Sonata NF (2006-10) :: A/C Fuse Blows Again And Again
Sep 15, 2013
Every time I replace the ac fuse it blows again sometimes immediately or later it never last more than a day.
View 3 Replies
Sep 15, 2013
Advertisement
Sonata NF (2006-10) :: Low Beam Fuse Blows Instantly Upon Replacement
Background: Sonata 2009 Limited. 165K Miles. Original factory installed everything. Chicago area.
Last week I drove to the mall in the snow. Headlights worked fine. Upon leaving the mall I realized that my low beam headlights were not working.
Purchased and installed one low beam headlight bulb, on the slim chance that both of them simply burned out at the same time. It didn't come on.
Results of an internet search indicated that the fuse might be blown. I pulled the 20amp Low Beam headlight fuse and sure enough it was bad. Put in a new fuse. Turned on the headlights and it blew instantly.
Have been driving with the high-beams the past 5 days. Only one car has "blinked" at me, so driving with the high-beams isn't a problem. Probably because there are so many cars with really bright low-beam headlights these days.
However, I would like some guidance to getting this problem resolved. What are the most likely reasons for the low-beam headlight fuse blowing instantly like this?
Sonata NF (2006-10) :: AC Blows Hot Air
So last summer I had the AC recharged. Worked great. I only ran the AC about twice over the winter to lub the seals (about 30 sec) prob not long enough but anyway.
I used the AC this month a couple of times briefly and it seemed to work just as well but today I get NOTHING except hot air. I cleaned the cabin filter, it sounds like the compressor comes on cause I know it makes that kick sound a few secs after hitting the AC button which illuminates. I took a quick look around but didn't see any leaks. fuse looked ok. I noticed the Low pressure line is wrapped.. do i have to take that off to check for leaks?
Does this sound like the refrigerant is low again after only like 6 months. If it worked great last week now nothing does that seem like the issue? Thinking of just filling up from autozone myself. I've also have a bad BCM with intermittent light/dash/window issues which arises in heat for past 2 years.
Sonata NF (2006-10) :: AC / Heat Blows Only About 60% Force
I am recently getting no AC just warm/hot air. I have yet to pressure check the system but i believe the compressor still turns. But I did notice throughout this the vents are only giving about 60% force on heat and AC as they used to. The blower motor spins although, cleaned the cabin air filter and one pin broke when putting it back. the blower motor spins louder on the "4" setting. I am guessing this is related to no A/C since it happened the same time and i don't think that low refrigerant would cause the heat system to blow less efficiently...
View 1 RepliesSonata NF (2006-10) :: 2009 - A/C Blows Hot Air Only On Passenger Side
clarification: temperature control works as expected on driver side. Only hot air comes out on the passenger side.
1. Most of the problems of this sort seemed to have been solved by replacing an actuator - air blend actuator, vent door actuator, etc are the terms used. Are these all different names for the same actuator? Or are there two actuators?
2. The problems occurs regardless of the DUAL setting so I think it is unlikely to be a temperature sensor problem.
Sonata NF (2006-10) :: Buzzing From Fuse Box Area
I have a 2007 3.3 litre Sonata and just recently heard a buzzing sound coming from what I think is the fuse box area. When in park and neutral (buzz) .... drive and reverse - no buzz.
View 4 RepliesSonata NF (2006-10) :: HIDs Installation - Keep Blowing Fuse
I tried installing my new DDMTuning 35W 6000K HID headlights with relay harness. No issues until I went to turn the car on and actually power them up. Neither side would work. I checked my power connection, ground, in-line fuse, swapped out the relay, tried without the harness, and nothing worked. I tried putting the stock bulbs back in and I found out they wouldn't turn on either.
I found the issue to be a blown 20 amp fuse in slot 23 (see pic). I replaced it and tried to turn the car on with the HIDs and it blew again. I hooked the stock lights back up and they seem to work fine now with another new fuse. The fuse description says H/LP LO and HID LO LH. Why this fuse is blowing. I am wondering if I just need a higher amperage fuse because of the HID power (in line for harness is 30 amp) or if something else is the culprit. I'm stumped.
Sonata NF (2006-10) :: 2009 - Headlight Fuse Keeps Blowing
I got in my 2009 Sonata this morning, started it and turned on the headlights. The headlights turned on momentarily and then turned off. The 20 amp headlight fuse blew. I cleaned the battery ground on the fender and the battery terminals. I also cleaned the connection between the battery terminal connector and the negative cable. I put everything back together and installed a new 20 amp fuse. I turned the lights on. They lit momentarily and then, predictably, blew the fuse again. Curiously enough, the "passing lights",which are just the high beams on another position on the headlight switch, still work.
View 2 RepliesSonata NF (2006-10) :: 2009 - Dome And Interior Light Fuse Blown - BCM Computer Gone?
Short, the dome and interior light fuse keeps blowing. Car is 2009 hyundai sonata nf. Is the bcm computer gone? The fuse pops as soon as i put a fuse in the car. The car can be off or on..it doesn't matter.
View 57 RepliesPrius (2004-09) :: AC 10 AMP Fuse Intermittently Blows
I have a 2004 Gen II that blows the A/C(Htr) 10 amp fuse. The dealer changed the inverter and replaced the fuse with a 15 amps which masked the problem. I have looked at the items that this feeds and have eliminated the: inverter (Dealer knows very little, Scary), A/C Control assembly, heater water pump assembly. I thought that since the Heater water pump assembly runs intermittently it might be that. Or could it be the diode in the relay that controls it? I cannot seem to find where it is located..
View 13 RepliesVolvo :: Wiper Fuse Blows Up After 5 Minutes In Rain
2 days ago I was driving to a friends house and it started to rain. I put on my wipers and after 5 minutes they stopped working. I pulled over and checked the fuse and it was burnt out. I had a spare 25A fuse and replaced it on the spot. I first check the horn since it's the same fuse connection. The horn worked ok then I went on with the wiper...the second I put on the wipers the fuse blew again not even letting the wiper make one cycle.
Could it be the wiper motors? What should I do other then bring it in. I want to do it myself.
Ford F-150 (2009-2014) :: Fuse Blows Using New Trailer
My father has a 2009 F-150 with almost 25,000 miles. (he leaves it in garage and polishes it weekly) He just purchased a new dual axle trailer with electric brakes and led lights. When we hook up the trailer and press the Brake, turn signal or hazards, we blow a under hood fuse (48 if I remember correctly). When connected to either of his other 2 trailers, everything works and no issues. When I connect my 2014 suburban, the new trailer works perfectly. He does not have a brake controller installed on the F-150 yet. It does have the 7 pin and 4 pin plugs under the bumper.
View 7 RepliesLand Rover :: Starter Blows Out The Fuse For Gauge Cluster
This is occurring on a 1997 Land Rover Discovery, but I have read of similar problems on many other "modern" cars. When I start my car, the fuse for dash gauges blows. Then with the blown fuse, the next time I try to start the car, the switch will not activate the startee solenoid relay. If I replace the dash fuse it will start again, but blow the fuse instantly, thus perpetuating the problem. This car is a beater off-road truck and I am willing to just bypass the starter switch and run a hotwired pus-button switch directly to the solenoid. Will this bypass any critical electrical operations? Should I wire the switch through the existing relay, or should I install a completely separate "siolated" relay? I having trouble tracking down how/why the starter solenoid relay would be related to the gauges....and if it is a short in the current starer solenoid circuit, can I just direct wire it to eliminate the problem?
View 3 RepliesKia - Forte :: 2010 - Left Rear Taillight Was Out / Fuse Blows Repeatedly
I have a 2010 Kia Forte, which I purchased in late 2011. I had not had the car for very long when I noticed that the left, rear taillight was out. My husband replaced the bulb and it still did not work. This led me to the fuse panel. The fuse was blown so not only the taillight was out, but also the front, left, parking light. I replaced the fuse and the lights came back on. However, within days, the lights were out again. I have replaced the fuse two or three times since then, but each time it blows again within days, so mostly, I am driving around without a tail light. What could be causing the fuse to blow repeatedly?
View 8 RepliesCelica :: 1992 - Fan Switch Blows Gauge Fuse / Drains Battery?
I have a 92 st, all stock. It was given to me by a friend that moved. The car was in very good shape before sitting for about two months (I had to go pick it up an hr and a half away, then replace the battery and starter).
The only issue it's had is the heater fan control will blow the circuit when turned on, which will kill my gauges, not to mention no fan. I removed the blower fan and bench tested it, seems fine. And with the fan unplugged, I can turn the switch on without blowing the fuse (it's possible that this plug is the only wiring from that switch, not sure).
My question is, is it possible this switch is short circuited and that's what is causing the fuse to blow? And is it possible this switch could be the source of my battery drain?
I was thinking maybe this was an ongoing thing, because the switch hasn't worked in a year and a half, before I got it. Perhaps this was draining the battery, but wasn't showing up because the car was being driven daily. I'm not sure what to do next but don't want to guess and start buying parts.
GTI 337/20th Anniversary :: 2003 - Fuse Blows For Windshield Wipers When Cleaner Used?
This is for a 2003 GTI, 89,00 miles. Every time I try to use the windshield cleaner the fuse blows for the windshield wipers. I have tried to put in a 25 amp fuse and it worked for a while but still blew. The windshield wiper motor has been replaced.
View 1 RepliesFord F-150 - 1997-2003 :: 2001 - Blows Fuse Touching Gas In Reverse
Got a 2001 F150 XLT 4x4,4.6L, When you start the vehicle it seems to run a little rough you can drive around with it OK. Soon as you put it in reverse,It starts to really run rough..touch the gas pedal and fuse position #30 blows.
This fuse is for : Passive Anti theft Transceiver, Cluster Ignition Coils, Powertrain Control Module, Relay Coil on Plugs, Radio noise Capacitor, ECC Diode.
I have checked cables and connections, all seem ok...Relays are fine. Nothing seems burnt on the cable running from the engine to the exhaust. I don't see any wire breakage in the tilt Column.
Cant find a short if it is one.. Even removed the aftermarket Remote starter from the circuit ... still blowing that darn fuse.... What to check now, or what it could be?
Golf IV / Jetta IV :: 2003 - Electrical Malfunction - Fuse Blows For Windshield Wiper?
This is for a 2003 GTI, 89,00 miles. Every time I try to use the windshield cleaner the fuse blows for the windshield wipers. I have tried to put in a 25 amp fuse and it worked for a while but still blew. The windshield wiper motor has been replaced.
View 2 RepliesFord F-150 - 1997-2003 :: Ignition Fuse Blows Every Time Turn The Key To On Position
97 F150 4.2 auto with Simple trans pan gasket change because it was leaking and now the ignition fuse blows every time I turn the key to the on position. Ran fine before now what? can't pull code with reader with key on or off.
View 4 RepliesFord Super Duty (1999-2016) :: F250 - Fuse 20 Blows When Trying To Start
The truck starter and radio would magically turn on and off after the first rain, it was hard on the starter and I had to replace the starter and the cause of that problem was the vacuum line coming from the brake booster running over the top of the wires in the 4 plugs attached to the driver side fender. It rubbed through exposing the wires and got wet connecting them. I cleaned them and put the electrical tape silicone and then it has been working fine for a couple months.
Now every time I try to start fuse #20 blows. So far I have traced the wire that goes through fuse 20 through the firewall being the blue wire with a orange stripe on it it goes through the top plug upper left most wire. From there I followed it through the 4 wheel fender plugs the furthest plug from the firewall still being the blue with orange stripe. If I unplug that plug and try to start the truck it won't start but the fuse does not blow.
I then followed that wire all the way to the neutral safety switch. I hate tracing wires. (About 8 hours so far). I am thinking neutral safety switch. Also another thing I am thinking is weird is that blue wire with the orange stripe is grounded when the safety switch is plugged into the transmission and if it is unplugged is is not grounded. And I don't think it is supposed to be grounded because that is the hot wire when the key is in the start position.
Details about the truck : 1999 f250 diesel 7.3 super duty automatic 4x4 dated 4/99
I have taken pictures of the plugs and wires I was going to post it but don't remember how.
Ford Ranger / B-Series :: 1985 - Brake Lights Out - Fuse Blows Every Time?
So I did alot of electrical work on this truck but never had any problems with the brake lights, now they dont work and the fuse blows every time you pop one in.
View 1 Replies