I have gear noise in my 2007 Liberty 4 X 4. It sounds like it is coming from the rear axle and is more pronounced under acceleration or decelleration.
View 5 RepliesMy ABS light and brake light come on within a few minutes of starting in gear. The brakes work fine and the brake shop says that the system is working fine, but I can't get the dang warning lights to turn off.
I've read online that it might be the sender mounted on the rear differential of my 2005 Jeep Liberty.
I have a 2003 Jeep Liberty V6 automatic 4x4- the car is getting stuck in neutral and won't change into gear. It starts up just fine and runs okay for about a mile before I notice a terrible hissing sound when I press the gas pedal just before it acts up and locks in neutral- dangerous on the highway as I have to pull over, shut it off and then restart which then resets but soon comes the hissing sound and again it locks in neutral... I tried adding Lucas transmission fix but this did nothing.
I purchased this car (2003 Jeep Liberty Lmtd. V6) the check engine light has been on for 4 years now- none of the mechanics I've brought it to have been able to figure out why. ( hoses changed and nothing) I have not had a smoke test done. I started having start-up issues. The radio and all the lights come on but the car won't start (rule out battery), eventually after a few tries, it starts up.
I've also noticed, when in reverse, sometimes it stalls, a few times it has shut off on me while trying to park in reverse gear, sometimes when driving it kicks as if it is having trouble shifting into gear (it's automatic)- and finally, the hissing and revving sound when pressing the gas pedal, it shifts into neutral and gets stuck there....
For the last few months, I've had an annoying problem with my 2003 Liberty. If I'm driving the car with the blower on (i.e. when it's cold out), whenever I stop the car and am idling, I get a very strong exhaust smell coming in through the vents. If I turn the fan off, the smell goes away. At first I figured it was due to being behind other vehicles, but now I've noticed that it does it all the time, even when there's nobody else around.
I brought the jeep into a shop a couple of weeks ago to deal with a separate CEL issue (evap leak - fixed by replacing gas cap) and I asked the mechanic to look for an exhaust leak. He said he didn't see any readily apparent problems with the exhaust line.
I'd like to deal with this because it's not very pleasant to inhale exhaust fumes through the vents. I intend to take it back in - but is there anything I can tell him (i.e. like, a particular part of the exhaust system to inspect more carefully) that will solve the problem?
I own a 2004 F-150 FX4 5.7L V8, I notice this morning that I had gear oil coming out of my rear Axle Vent Tube. What would cause this issue? I'm kinda at a loss as to what would cause it.
View 3 Replies2007 Jeep Liberty Can't get the oil dipstick back into the tube! Goes in about 3/4 of the way and jams - feels like it's hanging up on something. This is what I did: pulled it out, wiped it off, slipped it back in, pulled it out again to check the oil. Now it won't go back in. (No - I didn't put anything else down there!) The dipstick has this little twisty bit at the end - is there a valve in the tube it's supposed to slip through? This is my only car and I travel to work. Can I drive it without a dipstick?
View 19 RepliesMy dad has a Jeep Liberty that has been having some trouble while on the road. It's a 2007 and it's got close to 300,000 miles on it. Now, I'm not great with cars - I can change a tire and probably tell you how my oil looks, but even I know 300,000 is a solid amount of mileage for any car to have. A while ago, the Liberty broke down while my dad was out and he had to have it towed to the mechanic. Mechanic said he thought a plate within the battery had shifted and so he replaced the battery. Not long after that, the car died on my dad again. He describes the car as going haywire right before he has to pull over. Indicator lights starting going on, dials (such as the tachometer) would jump back and forth and the engine would rev without hitting the accelerator. And after he stops the car, it doesn't start up again.
When my dad was able to get it back to the mechanic after that second instance, the mechanic said he thought the Electronic Control Unit (ECU?) might have been fried by the battery and had it sent to the dealer to have the unit replaced. They replaced the control unit and the car ran for a while, but sure enough while my dad was out one day, the check engine light came on and it appeared that the car was once again going to freak out and die on him. He was able to make it back home, yet the car has been sitting in the driveway ever since. I turned the Liberty on today and just moved it around the driveway and I noticed the check engine light is still on and a "Part-Time" indicator light that is on, but flickered while I had the car running.
From what I understand, the Check Engine light has been perpetually lit at many times during the life of the car even after tune-ups and inspections. Could this be an electrical problem or mechanical? My dad thinks it might have something to do with the transmission, since it has been replaced before. Now, my dad and I are both aware that the Liberty is close to being laid to rest, but we also both think that it's still got some life in it worth trying to save. I had a problem with my motorcycle that seemed similar to this problem, between the haywire tachometer, the engine revving without hitting the gas, and not starting up after stopping the engine. Turned out that it was a short that caused that problem and it was quickly fixed by a mechanic. I know that does not mean it will be the same diagnosis, but that is what the Liberty problem sounds like to me.
I was driving home from a backpacking trip when I noticed a knocking coming from my engine. It got worse as I drove up a large hill and suddenly became very loud, and I lost the ability to accelerate, power steering and brakes.
I managed to pull off the road and checked all my fluids, everything was good. No smoke from the engine and it was not over heating. I was unable to start the car, it wouldn't even make a noise, just dead.
Check engine light is broken and remains on. No other warning lights came on while I was driving.
My jeep liberty 2002 has been sitting for two weeks. Noticed rear door latch opening and closing. So I unhooked battery. I figured battery was dead tried to hook charge to it but it keep discharging kicking off charger. Whats going on? Tried jumping but it was still discharging?
View 5 RepliesI bout a 2010 AWD LS460 in July and immediately noticed noises coming from the rear and front. The rear was a loud thud going over certain bumps and the front is making rattling noises. I lowered the windows and went down a rather bumpy block and the car sound like the bottom is falling out. I took it to the dealer and they had it for 2 and 1/2 weeks waiting on the rear air shocks to come in. They gave it back to me and did not address the front. Now the service manager is going away for two weeks and wants me to come back if I still feel the need to have the from done. The master tech stated the front left suspension needs replacing. I feel they are trying to drag this out so they dont have to pay for the repairs. The car has 80K and was bought from Bay Ridge Lexus and is not under CPO.
View 13 RepliesI own a 2010 Jeep Liberty and this is my first RWD vehicle (when set in the normal 2WD mode of course). I notice that whenever I accelerate from a stop, on even a slightly wet road, the rear wheels spin and I get the traction light on my dashboard. I then need to take my foot of the gas and accelerate ohhhh soooo slowly. I've never had this kind of wheel spin on my previous AWD or FWD vehicles. Is this a known "feature" or RWD vehicles? Or maybe my one year old tires are inadequate? With my Liberty I could try switching to 4WD LOCK mode before attempting the acceleration to see if this works.
View 19 RepliesOver the past month or so I've noticed that my 2005 Jeep Liberty Limited has started to make a creaking noise when it's a little off balance, such as driving down and uneven drive-way. I believe it's coming from the back?
View 4 RepliesI have a 2002 jeep liberty 3.7... It auto trans 4wheel drive. All at once it makes rattling noise and shake like crazy. I was thinking oh no another u joint but checked them none broke or cracked. So I got back in drove it on home and it had stopped. So then I thought front cv axle. So I put in 4x4 and drove it and nothing?
View 4 RepliesOkay, so I've been hearing this strange sloshing noise in my Jeep Liberty 2005. It happens when I start off from a stop and usually around 15mph. It seems to be coming from the front of the vehicle (engine). And I'm not the only one that has heard it so I'm not crazy.
View 3 RepliesI had the rear axle seals replaced less than 1000 miles ago. Now the axle is getting whiny. First I thought maybe that the tires made noise but now I'm pretty convinced it comes from the axle.
With a seal replacement, what do they do that might impact the axle - over tighten the bearings?
I also had the rear diff fluid replaced - perhaps they put in the wrong stuff...
Should I replace fluid and see if that stops or should I simply take it to the dealer and let them deal with it?
When I am coasting in reverse or forward at low speed e.g. 5 mph, I am hearing a whine that seems to be coming from the rear axle.
Usually it happens just after I have shifted OUT of gear (it's a manual transmission).
I uploaded the sound as a WAV file to here: Note! I recommend that you disable flash before going to this [URL]......
When I speed up the whine just rises in pitch and it's making my ears ring. What that sound might be? Maybe I just need some "axle grease" or something?
Noticing a somewhat regular sort of light tapping noise from Subaru CVT Outback, when slowing to stop or starting out?
Some days it's noticeable only for about a second after the clunk from shifting, often you can hear it a bit longer.
You can hear it best at about 1 min, and last 40 seconds of this short trip audio-clip.
I have a '98 Suburban 4WD, last week I started hearing a clicking noise when I go in reverse. Sounds like it is coming from the rear axle area. I don't hear the sound when going forward.
View 3 RepliesI have a 1998 F-250 LD 4x4 with 462,000 km. I have been hearing for some time quite a drone coming from the rear axle. I am guessing the wheel bearings are due, as both front ones have been replaced, but never the rear. More about the noise, I hear it come to life as I gain speed. The faster, the louder. If I decelerate the noise is still present, but volume significantly decreases. Should I change the oil and friction modifier and see if there's an improvement or go ahead and change both bearings too?
View 7 RepliesMy wife has a 2002 Hyundai Elantra that has a rotational noise coming from the left rear wheel. We just got it back from the shop where they replaced the left front wheel bearing and rear brakes/rotors, and the right/rear wheel bearing was replaced about a year ago. It's a thumping noise that speeds up proportionally to the speed of the car. Normally I'd expect a bad tire or warped rotor, but the tires are relatively new and we didn't notice the problem before we took it to the shop last week (though it's possible we weren't hearing it over the wheel bearing noise they fixed). Is it possible we got a bad rotor, or the shop did something wrong? Or could this be something new entirely (which would be entirely typical for this car).
View 1 RepliesSome family members borrowed my truck, and when they returned I have a loud whining noise coming from the rear axle, which I have determined is a 9.75 rear. I checked oil level and it was high enough, but has a slight leak from the pinion seal. Everything feels solid but I have nothing to compare it to.
Its on a 2005 Super Cab with the 5.4L 183,000 miles. The front pinion seal was replaced in Feb 2 years ago, by the dealer's mechanic, who may have been a shade tree mechanic.
I am a Youtube Certified Mechanic, as in, I watched about 10 videos of people working on their 9.75 differentials, and realize I don't have all of the tools to do the job, such as a press, or race drivers, or the special gauge.
How many of you have tackled this issue? What did you find? What am I looking at for cost? I am on a very small budget.