Dodge - Transmissions - Grandcaravan :: Shifts Just Fine Going Forward But Will Not Move In Reverse
Nov 21, 2011
I am considering buying a 1999 Dodge Grand Caravan with a reported transmission problem. Mileage is around 120k, and the price MIGHT be reasonable even if a trans rebuild would be necessary. I have not seen the vehicle yet, so I'm not yet committed to anything.
Seller claims the car shifts just fine going forward but will not move in reverse. Is this immediately clear that rebuild is going to be necessary? Are there less invasive repairs possible such as valves or controls or other parts which might solve this problem?
I suppose a Caravan transmission at 120,000miles is probably nearing the end of its lifetime, at least that was true of older ones. But like I said, the price is low enough that the cost of a rebuild might be justifiable if all else about the vehicle looks good. I want to have a better sense of the prospects before I invest time in going to look at this...it's about 50 miles away. I have a local transmission shop that I trust and which has reasonable prices
View 17 Replies
Advertisement
I have a 2000 grand caravan that has no reverse. When the problem started, it had no forward or reverse and a low ticking sound in reverse. Had it towed to the house where it sat for months. Decided to remove and charge battery and start engine. To my surprise, when i started the van and shifted into drive, the van moved forward and trans would hold even when brake applied without slipping. When i shifted into reverse, i had nothing but a low ticking or knocking noise. Does this sound familiar. Could it be an axle problem or a definite transmission failure.
View 4 Replies
I recently bought a 2001 Sante Fe 4X4, (my first Hyundai), that has transmission issues. It has about 135,000 miles on it. It will start easily, and go into Reverse just fine, but would not move in any forward gears. It would occasionally shudder a bit when put in 'drive', but only move forward a few inches. Recently, my mechanic backed it around, then decided to try it in forward again. This time it went forward a couple hundred feet, then quit moving forward. Do I need a new transmission, and if so, what vehicles use this same transmission? Or is there a sensor or valve that could be defective?
View 5 Replies
My 2007 Dodge Grand Caravan with a 3.8L engine won't shift going up hill. On any incline, it stays in the gear it was in when the incline starts and will never upshift. So we're stuck going 20 to 25MPH up hill. Once we get to the crest of the hill, it shifts to the next gear and we're good to go. From a standing still on flat land, if I nail the accelerator pedal, it also won't shift, I have to back off the accelerator, and it will upshift normally. What's up with this?
Have engine light on and the code indicates a bad EGR valve, and possibly a bad catalytic converter, but Autozone indicated that a bad EGR can also produce a code for a bad catalytic converter. They recommended replacing the EGR valve first, then see if the code comes back. But they didn't know if this would cause a loss of torque, which might be related to the shifting problem.
View 1 Replies
I'm new here and I am having issues with my Lumina. It is a 93 Chevy Lumina Euro 3.1L 6 cylinder and has 192K miles on it. It has had one owner for the past ten years that I know for a fact.
Here's what happened. I was coming back home (2hr trip) The brakes had started making that roaring sound on the way down and had gotten worse when I got ready to make the trip home. Okay so I know the brake pads needed to be changed. No big deal. Well going down the road at 65mph I round a curve and my car starts making this REALLY LOUD grinding clattering noise. It took me forever to get it stopped. I will still in the road and I needed to get it out bc it was right around a curve. So I put it in drive and it wont move. So I put it in reverse and it moves just fine with no problems and no noises made. After backing it out of the road I tried to put it in drive. It moved forward a few inches and stopped like something was binding it up.
So here's the problem.. it will move in reverse with no problems at all and only creeps a couple of inches forward then stops. The harder you press on the gas the more it tries to lurch forward but will not move.. like it's caught on something.
We changed the rear brakes on it. Discovered that the driver side rear rotor and caliper were broke beyond repair so we replaced those too. Still the same.. moves forward a lil bit and stops but will go in reverse just fine. We don't seem to think its the tranny bc it pulls hard and seems to not have any problems pulling.. but its like something is bound up somewhere. That is the best way I know how to explain this situation.
View 8 Replies
My trailblazer will not move in reverse , and will barely move forward, i checked transmission fluid hot and it's not even on the dipstick but when it was cold. it was?? Do I add more or what?..
View 9 Replies
Replaced the ac compressor/filter dryer/exp block on 04 dodge grand caravan. pulled vac for 45 min, let sit for 1hr. No movement of needles no leaks. charged system to 2.69, start van turn on ac compress clutch engaged but will not cycle off stays engaged. Air temp from vents 60 to 65 deg, low side 55 psi high side 250 psi at 85 deg air temp needles do not move up or down stay steady. high side hose from compress very hot ( burned hand on it ) low side hose to compress warm/cool.
View 5 Replies
When I started my car and put it in reverse, it didn't move. It felt like my front, right wheel was in a divet or was being blocked somehow (intuitively it seemed like if I accelerated enough, it would eventually move, but since there was nothing physically stopping it - that I could see - I didn't want to break something by doing that). I tried putting it in drive and neutral and the same issue was still there. I put the car up on a jack and checked one wheel at a time - I could move each wheel completely around in both directions.
I could move the steering wheel all the way to the right and to the left. I tried turning off the 4-wheel drive and that didn't do anything. At this point I'm concerned it could be the transmission or the drive shaft, but I'm not sure what to look for in order to know if I need to get it towed to a shop (hoping I can avoid this) or if there's a simple test I can do, or a way to "reset" something if it may be locked. I haven't had anything happen to the car that would have been of concern.
View 2 Replies
My 1996 Buick Park Avenue had problems finding reverse. You would have to move the shifter in and out of reverse and get it in just the right spot to go into reverse. once it is going in reverse you can hear a slight ticking sound like the park gear isn't totally disengaged. now it is nearly impossible to find reverse and when you put it in neutral its like it is in park.
View 2 Replies
If I am moving in reverse and tap the brake I hear a clunk from the rear of the car. If I continue in reverse and then again apply the brake then no clunk. If I drive forward and stop, no clunk. If I then shift into reverse again and apply brake I get the clunk again. Had the struts/shocks replaced but no change.
View 5 Replies
On our 2005 Grand Caravan with 165K miles, the back liftgate has worked fine for years. It continues to raise properly but now it suddenly decided to reverse about one third of the way down when closing button is pushed. Both struts were replaced 3 years ago with the liftgate working fine until now. I don't see any obstructions on gate or in the mechanism.
View 1 Replies
Our '03 Dodge Grand Caravan has been stalling sometimes in reverse and in first gear when starting to move. This usually only occurs if we hadn't yet driven it that day, or if it has completely cooled.
Put it in reverse and give it a little gas to get out of the spot, turn the wheel, and it stalls.. Park - Restart - Drive, and any attempt to press the gas normally probably results in stalling again. This presents a problem as I get to a stop sign and it stalls while in the middle of an intersection...so there is danger to this problem.
The only way I have found to somewhat thwart the problem is to ever so lightly feather the gas, and I mean I don't even push it, I tap-tap-tap it. This usually results in not stalling, but a slight lunge in acceleration.
There is a check engine light on and the code is for the emissions Evap. solenoid. Does this have anything to do with it? If not, what the heck is going on?!
View 2 Replies
My brother-in-law asked me about his 2010 Hyundai Santa Fe. It has an automatic transmission, that's where the problem is. Several times recently it doesn't want to go into reverse or park. Shifts fine, fluid fine, no smell or noises. Vehicle has about 68,000 miles on it.
View 1 Replies
2004 BMW 330i 140k miles.
We first noticed this problem a year or so ago. At first, it happened only on cool mornings if the car had been parked outside. The cold car would require 3-4,000 RPM to move, forward or reverse. After about one minute or 3-4 blocks, the transmission worked perfectly at the touch of the throttle for the rest of the day.
It only happens about half the time. Other times, even if cool and after being parked for days, the transmission engages normally from idle and up.
Once recently, it deviated from this pattern. After sitting overnight, it started and pulled into the garage normally. I shut it off for a couple of minutes to place ramps in front of the tires and restarted the car. It did not want to move on the second start. It took 3500 RPM to climb the ramps. That was scary. The car has never suddenly engaged, but if it had suddenly engaged at that moment, it would have shot me through the front of the garage.
Last week I took it to the transmission specialty shop with the best reviews in town. As life would have it, he kept it three days, driving it four times, and it worked perfectly each time he drove it. Fluid looks fine (replaced at 120k miles) and fluid level is perfect. No codes stored in transmission computer.
I thought it was intermittently draining the torque converter until this last time when it failed after being shut off for only a couple of minutes.
The transmission guy is not interested in rebuilding the transmission even if I wanted to try it. He worries that because he does not know what is causing the problem.
View 3 Replies
The gear shift works fine, and we lifted the hood and saw that the mech. arm IS working when we shift. However, the van will not move into any gear. won't go forward, reverse, etc... it acts like it isn't shifting.
i was driving down the highway, and noticed it wasn't accelerating and stepped on the gas.. .and nothing. I stopped the van, put in park, turned it off. Started it again, and put in D and wouldn't go, just engine revved. then put in reverse and same thing... didn't move but engine revved.
View 3 Replies
I have an 06 Montana sv6 that clunks when I start to move forward or reverse. Not when I put it in gear but as I start to move. It also does it when I take off from a stop sign. It doesn't make any noise while driving or turning though.
View 1 Replies
2000 ranger v6 automatic trans electronic 4wd shift on the dash. Plowing snow all of the sudden lost both forward and reverse never slipped or made any noise. Transmission fluid is fine to the level and clean. Put in drive nothing and reverse nothing put it back in park you can hear the park paul trying to click in. Towed it back to the shop thinking maybe the transfer case was junk. Decided to check the actuator on the transfer case no power going to it, go back to the switch no power there either check the fuses both are good and have power. The question i have is could a bad GEM module cause all this? ps the windshield wipers do work.
View 6 Replies
So, I don't know if any of these problems are related but a few months ago, I accidentally put diesel fuel in my car. We got it flushed out (used some fuel injector cleaner and filled the tank up to dilute what fuel was left after i siphoned it) and my car was doing fine. Then my car started running really shitty, just taking forever to accelerate, revving really hard when I gassed, but not going fast at all, so we changed the spark plugs, oil, and transmission fluid and now it drives forward just fine, but will not reverse. all it does is move forward a bit then stop. It will drive in neutral up to 20-25 mph. What might be wrong??
View 3 Replies
After washing my 08 GX and putting in the garage to wax dry I have found that the next time I get in it to drive-often a day or so later,the car will not move in reverse ( or forward) without me revving it up quite high to overcome the locked up pads on the rotors. Sometimes its even screeches the tires to get in unlocked. I just washed it and letting it sit outside for a bit to see if the sun will dry out the rotors/pads and that would work.
View 10 Replies
The truck will go into reverse, but will not go into drive or any of the other gears. When shifted into one of those gears, it just idles as though in neutral. This started as I was driving down the highway at approximate 70mph. The speedometer jumped up then fell to zero as the car slowed to a stop. There was no noise except the sound of rapid fuel intake and then it went to idling. I have been told it may be a speed sensor, but I was wondering if there was anyway to confirm that before I have the truck towed down to a mechanic and find out its more than I want to pay to fix it.
View 1 Replies
Just bought an 01 F250 7.3 but it will not move I think it has something to do with the fuses because it won't go in forward or reverse but I can't find an accurate diagram For fuse box I'm missing probably 8 fuses underneath the dash and I think one of them has to control the transmission module. What it could be if someone doesn't think the fuses...
View 9 Replies
