Toyota - Tercel :: 1985 - Brake Pedal Goes To The Floor Especially In Cold Morning
Mar 14, 2014
So, until recently I had a 2000 Ford Focus but it was totaled in an accident not long ago and is long gone now. I was given a 1985 Toyota Tercel Wagon with about 194,000 mi by a family member. However, it has always had a problem whereby the brake pedal goes to the floor now and then and especially when it is cold in the morning. So, I took the car to a mechanic (hwy 64 auto, Raleigh, NC) and they replaced the Master Cylinder yesterday and bled the brake lines through the master cylinder.
The mechanic told me that the bleeder valves were too old and corroded to try to bleed them at each wheel and that they might break and then the caliper(s) would then have to replaced. Anyway, long story short, the brakes are WORSE after he changed the master cylinder and bled the lines from the master cylinder. Now EVERY time you first press the brake the pedal goes down then immediately you can "pump" them back up so either air in the lines or still a leak somewhere in the braking system. I do not want to spend anymore money (or at least very little money) on this car as too much has already been spent on other things before I got it and also after I got it.
Did the mechanic screw up or am I looking at a problem you have with some old cars where you start replacing parts in the brake system and then still have the problem or a new problem and then you wind up spending $800 replacing old crappy, worn out parts. What should I do? Did the mechanic screw it up or is it just time to send this old car to the scrap pile and crusher? Remember, I don't want to keep pouring money into this thing. I've already spent some money on it with other stuff lately.
View 19 Replies
Advertisement
I have a 1985 Toyota Tercel that I just got, the thing has been sitting for 2 years and it started before it was left to sit. Now I have done all the usual maintenance on it, replaced the sparks, oil, oil filter, air filter, distributor cap, fuel pump and fuel filter, gave it some gas treatment and filled the tank and some carb cleaner to clean out the gunked up carb. My problem is that it starts but dies right after when it tries to idle. it can shift in to gear and such but it will still die out right after about 10 seconds unless I keep tapping the gas. The more times I start it the longer it stays idle but I wonder what the problem is...
View 4 Replies
Brake pedal goes to floor with no resistance first time I start in am. Rest of day all normal. Started when cold weather came. Fluid ok, no leaks seen.
View 3 Replies
My Sienna 2005 experience intermittent complete brake failure 3 times within 18,000 miles,the brake pedal goes to the floor and it does not slow down, so I coast until I stop. However, when I release the brake pedal and then reapply the brakes, it works fine. A non-Toyota mechanic thinks it's due to malfunction of ABS. The dealership is unable to finds error codes and brakes work fine when the Sienna is in their hands. I scared that the brakes will not work the next time I reapply the brakes.
View 30 Replies
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 Replies
I just bought a 1997 Toyota Tercel 5-speed stick, with 175,000 miles, and the temperature gauge moves from its lowest possible position to its highest possible position when the key is turned on, although the engine does not overheat, and no coolant is leaking or being burned. I replaced the coolant temperature sensor, but the actions of the gauge were not affected. I don't know if it is somehow related, but the heater blows cold, regardless the setting of the temperature dial on the dash. What I might try next?
View 3 Replies
I have noticed that anytime i leave the car parked for more than 5 hrs or so, when i get in and put my foot to the brake pedal to start, the pedal feels very hard... as tho someone sat in the car and pressed it several times.... So great force is needed to mash the pedal to start the car... After it starts the pedal gets nice and soft as normal... Is this normal?? Or should i get it checked
View 9 Replies
I have a 2004 Sienna LE and it has left/right signal problem (not working) in the morning or when the weather is cold. The problem usually last for about 5 to 10 minutes until the inside car temperature becomes warm.
When this problem happens the emergency lights are working. Only the signal left and right do not work.
Is this a common Sienna problems? I brought the car to the dealer but they refused to fix it because they cannot duplicate the problem. I am guessing when the warranty has expired, they will make suggestion to replace the part but not until then.
View 30 Replies
I was driving around today and had to hit the brakes really hard for the first time. ABS kicked in and during the ABS 'action' the brake pedal rapidly went to the floor. With each 'pump' the ABS made it felt like the pedal sunk slightly.
This was on dry pavement, a little gravelly / dirty and the car stopped rapidly, but just as I stopped the pedal was VERY close to the floor, and with just a touch more pressure it did in fact hit bottom.
Sounds to me like the ABS pump needs to be bled, is that right? Can I do that myself with a VAGCOM? I hate having the dealer do anything, even if it is their job. How to SAFELY confirm if cars does / does not do this as well?
View 8 Replies
After having rear disc pads replaced, my 2003 Toyota Avalon makes a terrible noise backing out of the driveway in the morning. I think it must be rust or something--it never happens in ultra-dry weather. It is a very loud squeaking and moaning. It only happens backing up, and it goes away after a bit of driving. Normally I would not worry about what is likely a bit of surface rust, but this is INTENSE. Like, the neighbors across the street stare at us. Should I worry about this, or just live with it since the brakes perform fine after this initial period?
View 1 Replies
2005 Volvo S60 T5, 90,000 miles. The brake pedal depresses almost to the floor. Dealer service has not had a solution to this problem. All brake components are supposedly nominal. Might pedal position sensor be faulty?
View 1 Replies
My 04 Camry is having brake issues. It has 205k miles. The front pads are great and the back shoes are great. (Drums in back) I've had them adjusted multiple times but my pedal still goes almost to the floor. It's not the master cylinder cause I've already replaced that. The pedal doesn't bleed off either. But I have bled the brake lines and there is no air left in the lines.
View 14 Replies
My mother went out 2 days ago to go run errands, she stepped on the brake pedal and it went to the floor (car still in garage and in park, low mileage car 81,xxx garage kept). I have not been able to duplicate the issue. The fluid has been changed twice since new, no signs of fluid loss, undercarriage inspection revealed nothing. I am thinking maybe a vacuum hose issue.
View 2 Replies
When I go to start and depress the brake pedal it goes all the way to the floor. The brake fluid is at the full mark and my 2011 has only 25k miles. Where should I look since it did not go all the way to the floor when I forst got it with 6K miles.
View 19 Replies
I drive a 1991 F-150 Lariat Extended Cab. Out of the blue, my brakes decided they didn't want to work unless the pedal is about 1/2 - 3/4 of the way down to the floor. As soon as I release past that 1/2 mark, they shut off. While this makes it great for tailgaters, it does not make it great for police officers.
We have already replaced the switch thinking maybe it was that, but alas it was not. I was reading in a couple difference places about the multiswitch? However, the symptoms other people had were similar, but not the same. I never tilt my steering wheel, so I dont know if that's the issue!
View 2 Replies
2013 Prius c Two, bought brand new with 15 miles on it 5 weeks ago. A few times when driving, I noticed the brakes seemed weak, like they weren't stopping the car very well even at low speeds (My driving is mostly in town on residential streets, so I'm rarely going over 35 MPH. Even so, I'd have to really mash the pedal all the way to the floor to get the car to come to a complete stop, otherwise it would keep moving forward. Several times I ended up about 5-10 feet past the line, sticking the front bumper into cross traffic. Luckily no one hit me. I chalked it up to the quirks of a different car than the one I was used to, and figured if it kept happening I'd take it to the dealership.
On Monday, my wife was stopped at a red light. The light turned green and the car in front of her started to move forward. After a few hundred feet, he suddenly slammed on his brakes. She said her brake pedal went all the way to the floor, and the Prius didn't slow down at all. She hit him going about 25-30 MPH and totaled the Prius. She's an excellent driver and I've been with her before when she's had to panic-stop. She's never driven a car without ABS, so she is used to pushing the pedal hard and keeping her foot on it. She wouldn't even know how to "pump" the pedal. She swears the pedal just went all the way to the floor and the car didn't slow down at all.
View 18 Replies
For the past several weeks, my daughter reports that she has to put her foot almost all the way to the floor to get the brakes to work. The brakes do not have an effect until her foot is 1-2 inches from the floor. It usually happens after she has been driving for a while without pressing the brakes. I’ve driven the car numerous times but haven’t been able to replicate the problem. Her commute is approximately 10 miles each way in stop and go traffic. The car is a Volvo xc70 with 200k+ miles. I've had it looked at by a mechanic who didn't find anything but it's continuing to happen. I'm suspicious that it may be a master cylinder problem and concerned about complete brake failure -- should I be?
View 7 Replies
When I press the brake pedal, the car will stop. But if I keep pressing it while the car is stopped, the pedal wants to keep going towards the floor. I have to press hard for it to do this. I have bled the brakes. I've checked the calipers and the hoses for leaks and don't see anything. The master cylinder is topped up and I don't see any fluid underneath it. It doesn't appear to be leaking. The funny thing is, when I turn the engine off and press the pedal, the pedal comes to a stop and doesn't want to move after I pressed on it as hard as I can.
View 2 Replies
I have a 2007 Sonata GLS 4cyl. Anyhow lately my brake pedal is going right to the floor. The brakes seem to work fine, but if I keep constant pressure on the pedal it will slowly go all the way to the floor. My rear rotors and pads have been changed a couple of months ago and I'm pretty sure my front brakes are good. What could be causing this? I also checked underneath the car for leaks and there doesn't seem to be anything leaking underneath.
View 6 Replies
I have been working on my 01 Elantra for 2 days now. My problem is that I have absolutely no brake pedal at all, it just goes right to the floor. and this is only when the car is running, when it is off I give it a quick pump and i have a nice firm pedal. I installed a new master cylinder, bench bled it and all that jazz. I replaced the rear brakes and a wheel cylinder, I have also bled the brakes multiple times, and mutliple ways. bled the master while on the car and all the brakes while the car is off and while it is running. I dont know what else could be wrong with this. I looked at all the lines and there are no wet spots, no hoses are swelling up. everything looks top notch...i just have no brakes why.
View 15 Replies
I have a 99 Blazer 4x4 with ABS. Brake pedal just went to the floor and car stopped eventually ... a bit scary. I've checked all the brake lines and the inside of all wheels and there is no sign of fluid anywhere. All pistons seem to be where they need to be with backing plates nicely visible.
I pumped the brakes quite a few times and same result ... but I'm not pumping fluid on the ground. As expected I've also checked the reservoir and its full. Didn't see any leaks so its full. I'm guessing that the master cylinder has given up the ghost ... truck has 470,000km so things wear out.
View 5 Replies
