2002 cheverlot impala . the oil pressure switch keeps going bad and the diaphragm bust and oil comes out where the plug is. had to replace four in over a year . why and what make them go bad ?
View 12 RepliesI am the (once) proud owner of a 2008 Chevrolet Impala. I have owned the car for one year, putting only 12,000 miles on it (was 109,000 when I bought it.) The car has run quite well—I have not had any problems out of it (unlike the 1999-2005 generation Impalas). But, as many of you may have heard, GM had some massive recalls as of late. Many of the cars have had fatal ignition switch failures. Basically every single Impala in the last (my) generation has been recalled.
Take any other keys/paraphernalia off of the chain—basically, just insert the key into the ignition, unattached to anything. This is the fix for the time being, apparently—until they can get ignition switches for however many hundred thousand Impalas they have to fix.
I am about to make a 3 hour drive. Now, that wouldn't be the longest drive that I have made in this car (and I cringe at the idea that, driving 17 hours with a bunch of crap hanging off of my chain, that my car easily could have been one of the unfortunate ones.)
Now that I know that I cannot be sure of the safety of my vehicle, I need to know what to do in the case of an emergency. I want to know what exactly the situation of an ignition switch failure entails...basically, what happens to my car and my ability to control the car. Lastly, I need to know what to do if this happens.
I have a 2006 chevy impala LT 3.9 v6. Intermittently it wont start, crank it and it does nothing. All accessories work fine. Had a new starter installed, switched the relay it works on, had the ignition switch changed (twice), had the passlock system replaced, new keys for the ignition. Had the car to the dealer four, times. It doesn't happen all the time so it cant be reproduced at will. I just keep trying to start it and it will eventually start, it can be turning the key from 4 to 40 times. there's no rhyme or reason, some times it doesn't happen for 5 days, then it happens everyday for a week.. according to the dealer when they reproduced it it was the ignition switch. I doubt i got 2 bad ignition switches so i don't believe the error is being reported correctly. According to chevy they have no other reports of this..
View 2 RepliesI have a 2003 Impala LS with around 114,000 miles. I noticed today that the control switch that turns on the AC or heat is not fully working right. My switch has 5 levels, and on levels 1 and 2 nothing happens. But when I switch to levels 3-4 or 5 it works just fine.
My question is is fixing this going to involve removing the entire dash from the car? My guess it's a contact issue, and figure it might be pricy to get repaired.
Last night I found out my car can "sense" when I have low pressure in my tires as it sounded an alarm. It was right my back driver side tire must have a slow leak because it was down to 25 PSI. I looked in my manual and on my inside panel of my driver side door but couldn't find anywhere what the correct pressure should be. I checked all my tires. My two front, which are brand new tires came it at 38 PSI, my passenger side back was at 35. So I filled the other back tire back up to 35 and reset the low tire pressure alarm. Got up this morning and the tire was down to around 30, so off to the tire shop on Saturday. But where can I find out what is the best PSI for the four tires.
View 19 RepliesMy impala over heated on me and it doesn't turn on..... What is wrong with it?
View 5 Repliesmy 2002 chevy impala has had the check engine light on for a while now i took it to a shop and he said my engine was bad. I asked for the codes he got he said he just told me my engine was bad why do I need codes. I talked to another mechanic this week and he said he'd look at it, that it might not be that because I should of got a print out for what I paid for. SO I got a oil change today and when i left I saw in the comments that they put class 2 oil pan leak and a class 2 transmission leak. Could that be why my check engine light is on? How bad is a class 2 transmission leak?
View 10 RepliesI have a 2002 Chevy Impalah 100k miles that frequently won't start. When I put the key in the ignition, I get lights, radio, and all electrical signs. But no sound from the engine. No matter how many times I try to turn the ignition, I get nothing.
But then when I stop trying and then come back to the car 5 to 10 minutes later, the car will start with no problem. This seems to happen randomly--sometimes first thing in the morning, sometimes after being parked for an hour. I can go for days with no problems and then it will start happening (randomly) again.
I just brought the car back from a dealership--they couldn't reproduce the problem and can't find anything wrong with the car. What systems or parts might be malfunctioning?
My 2002 Impala runs hot when pulling a long grade and I have to turn off the a/c. It runs fine every other time. New belts, hoses, thermostat and flushed completely with new coolant. The radiator is fine and a/c coils are clean also
View 2 RepliesI have a 2002 chevrolet impala. The traction active light and abs light and traction off light comes on and the car makes a scrubbing sound.
View 2 RepliesMy 2002 Impala 3.4l sometimes starts shifting hard through all gears. It's not all the time. I have heard of others with this same problem and a transaxle service is apparently not the fix.
View 3 RepliesI've been getting the gas cap code off and on for years now. I can wash the gasket off and it goes away for a few months, but then it returns. The cap itself is in showroom condition. It's just the rubber gasket/ring that appears to be "segmented" all the way around.
Replace just the gasket on the gas cap for this vehicle? I know I can buy a whole new AC Delco gas cap from Rock Auto for $20, but to me that's wasteful. Looking at the cap, I really can't see how it comes apart, though. No visible screws, but it must separate somehow ... or would you just use a pick and pull the gasket up and off that way?
I just installed a replacement Hazard Switch because the directional "blinker" light stopped working (after only working sporadically for a while). This particular switch is probably made in China. Hazards now working normally (with a blink rate of a little better than 1 Hz .. just like it used to work). Directional "blinker" lights - however - are also working, but at a very fast rate: probably 3+Hz. Why this might be? I'm pretty sure the directionals and the Hazards blinked at the same rate with the original switch. Maybe a side-effect of a cheap Chinese switch? I did check both tail lights and they're working for both Directionals and Hazards, but can't get over the difference in flash rate between the two. Doesn't give me a good feeling that this switch will last.
View 6 RepliesShop Manual says you need to remove the oil pan as part of the front cover gasket repair. Is that really true? Removing the oil pan on this car is a very complicated procedure. Want to make sure it's abosolutely necessary before continuing.
View 19 RepliesOk so about a week ago I was driving my 02 impala and I heard a loud noise while driving at 30 mph and it lasted till about 50mph. well I had my dad take it down the road while I was at work about 5 days later to hear what the noise was wondering if it might have been a hub. Well I call him an hour later cause he ain't back he says he's at the gas station and it won't reverse. Well apparently the noise was just my transmission being loud cause it was taking a while to shift. I've never had a problem with my tranny but some leakage which I think is just the gasket I just know that theres tranny fluid under my pan on one side. So I went to auto zone and they got a code for p1811. So I'm wondering if it just needs a filter and gasket change or is my tranny gone. It still shifts into gears just takes longer in 2nd and I can't drive in reverse at all?
View 15 RepliesI have a 2002 impala that has occasionally not started. The problem started a couple months ago, once it started getting cold here in the midwest. Every few weeks when I turned the key, nothing would happen. It only happened occasionally, and after waiting a bit it would start normally. I did some reading and suspected it was the anti theft locking the car down. Today I tried jumping the car just to be sure it wasn't the battery, and all of the electronics were very dim. I heard a rapid clicking noise from the dash that continued even after I removed the key. The headlights were rapidly flashing, although also very dim. This continued for about a minute before stopping. I tried letting the battery charge from the jump for about 10 minutes, no change.
View 1 RepliesI'm trying to find the power steering pressure switch for a 2002 PT Cruiser. I have been under the car and located a pump on the passenger side with a two prong connector. The connector looks to be in good shape. I thought the switch was replaceable but there was nothing to screw out only two prongs going in. Am I looking at the wrong part and if so where is the power steering pump?
View 4 RepliesI am having problem with the battery light coming on headlights on when switch is off the fuel gauge dancing up and down radio works intermittently that's when I start the van it will only run a few miles and the battery will go completely flat I have changed the starter do not believe it is the alternator as there to many electrical problems thinking that a short somewhere. Where to start and what to look at .....
View 3 RepliesI have a 2002 Chevy S10 with 155,000 mls with the 2.2 liter. When I start it up in the morning the oil pressure goes to about 70 lbs, then after it warms up it drop to about 30 lbs. What could cause this?
View 4 RepliesI need to replace, its either a brake pressure sensor or speed control deactivation switch . Would like to know which it is and can I get a generic one from other auto parts beside a ford dealer Can post a pic of part as soon as I figure out how to do that exactly. 2002 f250 super duty....
View 8 RepliesI have a 2003 Impala which up until this past monday had a tire with a slow leak in it. On monday I had that leak repaired, well the shop said it was repaird. Then driving home last night I got the "low tire pressure light" coming on, and well figured they actually had NOT fixed the leak or I had a new one. I pulled off at a station to refill, but first checked all four tires, all four were exactly the same at 35 PSI, which is where they are suppsed to be. So my question, what could have set off the LTPL if none of the tires were low in pressure or no tire was significantly different from the others presure wise?
View 8 Replies