Golf IV / Jetta IV :: Pulled Over P0441 Along With CEL
May 10, 2015
So my engine light came on today while I was out so when I got home I plugged in my OBD2 reader and it gave me a P0441 code which in my Haynes manual says "Evaporative emission control system- incorrect purge flow." Before I got my scanner, I had the engine light come on and I took it to VW. It was the same thing last time. I couldn't quite understand the poor explanation given from the VW guy and so now that that code ran again.
View 2 Replies
Advertisement
2.slow bev engine / 2004 golf gl / 105k miles
The car sat in a garage for 9 days. It had no problems before. Now I have a p0441 code that comes back after being cleared, and an intermittent gas cap light. Is there a typical problem that causes this?
View 1 Replies
I have a 2005 Jetta 2.0 BEV GLS. I got a code P0302 for misfire on cylinder 2. I am pretty sure it's the Ignition coil. I live in Canada and my autoparts store only has BWD brand. I have read this is a crappy brand.
View 1 Replies
The Electronic Power Control light in my 1999.5 Jetta GLS VR6 came on a day or two ago. Now it hesitates like crazy even after I've already pulled out and am trying to accelerate. Is there any common problem/malfunction that would cause the light to come on, and is there any correlation between the light and this symptom? Also, the check engine light came on.
View 24 Replies
Check engine light is driving me crazy, comes and go depending on weather conditions.
When "ON" the code I get is P0441 and P0171. The engine hesitates for a second or two,then stabilizes.
View 6 Replies
2001 Jetta GLX, 12v 2.8 VR6 Automatic, 157k miles.
Relevant Info: P0411 code, unknown if associated with my slightly rough idle and recently reduced mileage (down by 3-4 MPG). I see 2 N80 valves, one by the power steering reservoir and one behind the throttle body attached to the fire wall. I removed them both, got a tiny bit of what may have been charcoal out of the lower valve and tested both with a 9 volt battery. Both were closed with no power and open when I attached the battery. I cleared the code and it returns within 30 minutes.
Possibly irrelevant info:
Changed the timing chains 3 weeks ago and the code popped up just afterward. Prior to changing the chains, all I saw was a Cam Position Sensor code that is now clear. The slightly rough idle was present to a greater degree before chains were changed but has improved.
SAI solenoids look good but their little rubber hoses don't look fantastic. Could this contribute to the rough idle or is it not part of the vacuum system?
Ignition coil is new and all plug wires tested to about 6k ohms.
I've looked up other's experience with P0411's and have seen the list of possible causes. Wondering if I'm missing a possible cause, if I can test the system further without having to buy parts etc, if the reduced mpg's and rough idle are related...
View 3 Replies
After running to operating temp, if the car is turned off then restarted (like you would at a gas station, which is where I notice this) the engine will turn and turn and turn but not fire. I have noticed that stomping on the acceleration will cough it into life during this procedure. This doesn't happen every time and I have recently run high octane gas during a long distance trip.
106K miles...
Recent p0441 fault codes and gas cap warning light...
No other problems or codes...
View 4 Replies
I have a Jetta Mk IV, yesterday I went to go drive it and just as I pulled out of the driveway it started running rough, so I pulled back in the driveway and the coolant temperature sensor light came on, then the check engine light. and then it died. Then today I tried starting it, and it will only start and run if I have the gas pedal all the way to the floor, and it runs really rough. Then it will die. I thought maybe the coolant temp sensor since the light came on. I replaced that, and it still does it. I'm leaning towards a head gasket.
View 2 Replies
Pulled into my driveway one night and a get a AFS failure.
Lights work, everything functions correctly, except my headlights don't level. I've seen some threads refer to it as the "dance".
I have the light out warning on the dash and every time i start my car it says "AFS FAILURE" or something across those lines.
I replaced my headlight level sensor and made sure the level sensor is pointing the correct way (toward the driver side) and that didn't fix it.
My car is lowered, but this issue didn't happen until recently. I do also have Euro Headlights, these were installed months ago. Way before this issue came up aswell.
View 3 Replies
Check engine light came on the other day. Brought the car over to autozone and this was the code that came back. P0441 EVAC Control System; Incorrect flow. Where I should start looking?
View 3 Replies
I threw a code and I have it but I am unsure what to do.
The code is P0353
"Ignition Coil C Primary/Secondary Circuit"
I saw that this might be the coil, the wiring or the ground? I had my coils go on my 1.8t Jetta and that was pretty distinct as the car ran like crap.
The car seems to run fine, I have had the code for 2 days. It went off this morning and it came on again this afternoon.
View 3 Replies
I was installing the driver's side oem storage drawer and started by removing the 4 bolts that mount the rails to the car. While I was removing the seat rails, my outboard rail somehow slid all the way back and now seems "locked" into position. Basically, the inboard seat rail wants to slide when I lift the lever, however, the outboard seems to be caught and won't move. From the outboard rail perspective, the seat is all the way forward and will not shift back at all. How to deal with this? The pins that move down into the rail to hold the seat in place aren't what is holding it up. My guess is the edge of something in the track is catching.
View 4 Replies
Any easy way to get the inner fender back into shape evenly without having to get someone to roll it? Yes my car does have the screw mod, and my wheel fitment is not super extreme. I'm on ST's that are maxed out. This is my first vdub...
View 17 Replies
So I was getting p0420 and p0430. I installed new hi flow cats on and did coil pack 1 & 3 since I was getting misfires there. Erased the codes after all the installs and they stayed off. It's been a little over a month later since the installs and my CEL came back on, scanned it and I'm getting same 2 codes again
View 10 Replies
My 2.0t threw a MIL with code P0441 about 24 hours after having the timing and all replaced. I replaced the N80 valve last week, but this did not make the light turn off.
I also have a hard time starting after filling up. What this might be?
View 10 Replies
The check engine lamp on my '04 4cyl came on Saturday. I checked the code. It's P0441, which is supposed to be 'Evaporative emission control system incorrect purge.' I found a page on the web that said this might have to do with the gas cap. When I checked the cap it had not been tightened.
I've been driving it for 3 days and the check engine lamp is still on. How long should I expect it to take for it to extinguish? It seems unlikely to the point of incredible the gas cap was left loose (which I've never seen before) and another failure in this very system could have happened simultaneously. Particularly since this is the first time the check engine lamp has come on in 9 years and over 100,000 miles
View 6 Replies
I have a 06 treg V6 and the code is p0441 I have replaced the evap canister as recondmended on club treg and the code came back.
View 1 Replies
So one day when I was driving, the CEL comes on, and then I go to autozone to get my free diagnosis. I got codes: P0441 and P0171
My engine is running fine and everything else seems to be in order. However, I have to get a new canister purge valve and new oxygen sensors, in order to be in the clear.
For the Oxygen sensors, I have AN IDEA of where they're located; somewhere underneath the car, by the catalytic converter (the converter is in between the two connectors, apparently). I have yet to do this and would like some opinions on what to do for it.
For the Canister Purge Valve, I have no clue where to look. I pop open the hood and I notice a diagram with labels. Great, but there are just too many other pieces to look at...I do not know if it is visible as soon as I pop open the hood, or if I have to dig deeper, or even if I have to remove the fancy plastic thing that covers the engine.
View 12 Replies
I used an ELM327 to read codes with my BMW so when the check engine light came on my 2009 Prius I wanted to see what may be going on. It came back as a P0441. Going back to my BMW, it had a similar issue and changing the gas cap removed the code. So now I have a new cap on but the code remains.
I have a PCV on hand and plan on replacing that in the coming week.
I do not see where the PCV valve or spark plugs for that matter have been changed up to this point.
What I should be looking at with the P0441 code?
View 7 Replies
My Corolla has the P0441 code, but not the typical 0445 code that comes with a loose gas cap. I cleared it and it came back (yes, I checked the gas cap). Googling the issue, I found service bulletin SB 0392-08, which implies the ECM could need to be replaced if the issue is not in the Evap system.
View 1 Replies
Just bough a new (to me) Touareg yesterday...2008, 75k miles, good service history. Drove home from the dealer no problems. Driving that same night (last night) the CEL comes on. Ok, I've had VWs before, CELs don't really make me panic.
Get home and scan the car and it comes back with P0327 (knock sensor 1 circuit low) and P0441 (evaporative emissions system incorrect purge flow).
I have a feeling it's got less than premium gas in it....I'm gonna throw some octane booster in the remaining 1/2 tank and see what happens. Anything else I should do?
View 5 Replies
