, "speed sensor showing more than one mile per hour". Now the automatic transmission sometimes will not shift into first gear after stopping and has to be manually downshifted, after which, it works fine.
View 1 Replies
I have 2013 ford fiesta and the fan wasn't turning on!? It sounded like it wanted to and this is the first time I'm having problems with it. It was -23 out yesterday so that could b it but it's above 0 now and still not turning on?
View 6 Replies
I have a 99 Ford Explorer XLT, V6, 4X4 with the 5R55E automatic transmission. I'm getting ready to remove / replace the transmission. Do you have to lower the back of the engine any for the transmission to clear the torque converter? Any tricks to getting torque converter off the flywheel?
View 14 Replies
1998 Ford f150 172984 miles automatic with 4x4 runs and drives transmission is going out will not hit 3rd gear have to drive in 2nd. Is there a fix without pulling the transmission?
View 5 Replies
Would it work? I saw this on CL 2000 Ford F250 6 speed manual 2wd transmission. It says it is for 2WD but I don't think that matters because the transfer case is what make it 4WD anyway right?
I don't love automatics. With a manual trans, some new gears and the dully conversion this thing would be like driving a giant sports car. Any computer related problems?
View 14 Replies
Owned care for just 1 year. Always seemed to "search" for 2nd gear, now "stammers" and "stutters" into 2nd and starting to do same into 3rd. Dealer says that care "needs to get to know me and how I drive." I say: it must know me by now, so assume it just doesn't like me? Have heard horror stories about being abandoned, etc. My question: do I continue to try to get dealer to fix? or just trade car.
View 2 Replies
