Chevrolet - 1500 :: Only Start By Giving Small Bursts Of Cranking Power To Starter When Cold
Aug 19, 2012
I have a 1996 Chevy Cheyenne pickup with a fuel injected small block that has 50k miles. Earlier this summer the truck developed a problem where it is very hard to start when cold (after sitting overnight or after sitting for many hours on my flat driveway). When the engine is cold (say the first start of the day) I can only get it to start by giving small bursts of cranking power to the starter. That is, it won’t start if I hold the key in the cranking position but is more likely to start if I give it a short burst of cranking power (when I hold the key in “start” position) for a second or two.After the first start of the day, the engine runs fine and subsequent starts are quick and normal. The “Check Engine” light is not on and there are no trouble codes…. Other than hard starting there are no issues with engine performance.
View 1 Replies
Advertisement
Truck has 190,000 miles. First, every now and then the truck won't start. Turn the ignition key to the start position and nothing happens - like the battery is dead. Turn the key back to the off position, wait maybe 10 - 15 sec. Try and start again - starts right up. This maybe happens about half the time I start the truck. Always seems to start first start attempt of the day. Only later does it start to behave this way.
I took it into a repair shop and they claimed it was the starter relay. After the repair (about two weeks) it seemed fixed - started all the time. Then a couple of days ago it began to do the same thing again. Only now, maybe 10 - 20% of the time doesn't want to crank (vice 50% or more before the repair). Doesn't seem to be the battery because when it cranks it cranks very strong and starts right up.
Now additionally, today, the truck just dies while driving. Doesn't stall or run rough just before dying - just dies - like turning the ignition switch to off. Interestingly, it starts right back up after this - no extended cranking, etc., just starts right up. I have tried "jiggling" the start switch to see if maybe it is failing, but it has no effect. That is, when the truck won't crank, "jiggling" the switch won't make it crank, and "jiggling" the switch while the truck is running doesn't cause it to die. Sometimes, the waiting 10 -15 secs or so between crank attempts doesn't work - that is, it doesn't crank, but if I open up the hood and take the starter relay out of its socket and put it back in, it cranks.
View 13 Replies
Just got my new work truck a '12 EB. This morning it was about 9 degrees and I jumped in and turned the key. The dash screen went out and the radio display went out then cycled back on but the starter didn't crank. I tried 2 more times with the same result. Then I just let the key in the on position for about 10 seconds and then I turned the key and it started right up. I stopped at several places and every time I went to start it it cranked and fired up the first try. Now tonight the truck has been sitting for 7 hours and it is 12 degrees, it took several tries before it cranked.
View 14 Replies
I have a 1996 Chevy Cheyenne pickup with a fuel injected small block that has 50k miles. Earlier this summer the truck developed a problem where it is very hard to start when cold (after sitting overnight or after sitting for many hours on my flat driveway). When the engine is cold (say the first start of the day) I can only get it to start by giving small bursts of cranking power to the starter. That is, it won’t start if I hold the key in the cranking position but is more likely to start if I give it a short burst of cranking power (when I hold the key in “start” position) for a second or two.After the first start of the day, the engine runs fine and subsequent starts are quick and normal. The “Check Engine” light is not on and there are no trouble codes…. Other than hard starting there are no issues with engine performance.
View 2 Replies
My 2004 Chevrolet Siverado's steering box seems to leak. It was adressed at one point but then just seemed to leak all over my driveway, it sits alot. It also make a loud winding sound when it first starts in cold weather then goes away when warmed up? Finally the oil pressure gauge is pinned passed 80 psi. just gauge?
View 3 Replies
I have a 1995 4X4 Chevy Silverado. Well tonight the lower radiator hose came off, and all the coolant drained out while my wife was driving it around town. She noticed that the temp gauge spiked, and tried to get home. The truck stalled, was able to restart it for a moment, stalled again and now when we try to start it up there is a low spinning noise coming from the area around the starter. I think it might be the starter trying to engage the flywheel. My question is whether or not this could because the motor has seized, or is there another symptom that could potentially make this noise.
View 1 Replies
This morning when attempting a cold start of my 05 6.0, it would not start was noticeably harder cranking. I had no CEL. I checked my scan Guage and the volts were 13.4 and fcm main power was 48.4. I checked and I had a p0405 code. What could be going on? I read that it can be a stuck or bad EGR valve? Could it be battery related?
View 9 Replies
I have now replaced hpop, injectors, cups, gpr, batteries, uvch on both sides, icp and ipr on my 2002 F550 and it still has a long crank to start.
It has been driven about 1,000 miles since then and no change. I have no codes except buzz test produced a high to low 1272 1274 1276 1278 one time. Cannot get that to happen again.
It is taking 4 seconds of cranking to start consistently hot or cold. It always starts but cranks for what seems like too long compared to my other 7.3s. I have included a screenshot of the data and am curious on what everyone's thoughts are as I am out of things to look at!
View 14 Replies
For the past year I have had intermittent start issues with my LS that occur about 15 percent of the time. Ambient or engine temperature do not make a difference. Sometimes the starter engages but then disengages right away. I then need to depress the start button an additional time or two before it actually starts. At other times the starter engages and continues cranking while the engine sounds like it is trying to start (like it is just barely keeping ahead of the starter speed). That carries on for several seconds and then it starts. Nothing shows on diagnostics and the dealer says I am going to have to wait until there is a complete "no start" before they can trouble shoot. There was a similar issue with earlier 460 models but the Lexus service tech said that problem does not apply to the 2011's. It seems there is a lack of fuel delivery but from what point? And why only intermittent and momentary?
View 6 Replies
I drive an Infiniti i30. When I bought it, the guy who sold it to me told me that the car runs great but that I would have to turn the key kind of hard to get the car started. Over time, this problem has progressively gotten worse. There have been times where I'd be stuck in a parking lot for over an hour trying to get the car to start. When I turn the key, I can hear the starter clicking, and all of the dash lots and radio will come on but the car doesn't sound like its cranking or even trying to start. The weirdest thing is that the first time I drive my car in the morning it starts up just fine. It's once I turn the car off after driving somewhere and try to start it again that I have problems. I'll have to turn the key 100 times or more sometimes to get it to start if its not the first time of the day. What this could be?
View 4 Replies
I've been trying to figure out a slow start condition on my 06 F350. What should the starter rpms be when cranking? My scanguage reads 180. Does this sound low? Batteries are new.
View 9 Replies
Jumped small wire on starter straight to battery and started right up, the starter kept running until I pulled the jumper off. Starter relay? Ignition switch?
What ever it was it must have knocked it loose because I put the small wire back on the starter and it fired right up. Crazy thing.
View 1 Replies
What are the odds that the fly wheel is ok and I just need to replace the starter? I can hear it engage the flywheel, it's making the zzzzzzzzzzz noise after it disengages the flywheel, can these starters be oiled or anything to prevent that noise?
View 7 Replies
Vehicle - 2005 Suburban LS, 5.3L V8; manual slide temp controls, separate controls for driver and passenger sides.Issue - In winter drive side vents will suddenly switch from blowing hot air to cold air. Just the opposite happens in the summer with drive side vents suddenly switching for blowing cold air to hot. Interestingly the passenger side vents operate normally. Sometimes if I stop and restart the vehicle the system will start working properly again but this does not always work.
View 2 Replies
I have a 97 chevy and the only way to start it is to jump the starter relay, not sure if it is the key switch ot the nuetral saftey switch.
View 2 Replies
my 97 chevy blazer has a lot of cranking first start in the day. I changed the rotor and distributor cap but I don't smell any fuel then all fo asudden it will start. I am wondering is it a fuel relay problem, a fuel filter, or some sort of sensor. when it does start it is very smooth running no shaking or hesitation full of power for the rest of the day starts and stops erands . is it worth buying a plug in code gadget and will this problem show up as a code.
View 4 Replies
Infrequently (once every couple weeks) my 2002 Suburban won't start. The starter seems to work properly as the engine tries to turn over and even seems to initially start for a fraction of a second but then dies. If I wait 10 to 30 minutes it will usually start without a problem. This problem does not seem to be related to outside temp, recent use or car position. After dealing with this occasionally inconvenient problem for months I took the car to a service shop and was told that if they could not reproduce the problem that trying to fix it would be a wild goose chase. When the problem occurred again I took it to another shop who kept the car for 3-4 days but was unable to reproduce the problem.
They suggested that there was a problem with the fuel pump but did not want to replace it unless they were sure that was the problem. I then spoke to the Chevy dealership shop who also said it was most likely the fuel pump. In my frustration dealing with this problem I took the car back to my local shop and ask them to replace the fuel pump ($800). Unfortunately, the intermittent problem has persisted and I'm not sure what to do next. I did have an after market remote ignition added a number of years ago and took it back to them to see if this could be related and they said no way. I have also wondered about the security system being a problem in that my rear hatch cargo door does not lock even though the other doors lock normally.
View 3 Replies
99 suburban. X 1+ year progressively harder to start. Will turn over, but seems like it is not getting gas. Engine replaced 10k ago after I blew the last one at 220k. Did this before and after replacement. Once started runs fine. Can hear fuel pump kick on when key turned to on position? fuel relay?
View 8 Replies
1990 chevy silverado 4x4... My truck stumbles when you start it and within 5 seconds or so clears up and runs smooth.. I changed the fuel filter , still the same result.
View 1 Replies
I have a 97 Chevy K1500 truck that i have been having problem with starting. Sometimes it will start. When it does the idle is rough. When i put in in gear it almost acts like it will shut off. Then it comes back and it drives fine. If it shut it off it may or may not start. I had the distributor cap a rotor replaced. Then I replaced the spark plugs and wires. Still does not start. It seems like it is getting too much fuel. I pulled the fuel pump relay and the truck would start then die out. When i put the relay back in truck does not start. I am not sure what might be the next piece to look at. I was thinking the MAP sensor or the throttle position sensor. So far i have not had any codes come up.
View 4 Replies
My truck hasn't run for over a year and no one seems to be able to tell me why. The fuel pump supposedly has 10 lbs of pressure, it has new fuel pump relay, new throttle body, and probably more new things (can't remember exactly). It will start up normally and then it will act like it's not getting fuel and within seconds die. If I keep my foot on the gas and kind of pump it (I know it's EFI) it will try to keep running, but will die, and it really gets rough toward the end like the whole engine's going to fall out. The truck has 300K+ on it but the engine was replaced about 10,000 miles ago. It still has a lot of original equipment.
View 14 Replies
