Prius C :: Both Low And High Beams On Same Time When Flash Turn On
Sep 25, 2012
I used to think when I flash it'll turn on the high beam only but that's wrong.
Today I changed the high bulbs 9005 to a brighter pair trying to get a better DRLs, but when I tested the high beam by flashing I realized it turns both low & high beams on at the same time.
I have HID for low beam so that's not a good thing for me to flash. And I think I did it only one time in the past but now I won't do it again. Is it normal?
View 1 Replies
Advertisement
Anytime I turn the headlights on, the high beams go on too; I cannot switch off the high beams unless I turn off the headlights entirely (I have been driving with the low beams on during the day for the 5 years I have had the car)
I can find no reason for this; I'm inspecting the fuses (with little expectation). The only thing I can think of is the control switch or wiring. I have standard headlamps, not hid.
View 3 Replies
I have a 2010 prius the basic model I turned the lights and both headlights went out they only worked on high beams.
I changed the bulbs no luck they still only work on high beams checked fuses they looked good is there anything else I can check?
View 2 Replies
I love this car- i just bought it , but it has one problem i cant figure out .The high beams didn't work at all -till my mechanic figured the prior owner took out the two fuses - now they stay on all the time - even when the car is turned off . My guess is the light switch - my mechanic said it is probably more than that...
View 3 Replies
A good while back I seen a thread to do this , but can't locate it now. I have a 2012 F250 and looking to make my night time driving better ....... I want to run both low and high beams at the same time and getting the fog lamps to stay on when going from low to high beam.
View 14 Replies
I have a BMP 20th and I notice that I cannot turn on my high beams but I can flash them. What the problem could be? I was planning on installing my OEM HIDs tonight but now I am wanting to get this fixed before I put them in.
View 2 Replies
I have a 1991 Accord that won't turn on the high beams. I can pull the dimmer switch and it clicks and the dash indicator comes on for the high beams but it just keeps the low beams on. I am guessing the dimmer relay isn't working properly but am not sure how to test it. Also where would I buy one? I have checked a couple sites and even a search doesn't bring it up.
View 2 Replies
99 Buick LeSabre ... I only have one low-beam working, the other low-beam bulb went out today ... When I switch to high-beams, the high-beams come on, but I cannot turn them off via the manual light on/off switch on the door panel ... The Twilight Sentinel works properly, and will shut off the high-beams per switch setting ... During the daytime, the high-beams will just stay on till I turn off the car, manual headlight switch won't turn them off ...
View 1 Replies
Basically, my high beams work when flashed (pulling the lever), but they don't work when I want to leave them on (push the lever). It's obvious that it's not the bulbs since they work when flashing. I'd really like to avoid taking it to the dealership since the Lexus dealerships in my area are notorious for overcharging their customers and not doing a good job.
View 7 Replies
I bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 Replies
The turn signals and high beams do not work on my 1998 ford ranger xlt 4x4. I have replaced the multi function switch, the yellow flasher relay checked all fusses and all are good. What could be the problem?
View 7 Replies
I have a '99 Explorer XLT and when I turn the high beams on, the fog/driving lights shut off. Is this normal? Is there a way I can keep the fogs on while the highs are on?
View 1 Replies
My truck only has low beams. When you move the stalk on the colum backwords it changes nothing, when you move it forwards the low beams go out but the high beams do not come on.
View 14 Replies
I have a 2003 Toyota Corolla CE manual transmission with 431,000 (not a typo) miles on it. About 7 weeks ago I noticed that when I turn on my high-beams after driving for awhile, the car dies for a few seconds. All lights go out, radio stops, engine stops and then it starts up again as if nothing happened. It will just do it once in about a half-hour time frame. I can switch the high-beams on and off repeatedly afterwards and it doesn't do it again. I have to drive for about a half-hour before it will do it again. I usually hear a slight pop sound when it does it.
A month later I noticed that if I parked it after driving for awhile, like at a gas pump, and get back in it, it acts as if the battery is dead for a few seconds. If I step on the clutch or open and close the driver door, the car comes back on. It appears that the battery was disconnected. The CD pops out of the player and all the radio station settings are gone. One morning last week I got in, and it had happened during the night. The CD was out, station settings gone, and the clock was 6.5 hours off.
I have had the car to a Toyota repair center 3 times. They have checked fuses, battery, battery cables, grounds, alternator, tensioner, looked for rodent nests, squirrels and I don't know what-all, etc. They can't find what is wrong. I am scared to drive it, but I depend on it. I commute 200 miles/day. I won't leave anything important in the car because I am afraid it will catch fire. I am scared I am going to have a wreck, too, with no lights and no power steering suddenly.
View 6 Replies
I have checked fuse 46 and 47, and installed new headlight bulbs. I have high beams, but no low beams. I have searched this topic but no one has the same prob it seems. My headlight switch has broken. Could it be the headlight switch?
In my manual, it says the 2002 has a fuse panel behind the glove box. I took glove box out but it doesn't look like a fuse panel.
View 5 Replies
I recently installed new halo HID headlights in my 2003 f150 with HID bulbs and ballast the passenger side worked and the drivers side didn't nth lights wired exactly the same. I switched everything from the passenger to the drivers side still nothing I switched everything back to passenger side and they don't work now. I tired regular bulbs in the passenger side an it worked then on the drivers side and it worked for a split second and went out and then I retried t on the passenger side and it worked for a split second and went out a now neither are working. I checked all the fuses and their good. What the problem could be?
View 5 Replies
How to fix or solve front turn signals that are not working? I just realized that both the front signals on my Prius doesn't light or flash when making a turn, the rear are working fine. Is this an easy fix or should I bring it to the dealer?
View 4 Replies
After spending weeks ordering parts and doing research on this issue all my attempts have not solved the issue. To reiterate the issue, the high beams work, and the low beams do not. Thus far I have attempted the following without the desired result-
1. Changed the headlights out just in case both bulbs burnt at once.
2. Changed the blinker stalk in hopes of a faulty switch.
3. Changed the headlight switch to a brand new OEM Euro style switch.
4. Checked all fuses (did this first actually).
View 6 Replies
The other night on my way home, I flipped on the high beams and the low beams didn't shut off. Flash to pass still works, and pushing in on the end of the stem turns the low beams off as well.
Having the column switch apart, is it possible this could be fixed without having to pull the steering wheel? Or, am I better off just spending the hundred dollars of so and putting in a new part?
View 13 Replies
It ford related but I just bought a used car that has hid low beams and when you turn on high beams there is no light at all. The blue light on dash comes on and head lights go off. I just got this car 2 days ago and haven't really looked into it.
View 5 Replies
I have a 2000 Dakota quad cab with a 4.7 l when I turn on either turn signal itll flash 2-3 times or sometimes not even flash at all when it does it just stops u can hear the flasher working . What to check and how to check/ replace parts I need to get it working again is there a flasher inside the steering column. or is there just a relay on the side where the fuses are ?
View 1 Replies
