Accent LC (2000-05) :: Starting After 5 To 6 Seconds Of Cranking When Engine Is Cold
Jul 6, 2011
I have a 2000 Accent with 90k miles. The last week or two, it takes about 5- 6 seconds of cranking to start when the engine is cold. Having had the car since new, I know that it's not normal.
The engine seems to crank strongly, and once started idles and drives well. This occurs once about every 4 starts when engine cold. Warm engine starts normal.
Changed plugs - no difference. Maintenance current per owners manual schedule.
View 4 Replies
Advertisement
My daughter has a 2000 accent , SOHC 12V, I think it's the 1.5L.. It will not stay running when the engine is cold...........after it warms up, or if it sits in the hot sun it's fine................it has 166K .
She said she took it to an auto parts store and had the engine code read, p1123 came up.....
Code P1123 : Long term fuel trim, at idle - mixture too rich..
What do you think this is caused by................ the inlet air temp sensor? I was told someone just replaced the air max flow sensor, that don't sound correct to me, but that's what they called it....probably the MAF sensor....
View 9 Replies
I recently bought an 02 Chrysler sebring (4 cyl) When cold, it takes about 5-10 secs of cranking for engine to start. Is that normal?
View 4 Replies
I have a Hyundai-Accent 1.5 GL, Auto, year 2000 car. I bought this 4 months ago and ever since it has been giving the check engine signal. However, running conditions of the car has been normal and therefore, I didn't worry about the check engine signal. Now, the engine is rough idling for few seconds when I start the car in the morning, and then it comes back to normal.
View 12 Replies
My ugly little 2000 Accent that I've taken careful care of for 240,000 miles has developed an intermittent, multi-symptom cold starting problem, how to solve....
Background on the car: I've owned this car since it had only 9,000 miles, so I know everything that's happened to it over the years. I've kept up on all the regularly-scheduled maintenance over the years and miles - oil changes, timing belts, engine coolant, water pump, belts and hoses, pcv valve, plugs & wires, fuel and air filters, transmission fluid, etc.
No check engine light on, no codes to diagnose available
Not leaking oil from the top or the bottom
No vacuum leaks
Runs strong, no loss of power or rough running at idle or under load
No major components related to spark and fuel delivery have been replaced - coil pack, fuel pump, etc
Symptoms:
Starting problem 1 - The car will simply refuse to catch and start up, sometimes for as long as 10-15 seconds of cranking, after which it starts and runs normally. This happens infrequently, but has been becoming more frequent in recent months.
Starting problem 2 - The car will immediately start to fire (one or more of the cylinders will catch), but will hesitate to fully start up for about 2-3 full engine rotations, what I would describe as a rough start.
View 8 Replies
I have a 2002 Camry LE V6 with 189K on it and noticed that it takes several seconds (4 to 5 seconds) of cranking before the car starts. When the car was newer, it used to crank quicker.
Here is what I have done so far:
- Changed all spark plugs @ dealer using iridium type
- Always used Premium Fuel (Petro Canada 91 grade)
- Put in a bottle of injector cleaner (Redline Complete Fuel System Cleaner)
- Throttle Body has been cleaned about 20K ago
- Oil changes are Mobil 1 5W30 year round with Denso Filter
- Battery was replaced last year with an Optima Red Top and was tested a few months back to be in excellent working order.
What I have observed is that when the weather is VERY cold outside (i.e. -20), it seems to crank quicker, but if I keep my car parked in my garage overnight and start it, it takes several seconds. I have never had the car not start on me so that's a good thing.
View 12 Replies
I own a manual accent from the 2000 that I have since last December. Fuel pump and battery are new, I changed them after getting the car.
The issues I have and I think they are due to the same reason, are the following.
1. Sometimes, when I turn the key to on position and before cranking, the engine light blinks and the car wouldn't start. Then I remove the key and try again until the light doesn't blink and then the car would start. This could be the second time, the third time or after several times. When the light blinks and I try to start the car, I can hear the fuel pump and the battery working, so the problem must be somewhere else. Also, this issue happens very randomly, it may doesn't happen during two weeks and then it happens one day and next day is OK again.
2. Few times it happened that even if the engine light wasn't blinking, the car started but like without enough power and then it stalled, I tried again, and it has always started OK the second time.
3. A couple of times, I was on the road and stopped the car in a red light and it stalled when I switched to neutral.
4. The car sometimes struggles with the first gear, when I'm switching from neutral to first gear to start the car (after being stopped in a red light for example). The car would start very slowly, even if I'm pushing the accelerator and don't have my foot on the clutch anymore. But after few seconds, the car runs well and I switch to second gear, third gear, etc. and runs perfect. Above 10-20 km/h the car runs perfect, I only have issues (sometimes, not always) at very low speed in first gear.
I think that's it. So far, my mechanic has checked the code problem and he coded a new key, thinking that it was a communication problem between the key and the engine, but it didn't solve the problem. I don't know where to bring the car, because every time someone checks it, they can't find the problem or a solution and I don't want to spend more money for no reason. But I'm also worried that the car breaks down one day in the middle of the road or when I'm in the field with volunteers (I need the car to do field work, but luckily it's not a remote area.
View 4 Replies
Last week I started having problems with my 05 Accent, hatchback, 1.6L engine, automatic transmission. Filled the tank up with gas and the car stalled pulling out of the station and wouldn't start unless I pumped the gas while cranking the engine. Ran and started fine after that and I thought it may have just been an air bubble in the fuel line, since there wasn't a check engine light or any other symptoms after that. Fast forward to this morning and the check engine light comes on during my commute and when I checked it, it gave an EVAP code (P0441). I also stopped to refill the gas and it stalled again as I was leaving the station. Also after I measured the gas mileage I found that I'd lost around 7 mpg (from around 30 to around 23).
I've never heard of EVAP problems causing stalling and loss of gas mileage but I'm not all that familiar with these systems so I don't really know. I'm going to test if it's the gas cap going bad since on the list of things that could cause a P0441 that seems to be the easiest place to start, but other than that where to start looking?
View 8 Replies
The explorer has been having an issue starting after its warmed up. Starts perfectly fine when its cold. but sometimes when I drive, stop for 1-10 minutes, it takes a long time to get her to start up. Typically 30sec to 1 min of cranking. Doesn't seem to have any idle issues or issues running.
View 2 Replies
On the wifes Santa Fe 2.4 AWD every few starts it seems to crank over longer than it should. It will usually crank right up like it is supposed to. Every few times it may take 3-4 seconds of cranking before it will fire.
The car runs great, averages over 30mpg per the computer. No codes. I don't have a clue what it could be.
View 3 Replies
Hyundai makes squeaky noise when starting and stopping engine, starting to move and also when traveling at speed (during gear changing, turning, etc). What causes it? See website below for video with noise:
View 3 Replies
My 2000 honda accord v6 wont start (150,000 miles). It feels like its cranking over just wont go anywhere from there. So it doesn't seem like an starter issue or battery issue. It has done this to me in the past a couple of times but after letting it sit there for a bit it started back up. The weather hasn't been an issue on the times it wanted to start or not start. I know a oil change is due and
The EGR valve needs to be cleaned/replaced but could those things make my car from not starting? When i put the key in the car and turn it to the II, the Maintenance required light comes on and the light for the key just keeps blinking.
View 1 Replies
i've got a 2000 chevy impala 3.4 v6 E. runs great once it starts, but lately that takes a lot of cranking. it's getting spark. it's got a new alternator, battery, starter, plugs and wires (and i checked for spark already) I think it's a fuel issue but don't know where to start looking because it has no other problems. there's no smoke or noises, no misfires, or hesitations. i put in a new fuel filter. i have heard that it could be the fuel pressure regulator or maybe even a leak in the line that's causing it to not get pressure. i can't hear any sort of fuel pump sound (maybe i'm deaf) is there a way to check this without a gauge? i simply don't have one and don't have the money to take it to a shop. p.s. i recently replaced both o2 sensors, but i can't see how that would effect the starting. pump, hose, regulator, fuse?
View 4 Replies
I have now replaced hpop, injectors, cups, gpr, batteries, uvch on both sides, icp and ipr on my 2002 F550 and it still has a long crank to start.
It has been driven about 1,000 miles since then and no change. I have no codes except buzz test produced a high to low 1272 1274 1276 1278 one time. Cannot get that to happen again.
It is taking 4 seconds of cranking to start consistently hot or cold. It always starts but cranks for what seems like too long compared to my other 7.3s. I have included a screenshot of the data and am curious on what everyone's thoughts are as I am out of things to look at!
View 14 Replies
2005 Accent has been essentially bug free until now.
Drove 3 hours, parked for 4 hours, then when to turn it on... cranked, no turn over. Tried again and the crank died. I figured, ok, no problem, battery getting long in the tooth, time for a new one.
A friend and I were able to push start it (5 speed manual), and yesterday I bought a new battery for it. No worries right?
Wrong. Same thing now. Cranking but no gas/spark/turn over. No check engine light or codes.
My next place I'm guessing I need to check is the fuel pump relay? Should I hear a click a few seconds after I turn the key to on? I believe I should, not sure if my memory is playing tricks on me, but right now there is none.
Relay in the fuse box? Do I need to check anything else first? Have multimeter.
View 4 Replies
I go out to start the car, it cranks and cranks and cranks. I stop turning the key. I then try again and it hesitates to starts. I give it a little gas and it starts. When it does this, the car begins running very rough and idling rough. When I give it a little gas while it's parked, the check engine light begins flashing at me.
I turned the car off and came back to it the next morning (maybe 10 hours apart). It started right up no problem, no CEL either.
Plugs/Wires were done a few months back.
View 1 Replies
My 01 accent's engine makes a clattering sound(sounds a little bit like a diesel engine) when it's first started in the morning. After warming up (in about 20 seconds or so) the sound disappears. My oil level is normal(last oil change about 4k miles ago with full synthetic oil. I normally change oil at 5k intervals with full synthetic), timing belt changed about 1 year(20k miles) ago. Should I be worried?
View 4 Replies
When engine is cold it starts fine, when hot from driving (e.g. the engine's temperature display's needle is in the middle) i cannot start it unless i try 3-4 LONG keys. What can it be? Where should i start?
View 17 Replies
I have a 2000 Hyundai Accent hatchback with 98k miles. About a month ago we were headed out of town and got gas about a mile away from the house. After filling up, the car wouldn't start. It would crank but not fire. Tried for about 15mins to no avail. Had it towed to local mechanic and it started right away. They kept it for the weekend and said they had no problems starting it, so without experiencing the problem they said they would just be throwing parts at it.
About 2 weeks after my wife drove to store and when she went to leave and same experience, but this time it started after trying for a couple of mins. Then just this Tuesday it wouldn't start in the morning. When it just cranks but not fire it shows a pending P0335 (crankshaft position sensor). So I ordered the part (won't arrive til Friday). When I got home I tried to start it as well to no avail; tried again Wednesday morning and evening, nothing. Then this morning (Thursday) it starts right up. Once its started it runs great. After recurrence of no start 2 weeks ago, I replaced spark plugs and spark plug wires.
View 6 Replies
So my 1.6 accent (140,000) decided to no longer start. Just keeps cranking but doesn't ignite. Plugged a scanner in and it's the crankshaft position sensor. How difficult is this to get to? From what I've ready its just held on one end by a 10mm bolt and the older end is just a connector, but it looks like it might be in a pain in the ass location. Does anything need to be taken off first to access? Should this take less than 30 min?
View 1 Replies
I'm working on a family members car. We pulled out the old motor and put in a new one because the old one has rod knock. We're not getting ANY spark. Crank position sensor shows no resistance when cranking. The harness at the crank position sensor shows no voltage. The both coils measure 1.5ohms.
The only two bits of the harness that are in questionable locations are the grounds next to the ignition coil and the passenger side strut tower ground. I have the strut tower one to the closest bolt on the intake manifold and the coil pack grounds to the coil pack bracket.
The car has plenty of fuel and good cranking speed, just no spark. I verified using a timing light (no flash) and spark-plug short-to-ground. The old engine WAS running and all of the sensors on this one were swapped over from the running one. Also, the tach doesn't move when cranking.
Is there something that's commonly overlooked, or something that could be causing the issue searching showed it could be the crank position sensor, but like I said, I pulled the working one off the running engine.
View 1 Replies
