Ford - Explorer :: 1995 - Idle And Acceleration Rough
Mar 24, 2015
I have some major problems with my explorer. The idle is rough and accelerating is rough also. If I nearly put it to the floor it almost seems like it studders the power. it will feel great for a second that feels like it's less power for a second then more and less and more and less. When I'm sitting at idle, it will idle fine then after a minute or so it will bog way down and shake the whole vehicle. when that happens I give it some gas and it comes back to normal idle then it does it again after sitting for another minute. I've replaced spark plugs, wires, alternator, oil change and some tires. I've been told by many mechanics it could be the IAC Valve or the fuel pump or the fuel filter or a vacuum leak.
View 8 Replies
Advertisement
Symptoms: (162K miles, last tune up about 70K miles ago) rough idle, and poor acceleration. Occasionally, the car really jerks while accelerating. I read about new plugs/wires, and something called seafoam. I think the highway patrol would pull me over as a gross polluter, but that too seems worth a try. Various sensors and hoses, I'm frankly overwhelmed. Where to start?
Something I learned today: My car was made in 10/95. Apparently, I can scan for trouble codes?!? How and where? Is it OBD I or II or something else? Dumb question: I can't even get the interior engine shroud off. I found three clamps, but it still hangs up near the top. What am I missing?
View 14 Replies
My truck is a 1995 Explorer 4.0 150,000 miles, 5 speed.
Problem - Rough idle : when cold it's worse and will stall and choke a little. When warmed up it just has a rough idle but will not stall and stays at a pretty constant RPM. It's very tolerable when warmed up but still not right. It drives fine once off idle. No black smoke that I can see. Power may be just a little off but I would not bet on it. MPG seems about normal but haven't been on a long enough trip since problem started to tell for sure. Also longer than normal cranking on occasion.
Diagnostics so far : Fuel pressure is at 32 PSI, vacuum off regulator it's at 40 PSI. Not sure about key on only as I don't trust the autozone loaner gauges. You have to fiddle with it each time before it will read. Leak down after 30 minutes was about 4 PSI
No Check engine light ever. KOEO test shows no hard or on demand codes, I get the 111 pass. From CM I get 336 and 45.
336 is EGR related and my looks pretty rusty. I put a vacuum pump on it while running and the EGR held vacuum but had no effect at all on idle, I was expecting it to get worse as I opened the EGR so it may be stuck.
Searched high and low for vacuum leaks by ear, visual and with starting fluid all turned up nothing.
Actions so far : Replaced plugs, wires, IAC, and fuel filter. Cleaned MAF sensor and throttle body plus ran lucas fuel injector cleaner through it.
Next steps : I've got the EGR but it's so rusty I am sure I'll break the tube it bolts to plus I don't know it that alone will cause the rough idle. Will the DPFE sensor and/or EVR create a rough idle yet not turn on the CEL?
Thought about changing the fuel pump and/or regulator but the numbers are not terrible. Agree?
Thought about changing the intake gaskets but don't see any leaks.
View 8 Replies
I have a 95 explorer, has been a great truck until lately. it started as just a small rough idle every now and then, nothing to make a big deal about. just changed the oil and wiped things down a bit, started it up ran just fine for a couple of minutes and when it starts to just barely warm up and the idle drops down it starts louping or surging, if i hold the throttle open it bit it kinda goes away and it would continue to warm up and not have a problem idling. now it won't even do that. i'm pulling several codes, to many to list and the truck ran just fine a few days ago ...
View 3 Replies
1995 ford ranger with 4.0. It idles rough. Replaced MAF TPS fuel pump fuel filter fuel pressure regulator upper o2 sensor. IAC.. still idles rough RPMs drop. It isn't as bad since replacing MAF but still not right. What else is there.. Cleaned out the air intake port it was gummed up. Don't know what else to do?
View 3 Replies
The problem starts after about 5-10 mins of start up and normal driving. First signs usually come leaving a stop light or stop sign. Hesitation, jerkiness, rough acceleration. It's usually slight, just enough to feel it. Soon it really shows up while keeping the truck at a steady speed, say 40 for example.
I finally heard what I would describe as a puffing air sound and figured vacuum leak.. finally! Nope.. it's coming from the rear underneath of the vehicle. I can't hear it in the engine, or the tail pipe.
2002 Ford Explorer xls 4.0 125k miles, I've replaced the air filter, egr valve, pcv valve, cleaned the maf and covered about every hose I can reach with carb cleaner checking for a vacuum leak. I've yet to try some of the other things due to hearing that puffing sound.
View 8 Replies
I have a 07 Explorer with the 4.6 that just developed a problem. It has 75,000 on it and has all of sudden started shaking at idle and acceleration. The acceleration issue doesn't seem to occur until after 45mph. I have cleaned air filter and MAF sensor. Still need to put a code reader on it. Where to start troubleshooting.
View 3 Replies
My 95 4.0 has had a periodic idle issue for quite a while. It seems it may be getting worse. Here is when it may only happen:
Vehicle is fully warm. I shut it off for about 1 hr or so and when I restart it, it shakes and misses in idle. It will idle fine after I drive it around or if I rev the engine for a while when still parked.
This never triggers the "check engine light". New fuel filter, plugs and wires.
View 1 Replies
When I start the truck it hard to start and the idle is rough but when it warms up it seems to get better but still miss fires now and then so i was thinking could it be a bad O2 there is now "CEL" because the battery was dead (installed a new one) and the truck has not been on the road yet (want to get everything fixed first) and update on the door alarm will be working on that tomorrow almost forgot 2002 explorer 4.0L "E" for the vin 4 wheel drive 124k on it.
View 5 Replies
My explorer has been running a little rough, particularly at idle. When I take off from a rough idle, it'll run rough until I hit 25-30mph. I ran by O'Reilly's hoping to pick up a pack of spark plugs and be done with it, ended up leaving with a new MAF sensor. It ran better for about 10 miles (I'm a delivery driver, so I did a lot of stop and go immediately), before it ran even worse than it did before, but at least my CEL finally came on. Took it back to O'Reilly's and they read a MAF sensor code and a catalytic system code (didn't ask for the codes, and now realize that was a mistake).
So today I took it to a muffler shop to have the catalytic system diagnosed. They looked at it for 10 minutes and told me they didn't think it was the converter. They said it seemed more like the EGR valve or solenoid, or the IAC. He scanned the codes again and got multiple "running lean" codes (0171, 0174, etc). The guy said I didn't have a vacuum leak, so I think I can rule that out. Unfortunately, the truck idled fine the whole time so he didn't feel comfortable giving me a definitive answer. He told to to leave the EGR valve hose unplugged for a few days and see if anything changes. I'm thinking about running a bottle of fuel cleaner through it or taking off the IAC and/or EGR and cleaning them myself.
View 6 Replies
99 explorer 4.0 automatic, lately been running weird. Starts up but will stall out unless you let it warm up. And idle drops below 500 rpm. And is really rough feeling. To like 2 or 300 rpm, then will stall but will start right back up. When I changed spark plugs and wires problem stopped for about 2 weeks and now is back. And has no engine code.
View 7 Replies
What can cause my 99 explorer xlt to have a rough idle on initial start ups?(Its worse in the winter time) And sometime after driving places when i put it in park the truck will cut off. It has the 6 cylinder SOHC if that's useful.
View 1 Replies
Bought a used 2003 Explorer 4X4 that runs like crap.... All I know is it has new upper and lower radiator hoses, new battery, new brakes, 2 new tires and new belts... suspension seems great and body is nice too. It obviously needed a new radiator and complete exhaust, so I did those. Now it is running better ( I can actually get the RPMs over 1500) but still running rough and will stall if I let off the gas. It will surge and dip in RPMs. Very suspicious of vacuum leak.
Unplugged the MAFS and it roared upon start but within a minute started the sputtering etc. Currently pulled the IAC and check continuity between pins and it was 10 ohms so that passed but there is no continuity between either pin and the case. So this seems to indicate I need to replace the IAC which I will do tomorrow. I would love to find a diagram that displays the vacuum system so I can make a thorough check of it. Also seems to have an oil leak on drivers side valve cover gasket.
View 14 Replies
I have a 2000 F-150 5.4 L. I was driving from home and seconds after the engine went into a rough idle that wouldn't let me accelerate. I scanned it and gave me multiple transmission trouble codes, about 15. I checked the wiring, the transmission fluid and it all looked good. So, what could be the problem?
View 3 Replies
V-10 getting a weird hesitation on acceleration and rough, sporadic idle. Fuel filter is brand new, spark plugs only have 8000 miles on them. If im just cruising and give it just a little gas it gets real rough and wont smooth out unless I give it more gas. What else could it be? Coil packs?
View 14 Replies
My 95 3000gt is smoking after about 30 minutes of driving. Smokes mainly when idle and upon acceleration. car has about 200k in mile. what could cause this.
View 5 Replies
1994 Ford Explorer; When I start it, if I don't step on the gas it will stop. If I give it some gas when I start it, the engine will race and then decelerates about 2000 rpms and keeps doing this, it does get better as the engine warms up. But the idle is really rough. It has new wires, plugs, vacume lines, oil change, air filter and battery. If I put the gas pedal to the rug, it will go from 4000rpm back down to 2000rpm and continue doing this as long as I keep the pedal to the metal. I had it put on an analyzer and it didn't read anything.
View 6 Replies
I have a weird intermittent problem. Sometimes when I start my explorer it will idle down and die immediately, I restart and it will idle about 400-600 really rough, sounds like it is missing. When I drive it it is jerky and the acceleration is sluggish but after I get it up to about 20 mph it clears out and then drives and idles fine until I shut it down. Plus these things only happen about every third time (on average) that I drive it. Lastly it's not giving me any codes. What this could be?
View 2 Replies
My 07 F150 has no power. I changed the timing chain, cam phasers, spark plugs and all 8 coils and still no power. Rough idle and bogs on acceleration.
View 3 Replies
I have a 04 FX4 scab with a 5.4L and am having issues with it idling rough, and low power and stumbling upon acceleration and cruising speed. I did a scan and the codes show lean run condition, misfire on cyl 4, etc. I changed injector and coil on #4 and it seems worse. Scared to change the plugs, until I can leave the truck down a day or two in the event that I break one or more.
View 10 Replies
ok, 3 times now I've been extremely close to being hit head on by oncoming traffic due to a seemingly uncurable stalling problem. It idles rough sometimes, and other times it seems fine. BUT when sitting at a light, waiting to turn left after the oncoming traffic has a quick opening, I start to go, I get halfway across the intersection and then without warning, it dies completely. Now its too late to stop and back up- and the cars are flying head on towards you locking up they're brakes. One time I would have been killed by the 18 wheeler that was coming if I hadn't gotten it started and moving again just in time.
I replaced the IAC, the plugs, filters and wires, and the EGR valve. I checked everywhere for intake leaks and found nothing. Changed the O2 sensors since they had plenty of mileage on em. It idles like crap still, even after 30+ tanks of every kind of injector cleaner they make. We used the snap on scanner tool to monitor things and it never acted up then. The TPS seems to move smoothly, and fuel pressure was checked and found to be around 25-30 psi. Don't know if that's normal. The intake air temp was reading a constant 120 degrees F. I also checked the fuel cap to make sure it was closing completely. The dealer checked the TB for excessive clearance and said it was ok.
It seems to only stall like that after driving on the highway and then stopping at the first light after that.
View 12 Replies
