Impala - Chevrolet :: Control Switch That Turns On AC Or Heat Is Not Fully Working Right
Dec 31, 2015
I have a 2003 Impala LS with around 114,000 miles. I noticed today that the control switch that turns on the AC or heat is not fully working right. My switch has 5 levels, and on levels 1 and 2 nothing happens. But when I switch to levels 3-4 or 5 it works just fine.
My question is is fixing this going to involve removing the entire dash from the car? My guess it's a contact issue, and figure it might be pricy to get repaired.
View 5 Replies
Advertisement
My remote controls just stop working. 2006 Chevrolet Impala LTZ .
View 10 Replies
I am trying to troubleshoot why my heater blower, cruise control and info center above my rear-view mirror has stopped working. I am trying to confirm power to an orange wire next to the driver-side fuse box. I have confirmed no power at the fuses. I am hoping the problem is the wire box below the fuse box and not the ignition switch. I have a wiring diagram and the power feed to these three fuses is via an Orange wire. There are two Orange wires in the box, I am trying to determine which one feeds the fuses for these three devices. I have a picture of the fuse box.
View 2 Replies
2009 Impala, 6 cyl., 32k miles, with the engine warm and running below 1000 rpm I only get cool air entering the cabin. As soon as I rev up to 1000 rpm and above heat enters the cabin. The coolant level was a little low and I added about 2 cups. I haven't driven it since adding the coolant but I doubt that is an issue. Since the day I bought this vehicle (at about 16k miles) I could detect a whine sound coming from the engine compartment at start up. This may have something to do with this problem, but until just recently the heater did work fine. The A/C works fine. Thinking maybe a water pump?
View 4 Replies
2002 cheverlot impala . the oil pressure switch keeps going bad and the diaphragm bust and oil comes out where the plug is. had to replace four in over a year . why and what make them go bad ?
View 12 Replies
I am the (once) proud owner of a 2008 Chevrolet Impala. I have owned the car for one year, putting only 12,000 miles on it (was 109,000 when I bought it.) The car has run quite well—I have not had any problems out of it (unlike the 1999-2005 generation Impalas). But, as many of you may have heard, GM had some massive recalls as of late. Many of the cars have had fatal ignition switch failures. Basically every single Impala in the last (my) generation has been recalled.
Take any other keys/paraphernalia off of the chain—basically, just insert the key into the ignition, unattached to anything. This is the fix for the time being, apparently—until they can get ignition switches for however many hundred thousand Impalas they have to fix.
I am about to make a 3 hour drive. Now, that wouldn't be the longest drive that I have made in this car (and I cringe at the idea that, driving 17 hours with a bunch of crap hanging off of my chain, that my car easily could have been one of the unfortunate ones.)
Now that I know that I cannot be sure of the safety of my vehicle, I need to know what to do in the case of an emergency. I want to know what exactly the situation of an ignition switch failure entails...basically, what happens to my car and my ability to control the car. Lastly, I need to know what to do if this happens.
View 14 Replies
I have a 2006 chevy impala LT 3.9 v6. Intermittently it wont start, crank it and it does nothing. All accessories work fine. Had a new starter installed, switched the relay it works on, had the ignition switch changed (twice), had the passlock system replaced, new keys for the ignition. Had the car to the dealer four, times. It doesn't happen all the time so it cant be reproduced at will. I just keep trying to start it and it will eventually start, it can be turning the key from 4 to 40 times. there's no rhyme or reason, some times it doesn't happen for 5 days, then it happens everyday for a week.. according to the dealer when they reproduced it it was the ignition switch. I doubt i got 2 bad ignition switches so i don't believe the error is being reported correctly. According to chevy they have no other reports of this..
View 2 Replies
Presenlty my switch that turns on the heat/ac is dark as is the switch for the speed for that device is dark. Are these bulbs that burn out and just need replacing? the two other switches in that area are lit and fine. Or could it be a wiring issue?
View 2 Replies
I have an 07 Impala. Just recently, the engine light came on. I contacted OnStar who did a vehicle diagnostic and told me the problem was the emission control and further told me I should tighten my gas cap which might take care of the problem. It didn't. How important is it to take care of this?
View 3 Replies
I have a 2003 Chevy Impala LS with 120,000 miles, equipped with sentinel lighting. Recently, the instrument cluster lights along with the lighted controls on the door panels and steering wheel stopped working leaving me unable to see the speedometer while driving at night. All controls seem work properly. I did some internet research and it appears there are several causes and/or fixes out there. I would like to have one or two more probable approaches than just throw money and time at a trial and error approach.
View 9 Replies
I have a 2003 Impala with about 122,000 miles on it. On my recent fill up I by accident put in mid grade over the normal unleaded, now I now that won't cause any engine issues that I am aware of, but after doing this fill up my gas gauge is not working properly. When I start the car in the morning the gauge will go to where it should given the mileage I have driven to this point but as I drive the car the gauge goes up to almost full then down some but never back to where it should be. what might be causing this floating incorrect reading by my gas gauge.
View 19 Replies
I just installed a replacement Hazard Switch because the directional "blinker" light stopped working (after only working sporadically for a while). This particular switch is probably made in China. Hazards now working normally (with a blink rate of a little better than 1 Hz .. just like it used to work). Directional "blinker" lights - however - are also working, but at a very fast rate: probably 3+Hz. Why this might be? I'm pretty sure the directionals and the Hazards blinked at the same rate with the original switch. Maybe a side-effect of a cheap Chinese switch? I did check both tail lights and they're working for both Directionals and Hazards, but can't get over the difference in flash rate between the two. Doesn't give me a good feeling that this switch will last.
View 6 Replies
I inherited this car from my parents a couple years ago with about 80,000 miles. It ran great for awhile, then the air conditioner and the gauges would quit working while driving. After a few minutes they would resume working and everything would go back to normal. Now it will start sometimes and will not start at other times. I have replaced the battery two times and it seemed to work for a short period. I have had several mechanics look at it. After checking the code and replacing a fuse or sensor and replacing the ignition switch the car is still doing the same thing and no one has a clue what is going on. It seems to me that it may happen more often when going over a bump. What could be causing this?
View 2 Replies
Can I use the remote climate control switch to heat the cabin during cold mornings as well as cool the cabin during hot summer days?
View 8 Replies
My 2007 Chevy Impala has developed a brand new problem today. Driving down the block to the store, the speedometer started fluctuating wildly. I was going a consistent speed of about 10 mph in my parking lot and when I braked to a stop the speedometer started swinging all over the place, from 10 to 35 mph. It then gave me a message on the dash saying "Speed Limited to 107 MPH" and somehow killed my accelerator because the gas pedal no longer did anything. I restarted the car and the accelerator worked again for a bit and then pulled the same problem again. The speedometer is now fluctuating wildly the entire time I drive, including while stopped, but so far the message seems to have kicked on and disabled my accelerator only when slowing to a stop and accelerating out of a stop (it happened three times).
I know that the Impala's governor is set to 107 mph so I can guess why that message exists, but I wouldn't think a governor would actually kill the car even if it kicked in at the right speed.
It wasn't that long ago that we had to have our pedal position sensor resynchronized and the mechanic had mentioned that it was possible the sensor was going bad, but I don't think that would be the problem here as it seems like the car would actually have been accelerating sporadically, whereas in my case just the speedometer is swinging around despite an even speed.
View 1 Replies
My heat control stopped working. If I play with the enough I get heat but when I turn the there isn't any tension there, I'm thinking something broke in the dash. I put a different on from my parts truck, no difference at all.
99 f150 xlt
View 9 Replies
When in drive and cruising, I press the transmission control switch to turn off the O/D and do not get any 'OFF' illumination - what are the usual suspects?
View 3 Replies
I have a 2008 Chevy Equinox, and have had issues with the air conditioner for a while (see my other post: [URL] ....).
Lately, if the car is stopped in traffic or at a red light, I cannot get any cold air. The compressor will turn on, but only 2-3 seconds, then it shuts back off. It will cycle like this, on and off, about every 10-15 seconds while I am stopped. Each time this happens, the RPMs jump and the car lurches forward a little as well. As soon as I start moving at a decent speed (20 mph or so), the air gets cold again.
The recommendation from my other thread was to replace the heater control module.
View 8 Replies
I have a 2000 yukon and the climate control stopped working. The defrost works just fine but the heater/ac stopped working nothing blows out from my vents when ac/heater setting is on. I checked all fuses and wires and everything is ok and connected. I just replaced my cd player and the next day climate control stopped working. I went back and checked the wireing of the cd player as well, everything is fine. Would i need a new climate control, or senser or is there a fuse on the heater itself.
View 1 Replies
The cruise control on my 2000 Blazer LS 4X4 is not working. I just changed the multi-function switch and still nothing. I looked at the throttle cables and they seem to be fine. All the fuses are good as well.
View 4 Replies
2010 f150; intermittently the key turns fully without turning the engine on. Still under warrenty, been to shop twice, cant find anything wrong and service people have no clue. new battery, no codes. Occurs usually after the truck has run never when sat idle for a period. Start after a while can be 1 min to 2h.
View 12 Replies
