1998 Honda CRV ... Replaced the AC compressor. AC is cold only when the engine is revving above certain rpm. When at a stop, the air is warm...but if I put it into neutral and rev the engine to, let's say, 2000+ rpm, AC gets colder....or when I am driving, obviously. I know everyone is gonna say something about the condenser fan but would it be the fan given above circumstances?
View 16 RepliesI have a 1998 Honda Accord with about 170k miles on it. Lately, I've noticed that the temperature gauge creeps up to about 3/4 of the way to max when I'm driving in heavy traffic and running the air conditioner. This is the only time it goes past the midpoint, and it usually starts going up after maybe 15-20mn of sitting in traffic. If I turn the A/C off, the temperature immediately starts going back down to normal. Also, when traffic is flowing at normal speeds, I can have the a/c on for hours with no issues. The air conditioning itself is also pretty ineffective in heavy traffic situations. It gets very cold when I'm moving at a decent speed, but is pretty weak at low speeds. I just had the radiator replaced about six months ago, and it doesn't seem to be a coolant issue. What the issue could be?
View 11 RepliesMy heater/AC fan only works on high. how do i get the low and medium settings to work?
View 3 RepliesMy oil pressure had been dropping to 0 for a while. After searching the internet, I replaced the oil sending unit. This seemed to fix the issue for a while - until I was going up some hills, and the engine began revving really high, and the oil pressure once again dropped to 0. I then heard some noise from the engine, so I pulled over and turned it off. I had it towed to a garage, and told the tow driver to NOT start the car, because I thought the oil pump was out, and so no oil was getting to the engine.
I then called the garage, and told them it was coming in, and NOT to start it, because the engine was not getting oil, and I thought oil pump might be bad. They called me back an hour later to tell me they had added some oil and started it, and the engine was gone.
First question, is would a good garage have tried starting the car with the information they had? My expectation was that they would have tried to check things out without starting it.
Second, should I try to replace the oil pump and see if the car starts?
Make: dodge
Model: durango
Model Year: 2000
Odometer Mileage: 205,000
Amount of oil consumed between oil changes: 1 qt
Frequency of oil changes, in terms of both odometer mileage and elapsed time: 6months, 5000 miles
Oil level was checked once every one to two weeks.
I have a 95 Mercury Villager that didn't pass inspection. I put SeaFoam in it before inspection to clean the engine. Now I have been told that it may have caused gunk to loosen up and that I need to run out all of the gas in it and then fill it up and run it at high speeds for a period of time on the highway before I try to get it re-inspected. Since it didn't pass inspection I couldn't get it registered and it is technically not street legal at this point. I'm letting it run in the driveway to burn up the gas. Should I fill it completely when I get gas or should I put just a bit in and run it out a couple of times before I try to get it inspected again? Also, if I put it in park and rev it for 20 mins or so would that be equivalent to driving it on the highway?
View 14 RepliesMy girlfriend has a 2004 Prius with the nav kit and has been having some rather odd issues as of late, of which seemed to have started after she hit an animal. The gas engine in her car seems to be turning on right away when she turns the car on. The engine also sounds quite loud, almost as if it is revving. Her gas mileage has also dropped considerably, from 45-ish down to around 33 mpg. Also, upon stopping, the mileage gauge on her nav screen doesn't immediately go to 99. Instead it sits around in the 40s for a while before jumping up to 99.
Now, she mentioned this to the tech at the dealer when she finally went to get the recall done on her water pump, but the guy said it drove fine and threw no codes. She then took it to another shop who said it threw a P3190 code, but he had never seen this issue and wouldn't know how to fix it.
The only thing I could find while searching around (mainly on this forum) was that it could be a problem with the electric throttle body. The throttle body seems to make sense to me, but she isn't totally convinced. She also has a 200+ mile trip coming up for the holiday season and it would be nice to fix the issue before that.
My 2003 subaru outback wagon, manual transmission, starting revving about 1500-2000 rpms higher than normal today. When I put the car in neutral, the car revs high sometimes increasing in rpms. Also when i left off the gas the car doesn't decrease in speed or rpms almost like the gas pedal is sticking. I revved the engine while in neutral a few times to try to see if I could get the rpms to drop but that didn't work. I had two belts changed yesterday (excluding the timing belt) and everything was fine with car until today, after driving 70 miles.
View 2 RepliesI've just done an engine swap to my 2000 GTS Celica. The new engine seems to run nice and tight and smooth and everything but I can't seem to bring the idle down. It stays revving at about 2000 RPM and the check engine light is on. The engine is from Japan and only has 35,000 kms. on it.
View 14 RepliesI bought a CPO 2010 Camry LE (2.5 4 cyl, 6 sp auto) a few months ago. The car had around 34K miles when I got it, and ever since then, it has had a high pitched whining noise when accelerating or revving the engine in park. It is noticeable from around 2500RPM up, and seems to be a little louder when the engine is cold.
I have left it at the dealer twice, and both times they have come back and said it is normal. I can't believe this, because I have owned many cars over the years, most of them being fairly dilapidated, yet most of them haven't had a noise like this. I think I have read a comment online somewhere that an issue like this was found due to a bad power steering pump .
I have a 1994 Toyota Camry. Took it to a shop to repair an oil leak. They had to dismount the transmission to get to the gasket. I got the car back and the transmission was messed up. Took it to a transmission shop and they told me that the transmission "cable" wasn't positioned correctly by whoever had done the work and they could fix it. They told me it was safe to drive it until my appointment. The engine was revving too high before changing gears and while driving home, I heard a loud rattling noise in the engine and my car stopped in the middle of the road. I'm told that a rod has broken inside the engine. My question is: can this in any way be related to the transmission cable not having been set/positioned correctly?
View 5 RepliesIt happened as I was stopped at a traffic light. without warning it just revved up as though I punched the gas pedal, which I didn't. had my foot on the brakes but it still wanted to fly! I dumped it into park and it really howled! I shut off the engine, started it back up and everything was fine! what the heck caused this and what needs fixed?
View 7 RepliesRecently, when I start my Golf 2.5 DSG it has been revving a little loud or rough. It usually revs at under 1k at idle, but when starting up it revs at around 1500 until I put it in drive and release the footbrake.
View 10 RepliesI am at my wits' end with my 98 Honda Civic LX. The problem starts around late summer of last year. It is sporadic, so I didn't quite pay attention until one day the engine died on the highway after I picked up the kids at the school. It didn't make any sound nor giving any warnings, just suddenly died. After that highway episode, it seems like it just taken its own fancy schedule as far as when to die, so to say. In a given day, it could 4 episodes in a day. Then it runs perfectly for some weeks then it starts again and went away again.
It just quietly dies while being driven. I had to turn it completely off, wait for some moment and try to turn it on again. Sometimes it just turns on again without me being frustrated and there were moments when I had to do several attempts. Once I heard clicking sound before the engine died, only once, the rest makes no sound at all. No lights are on.
I have a 1998 Honda accord with 4 cyl. engine. Recently, the engine would stop at then end of the first block after 8 hours or longer of parking. I am very light on the gas pedal. I generally release the gas and let it roll for a couple of seconds before applying the brakes at the stop sign and during the time, the engine seem to throttle a bit then stops. After a restart and applying gas, it seem fine. What can be wrong with it?
View 6 RepliesI have a 1998 Honda Accord that intermittently won't start. When the issue occurs the dashboard lights, radio, etc all work just fine, but the engine won't turn over (no clicking, no noise at all). It's standard vehicle, but I definitely have my foot all the way to the floor to depress the clutch safety switch. The issue only seems to occur when the car is warm (i.e. it never happens on the first start in the morning), although it's been known to happen even after 2hrs of cooling down. The issue used to only occur 1 out of 100 starts, but now it's getting closer to 1 out of 4 times. I'm able to get the car going by jump starting it, but that's getting old.
View 5 RepliesOut of nowhere my check engine light came on bought some oil thought it was low, and i just recently got an oil change. Checked my sparks and it was okay. Couple hours later my car began over heating With engine light still on, and my temperature gauges increased knew something was wrong, filled it with anti freeze to cool it down, continued driving and the issue continued. Bought me a knew sensor, I noticed it worked but did not fix the issue, my car continues to over heat, couple days later without driving it, this morning on my way to work it was really cold so my car did not overheat, but my check engine light began blinking and my vehicle began rattling from my house all the way to work, for about 9 miles. Whats wrong with it? Is it safe to drive back home after work.??
View 19 RepliesI've been dealing with this for over a year. 97 s-10 (4.3, 4wd, 5spd) always wants to keep revving. When I put it in neutral and coast, the rpms rise. When in gear, it powers itself down the road even when I'm off the gas. The part that really gets me, is that it will keep revving in neutral until the vehicle comes to a COMPLETE STOP. Then, it drops to a nice idle within 2-3 seconds. I don't understand what the momentum of the vehicle has to with the revving of the engine when its in neutral.? I replaced the IAC valve (and set the pintle) and tried to clean up everything I could. It seemed to be better for only a little while. Faulty new part? Is the IAC getting "gummed up" quickly because of something else?
View 3 RepliesI have a 2007 Passat with >120k miles on it. For the last month or so, occasionally when I start the car up, the EPC (I think it stands for Electronic Power Control) light and the Check Engine (the engine sign) light comes on. When I hit the gas, it barely goes past 20 and seems to be revving really high (almost redlining) before it finally accelerates. Needless to say, this is not a good thing; especially when it happens on the freeway.
I called around to a few mechanics but they all want to see the car and run the computer codes on it before they even tell me what's wrong with it; which I am loathe to do just yet because I don't want them to charge me an extra $100 for a diagnostic for a repair I may not even get done with that mechanic. Meanwhile I'm driving around feeling like I should put my feet on the ground like Fred Flintstone to gain speed.
In the research I've done online, I've seen that it may be an issue with the throttle wire or some other wiring issue.
I had some problems with my Elantra and I fixed (or tried to) them all this weekend. I needed a new IAC motor, the motor was reving up and down and I tested it, then changed it. I needed a fuel injector and changed that. I needed a lower thermostat housing and changed that.
These changes resulted in the following problems. The vehicle now revs at a high idle all the time at approximately 3000. What are the causes of this?
I know that when I was burping the coolant system (changing out all the hoses and the thermostat housing) I got antifreeze sprayed all over the top of the motor.
Here is the problems that I have now. Didn't have these before.....
The engine idles at or about 3000 rpm. Constant from startup until shutdown. It idles down when you shift it into gear but that is because of the strain on the motor with the brake used.
The transmission is now having problems shifting from 1st to 2nd. I checked the fluid, its good. There is however antifreeze on top of the transmission by some sensors. Do these sensors have anything to do with the shifting?
I just brought my 2011 Prius to the dealership today after the check engine light came on. Last night, the car was intermittently revving at a high level, but otherwise the car as running fine. The service technician was saying it was the VSV valve that was intermittently sticking. I was told that there was a software update on this valve that might take care of the problem; I asked about the lifespan for the valve, but he had no information about that. I told him to just do the software update, but now I'm wondering if I should also replace the valve.
View 2 RepliesI have a 2008 Subaru Forester that I bought used. It has 37,000 miles on it. When I drive at high altitudes, the rpms rev up, the car slows down, sounds terrible. Why is this and what can be done?
View 3 Replies