My 1994 Toyota Corolla idles at around 1500 and 2000 RPM just about anytime I drive it.
It is worst when I first start the car, and it gets better the longer I drive, however, it is still well above a normal idling range!!
I add oil regularly and do check the levels on most of my fluids on a weekly basis!
I've got a 1994 Camry V6 that I am swapping transmissions from automatic to manual. Before the swap, the engine ran fine and started first time every time. Now that I have everything back together, the car will take many times of 10 seconds or longer cranking to be able to start. Once it does start, it idles very high and within 15 seconds will die. If, during the time it is running, you touch the gas at all, the car instantly dies. I've got CEL's for CPS and TPS. I have replaced both sensors numerous times, checking with a voltmeter they are within spec as are the wires, I have replaced the ECU and wiring harness.
View 5 RepliesMy 2001 Intrepid ran good before I removed the intake air plenum. I removed the plenum to replace the air coolant bleeder. When the plenum was removed, I left the throttle body connected and just unhooked the wires from the idle air controller (IAC) and throttle position sensor (TPS). After reassembling the intake, the car was idling up around 4000-4500 RPM. The idle is really rough as though it is hitting a rev limiter.
When I unhook the TPS, the car idles around 1500-2000 RPM but still acts like it is hitting a rev limiter. What might be causing this? I don't know why lifting the plenum and throttle body would wreck either of the two sensors. I also can't figure out why the car idles so much lower when the TPS is unhooked. Would that suggest the TPS needs to be replaced? The throttle is operating freely and is fully closed when I'm attempting to start the car.
I have an 02 Santa Fe with the 2.7, 4x4. This started a few weeks ago. When it is first started, it cranks over for a few then starts, idles 1500-2000 rpm. It is a little hesitant at first, but will eventually run fine. If I go to the store after it is warmed up, shut it off, then go back to start it again after shopping, it does the cranking over for a few, and when it starts, you can smell gas (strong smell). when you go to take off, it hesitates real bad, backfire rumble through the exhaust, has no power, bucks, and you have to feather the throttle to keep it running. If you put your foot to the floor, it does nothing, 20 mph if your lucky. if you can keep it running long enough without it stalling, which it has done, and hit the highway, and get going, it will eventually work itself out and run ok again. There is NO CEL. It is getting worse.
View 1 RepliesMy 94 850 turbo wagon starts rough and idles very high. the rpms dont come down. After turning car off, wont restart again unless I let in sit for a while.
View 11 RepliesJust as the title says, 214k great shape just wont get going more you mash the less it goes.... fuel pump already replaced, can undo battery and take a while to reset feels to do fine then goes back to bogging down... TPS ? idle air control?
View 3 RepliesI have a 2000 Toyota Corolla with about 170,000 miles. It idles rough and at about 50-55 mph it loses power and runs very poorly, like it is not banging on all cylinders.
View 1 RepliesThis corolla is about 10-15 years old, i don't know how old. Again, its a manual transmission. It started today, when the car idles, the engine revs up a bit like a hum. I wasn't pressing the gas petal or anything and it just revs by it self. My dad says it was probably the engine was too cold and it is just warming itself. Then my dad said the car mechanic said its the gas sensor? He also said the sensor cost about 200 and with labor job, 280$. good deal?
View 9 RepliesMy 03 Corolla S - 5 Speed has developed a sound while driving, only when giving it gas. The sound goes away when I press in the clutch. It doesn't make any unusual sounds while parked and idling.
The sound, sounds like a knocking noise. At least to me that's what it sounds like. My car has 156k miles on it.
The car idles fine, rpm's are good on while driving, temps good and still gets really good gas mileage.
Does it have something to do with my clutch, since the noise goes away when I take my foot off the gas, or press the clutch in?
Is there something I should be checking? All my fluids are good, brake/clutch, oil, transmission fluid, radiator, etc.
I have a 1994 Toyota Corolla, automatic transmission. I went to start it this afternoon and it made a clicking sound a few times then went completely dead. When I jumped it, the dashboard panels, radio, lights, doors, etc. began to work, but it still would not start. I have replaced the alternator about 1.5 yrs ago and had the battery checked then too (it was fine then). I have had this problem before about a year ago, but it did start when jumped. I didn't leave my lights on or any doors open, so I don't think I drained the battery.
View 2 RepliesMy 1994 Toyota Corolla wagon has a problem. I drove to work, all seemed fine. I jumped in it in the afternoon, and my key won't go in the ignition - it gets half way in, and that's it. It feels like the key is bumping into something into the ignition lock cylinder. In the interest of full disclosure, I've sprayed some WD-40 into the lock cylinder, thinking maybe the pins were jammed. If that is the case, it hasn't worked. Zero improvement. This originally happened when it was really cold out, so I've waited and tried it again on a warm (40 degree) day - no change (though my door lock and ignition have been more stubborn in the cold in the past, but only marginally so). So, what are my options? I guess you can't (easily) replace the lock cylinder without the key in the "on" or "acc" position (which I obviously cannot do). I'm not opposed to using a screwdriver as the key, or hot-wiring the car, but don't want to take drastic (or stupid) steps before being sure I don't have other choices..
View 6 RepliesAfter a new distributor, check engine light coming on, getting a code 52, they (Toyota Dealership) replaced knock sensor. Unfortunately it seems to improve a little bit, but same issues happen; engine not running smooth at times. 94 Corolla. In the 223,000 mile club. 1.6
View 7 RepliesPeriodically my 1994 Toyota Corolla 5-speed manual will not start. Other times it seems to hesitate before starting. The rest of the time it starts fine.
When it does not start: I turn the key, and hear the fuel pump relay click, and hear the fuel pump on the gas tank energize, but the car does not try to crank. I do not know if the starter solenoid is engaging at this time, as I could not listen for it while in the car. When I did try to listen for it while under the hood with someone else starting the car, it actually started (did not exhibit the issue)
When it hesitates before starting: However, sometimes, when I turn the key I hear the fuel pump relay click and the fuel pump energize, after about 1-1/2 seconds of holding the key, it does start.
When it does start it sounds normal, not like a low battery. The battery is new. I had the charging system checked at Advance Auto and they said the battery was good as was the alternator and starter. Plenty of cranking amps.
I disconnected the main wire on the starter motor and cleaned it with a wire brush. I also cleaned up the battery terminals.
I did find that the switch on the clutch pedal that allows the car to start when pressed has some fluid leaking on it (clutch fluid I think). Could that be causing the intermittent starting issue? If so, can I just clean it with WD-40 or something like that?
This car was running fine until my daughter brought it to a reputable tire shop to have new tires put on and an alignment done. The day after this was done, she started having issues with the car not wanting to move when it is in drive. It would eventually take off, but very reluctantly, and once she got going down the road it would be fine. After a couple days like this, it just wouldn't go at all in drive unless someone was pushing it. It goes fine in reverse.
The transmission fluid level had been recently checked, and was fine. Now when this problem cropped up and it was checked, the fluid was gone! We don't notice anything on the ground where it has been parked.
I have recently been having a problem with my Toyota Corolla. It starts up fine in the morning, but after a couple of hours of driving with the A/C on and the running lights (which are always on), and the radio, when I shut the car off, it will not start without a jump. With my heavy duty cables it starts instantly with the jump but then I am afraid to turn it off again. It has a genuine Toyota battery that has the dots removed saying it was installed Dec. 2012 although it looks older. After driving for a couple of hours the battery should be fully charged right? Or, does having the A/C and lights on suck up to much juice?
View 1 RepliesMy 94 Toyota Corolla has about 190,000 miles on it and lately it has had a hard time shifting between 20-30mph. It finally does reach it and does not have trouble shifting at any other speeds. This only happens in the heat of the afternoon (Never have this problem in the morning). Also, my O/D light has been flashing when this happens, or at least around the time it happens. Could these two problems be linked? I took it to my mechanic in the morning and he checked the transmission fluid and it seemed fine, he also had no problems driving around when he tested the car. He said my transmission is going and that I should make "long term" plans. Is there any hope?
View 1 RepliesI have a 220k 1994 Corolla with I have come across a couple problems recently. It all started about a week ago when I decided to change my rear brake shoes. The old ones turned out to be all cracked and everything but were generally in pretty good shape in terms of wear. Anyways I put the new shoes in (my first brake job) and tightened up the e brake cable and went for a test drive. I walked away extremely satisfied, the e brake worked perfect which was my main reason for changing the shoes in the first place.
Basically the whole thing worked perfectly until 2 days later. I was driving for about 8 miles when my brake pedal suddenly fell through to the floor (or pretty close) at first I even thought I hit the clutch pedal! anyways after pumping the pedal a few times my pedal feel returned about 70% and after another maybe 10 seconds braking power was lost again until I pumped the pedal. So lucky for me my destination was a 1/4 mile away so I parked and checked the fluid level; it was at the max mark, then I check the wheels/drums and they were REALLY hot.
Also the driver's side drum had a faint smell of brake fluid. Anyways about an hour later I went for a short drive and the brakes worked fine so an hour after that I drove the 8 miles home and about 1/8 of a mile from home same thing happened; brake pedal basically goes almost down to the floor until pumped. My thoughts were that the new shoes were constantly rubbing and the old fluid overheated and caused failure so I flushed the system and put new fluid in and adjusted the shoes "in" with the click adjuster bolt. I had a really hard time getting the drums of to begin with. That and I loosened the e brake cable just in case.
So the next morning I drive about 5 miles without using the brakes pulled over to check that the drums were not heating up anymore (they weren't) so I thought I had fixed it. Well 3 days later (last night) I was experiencing the rear brake stickiness again. Basically when I was just moving from a stop where I had used the e brake to secure the car, I could literally feel that the rear brakes were stopping the car pretty aggressively and sure enough after a few more miles my brake pedal fell through so I poured water on the drums and they started to let off lots of steam, even after like 10 bottles!
So I limped to my friends house at 12:00 AM and jacked my car for a look. Again the drums really didn't want to come off and once we did get them off my friends dad inspected them and could find anything wrong with my installation. The conclusion that we came to was that the auto adjustor for the shoes makes the shoes too tight and they rub. So I am thinking maybe this is cause for the fluid to overheat and boil, causing the pedal to fall through. The pedal fell has gotten much worse since I bled the system 3 days ago so that may be an indicator. Did a test this morning for 5 miles and the drums were just below lukewarm.
My 1994 Toyota Corolla's speedometer just stopped working while I was driving this morning. Does this mean that there could be something worse going on than just my speedometer?
View 4 RepliesMy 2000 4x4 4runner just after it starts up tends to have a funky idle. It rarely goes above 2000 rpm but it ranges from 300-1500 when idling after start. Also when I drive home from work it tries to idle as low as it can then if I don't rev the engine it usually dies in the middle of traffic. Once it's going it's fine though. I've already cleaned the IAC and the Mass airflow sensor. Maybe one needs to be replaced or just a tune up?
View 5 RepliesMy toyota will not idle. The last time this happened, it needed a new battery. The idle is controlled by the battery. The alternator doesn't kick in untill 1500 to 2000 rpms. The battery checks out OK this time. It's an 03 4cyl.
View 5 RepliesI have a 1994 Toyota Camry. Took it to a shop to repair an oil leak. They had to dismount the transmission to get to the gasket. I got the car back and the transmission was messed up. Took it to a transmission shop and they told me that the transmission "cable" wasn't positioned correctly by whoever had done the work and they could fix it. They told me it was safe to drive it until my appointment. The engine was revving too high before changing gears and while driving home, I heard a loud rattling noise in the engine and my car stopped in the middle of the road. I'm told that a rod has broken inside the engine. My question is: can this in any way be related to the transmission cable not having been set/positioned correctly?
View 5 Replies